Zhen Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhen Zhu has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Saoussen Merdes
Beneq Oy, Olarinluoma 9, FI-02200 Espoo, Finland
4 shared publications - Hele Savin
Aalto University
3 shared publications - Chiara Modanese
Aalto Univ, Dept Elect & Nanoengn, Tietotie 3, Espoo, Finland
2 shared publications - Harri Lipsanen
Department of Electronics and Nanoengineering, Aalto University, Espoo, Finland
2 shared publications - Kenichiro Mizohata
University of Helsinki
2 shared publications Perttu Sippola
Department of Electronics and Nanoengineering, Aalto University, Tietotie 3, 02150 Espoo, Finland
2 shared publications
Latest Publications
- Open Access
Control of Eu Oxidation State in Y2O3−xSx:Eu Thin-Film Phosphors Prepared by Atomic Layer Deposition: A Structural and Photoluminescence Study
Structural and photoluminescence studies were carried out on Eu-doped Y2O3−xSx thin films grown by atomic layer deposition at 300 °C. (CH3Cp)3Y, H2O, and H2S were used as yttrium, oxygen, and sulfur precursors, respectively, while Eu(thd)3 was used as the europium precursor. The Eu oxidation state was controlled during the growth process by following the Eu(thd)3 pulse with either a H2S or O3 pulse. The Eu(thd)3/O3 pulse sequence led to photoluminescence emission above 550 nm, whereas the Eu(thd)3/H2S pulse sequence resulted in emission below 500 nm.
Open AccessControl of Eu Oxidation State in Y2O3−xSx:Eu Thin-Film Phosphors Prepared by Atomic Layer Deposition: A Structural and Photoluminescence Study
Structural and photoluminescence studies were carried out on Eu-doped Y2O3−xSx thin films grown by atomic layer deposition at 300 °C. (CH3Cp)3Y, H2O, and H2S were used as yttrium, oxygen, and sulfur precursors, respectively, while Eu(thd)3 was used as the europium precursor. The Eu oxidation state was controlled during the growth process by following the Eu(thd)3 pulse with either a H2S or O3 pulse. The Eu(thd)3/O3 pulse sequence led to photoluminescence emission above 550 nm, whereas the Eu(thd)3/H2S pulse sequence resulted in emission below 500 nm.
- 12 September 2019
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (8)
Al2O3 Thin Films Prepared by a Combined Thermal‐Plasma Atomic Layer Deposition Process at Low Temperature for Encapsulation Applications
In this article, a combined H2O thermal atomic layer deposition of Al2O3 with in situ N2 plasma treatment process at 90 °C for encapsulation applications is reported. The effect of process parameters on the growth behavior and properties of Al2O3 thin films, such as elemental composition, residual stress, moisture permeation barrier ability, density, and roughness, is investigated. Optimization of plasma exposure time gives films with a low impurity (≈3.8 at% for hydrogen, ≈0.17 at% for carbon, and ≈0.51 at% for nitrogen), a high mass density (≈3.1 g cm−3), and a low tensile residual stress (≈160 MPa). A water vapor transmission rate of 2.9 × 10−3 g m−2 day−1 is obtained for polyethylene naphthalate substrates coated with 4‐nm‐thick Al2O3 films.
- 12 September 2019
- Published by Wiley in Physica Status Solidi (a)
- Vol. 217 (8)
Al2O3 Thin Films Prepared by a Combined Thermal‐Plasma Atomic Layer Deposition Process at Low Temperature for Encapsulation Applications
In this article, a combined H2O thermal atomic layer deposition of Al2O3 with in situ N2 plasma treatment process at 90 °C for encapsulation applications is reported. The effect of process parameters on the growth behavior and properties of Al2O3 thin films, such as elemental composition, residual stress, moisture permeation barrier ability, density, and roughness, is investigated. Optimization of plasma exposure time gives films with a low impurity (≈3.8 at% for hydrogen, ≈0.17 at% for carbon, and ≈0.51 at% for nitrogen), a high mass density (≈3.1 g cm−3), and a low tensile residual stress (≈160 MPa). A water vapor transmission rate of 2.9 × 10−3 g m−2 day−1 is obtained for polyethylene naphthalate substrates coated with 4‐nm‐thick Al2O3 films.
