VSVijay S. Sapner

Vijay S. Sapner

*This is an algorithmically generated author record based on publicly available information.

Vijay S. Sapner has a total of 20 co-authors. Here are the top co-authors by number of shared publications:

  • Bhaskar Ramchandra Sathe

    Dr. Babasaheb Ambedkar Marathwada University

    10 shared publications
  • Balaji B. Mulik

    Department of Chemistry, Dr Babasaheb Ambedkar Marathwada University, Aurangabad 431004, India

    2 shared publications
  • Janak

    Department of Chemistry, Dr B.R. