Limei Cao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Limei Cao has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Xinhui Si
School of Mathematics and Physics, University of Science and Technology Beijing, Beijing 100083, China
3 shared publications - Fangyuan Dong
School of Mathematics and Physics, University of Science and Technology, Beijing, China
2 shared publications - Botong Li
School of Mathematics and Physics, University of Science and Technology Beijing , Beijing 100083
1 shared publication - Hao Yuan
School of Energy and Environmental Engineering, University of Science and Technology Beijing, Beijing 100083, China
1 shared publication - Hui Liu
School of mathematical sciences, University of Jinan, Jinan, China
1 shared publication - Hui Liu
School of Mathematical Sciences University of Jinan 250022 Jinan PR China
1 shared publication
Latest Publications
- 23 May 2025
- Published by Springer Nature in Zeitschrift für angewandte Mathematik und Physik
- Vol. 76 (3) , 1-17
Global well-posedness to the 3-D inhomogeneous incompressible MHD-Boussinesq equations with vacuum
- 23 May 2025
- Published by Springer Nature in Zeitschrift für angewandte Mathematik und Physik
- Vol. 76 (3) , 1-17
Global well-posedness to the 3-D inhomogeneous incompressible MHD-Boussinesq equations with vacuum
- Open Access
- 22 May 2025
- Published by MDPI AG in Fractal and Fractional
- Vol. 9 (6) , 329
Existence and Stability in Nonlocal Schrödinger–Poisson–Slater Equations
In this paper, we study a class of nonlocal Schrödinger–Poisson–Slater equations: , where , , and is the Riesz potential. We obtain the existence, stability, and symmetry-breaking of solutions for both radial and nonradial cases. In the radial case, we use variational methods to establish the coercivity and weak lower semicontinuity of the energy functional, ensuring the existence of a positive solution when p is below a critical threshold . In addition, we prove that the energy functional attains a minimum, guaranteeing the existence of a ground-state solution under specific conditions on the parameters. We also apply the Pohozaev identity to identify parameter regimes where only the trivial solution is possible. In the nonradial case, we use the Nehari manifold method to prove the existence of ground-state solutions, analyze symmetry-breaking by studying the behavior of the energy functional and identifying the parameter regimes in the nonradial case, and apply concentration-compactness methods to prove the global well-posedness of the Cauchy problem and demonstrate the orbital stability of the ground state. Our results demonstrate the stability of solutions in both radial and nonradial cases, identifying critical parameter regimes for stability and instability. This work enhances our understanding of the role of nonlocal interactions in symmetry-breaking and stability, while extending existing theories to multiparameter and higher-dimensional settings in the Schrödinger–Poisson–Slater model.- 22 May 2025
- Published by MDPI AG in Fractal and Fractional
- Vol. 9 (6) , 329
Open AccessExistence and Stability in Nonlocal Schrödinger–Poisson–Slater Equations
In this paper, we study a class of nonlocal Schrödinger–Poisson–Slater equations: , where , , and is the Riesz potential. We obtain the existence, stability, and symmetry-breaking of solutions for both radial and nonradial cases. In the radial case, we use variational methods to establish the coercivity and weak lower semicontinuity of the energy functional, ensuring the existence of a positive solution when p is below a critical threshold . In addition, we prove that the energy functional attains a minimum, guaranteeing the existence of a ground-state solution under specific conditions on the parameters. We also apply the Pohozaev identity to identify parameter regimes where only the trivial solution is possible. In the nonradial case, we use the Nehari manifold method to prove the existence of ground-state solutions, analyze symmetry-breaking by studying the behavior of the energy functional and identifying the parameter regimes in the nonradial case, and apply concentration-compactness methods to prove the global well-posedness of the Cauchy problem and demonstrate the orbital stability of the ground state. Our results demonstrate the stability of solutions in both radial and nonradial cases, identifying critical parameter regimes for stability and instability. This work enhances our understanding of the role of nonlocal interactions in symmetry-breaking and stability, while extending existing theories to multiparameter and higher-dimensional settings in the Schrödinger–Poisson–Slater model. - 11 October 2023
- Published by ASME International in Journal of Fluids Engineering
- Vol. 146 (1) , 1-43
Numerical Simulation of Two-Dimensional Giesekus Flow Past a Rotating Cylinder
The two-dimensional viscoelastic Giesekus flow past a circular cylinder is investigated by the OpenFOAM platform based on the finite volume method. The physical parameters, including Weissenberg number (0.1 ≤ Wi ≤ 10), dimensionless rotation rate (0 = Ro ≤ 2) and mobility factor (0 ≤ a ≤ 0.5), are investigated when Reynolds number is defined as 100. Two cases, i.e. ß = 0.1 and ß = 0.9, are considered. The combination effects are discussed using lift coefficients, instantaneous vorticity, time-averaged streamlines and pressure distribution along the cylinder wall. The results are compared with other numerical computations. Dimensionless rotation rate destroys the symmetry of vertex shedding and suppresses the instability of the viscoelastic fluids. Elastic property facilitates the formation of the closed streamlins around the cylinder surface. This effects are amplified by the introduction of dimensionless rotation rate. However, shear-shinning property has opposite effects on this region. The distribution of polymer stress txxp and tyyp are given to analyze the effects of viscoelasticity. Under the effects of the shear-shinning property, the values of polymer stresses have an obvious decrease.
