Michael Fulde
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Michael Fulde has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
D. Schmitt-Landsiedel
Institute of Technical Electronics, Technical University Munich, Germany
2 shared publicationsG. Knoblinger
Infineon Technologies AG, Villach, Austria
2 shared publicationsA. Marshall
Texas Instruments Inc., Dallas, TX, USA
1 shared publicationC. Pacha
Infineon Technologies AG, Neubiberg, Germany
1 shared publicationC. R. Cleavelin
Texas Instruments Inc., Dallas, TX, USA
1 shared publicationC. Russ
Infineon Technologies AG, Neubiberg, Germany
1 shared publication
Latest Publications
- 1 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 186-189
Advances in Multi-Gate MOSFET Circuit Design
In this paper recent advances in multi-gate MOSFET (MuGFET) circuit design are reported. The feasibility of essential parts of low-power mobile SoC applications and large scale integration capability is shown. Excellent short channel control enables undoped metal gate MuGFETs to outperfom their planar counterparts in terms of delay-leakage trade-off. Superior voltage scaling efficiency and competitive performance is demonstrated for a product typical critical path. Design and layout optimization for improved SRAM cell stability is shown. Beneficial analog performance is exemplary demonstrated for an OpAmp. A potential degradation of ADC performance due to transient Vt mismatch is shown, the use of redundancy is proposed as countermeasure. Key RF building blocks are presented, MuGFET specific design issues are outlined. A comparison of different ESD elements yields a potential ESD protection scheme combining planar and MuGFET devices.
- 1 December 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 186-189
Advances in Multi-Gate MOSFET Circuit Design
In this paper recent advances in multi-gate MOSFET (MuGFET) circuit design are reported. The feasibility of essential parts of low-power mobile SoC applications and large scale integration capability is shown. Excellent short channel control enables undoped metal gate MuGFETs to outperfom their planar counterparts in terms of delay-leakage trade-off. Superior voltage scaling efficiency and competitive performance is demonstrated for a product typical critical path. Design and layout optimization for improved SRAM cell stability is shown. Beneficial analog performance is exemplary demonstrated for an OpAmp. A potential degradation of ADC performance due to transient Vt mismatch is shown, the use of redundancy is proposed as countermeasure. Key RF building blocks are presented, MuGFET specific design issues are outlined. A comparison of different ESD elements yields a potential ESD protection scheme combining planar and MuGFET devices.
- Open Access
- 13 June 2007
- Published by Copernicus GmbH in Advances in Radio Science
- Vol. 5 (D.1) , 285-290
Analog circuits using FinFETs: benefits in speed-accuracy-power trade-off and simulation of parasitic effects
Multi-gate FET, e.g. FinFET devices are the most promising contenders to replace bulk FETs in sub-45 nm CMOS technologies due to their improved sub threshold and short channel behavior, associated with low leakage currents. The introduction of novel gate stack materials (e.g. metal gate, high-k dielectric) and modified device architectures (e.g. fully depleted, undoped fins) affect the analog device properties significantly. First measurements indicate enhanced intrinsic gain (gm/gDS) and promising matching behavior of FinFETs. The resulting benefits regarding the speed-accuracy-power trade-off in analog circuit design will be shown in this work. Additionally novel device specific effects will be discussed. The hysteresis effect caused by charge trapping in high-k dielectrics or self-heating due to the high thermal resistor of the BOX isolation are possible challenges for analog design in these emerging technologies. To gain an early assessment of the impact of such parasitic effects SPICE based models are derived and applied in analog building blocks.
- 13 June 2007
- Published by Copernicus GmbH in Advances in Radio Science
- Vol. 5 (D.1) , 285-290
Open AccessAnalog circuits using FinFETs: benefits in speed-accuracy-power trade-off and simulation of parasitic effects
Multi-gate FET, e.g. FinFET devices are the most promising contenders to replace bulk FETs in sub-45 nm CMOS technologies due to their improved sub threshold and short channel behavior, associated with low leakage currents. The introduction of novel gate stack materials (e.g. metal gate, high-k dielectric) and modified device architectures (e.g. fully depleted, undoped fins) affect the analog device properties significantly. First measurements indicate enhanced intrinsic gain (gm/gDS) and promising matching behavior of FinFETs. The resulting benefits regarding the speed-accuracy-power trade-off in analog circuit design will be shown in this work. Additionally novel device specific effects will be discussed. The hysteresis effect caused by charge trapping in high-k dielectrics or self-heating due to the high thermal resistor of the BOX isolation are possible challenges for analog design in these emerging technologies. To gain an early assessment of the impact of such parasitic effects SPICE based models are derived and applied in analog building blocks.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 1249-1252
Transient Variations in Emerging SOI Technologies: Modeling and Impact on Analog/Mixed-Signal Circuits
This paper presents the impact of transient variations on SOI device and circuit behavior. History effects, self heating and charge trapping are considered in partially and fully depleted SOI devices. Modeling approaches for these effects are shown and, based on measurement, extended to the specific issues of emerging SOI technologies. The scaling behavior of self heating is investigated, revealing an increase of the thermal resistance with technology scaling. A simple equivalent circuit model for the charge trapping effect is proposed and verified with measurement data. Simulations based on these models show how transient variations influence the circuit behavior. As an example a 12bit SAR-AD converter is analyzed. The dynamic V T shift of the SOI devices degrades the resolution of the converter.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 02714302,p. 1249-1252
Transient Variations in Emerging SOI Technologies: Modeling and Impact on Analog/Mixed-Signal Circuits
This paper presents the impact of transient variations on SOI device and circuit behavior. History effects, self heating and charge trapping are considered in partially and fully depleted SOI devices. Modeling approaches for these effects are shown and, based on measurement, extended to the specific issues of emerging SOI technologies. The scaling behavior of self heating is investigated, revealing an increase of the thermal resistance with technology scaling. A simple equivalent circuit model for the charge trapping effect is proposed and verified with measurement data. Simulations based on these models show how transient variations influence the circuit behavior. As an example a 12bit SAR-AD converter is analyzed. The dynamic V T shift of the SOI devices degrades the resolution of the converter.