Gregor T. Leuthner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gregor T. Leuthner has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Jani Kotakoski
Faculty of Physics, University of Vienna, Boltzmanngasse 5, Vienna 1090, Austria
4 shared publications - Toma Susi
Faculty of Physics, University of Vienna, Vienna, Austria
4 shared publications Clemens Mangler
University of Vienna, Faculty of Physics, Boltzmanngasse 5, 1090 Vienna, Austria
3 shared publications- Jannik C. Meyer
University of Tübingen
2 shared publications - Alexandru Ionut Chirita Mihaila
Faculty of Physics University of Vienna Boltzmanngasse 5 1090 Vienna Austria
1 shared publication - Andreas Postl
University of Vienna Faculty of Physics Boltzmanngasse 5 Vienna 1090 Austria
1 shared publication
Latest Publications
- Open Access
Creation of Single Vacancies in hBN with Electron Irradiation
Understanding electron irradiation effects is vital not only for reliable transmission electron microscopy characterization, but increasingly also for the controlled manipulation of 2D materials. The displacement cross sections of monolayer hexagonal boron nitride (hBN) are measured using aberration‐corrected scanning transmission electron microscopy in near ultra‐high vacuum at primary beam energies between 50 and 90 keV. Damage rates below 80 keV are up to three orders of magnitude lower than previously measured at edges under poorer residual vacuum conditions, where chemical etching appears to dominate. Notably, it is possible to create single vacancies in hBN using electron irradiation, with boron almost twice as likely as nitrogen to be ejected below 80 keV. Moreover, any damage at such low energies cannot be explained by elastic knock‐on, even when accounting for the vibrations of the atoms. A theoretical description is developed to account for the lowering of the displacement threshold due to valence ionization resulting from inelastic scattering of probe electrons, modeled using charge‐constrained density functional theory molecular dynamics. Although significant reductions are found depending on the constrained charge, quantitative predictions for realistic ionization states are currently not possible. Nonetheless, there is potential for defect‐engineering of hBN at the level of single vacancies using electron irradiation.
Open AccessCreation of Single Vacancies in hBN with Electron Irradiation
Understanding electron irradiation effects is vital not only for reliable transmission electron microscopy characterization, but increasingly also for the controlled manipulation of 2D materials. The displacement cross sections of monolayer hexagonal boron nitride (hBN) are measured using aberration‐corrected scanning transmission electron microscopy in near ultra‐high vacuum at primary beam energies between 50 and 90 keV. Damage rates below 80 keV are up to three orders of magnitude lower than previously measured at edges under poorer residual vacuum conditions, where chemical etching appears to dominate. Notably, it is possible to create single vacancies in hBN using electron irradiation, with boron almost twice as likely as nitrogen to be ejected below 80 keV. Moreover, any damage at such low energies cannot be explained by elastic knock‐on, even when accounting for the vibrations of the atoms. A theoretical description is developed to account for the lowering of the displacement threshold due to valence ionization resulting from inelastic scattering of probe electrons, modeled using charge‐constrained density functional theory molecular dynamics. Although significant reductions are found depending on the constrained charge, quantitative predictions for realistic ionization states are currently not possible. Nonetheless, there is potential for defect‐engineering of hBN at the level of single vacancies using electron irradiation.
