WJWenya Jiao

Wenya Jiao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Wenya Jiao has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Study on the Effect of Fe3+ on Zircon Flotation Separation from Cassiterite Using Sodium Oleate as Collector

    by Huiqing Peng, Wen Luo, Di Wu, Xuexiang Bie, Hui Shao, Wenya Jiao, Yike Liu

    The effect of ferric ions (Fe3+) on the flotation of zircon and cassiterite using sodium oleate (NaOL) was investigated by single mineral flotation tests, adsorption density tests, zeta potential measurements, solution chemistry analyses, and FTIR analyses. It is difficult for zircon to be separated from cassiterite by using NaOL alone. Nevertheless, the flotation of zircon was activated while that of cassiterite was depressed in the presence of Fe3+. Adsorption density tests indicated that the addition of Fe3+ enhanced the adsorption of NaOL on zircon surfaces, whereas it receded on cassiterite surfaces. Zeta potential measurements and solution chemistry analyses found that H(OL) 2 − was the predominant species to determine the flotation behaviors of zircon and cassiterite. Furthermore, the addition of Fe3+ at pH < 8 reduced the negative charges on the zircon and cassiterite surfaces. It was confirmed that the positive charges of zircon were caused by the positively charged species of Fe3+, including Fe3+, Fe(OH)2+, and Fe(OH) 2 + . Meanwhile, these results revealed that the hydroxy complex and the precipitate of Fe(OH)3(s) adsorbed onto the cassiterite surfaces caused the flotation of cassiterite to be inhibited. It can be concluded from FTIR analyses that the peaks of zircon at 894.14 cm−1 and 611.65 cm−1 were strengthened and the adsorption on zircon surfaces was found to be chemisorption due to the addition of Fe3+, whereas both chemical and physical adsorptions of NaOL on cassiterite surfaces were weakened, resulting in the different flotation behaviors of zircon and cassiterite in the presence of Fe3+.


  • Open Access

    Study of the Effect of Sodium Sulfide as a Selective Depressor in the Separation of Chalcopyrite and Molybdenite

    by Huiqing Peng, Di Wu, Mohamed Abdalla, Wen Luo, Wenya Jiao, Xuexiang Bie

    Two kinds of collectors, sodium butyl xanthate and kerosene, and a depressor, sodium sulfide, were used in this research. The study applied flotation tests, pulp potential measurements, contact angle measurements, adsorption calculations, and Fourier Transform Infrared Spectroscopy (FTIR) analyses to demonstrate the correlation between reagents and minerals. For xanthate collectors, the best flotation responses of chalcopyrite and molybdenite were obtained at pH = 8, and, for kerosene, these were obtained at pH = 4. The flotation of molybdenite seemed to be less influenced by xanthate than by kerosene, while that of chalcopyrite showed the opposite. The optimum concentration of sodium sulfide for separation was 0.03 mol/L, which rejected 83% chalcopyrite and recovered 82% molybdenite in the single mineral flotation. Pulp potential measurements revealed that the dixanthogen and xanthate were decomposed and desorbed, respectively, from the mineral surface in a reducing environment. The contact angle measurement and adsorption calculation conformed to the flotation response, indicating that few functions of the xanthate and sodium sulfide on the molybdenite flotation were due to their low adsorption densities. The FTIR results further clarified that the xanthate ion was adsorbed on chalcopyrite by forming cuprous xanthate and dixanthogen; however, on molybdenite the adsorption product was only dixanthogen. After conditioning with sodium sulfide, the chalcopyrite surface became clean, but the molybdenite surface still retained slight peaks of dixanthogen. Meanwhile, the possible mechanism was expounded in this research.