- Open Access
- 12 February 2019
- Published by Springer Nature in Discover Nano
- Vol. 14 (1) , 1-8
Low-Temperature Plasma-Enhanced Atomic Layer Deposition of SiO2 Using Carbon Dioxide
In this work, we report the successful growth of high-quality SiO2 films by low-temperature plasma-enhanced atomic layer deposition using an oxidant which is compatible with moisture/oxygen sensitive materials. The SiO2 films were grown at 90 °C using CO2 and Bis(tertiary-butylamino)silane as process precursors. Growth, chemical composition, density, optical properties, and residual stress of SiO2 films were investigated. SiO2 films having a saturated growth-per-cycle of ~ 1.15 Å/cycle showed a density of ~ 2.1 g/cm3, a refractive index of ~ 1.46 at a wavelength of 632 nm, and a low tensile residual stress of ~ 30 MPa. Furthermore, the films showed low impurity levels with bulk concentrations of ~ 2.4 and ~ 0.17 at. % for hydrogen and nitrogen, respectively, whereas the carbon content was found to be below the measurement limit of time-of-flight elastic recoil detection analysis. These results demonstrate that CO2 is a promising oxidizing precursor for moisture/oxygen sensitive materials related plasma-enhanced atomic layer deposition processes.
- 12 February 2019
- Published by Springer Nature in Discover Nano
- Vol. 14 (1) , 1-8
Open AccessLow-Temperature Plasma-Enhanced Atomic Layer Deposition of SiO2 Using Carbon Dioxide
In this work, we report the successful growth of high-quality SiO2 films by low-temperature plasma-enhanced atomic layer deposition using an oxidant which is compatible with moisture/oxygen sensitive materials. The SiO2 films were grown at 90 °C using CO2 and Bis(tertiary-butylamino)silane as process precursors. Growth, chemical composition, density, optical properties, and residual stress of SiO2 films were investigated. SiO2 films having a saturated growth-per-cycle of ~ 1.15 Å/cycle showed a density of ~ 2.1 g/cm3, a refractive index of ~ 1.46 at a wavelength of 632 nm, and a low tensile residual stress of ~ 30 MPa. Furthermore, the films showed low impurity levels with bulk concentrations of ~ 2.4 and ~ 0.17 at. % for hydrogen and nitrogen, respectively, whereas the carbon content was found to be below the measurement limit of time-of-flight elastic recoil detection analysis. These results demonstrate that CO2 is a promising oxidizing precursor for moisture/oxygen sensitive materials related plasma-enhanced atomic layer deposition processes.
- Open Access
- 26 October 2018
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 57 (12) , 125502
Influence of plasma parameters on the properties of ultrathin Al2O3 films prepared by plasma enhanced atomic layer deposition below 100 °C for moisture barrier applications
- 26 October 2018
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 57 (12) , 125502
Open AccessInfluence of plasma parameters on the properties of ultrathin Al2O3 films prepared by plasma enhanced atomic layer deposition below 100 °C for moisture barrier applications
- 8 December 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (6)
Nanometer‐Scale Depth‐Resolved Atomic Layer Deposited SiO2 Thin Films Analyzed by Glow Discharge Optical Emission Spectroscopy
In this contribution, pulsed radio frequency (rf) glow discharge optical emission spectroscopy (GDOES) is used to investigate the film properties of SiO2 deposited by plasma enhanced atomic layer deposition (PEALD), for example, the chemical composition, structural properties and film thickness. The total sputtering time until the interface between the SiO2 layer and the Si substrate is ≈13 s. The main impurities in the film, that is, H, C, and N, are detected. It is observed that both C and N intensities decrease with increasing plasma power during deposition of the thin film. The higher plasma power seems to increase the reactivity of the PEALD process and consequently, it might reduce the concentration of impurities in the deposited film. Moreover, the deviation of the GDOES sputtering rates on the film are related to the film density. The thickness of one‐hundred‐nanometer range SiO2 film is calculated from the GDOES silicon and oxygen emission profiles, and its difference from ellipsometry and X‐ray reflectivity measurements highlights the challenges for the GDOES technique for transparent thin films.
- 8 December 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (6)
Nanometer‐Scale Depth‐Resolved Atomic Layer Deposited SiO2 Thin Films Analyzed by Glow Discharge Optical Emission Spectroscopy
In this contribution, pulsed radio frequency (rf) glow discharge optical emission spectroscopy (GDOES) is used to investigate the film properties of SiO2 deposited by plasma enhanced atomic layer deposition (PEALD), for example, the chemical composition, structural properties and film thickness. The total sputtering time until the interface between the SiO2 layer and the Si substrate is ≈13 s. The main impurities in the film, that is, H, C, and N, are detected. It is observed that both C and N intensities decrease with increasing plasma power during deposition of the thin film. The higher plasma power seems to increase the reactivity of the PEALD process and consequently, it might reduce the concentration of impurities in the deposited film. Moreover, the deviation of the GDOES sputtering rates on the film are related to the film density. The thickness of one‐hundred‐nanometer range SiO2 film is calculated from the GDOES silicon and oxygen emission profiles, and its difference from ellipsometry and X‐ray reflectivity measurements highlights the challenges for the GDOES technique for transparent thin films.