- Open Access
- 28 March 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 107 (9) , 094112
Combined electronic excitation and knock-on damage in monolayerElectron irradiation-induced damage is often the limiting factor in imaging materials prone to ionization or electronic excitations due to inelastic electron scattering. Quantifying the related processes at the atomic scale has only become possible with the advent of aberration-corrected (scanning) transmission electron microscopes and two-dimensional materials that allow imaging each lattice atom. While it has been shown for graphene that pure knock-on damage arising from elastic scattering is sufficient to describe the observed damage, the situation is more complicated with two-dimensional semiconducting materials such as . Here, we measure the displacement cross section for sulfur atoms in with primary beam energies between 55 and 90 keV, and correlate the results with existing measurements and theoretical models. Our experimental data suggests that the displacement process can occur from the ground state, or with single or multiple excitations, all caused by the same impinging electron. The results bring light to reports in the recent literature, and add necessary experimental data for a comprehensive description of electron irradiation damage in a two-dimensional semiconducting material. Specifically, the results agree with a combined inelastic and elastic damage mechanism at intermediate energies, in addition to a pure elastic mechanism that dominates above 80 keV. When the inelastic contribution is assumed to arise through impact ionization, the associated excitation lifetime is on the order of picoseconds, on par with expected excitation lifetimes in , whereas it drops to some tens of femtoseconds when direct valence excitation is considered.- 28 March 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 107 (9) , 094112
Open AccessCombined electronic excitation and knock-on damage in monolayerElectron irradiation-induced damage is often the limiting factor in imaging materials prone to ionization or electronic excitations due to inelastic electron scattering. Quantifying the related processes at the atomic scale has only become possible with the advent of aberration-corrected (scanning) transmission electron microscopes and two-dimensional materials that allow imaging each lattice atom. While it has been shown for graphene that pure knock-on damage arising from elastic scattering is sufficient to describe the observed damage, the situation is more complicated with two-dimensional semiconducting materials such as . Here, we measure the displacement cross section for sulfur atoms in with primary beam energies between 55 and 90 keV, and correlate the results with existing measurements and theoretical models. Our experimental data suggests that the displacement process can occur from the ground state, or with single or multiple excitations, all caused by the same impinging electron. The results bring light to reports in the recent literature, and add necessary experimental data for a comprehensive description of electron irradiation damage in a two-dimensional semiconducting material. Specifically, the results agree with a combined inelastic and elastic damage mechanism at intermediate energies, in addition to a pure elastic mechanism that dominates above 80 keV. When the inelastic contribution is assumed to arise through impact ionization, the associated excitation lifetime is on the order of picoseconds, on par with expected excitation lifetimes in , whereas it drops to some tens of femtoseconds when direct valence excitation is considered. - Open Access
- 29 April 2021
- Published by IOP Publishing in 2D Materials
- Vol. 8 (3) , 035023
Chemistry at graphene edges in the electron microscope
Transmission electron microscopy (TEM) and scanning TEM (STEM) are indispensable tools for materials characterization. However, during a typical (S)TEM experiment, the sample is subject to a number of effects that can change its atomic structure. Of these, perhaps the least discussed are chemical modifications due to the non-ideal vacuum around the sample. With single-layer graphene, we show that even at relatively low pressures typical for many instruments, these processes can have a significant impact on the sample structure. For example, pore growth becomes up to two orders of magnitude faster at a pressure of ca. 10−6 mbar as compared to ultra-high vacuum (UHV; 10−10 mbar). Even more remarkably, the presence of oxygen at the sample also changes the observed atomic structure: When imaged in UHV, nearly 90% of the identifiable graphene edge configurations have the armchair structure, whereas armchair and zigzag structures are nearly equally likely to occur when the oxygen partial pressure in the column is higher. Our results both bring attention to the role of the often neglected vacuum composition of the microscope column, and show that control over it can allow atomic-scale tailoring of the specimen structure.
- 29 April 2021
- Published by IOP Publishing in 2D Materials
- Vol. 8 (3) , 035023
Open AccessChemistry at graphene edges in the electron microscope
Transmission electron microscopy (TEM) and scanning TEM (STEM) are indispensable tools for materials characterization. However, during a typical (S)TEM experiment, the sample is subject to a number of effects that can change its atomic structure. Of these, perhaps the least discussed are chemical modifications due to the non-ideal vacuum around the sample. With single-layer graphene, we show that even at relatively low pressures typical for many instruments, these processes can have a significant impact on the sample structure. For example, pore growth becomes up to two orders of magnitude faster at a pressure of ca. 10−6 mbar as compared to ultra-high vacuum (UHV; 10−10 mbar). Even more remarkably, the presence of oxygen at the sample also changes the observed atomic structure: When imaged in UHV, nearly 90% of the identifiable graphene edge configurations have the armchair structure, whereas armchair and zigzag structures are nearly equally likely to occur when the oxygen partial pressure in the column is higher. Our results both bring attention to the role of the often neglected vacuum composition of the microscope column, and show that control over it can allow atomic-scale tailoring of the specimen structure.
- 1 August 2019
- Published by Elsevier in Ultramicroscopy
- Vol. 203, 76-81
Scanning transmission electron microscopy under controlled low-pressure atmospheres
- 1 August 2019
- Published by Elsevier in Ultramicroscopy
- Vol. 203, 76-81
Scanning transmission electron microscopy under controlled low-pressure atmospheres