Martin Juigner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Martin Juigner has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Cyril Michon
GEOFIT-Expert, 1 Route de Gachet, CEDEX 3, 44307 Nantes, France
1 shared publication - Françoise Debaine
Littoral Environnement Télédétection Géomatique, UMR CNRS 6554, Université de Nantes, Campus Tertre, 44312 Nantes, France
1 shared publication - Giovanni Frati
Laboratoire de Planétologie et Géodynamique (LPG) CNRS: UMR6112, INSU, Université de Nantes, OSUNA, Université d’Angers 2 Rue de la Houssinière—BP 92208 44322 NANTES CEDEX 3 2 bd Lavoisier, CEDEX, 49045 Angers, France
1 shared publication - Manuel Giraud
Laboratoire de Planétologie et Géodynamique (LPG) CNRS: UMR6112, INSU, Université de Nantes, OSUNA, Université d’Angers 2 Rue de la Houssinière—BP 92208 44322 NANTES CEDEX 3 2 bd Lavoisier, CEDEX, 49045 Angers, France
1 shared publication - Marc Robin
Littoral Environnement Télédétection Géomatique, UMR CNRS 6554, Université de Nantes, Campus Tertre, 44312 Nantes, France
1 shared publication - Marc Robin
UMR CNRS 6554, University of Nantes
1 shared publication
Latest Publications
- Open Access
- 23 December 2020
- Published by MDPI AG in Remote Sensing
- Vol. 13 (1) , 29
Coastal Sand Dunes Monitoring by Low Vegetation Cover Classification and Digital Elevation Model Improvement Using Synchronized Hyperspectral and Full-Waveform LiDAR Remote Sensing
Due to the coastal morphodynamic being impacted by climate change there is a need for systematic and large-scale monitoring. The monitoring of sandy dunes in Pays-de-la-Loire (France) requires a simultaneous mapping of (i) its morphology, allowing to assess the sedimentary stocks and (ii) its low vegetation cover, which constitutes a significant proxy of the dune dynamics. The synchronization of hyperspectral imaging (HSI) with full-waveform (FWF) LiDAR is possible with an airborne platform. For a more intimate combination, we aligned the 1064 nm laser beam of a bi-spectral Titan FWF LiDAR with 401 bands and the 15 cm range resolution on the Hyspex VNIR camera with 160 bands and a 4.2 nm spectral resolution, making both types of data follow the same emergence angle. A ray tracing procedure permits to associate the data while keeping the acquisition angles. Stacking multiple shifted FWFs, which are linked to the same pixel, enables reaching a 5 cm range resolution grid. The objectives are (i) to improve the accuracy of the digital terrain models (DTM) obtained from an FWF analysis by calibrating it on dGPS field measurements and correcting it from local deviations induced by vegetation and (ii) in combination with airborne reflectances obtained with PARGE and ATCOR-4 corrections, to implement a supervised hierarchic classification of the main foredune vegetation proxies independently of the acquisition year and the physiological state. The normalization of the FWF LiDAR range to a dry sand reference waveform and the centering on their top canopy echoes allows to isolate Ammophilia arenaria from other vegetation types using two FWF indices, without confusion with slope effects. Fourteen HSI reflectance indices and 19 HSI Spectral Angle Mapping (SAM) indices based on 2017 spectral field measurements performed with the same Hyspex VNIR camera were stacked with both FWF indices into a single co-image for each acquisition year. A simple straightforward hierarchical classification of all 35 pre-classified co-image bands was successfully applied along 20 km, out of the 250 km of coastline acquired from 2017 to 2019, prefiguring its systematic application to the whole 250 km every year.
