Dexiang Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dexiang Li has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Gongming Xin
School of Energy and Power Engineering, Shandong University, Jinan 250061, China
10 shared publications - Yufan Zhang
School of Energy and Power Engineering, Shandong University, Jinan 250061, China
7 shared publications Shaoran Ren
6 shared publicationsGongming Xin
5 shared publicationsHanxin Jiu
5 shared publicationsHuaxue Yan
School of Nuclear Science, Energy and Power Engineering
4 shared publications
Latest Publications
- 5 July 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (28) , 20274-20290
Molecular-Scale Mechanisms of CH 4 Hydrate Displacement Using Multi-Component CO 2 -Rich Industrial Waste Gas: Impacts of Gas Composition, Thermodynamic Conditions, and Salinity on Structural Evolution and Mass Transfer
The CH4/CO2 displacement method is regarded as a highly promising approach for natural gas extraction, which can improve CH4 recovery efficiency while achieving carbon sequestration. However, CO2 purification is technologically complex and energy-intensive, and the replacement performance remains limited. Directly injecting CO2-rich industrial waste gases can not only improve the CH4 recovery efficiency but also achieve waste gas sealing, reducing the cost of gas separation and purification. In this study, a model for replacing CH4 hydrate with CO2-rich industrial waste gas is established based on the molecular dynamics method. The effects of temperature, pressure, concentration of industrial waste gas, and salinity on the molecular structure evolution and mass transfer behavior during the displacement process were comprehensively analyzed. The results indicate that an increase in temperature can significantly promote the release of CH4 and the formation of CO2 hydrates within the simulation range. The influence of pressure on the displacement process is relatively limited. Overall, the increase in pressure enhances the spatial correlation between CO2 and the hydrate cage, promoting the displacement and sequestration of CO2. Compared with pure CO2, the introduction of an appropriate amount of N2 and NO can promote the displacement process, indicating that a small amount of associated components have a synergistic regulatory effect in confined systems. Salinity exerts a significant inhibitory effect on the displacement process by weakening the hydrogen bond network of H2O molecules and the intermolecular spatial correlation. This study offers a molecular-scale basis for mechanism analysis and operational condition evaluation of CO2 participation in hydrate displacement within multicomponent industrial waste gas environments.
- 5 July 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (28) , 20274-20290
Molecular-Scale Mechanisms of CH 4 Hydrate Displacement Using Multi-Component CO 2 -Rich Industrial Waste Gas: Impacts of Gas Composition, Thermodynamic Conditions, and Salinity on Structural Evolution and Mass Transfer
The CH4/CO2 displacement method is regarded as a highly promising approach for natural gas extraction, which can improve CH4 recovery efficiency while achieving carbon sequestration. However, CO2 purification is technologically complex and energy-intensive, and the replacement performance remains limited. Directly injecting CO2-rich industrial waste gases can not only improve the CH4 recovery efficiency but also achieve waste gas sealing, reducing the cost of gas separation and purification. In this study, a model for replacing CH4 hydrate with CO2-rich industrial waste gas is established based on the molecular dynamics method. The effects of temperature, pressure, concentration of industrial waste gas, and salinity on the molecular structure evolution and mass transfer behavior during the displacement process were comprehensively analyzed. The results indicate that an increase in temperature can significantly promote the release of CH4 and the formation of CO2 hydrates within the simulation range. The influence of pressure on the displacement process is relatively limited. Overall, the increase in pressure enhances the spatial correlation between CO2 and the hydrate cage, promoting the displacement and sequestration of CO2. Compared with pure CO2, the introduction of an appropriate amount of N2 and NO can promote the displacement process, indicating that a small amount of associated components have a synergistic regulatory effect in confined systems. Salinity exerts a significant inhibitory effect on the displacement process by weakening the hydrogen bond network of H2O molecules and the intermolecular spatial correlation. This study offers a molecular-scale basis for mechanism analysis and operational condition evaluation of CO2 participation in hydrate displacement within multicomponent industrial waste gas environments.
- Open Access
Molecular-Level Insights into CO2 Dissolution Trapping in Deep Saline Aquifers: Diffusion Behavior in NaCl Brines
Carbon capture, utilization, and storage (CCUS) is critical for carbon neutrality, and deep saline aquifers are promising reservoirs for CO2 sequestration. CO2 diffusion in brine directly affects dissolution trapping efficiency and is strongly influenced by salt ions. Molecular dynamics simulations were employed to investigate CO2 diffusion in NaCl brines under varying concentrations (0.1–5.0 mol/L), temperatures (298–353 K), and pressures (3–40 MPa). Diffusion coefficients were derived from mean square displacement, and radial distribution functions combined with hydrogen bond analysis were used to elucidate microscopic mechanisms. Results show that as NaCl concentration increases from 0.1 to 5.0 mol/L, the diffusion coefficient decreases by ~50%, reflecting the kinetic consequence of the salting-out effect. Raising temperature from 298 to 353 K enhances diffusion by ~149%, following Arrhenius behavior, while pressure shows negligible influence below 30 MPa but causes a 15% drop at 40 MPa. RDF analysis reveals that higher salinity densifies the CO2 hydration shell without changing its coordination number, and ions do not accumulate near CO2. Hydrogen bond analysis indicates that slower diffusion arises primarily from increased viscosity and steric hindrance from hydrated ions rather than disruption of hydrogen bonds. These molecular-level insights can guide site selection and injection strategy optimization for CO2 geological storage in saline aquifers.