- 11 October 2023
- Published by ASME International in Journal of Fluids Engineering
- Vol. 146 (1) , 1-43
Numerical Simulation of Two-Dimensional Giesekus Flow Past a Rotating Cylinder
The two-dimensional viscoelastic Giesekus flow past a circular cylinder is investigated by the OpenFOAM platform based on the finite volume method. The physical parameters, including Weissenberg number (0.1 ≤ Wi ≤ 10), dimensionless rotation rate (0 = Ro ≤ 2) and mobility factor (0 ≤ a ≤ 0.5), are investigated when Reynolds number is defined as 100. Two cases, i.e. ß = 0.1 and ß = 0.9, are considered. The combination effects are discussed using lift coefficients, instantaneous vorticity, time-averaged streamlines and pressure distribution along the cylinder wall. The results are compared with other numerical computations. Dimensionless rotation rate destroys the symmetry of vertex shedding and suppresses the instability of the viscoelastic fluids. Elastic property facilitates the formation of the closed streamlins around the cylinder surface. This effects are amplified by the introduction of dimensionless rotation rate. However, shear-shinning property has opposite effects on this region. The distribution of polymer stress txxp and tyyp are given to analyze the effects of viscoelasticity. Under the effects of the shear-shinning property, the values of polymer stresses have an obvious decrease.
- Open Access
Influence of Photoperiods on Microalgae Biofilm: Photosynthetic Performance, Biomass Yield, and Cellular Composition
Microalgae have immense potential as biological sources to produce biofuels and high-value biomolecules. Biofilm-based microalgae cultivation has attracted much interest recently because of its high biomass productivity, reduced water use, and low cost of harvesting. This study aimed to understand the effect of photoperiod on three microalgae biofilms, including Nannochloris oculata, Chlorella sp., and Chlorella pyrenoidosa. The examined photoperiods were 3:3 s, 5:5 s, 30:30 min, 12:12 h (light-period-to-dark-period ratio), and continuous lighting. By determining the maximum quantum yield and relative electron transport rate of photosystem II, we found that photoperiods on the seconds scale improved photosynthetic performance of microalgae biofilm. Biomass yield and lipid content of these three microalgae cultured under the photoperiod with the seconds scale increased by 11%–24% and 7%–22%, respectively, compared with those cultured under continuous lighting. In addition, the photoperiods of 3:3 s, 5:5 s, 30:30 min, and 12:12 h were beneficial for protein synthesis. These results have important implications in establishing suitable light regimes for microalgae biofilm-based cultivation systems.
Open AccessInfluence of Photoperiods on Microalgae Biofilm: Photosynthetic Performance, Biomass Yield, and Cellular Composition
Microalgae have immense potential as biological sources to produce biofuels and high-value biomolecules. Biofilm-based microalgae cultivation has attracted much interest recently because of its high biomass productivity, reduced water use, and low cost of harvesting. This study aimed to understand the effect of photoperiod on three microalgae biofilms, including Nannochloris oculata, Chlorella sp., and Chlorella pyrenoidosa. The examined photoperiods were 3:3 s, 5:5 s, 30:30 min, 12:12 h (light-period-to-dark-period ratio), and continuous lighting. By determining the maximum quantum yield and relative electron transport rate of photosystem II, we found that photoperiods on the seconds scale improved photosynthetic performance of microalgae biofilm. Biomass yield and lipid content of these three microalgae cultured under the photoperiod with the seconds scale increased by 11%–24% and 7%–22%, respectively, compared with those cultured under continuous lighting. In addition, the photoperiods of 3:3 s, 5:5 s, 30:30 min, and 12:12 h were beneficial for protein synthesis. These results have important implications in establishing suitable light regimes for microalgae biofilm-based cultivation systems.
