Yutaka Genchi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yutaka Genchi has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
Yukihiro Kikegawa
7 shared publicationsHiroaki Kondo
5 shared publicationsHiroshi Yoshikado
Research Institute of Science for Safety and Sustainability, National Institute of Advanced Industrial Science and Technology (AIST), 16-1 Onogawa, Tsukuba, Ibaraki 305-8569, Japan
5 shared publications- Tomohiko Ihara
Department of Environment Systems, Graduate School of Frontier Sciences, The University of Tokyo, 5-1-5 Kashiwanoha, Kashiwa, Chiba 277-8563, Japan
5 shared publications - Hiroaki Kondo
National Institute of Advanced Industrial Science and Technology
2 shared publications Hiroshi Komiyama
University of Tokyo
2 shared publications
Latest Publications
- Open Access
- 26 May 2023
- Published by Elsevier in Science of The Total Environment
- Vol. 891, 164442
Impact of introducing net-zero carbon strategies on tropospheric ozone (O3) and fine particulate matter (PM2.5) concentrations in Japanese region in 2050
- 26 May 2023
- Published by Elsevier in Science of The Total Environment
- Vol. 891, 164442
Open AccessImpact of introducing net-zero carbon strategies on tropospheric ozone (O3) and fine particulate matter (PM2.5) concentrations in Japanese region in 2050
- Open Access
- 23 June 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (7) , 1101
Assessing Uncertainties of Well-To-Tank Greenhouse Gas Emissions from Hydrogen Supply Chains
Hydrogen is a promising energy carrier in the clean energy systems currently being developed. However, its effectiveness in mitigating greenhouse gas (GHG) emissions requires conducting a lifecycle analysis of the process by which hydrogen is produced and supplied. This study focuses on the hydrogen for the transport sector, in particular renewable hydrogen that is produced from wind- or solar PV-powered electrolysis. A life cycle inventory analysis is conducted to evaluate the Well-to-Tank (WtT) GHG emissions from various renewable hydrogen supply chains. The stages of the supply chains include hydrogen being produced overseas, converted into a transportable hydrogen carrier (liquid hydrogen or methylcyclohexane), imported to Japan by sea, distributed to hydrogen filling stations, restored from the hydrogen carrier to hydrogen and filled into fuel cell vehicles. For comparison, an analysis is also carried out with hydrogen produced by steam reforming of natural gas. Foreground data related to the hydrogen supply chains are collected by literature surveys and the Japanese life cycle inventory database is used as the background data. The analysis results indicate that some of renewable hydrogen supply chains using liquid hydrogen exhibited significantly lower WtT GHG emissions than those of a supply chain of hydrogen produced by reforming of natural gas. A significant piece of the work is to consider the impacts of variations in the energy and material inputs by performing a probabilistic uncertainty analysis. This suggests that the production of renewable hydrogen, its liquefaction, the dehydrogenation of methylcyclohexane and the compression of hydrogen at the filling station are the GHG-intensive stages in the target supply chains.
- 23 June 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (7) , 1101
Open AccessAssessing Uncertainties of Well-To-Tank Greenhouse Gas Emissions from Hydrogen Supply Chains
Hydrogen is a promising energy carrier in the clean energy systems currently being developed. However, its effectiveness in mitigating greenhouse gas (GHG) emissions requires conducting a lifecycle analysis of the process by which hydrogen is produced and supplied. This study focuses on the hydrogen for the transport sector, in particular renewable hydrogen that is produced from wind- or solar PV-powered electrolysis. A life cycle inventory analysis is conducted to evaluate the Well-to-Tank (WtT) GHG emissions from various renewable hydrogen supply chains. The stages of the supply chains include hydrogen being produced overseas, converted into a transportable hydrogen carrier (liquid hydrogen or methylcyclohexane), imported to Japan by sea, distributed to hydrogen filling stations, restored from the hydrogen carrier to hydrogen and filled into fuel cell vehicles. For comparison, an analysis is also carried out with hydrogen produced by steam reforming of natural gas. Foreground data related to the hydrogen supply chains are collected by literature surveys and the Japanese life cycle inventory database is used as the background data. The analysis results indicate that some of renewable hydrogen supply chains using liquid hydrogen exhibited significantly lower WtT GHG emissions than those of a supply chain of hydrogen produced by reforming of natural gas. A significant piece of the work is to consider the impacts of variations in the energy and material inputs by performing a probabilistic uncertainty analysis. This suggests that the production of renewable hydrogen, its liquefaction, the dehydrogenation of methylcyclohexane and the compression of hydrogen at the filling station are the GHG-intensive stages in the target supply chains.