Open AccessMolecular-Level Insights into CO2 Dissolution Trapping in Deep Saline Aquifers: Diffusion Behavior in NaCl Brines
Carbon capture, utilization, and storage (CCUS) is critical for carbon neutrality, and deep saline aquifers are promising reservoirs for CO2 sequestration. CO2 diffusion in brine directly affects dissolution trapping efficiency and is strongly influenced by salt ions. Molecular dynamics simulations were employed to investigate CO2 diffusion in NaCl brines under varying concentrations (0.1–5.0 mol/L), temperatures (298–353 K), and pressures (3–40 MPa). Diffusion coefficients were derived from mean square displacement, and radial distribution functions combined with hydrogen bond analysis were used to elucidate microscopic mechanisms. Results show that as NaCl concentration increases from 0.1 to 5.0 mol/L, the diffusion coefficient decreases by ~50%, reflecting the kinetic consequence of the salting-out effect. Raising temperature from 298 to 353 K enhances diffusion by ~149%, following Arrhenius behavior, while pressure shows negligible influence below 30 MPa but causes a 15% drop at 40 MPa. RDF analysis reveals that higher salinity densifies the CO2 hydration shell without changing its coordination number, and ions do not accumulate near CO2. Hydrogen bond analysis indicates that slower diffusion arises primarily from increased viscosity and steric hindrance from hydrated ions rather than disruption of hydrogen bonds. These molecular-level insights can guide site selection and injection strategy optimization for CO2 geological storage in saline aquifers.
- Open Access
- 22 May 2026
- Published by Elsevier in Results in Engineering
- Vol. 30
Beyond pure CO2: industrial waste gas as a dual-functional agent for enhanced shale hydrocarbon recovery and geological carbon sequestration—a critical review
- 22 May 2026
- Published by Elsevier in Results in Engineering
- Vol. 30
Open AccessBeyond pure CO2: industrial waste gas as a dual-functional agent for enhanced shale hydrocarbon recovery and geological carbon sequestration—a critical review
- Open Access
CO2-Rich Industrial Waste Gas as a Storage-Enhanced Gas: Experimental Study on Changes in Pore Structure and Methane Adsorption in Coal and Shale
A technology that directly injects CO2-rich industrial waste gas (CO2-rich IWG) into underground spaces for unconventional natural gas extraction and waste gas storage has received increasing attention. The pore characteristics of coal and shale in a coal-bearing rock series before and after CO2-rich IWG treatment are closely related to gas recovery and storage. In this study, three coals ranging from low to high rank and one shale sample were collected. The samples were treated with CO2-rich IWG using a high-precision geochemical reactor. The changes in the pore volume (PV), specific surface area (SSA), and pore size distribution of micropores, mesopores, and macropores were analyzed. The correlations between the Langmuir volume and the PV and SSA of the micropores and mesopores were analyzed. It was confirmed that for micropores, SSA was the dominant factor influencing adsorption capacity. The effectively interconnected pore volume was calculated using macropores to characterize changes in the sample’s connectivity. It was found that the PV and SSA of the micropores in the coal samples increased with increasing coal rank. The CO2-rich IWG treatment increased the PV and SSA of the micropores in all of the samples. In addition, for mesopores and macropores, the treatment reduced the SSA in the coal samples but enhanced it in the shale. The results of this study improve the understanding of the mechanisms of the CO2-rich IWG treatment method and emphasize its potential in waste gas storage and natural gas extraction.
Open AccessCO2-Rich Industrial Waste Gas as a Storage-Enhanced Gas: Experimental Study on Changes in Pore Structure and Methane Adsorption in Coal and Shale
A technology that directly injects CO2-rich industrial waste gas (CO2-rich IWG) into underground spaces for unconventional natural gas extraction and waste gas storage has received increasing attention. The pore characteristics of coal and shale in a coal-bearing rock series before and after CO2-rich IWG treatment are closely related to gas recovery and storage. In this study, three coals ranging from low to high rank and one shale sample were collected. The samples were treated with CO2-rich IWG using a high-precision geochemical reactor. The changes in the pore volume (PV), specific surface area (SSA), and pore size distribution of micropores, mesopores, and macropores were analyzed. The correlations between the Langmuir volume and the PV and SSA of the micropores and mesopores were analyzed. It was confirmed that for micropores, SSA was the dominant factor influencing adsorption capacity. The effectively interconnected pore volume was calculated using macropores to characterize changes in the sample’s connectivity. It was found that the PV and SSA of the micropores in the coal samples increased with increasing coal rank. The CO2-rich IWG treatment increased the PV and SSA of the micropores in all of the samples. In addition, for mesopores and macropores, the treatment reduced the SSA in the coal samples but enhanced it in the shale. The results of this study improve the understanding of the mechanisms of the CO2-rich IWG treatment method and emphasize its potential in waste gas storage and natural gas extraction.