- Open Access
- 1 April 2015
- Published by MDPI AG in Mathematical and Computational Applications
- Vol. 20 (1) , 15-24
Dtm-Bf Method for the Flow and Heat Transfer Over a Nonlinearly Stretching Sheet With Nanofluids
This paper investigates an analytical analysis for the flow and heat transfer in a viscous fluid over a nonlinear stretching sheet. The governing partial differential equations are transformed into coupled nonlinear differential equations by introducing a siφmilarity transformation. The asymptotic analytical solutions are obtained by using differential transform method-basic functions (DTM-BF). Four types of nanofluids, namely Cu-water, Ag-water, Al2O3 -water and TiO2 -water were studied. The influence of the nanoparticle volume fraction φ, the nonlinear stretching parameter n , Prandtl number Pr, Eckert number Ec and different nanoparticles on the velocity and temperature are discussed and shown graphically. The comparison with the numerical results is presented and it is found to be in excellent agreement.
- 1 April 2015
- Published by MDPI AG in Mathematical and Computational Applications
- Vol. 20 (1) , 15-24
Open AccessDtm-Bf Method for the Flow and Heat Transfer Over a Nonlinearly Stretching Sheet With Nanofluids
This paper investigates an analytical analysis for the flow and heat transfer in a viscous fluid over a nonlinear stretching sheet. The governing partial differential equations are transformed into coupled nonlinear differential equations by introducing a siφmilarity transformation. The asymptotic analytical solutions are obtained by using differential transform method-basic functions (DTM-BF). Four types of nanofluids, namely Cu-water, Ag-water, Al2O3 -water and TiO2 -water were studied. The influence of the nanoparticle volume fraction φ, the nonlinear stretching parameter n , Prandtl number Pr, Eckert number Ec and different nanoparticles on the velocity and temperature are discussed and shown graphically. The comparison with the numerical results is presented and it is found to be in excellent agreement.
- Open Access
- 11 November 2014
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 13 (1)
The analysis of the suction/injection on the MHD Maxwell fluid past a stretching plate in the presence of nanoparticles by Lie group method
In this paper, the magnetohydrodynamic (MHD) Maxwell fluid past a stretching plate with suction/ injection in the presence of nanoparticles is investigated. The Lie symmetry group transformations are used to convert the boundary layer equations into non-linear ordinary differential equations. The dimensionless governing equations are solved numerically using Bvp4c with MATLAB, which is a collocation method equivalent to the fourth order mono-implicit Runge-Kutta method. The effects of some physical parameters, such as the elastic parameter K, the Hartmann number M, the Prandtl number Pr, the Brownian motion Nb, the thermophoresis parameter Nt and the Lewis number Le, on the velocity, temperature and nanoparticle fraction are studied numerically especially when suction and injection at the sheet are considered.
- 11 November 2014
- Published by Walter de Gruyter GmbH in Open Physics
- Vol. 13 (1)
Open AccessThe analysis of the suction/injection on the MHD Maxwell fluid past a stretching plate in the presence of nanoparticles by Lie group method
In this paper, the magnetohydrodynamic (MHD) Maxwell fluid past a stretching plate with suction/ injection in the presence of nanoparticles is investigated. The Lie symmetry group transformations are used to convert the boundary layer equations into non-linear ordinary differential equations. The dimensionless governing equations are solved numerically using Bvp4c with MATLAB, which is a collocation method equivalent to the fourth order mono-implicit Runge-Kutta method. The effects of some physical parameters, such as the elastic parameter K, the Hartmann number M, the Prandtl number Pr, the Brownian motion Nb, the thermophoresis parameter Nt and the Lewis number Le, on the velocity, temperature and nanoparticle fraction are studied numerically especially when suction and injection at the sheet are considered.