- Open Access
- 14 January 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (1) , 119
Evaluating the Potential of Variable Renewable Energy for a Balanced Isolated Grid: A Japanese Case Study
There is a global push to develop renewable energy to further a low-carbon society. However, the nature of variable renewable energy (VRE) sources such as wind power and solar photovoltaic (PV) systems may create problems because electricity grids require a stable power supply to match demand. To evaluate the potential capacity of VREs that may be installed, we develop an optimized model that balances power supply and demand and also considers grid balancing by battery storage and load frequency control. The model was applied to a case study of an isolated grid on a remote Japanese island. When set to optimize the grid in terms of lowest cost, the model suggested that, compared with the base case, the capacity of wind power should be increased by a factor of 1.7 and 15.8 for situations without and with battery storage, respectively. Since it was always considered to be more expensive than wind power, no change in solar PV capacity was observed. These approaches resulted in a decrease in the total power generation cost of 2% and 24%, respectively, while total CO2 emissions fell by 3% and 52%, primarily driven by decreased used of the existing fossil-fueled thermal plant.
- 14 January 2017
- Published by MDPI AG in Sustainability
- Vol. 9 (1) , 119
Open AccessEvaluating the Potential of Variable Renewable Energy for a Balanced Isolated Grid: A Japanese Case Study
There is a global push to develop renewable energy to further a low-carbon society. However, the nature of variable renewable energy (VRE) sources such as wind power and solar photovoltaic (PV) systems may create problems because electricity grids require a stable power supply to match demand. To evaluate the potential capacity of VREs that may be installed, we develop an optimized model that balances power supply and demand and also considers grid balancing by battery storage and load frequency control. The model was applied to a case study of an isolated grid on a remote Japanese island. When set to optimize the grid in terms of lowest cost, the model suggested that, compared with the base case, the capacity of wind power should be increased by a factor of 1.7 and 15.8 for situations without and with battery storage, respectively. Since it was always considered to be more expensive than wind power, no change in solar PV capacity was observed. These approaches resulted in a decrease in the total power generation cost of 2% and 24%, respectively, while total CO2 emissions fell by 3% and 52%, primarily driven by decreased used of the existing fossil-fueled thermal plant.
- 1 January 2015
- Published by Elsevier in Forest Policy and Economics
- Vol. 50, 163-171
CO2 emissions and economic impacts of using logging residues and mill residues in Maniwa Japan
- 1 January 2015
- Published by Elsevier in Forest Policy and Economics
- Vol. 50, 163-171
CO2 emissions and economic impacts of using logging residues and mill residues in Maniwa Japan
- 1 January 2015
- Published by Elsevier in Journal of Cleaner Production
- Vol. 87, 208-215
Evaluation of energy consumption and greenhouse gas emissions from poly(phenyllactic acid) production using sweet sorghum
- 1 January 2015
- Published by Elsevier in Journal of Cleaner Production
- Vol. 87, 208-215
Evaluation of energy consumption and greenhouse gas emissions from poly(phenyllactic acid) production using sweet sorghum
- Open Access
- 1 January 2015
- Published by The Japan Institute of Energy in Journal of the Japan Institute of Energy
- Vol. 94 (6) , 582-587
Economic Impact of Utilizing Woody Biomass to Manufacture High Value-Added Material Products: a Study of Cellulose Nanofiber and High Standard Chip-Dust Production in Maniwa, Japan
- 1 January 2015
- Published by The Japan Institute of Energy in Journal of the Japan Institute of Energy
- Vol. 94 (6) , 582-587
Open AccessEconomic Impact of Utilizing Woody Biomass to Manufacture High Value-Added Material Products: a Study of Cellulose Nanofiber and High Standard Chip-Dust Production in Maniwa, Japan
- 19 February 2013
- Published by Springer Nature in The International Journal of Life Cycle Assessment
- Vol. 18 (5) , 1089-1097
Japanese sleep disturbance and fatigue disability weights in evaluating the effects of increasing temperatures on health by a life cycle approach
- 19 February 2013
- Published by Springer Nature in The International Journal of Life Cycle Assessment
- Vol. 18 (5) , 1089-1097
Japanese sleep disturbance and fatigue disability weights in evaluating the effects of increasing temperatures on health by a life cycle approach
- 5 June 2012
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 46 (13) , 7415-7421
The Right Place for the Right Job in the Photovoltaic Life Cycle
The potential for photovoltaic power generation (PV) to reduce primary energy consumption (PEC) and CO2 emissions depends on the physical locations of each stage of its life cycle. When stages are optimally located, CO2 emissions are reduced nearly ten times as much as when each stage is located in the country having the largest current market share. The usage stage contributes the most to reducing CO2 emissions and PEC, and total CO2 emissions actually increase when PV is installed in countries having small CO2 emissions from electricity generation. Global maps of CO2 reduction potential indicate that Botswana and Gobi in Mongolia are the optimal locations to install PV due to favorable conditions for PV power generation and high CO2 emissions from current electricity generation. However, the small electricity demand in those countries limits the contribution to global CO2 reduction. The type of PVs has a small but significant effect on life cycle PEC and CO2 emissions.
