JZJakub Zázvorka

Jakub Zázvorka

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jakub Zázvorka has a total of 161 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Spin- to charge-current conversion in altermagnetic candidate RuO 2 probed by terahertz emission spectroscopy

    by J. Jechumtál, O. Gueckstock, K. Jasenský, Z. Kašpar, K. Olejník, M. Gaerner, G. Reiss, S. Moser, P. Kessler, G. De Luca, et al.


  • Open Access

    Functional laser-induced damage threshold of aluminum coating deposited by magnetron sputtering with different power supply modes

    by Adrien Chauvin, Stephanos Konstantinidis, Jakub Zázvorka, Mojmír Havlík, Lukáš Horák, Martin Přeček, Ľudovít Haizer, Štěpán Vyhlídka, Milan Dopita, Martin Veis, et al.

    The need for high-power, high-intensity laser facilities has driven the scientific community to develop optics capable of withstanding higher fluences. The main challenge in increasing power levels is the limited damage threshold of optics. In this paper, we report the laser-induced damage threshold (LIDT) of aluminum coatings deposited via magnetron sputtering. Aluminum coatings (150 nm) were investigated as 45° s-polarization mirrors, a geometry widely employed for beam steering in high-power laser systems. The coatings were produced using three plasma techniques: direct-current (DCMS), radiofrequency (RFMS), and high-power impulse (HiPIMS). Our results show that the RFMS coating is rougher than the DCMS and HiPIMS coatings, which affects its reflectance efficiency (at 45° in s-polarization), even at 1060 nm, decreasing from 96% for DCMS and HiPIMS to 91% for RFMS. 1k-on-1 LIDT tests using a femtosecond laser beam (110 fs) at 1060 nm demonstrate that coatings deposited by HiPIMS and DCMS withstand higher fluences (0.260 J/cm2) compared to RFMS (0.112 J/cm2). Finally, the LIDT performance was compared with the Functional LIDT (F-LIDT), defined as the incident fluence at which the reflected beam decreases by less than 5%. In this study, we observed a discrepancy between the 1k-on-1 LIDT and the F-LIDT values for DCMS and HiPIMS. The F-LIDT for DCMS was higher (0.288 J/cm2) than that of HiPIMS (0.232 J/cm2), which may be partly attributed to the larger crystallite size observed in DCMS. Additionally, the potential use of the HiPIMS power supply mode for developing high-performance optical coatings is discussed.

  • Room-temperature weak collinear ferrimagnet with symmetry-driven large intrinsic magneto-optic signatures

    by F. Johnson, J. Zázvorka, L. Beran, D. Boldrin, L. F. Cohen, J. Zemen, M. Veis

    Here we present a magnetic thin film with a weak ferrimagnetic (FIM) phase above the Néel temperature (TN=240K) and a noncollinear antiferromagnetic (AFM) phase below, exhibiting a small net magnetization due to strain-associated canting of the magnetic moments. A long-range ordered FIM phase has been predicted in related materials, but without symmetry analysis. We now perform this analysis and use it to calculate the magneto-optical Kerr effect (MOKE) spectra in the AFM and FIM phases. From the good agreement between the form of the measured and predicted MOKE spectra, we propose the AFM and FIM phases share the magnetic space group C2′/m′ and that the symmetry-driven magneto-optic and magneto-transport properties are maximized at room temperature in the FIM phase due to the nonzero intrinsic Berry phase contribution present in these materials. A room temperature FIM with large optical and transport signatures, as well as sensitivity to lattice strain and magnetic field, has useful prospects for high-speed spintronic applications.


  • Analysis of atomic ordering of the ferromagnetic Co2Fe(Ga0.5Ge0.5) Heusler compound using spectroscopic ellipsometry

    by D. Kral, P. Cejpek, J. Kudrnovsky, V. Drchal, L. Beran, E. Vilanova, G. Jakob, J. Zazvorka, R. Antos, J. Hamrle, et al.

    Atomic ordering of ferromagnetic alloys, such as Heusler compounds, vastly influences their magnetic properties and overall usability. However, in some cases x-ray diffraction cannot unambiguously determine the correct atomic structure, which hampers further research. In this paper, we analyze the atomic ordering using spectroscopic ellipsometry—a simple tabletop method that researchers can use in situ during sample deposition. The Co2Fe(Ga0.5Ge0.5) Heusler compound was chosen for the analysis, as the atomic ordering greatly influences its spin-polarizing capabilities. The ellispometric results are confronted with x-ray diffraction and with the help of ab initio calculations the qualitative changes in the optical response are linked to the changes in atomic ordering.


  • Top Cited Papers
    Open Access

    Skyrmion pinning energetics in thin film systems

    by Raphael Gruber, Jakub Zázvorka, Maarten A. Brems, Davi R. Rodrigues, Takaaki Dohi, Nico Kerber, Boris Seng, Mehran Vafaee, Karin Everschor-Sitte, Peter Virnau, et al.

    A key issue for skyrmion dynamics and devices are pinning effects present in real systems. While posing a challenge for the realization of conventional skyrmionics devices, exploiting pinning effects can enable non-conventional computing approaches if the details of the pinning in real samples are quantified and understood. We demonstrate that using thermal skyrmion dynamics, we can characterize the pinning of a sample and we ascertain the spatially resolved energy landscape. To understand the mechanism of the pinning, we probe the strong skyrmion size and shape dependence of the pinning. Magnetic microscopy imaging demonstrates that in contrast to findings in previous investigations, for large skyrmions the pinning originates at the skyrmion boundary and not at its core. The boundary pinning is strongly influenced by the very complex pinning energy landscape that goes beyond the conventional effective rigid quasi-particle description. This gives rise to complex skyrmion shape distortions and allows for dynamic switching of pinning sites and flexible tuning of the pinning.