- 23 December 2020
- Published by MDPI AG in Remote Sensing
- Vol. 13 (1) , 29
Open AccessCoastal Sand Dunes Monitoring by Low Vegetation Cover Classification and Digital Elevation Model Improvement Using Synchronized Hyperspectral and Full-Waveform LiDAR Remote Sensing
Due to the coastal morphodynamic being impacted by climate change there is a need for systematic and large-scale monitoring. The monitoring of sandy dunes in Pays-de-la-Loire (France) requires a simultaneous mapping of (i) its morphology, allowing to assess the sedimentary stocks and (ii) its low vegetation cover, which constitutes a significant proxy of the dune dynamics. The synchronization of hyperspectral imaging (HSI) with full-waveform (FWF) LiDAR is possible with an airborne platform. For a more intimate combination, we aligned the 1064 nm laser beam of a bi-spectral Titan FWF LiDAR with 401 bands and the 15 cm range resolution on the Hyspex VNIR camera with 160 bands and a 4.2 nm spectral resolution, making both types of data follow the same emergence angle. A ray tracing procedure permits to associate the data while keeping the acquisition angles. Stacking multiple shifted FWFs, which are linked to the same pixel, enables reaching a 5 cm range resolution grid. The objectives are (i) to improve the accuracy of the digital terrain models (DTM) obtained from an FWF analysis by calibrating it on dGPS field measurements and correcting it from local deviations induced by vegetation and (ii) in combination with airborne reflectances obtained with PARGE and ATCOR-4 corrections, to implement a supervised hierarchic classification of the main foredune vegetation proxies independently of the acquisition year and the physiological state. The normalization of the FWF LiDAR range to a dry sand reference waveform and the centering on their top canopy echoes allows to isolate Ammophilia arenaria from other vegetation types using two FWF indices, without confusion with slope effects. Fourteen HSI reflectance indices and 19 HSI Spectral Angle Mapping (SAM) indices based on 2017 spectral field measurements performed with the same Hyspex VNIR camera were stacked with both FWF indices into a single co-image for each acquisition year. A simple straightforward hierarchical classification of all 35 pre-classified co-image bands was successfully applied along 20 km, out of the 250 km of coastline acquired from 2017 to 2019, prefiguring its systematic application to the whole 250 km every year.
- Open Access
- 1 January 2018
- Published by OpenEdition in VertigO
- Vol. 18-2 (Volume 18 )
Caractérisation de la morphologie des massifs dunaires de la région Pays de la Loire (France) face au risque de submersion marine
Les massifs dunaires peuvent jouer un rôle d’obstacle face au risque de submersion marine, notamment au droit de secteurs à enjeux humains et non-humains, ce qui justifie l’intérêt de l’évaluation de leur capacité à protéger les zones basses. Cet article propose une démarche géomatique reproductible pour évaluer : (i) la sensibilité des massifs dunaires, (ii) l’exposition des enjeux bâtis et réseau routier face au risque de submersion marine et (iii) la capacité de protection globale des massifs. La segmentation des 140 km de cordons littoraux et flèches sableuses de la région Pays de la Loire est réalisée à l’aide de boites de 25*400 m. Huit indicateurs synthétiques sont extraits de données génériques puis calculés au sein de chaque boite : l’altitude minimum de la crête, l’assise et le volume du cordon de 1re ligne ; la dynamique historique du trait de côte ; l’emprise des zones basses et l’assise du cordon de 2e ligne ; l’emprise et la hauteur d’eau potentielle des enjeux bâtis et réseau routier implantés en zone basse. L’agrégation des indicateurs conduit à la création d’indices dont la valeur dépend de l’intensité et de la concomitance des indicateurs. Cette démarche simple, exhaustive et reproductible permet (i) d’évaluer finement l’ensemble des sites étudiés et (ii) de localiser les secteurs sensibles et/ou exposés à l’aléa submersion marine. À terme, cette démarche ambitionne d’aider à prioriser l’action publique sur les secteurs les plus à risque grâce à un porter à connaissance qui repose sur une approche objective du risque.
- 1 January 2018
- Published by OpenEdition in VertigO
- Vol. 18-2 (Volume 18 )
Open AccessCaractérisation de la morphologie des massifs dunaires de la région Pays de la Loire (France) face au risque de submersion marine
Les massifs dunaires peuvent jouer un rôle d’obstacle face au risque de submersion marine, notamment au droit de secteurs à enjeux humains et non-humains, ce qui justifie l’intérêt de l’évaluation de leur capacité à protéger les zones basses. Cet article propose une démarche géomatique reproductible pour évaluer : (i) la sensibilité des massifs dunaires, (ii) l’exposition des enjeux bâtis et réseau routier face au risque de submersion marine et (iii) la capacité de protection globale des massifs. La segmentation des 140 km de cordons littoraux et flèches sableuses de la région Pays de la Loire est réalisée à l’aide de boites de 25*400 m. Huit indicateurs synthétiques sont extraits de données génériques puis calculés au sein de chaque boite : l’altitude minimum de la crête, l’assise et le volume du cordon de 1re ligne ; la dynamique historique du trait de côte ; l’emprise des zones basses et l’assise du cordon de 2e ligne ; l’emprise et la hauteur d’eau potentielle des enjeux bâtis et réseau routier implantés en zone basse. L’agrégation des indicateurs conduit à la création d’indices dont la valeur dépend de l’intensité et de la concomitance des indicateurs. Cette démarche simple, exhaustive et reproductible permet (i) d’évaluer finement l’ensemble des sites étudiés et (ii) de localiser les secteurs sensibles et/ou exposés à l’aléa submersion marine. À terme, cette démarche ambitionne d’aider à prioriser l’action publique sur les secteurs les plus à risque grâce à un porter à connaissance qui repose sur une approche objective du risque.