Solomon Gabche Anagho

Biochar and ferromagnetic biochar obtained from the pyrolysis of dried mango seeds and modified using a hydrothermal method were used as catalyst for the heterogeneous degradation of indigo carmine in an aqueous medium. These prepared biochars were characterized using different techniques: Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDX). The analyses of the results revealed the presence of iron oxide in the form of magnetite (Fe₃O₄) in the catalyst. The catalytic tests carried out with this composite material showed a significant degradation of indigo carmine. The maximum degradation of indigo carmine in the aqueous solution was reached after 240 min of agitation. The Fenton degradation process using irradiation with a 100 W electric lamp and hydrogen peroxide (concentration 4 mol/L) showed the best results at pH = 3. From this study, it emerged that the second-order kinetic model better described the degradation process, and it gave lower half-lives compared to those obtained with the first-order kinetic law. The study also showed that ferromagnetic biochar could be prepared from mango seeds and used for the degradation of indigo carmine in an aqueous solution.

In the quest for a sustainable environment and clean water resources, the efficacy of activated carbons synthesized from Garcinia cola nut shells impregnated with KOH (CBK_1/1) and ZnCl₂ (CBZ_1/1) for the adsorption of indigo carmine (IC) dye was studied using the batch technique. The prepared activated carbons were characterized using iodine number, elemental analysis, scanning electron microscopy (SEM), FTIR spectroscopy, powder X-ray diffraction (XRD), TGA/DTA, Boehm titration, and pH at point of zero charge. The elemental analysis showed a high percentage of carbon in both activated carbons (ACs). FTIR and Boehm titration analysis indicated the presence of several functional groups on the surfaces of both ACs which could influence the adsorption of IC. The primary adsorption mechanisms involved electrostatic interaction, hydrogen bonds formation, and ππ interactions. Maximum adsorption capacity values obtained using the FritzSchlunder III three-parameter model were 19.019mg·g⁻¹ and 18.299mg·g⁻¹ for CBK_1/1 and CBZ_1/1, respectively. The FritzSchlunder model exponent m_FS of value less than 1 showed that the adsorption of IC by the ACs occurred on heterogeneous surfaces. Positive values of Q obtained by the linear and nonlinear forms of the Temkin model indicate the exothermic character of the adsorption process.

The production of methyl esters (biodiesel) by the transesterification of Podocarpus falcatus oil (PFO) with methanol was optimized by response surface methodology (RSM) using the Box-Behnken design. The effects of parameters such as temperature, reaction time, and alcohol/oil molar ratio using yield and viscosity as responses were investigated. The optimum conditions for the production of biodiesel were as follows: temperature at 65C, reaction time of 180min, and molar ratio of 10:1, while the minimum viscosity was obtained for a temperature of 50C, a reaction time of 120min, and a molar ratio of 10:1. Physicochemical characterization by infrared spectroscopy (FT-IR) and UV visible spectroscopy showed that the free fatty acid (FFA) content of Podocarpus oil was 1.9, which is less than the maximum of 2 recommended for the application of the one-step alkaline transesterification process. Also, the biodiesel obtained from the oil was seen to consist mainly of methyl esters, and that its physicochemical characteristics are within the standard set by the American Standard for Testing and Materials (ASTM).

The present work demonstrates the adsorption of hydroquinone (HQ) and resorcinol (R) by activated carbon based on shea residue (Vitellaria paradoxa). The adsorbent was prepared chemically by impregnation with sulfuric acid and coded by the acronym CAK-S. The central composite design (CCD) was used to optimize the main factors that influence the adsorption of HQ or R by activated carbon such as the initial concentration, the pH of the solution, the contact time, and the mass of the carbon on the expected response, which is the adsorbed quantity of the target pollutants. The optimal conditions obtained from the statistical analysis are as follows: concentration of 158 mg/L, pH 3, time of 120 min, and mass of 50 mg for the adsorption of HQ and concentration of 180 mg/L, pH 3, time of 86 min, and mass of 118 mg for the adsorption of R. The maximum quantities of HQ and R adsorbed are 45.02 mg/g and 33.65 mg/g, respectively. The analysis of variance (ANOVA) showed a good relationship between the variables involved with the coefficients of determination R² = 98.69% for the adsorption of hydroquinone and R² = 90.55% for that of resorcinol, which means that the model is more suitable to express the adsorbed amount according to the four optimized parameters. The experimental data obtained under these optimal conditions were simulated with two and three parameter nonlinear isotherm models as well as kinetic models. The results show that Elovich kinetic model better describes the adsorption of HQ and R, indicating chemisorption with heterogeneous active sites on the surface of CAK-S. Temkin’s two-parameter model shows that adsorption occurs on heterogeneous surfaces with a nonuniform adsorption energy distribution at the surface and Sips’s three-parameter model confirms the heterogeneity of the surface with a localized adsorption of HQ or R by CAK-S. The thermodynamics study has shown that the adsorption is endothermic ( ) and spontaneous ( ).

The use of fossil fuels in modern economies has been a success because of the low cost of fossil resources. However, the depletion of fossil reserves, the increase in waste production and global warming concerns have led to increased research on the production of biofuels from renewable resources. Waste production is steadily increasing in quantity and constantly changing in quality, creating enormous risks for the environment and, consequently, for the health of the population. This situation is much more worrying in developing countries, in particular because of the considerable delay in the field of the conversion and recovery of biomaterials, due to their difficulty in approaching the problem in a way that fits their context. The composition of such wastes and residues, rich in organic matter, allows their conversion via biochemical mechanisms, thus constituting an effective solution to address the environmental problems of their disposal. Anaerobic digestion remains a valuable and effective technology for transforming these biomaterials into biogas. The present review focuses on technologies, challenges and areas of application of biogas, especially in China and some African countries, in order to promote the large-scale use of biogas for electricity generation and biofuels. Results point out that China is more used to this technology, while African countries still rely on traditional and less advanced technologies, thus hampering the potential derived from the large availability of biomaterials. Both realities, however, share similar backgrounds about the dimension of the biogas plants and their non-commercial purposes, even if China is recently shifting toward the adoption of a different model. These considerations are used in the article to open an interesting new scenario of political alternatives which may provide a way out from poverty and economic dependence, within the framework of a wider circularity.

Olives stones and cotton cakes have been investigated as a cheap and available precursor used for the production of novel carbon using potassium hydroxide as chemical activating agent with 2:1 impregnation ratio at 1.5 M KOH. Carbonization was performed at 450°C for one hour. The activated carbons NOK and MK3 were characterized by Iodine Number, Fourier Transform Infrared (FTIR) spectroscopy, EDX Analysis, Scanning Electron Microscopy (SEM), X-ray Diffraction (XRD) Analysis and Proximate Analysis (pHZCN, pH, volatile matter, fixed carbon). The effects of initial sorbate concentration and contact time on adsorption were evaluated. Errors analysis methods were used to evaluate the experimental data: Correlation coefficient (R2), chi-square (χ2), average relative error (ARE), sum of absolute errors (EABS) and root mean square error (RMSE) values were tested to find the best fitting isotherm. Elovich models provide the best fit in the uptake of 2,4-dinitrophenol by activated carbons NOK and MK3. Thus, among the isotherm models studied, it appears that the Dubinin-Radushkevich and Temkin (two parameters), Sips (three parameters) and Baudu (four parameters) models describe better the adsorption data. Error analysis showed that the models with two parameters better described the adsorption of 2,4-diniphenol data compared with the three parameter and four-parameter models. Key words: 2,4-dinitrophenol, activated carbon, cotton cake, olives stones, isotherms, kinetics.