- 5 June 2012
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 46 (13) , 7415-7421
The Right Place for the Right Job in the Photovoltaic Life Cycle
The potential for photovoltaic power generation (PV) to reduce primary energy consumption (PEC) and CO2 emissions depends on the physical locations of each stage of its life cycle. When stages are optimally located, CO2 emissions are reduced nearly ten times as much as when each stage is located in the country having the largest current market share. The usage stage contributes the most to reducing CO2 emissions and PEC, and total CO2 emissions actually increase when PV is installed in countries having small CO2 emissions from electricity generation. Global maps of CO2 reduction potential indicate that Botswana and Gobi in Mongolia are the optimal locations to install PV due to favorable conditions for PV power generation and high CO2 emissions from current electricity generation. However, the small electricity demand in those countries limits the contribution to global CO2 reduction. The type of PVs has a small but significant effect on life cycle PEC and CO2 emissions.
- 18 August 2011
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 45 (20) , 9030-9035
Effect of Temperature on PV Potential in the World
This work aims to identify the geographic distribution of photovoltaic (PV) energy potential considering the effect of temperature on PV system performance. A simple framework is developed that uses the JIS C 8907 Japanese industrial standard to evaluate the effects of irradiation and temperature on PV potential. The global distributions of PV potential and yearly performance ratio are obtained by this framework. Generally, the performance ratio decreases with latitude because of temperature. However, regions with high altitude have higher performance ratios due to low temperature. The southern Andes, the Himalaya region, and Antarctica have the largest PV potentials. Although PV modules with less sensitivity to temperature are preferable for the high temperature regions, PV modules that are more responsive to temperature may be more effective in the low temperature regions. The correlation between the estimates obtained by our framework and results from a more data-intensive method increases when the temperature effects are considered.
- 18 August 2011
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 45 (20) , 9030-9035
Effect of Temperature on PV Potential in the World
This work aims to identify the geographic distribution of photovoltaic (PV) energy potential considering the effect of temperature on PV system performance. A simple framework is developed that uses the JIS C 8907 Japanese industrial standard to evaluate the effects of irradiation and temperature on PV potential. The global distributions of PV potential and yearly performance ratio are obtained by this framework. Generally, the performance ratio decreases with latitude because of temperature. However, regions with high altitude have higher performance ratios due to low temperature. The southern Andes, the Himalaya region, and Antarctica have the largest PV potentials. Although PV modules with less sensitivity to temperature are preferable for the high temperature regions, PV modules that are more responsive to temperature may be more effective in the low temperature regions. The correlation between the estimates obtained by our framework and results from a more data-intensive method increases when the temperature effects are considered.
- 1 August 2011
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 15 (6) , 2772-2778
Life cycle assessment for co-firing semi-carbonized fuel manufactured using woody biomass with coal: A case study in the central area of Wakayama, Japan
- 1 August 2011
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 15 (6) , 2772-2778
Life cycle assessment for co-firing semi-carbonized fuel manufactured using woody biomass with coal: A case study in the central area of Wakayama, Japan