  • Anisotropic Skyrmion Diffusion Controlled by Magnetic-Field-Induced Symmetry Breaking

    by Nico Kerber, Markus Weißenhofer, Klaus Raab, Kai Litzius, Jakub Zázvorka, Ulrich Nowak, Mathias Kläui

    The diffusion of particles has wide repercussions, ranging from particle-based soft-matter systems to solid-state systems with particular electronic properties. Recently, in the field of magnetism, the diffusion of magnetic skyrmions, topologically stabilized quasiparticles, has been demonstrated. Here, we show that, by applying a magnetic in-plane field, and therefore, breaking the symmetry of the system, skyrmion diffusion becomes anisotropic, with faster diffusion parallel to the field axis and slower diffusion perpendicular to it. We furthermore show that the absolute value of the applied magnetic in-plane field controls the absolute values of the diffusion coefficients, so that one can thereby tune both the orientation of the diffusion and its strength. Based on the stochastic Thiele equation, we can explain the observed anisotropic diffusion as a result of the elliptical deformation of the skyrmions by the application of the in-plane field.


  • Open Access

    Skyrmion Lattice Phases in Thin Film Multilayer

    by Jakub Zázvorka, Florian Dittrich, Yuqing Ge, Nico Kerber, Klaus Raab, Thomas Winkler, Kai Litzius, Martin Veis, Peter Virnau, Mathias Kläui

    Phases of matter are ubiquitous with everyday examples including solids and liquids. In reduced dimensions, particular phases, such as the 2D hexatic phase and corresponding phase transitions occur. A particularly exciting example of 2D ordered systems are skyrmion lattices, where in contrast to previously studied 2D colloid systems, the skyrmion size and density can be tuned by temperature and magnetic fields. This allows for the system to be driven from a liquid phase to the onset of a hexatic phase as deduced from the analysis of the hexagonal order. Using coarse‐grained molecular dynamics simulations of soft disks, the skyrmion interaction potentials are determined, and it is found that the simulations are able to reproduce the phase behavior. This shows that not only the static behavior of skyrmions is qualitatively well described in terms of a simple 2D model system but skyrmion lattices are versatile and tunable 2D model systems that allow for studying phases and phase transitions in reduced dimensions.


  • Open Access

    Influence of Surface and Bulk Defects on Contactless Resistivity Measurements of CdTe and Related Compounds

    by Jan Franc, Roman Grill, Jakub Zázvorka

    We analyzed the influence of parameters of deep levels in the bulk and conditions on the surface on transient charge responses of semi-insulating samples (CdTe and GaAs). We studied the dependence on the applied bias step used for the experimental evaluation of resistivity in contactless measurement setups. We used simulations based on simultaneous solutions of 1D drift diffusion and Poisson’s equations as the main investigation tool. We found out that the resistivity can be reliably determined by the transient contactless method in materials with a large density of deep levels in the bulk (e.g., semi-insulating GaAs) when the response curve is described by a single exponential. In contrast, the materials with the low deep-level density, like semiconductor radiation detector materials (e.g., CdTe, CdZnTe, etc.), usually exhibit a complex response to applied bias, depending on the surface conditions. We show that a single exponential fit does not represent the true relaxation time and resistivity, in this case. A two-exponential fit can be used for a rough estimate of bulk material resistivity only in a limit of low-applied bias, when the response curve approaches a single-exponential shape. A decreasing of the bias leads to a substantially improved agreement between the evaluated and true relaxation time, which is also consistent with the approaching of the relaxation curve to the single-exponential shape.

  • Open Access

    Magnetic and Magneto-Optical Properties of Fe75−xMn25Gax Heusler-like Compounds

    by Daniel Král, Lukáš Beran, Martin Zelený, Jan Zemen, Roman Antoš, Jaroslav Hamrle, Jakub Zázvorka, Michal Rameš, Kristýna Onderková, Oleg Heczko, et al.

    Fe75−xMn25Gax Heusler-like compounds were investigated in a wide range of Fe/Ga ratios while keeping the Mn content constant and equal 25 at% in order to elucidate the interplay between magnetic properties and composition. Materials were prepared by arc-melting from pure elements and subsequently annealed. Experimental investigations were focused on magnetization behavior in a wide temperature range from 4 to 1000 K and magnetic field up to 9 T. Optical and magneto-optical (MO) measurements were employed to shed more light on the magnetic state and electronic structure of investigated materials. Magnetization measurements indicated that in the vicinity of stoichiometry (Fe2MnGa) the compounds are ferro/ferrimagnetic, whereas the Fe-deficient compound is paramagnetic and at high Fe concentration the antiferromagnetic interaction prevails. Theoretical calculations of corresponding ordered and disordered stoichiometric compounds were carried out and compared to the experiment on the level of net magnetic moment as well as magneto-optical spectra. This comparison suggests that the Heusler crystal structure, L21, is not present even close to stoichiometry. Moreover, the comparison of density of states (DOS) for ordered and disordered structures allowed us to explain missing martensitic transformation (MT) in investigated materials.