Marin Viceić
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Marin Viceić has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Dražen Živković
Univ Split, Fac Elect Engn Mech Engn & Naval Architecture, Rudera Boskovica 32, Split 21000, Croatia
1 shared publication - Nikša Čatipović
Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Ruđera Boškovića 32, 21000 Split, Croatia
1 shared publication - Zvonimir Dadić
Univ Split, Fac Elect Engn Mech Engn & Naval Architecture, Rudera Boskovica 32, Split 21000, Croatia
1 shared publication
Latest Publications
- Open Access
- 13 October 2017
- Published by MDPI AG in Preprints.org
Influence of the Salt Bath Agitation and Austempering Temperature on the Microstructure of Austempered Ductile Iron
In this paper the influence of austempering temperature and salt bath agitation on the final microstructure and mechanical properties of the ferritic ductile iron were studied. 17 samples had been subjected to different heat treatment parameters. Different microstructures were recorded upon the completion of the tests. From the obtained micro images, it is obvious that both the austempering temperature and salt bath agitation affect the final microstructure of the austempered ductile iron. Lower austempering temperatures and salt bath agitation produce more ausferrite in the microstructure, hence the harder and tougher phases are present. This was confirmed with hardness and toughness test of the 17 heat-treated samples. Lower austempering temperatures give more ausferrite phase and therefore higher hardness, but hardness decreases with increasing austempering temperatures. Toughness rises with rising austempering temperatures, but drops significantly with temperatures above 395°C because of the final microstructure.
- 13 October 2017
- Published by MDPI AG in Preprints.org
Open AccessInfluence of the Salt Bath Agitation and Austempering Temperature on the Microstructure of Austempered Ductile Iron
In this paper the influence of austempering temperature and salt bath agitation on the final microstructure and mechanical properties of the ferritic ductile iron were studied. 17 samples had been subjected to different heat treatment parameters. Different microstructures were recorded upon the completion of the tests. From the obtained micro images, it is obvious that both the austempering temperature and salt bath agitation affect the final microstructure of the austempered ductile iron. Lower austempering temperatures and salt bath agitation produce more ausferrite in the microstructure, hence the harder and tougher phases are present. This was confirmed with hardness and toughness test of the 17 heat-treated samples. Lower austempering temperatures give more ausferrite phase and therefore higher hardness, but hardness decreases with increasing austempering temperatures. Toughness rises with rising austempering temperatures, but drops significantly with temperatures above 395°C because of the final microstructure.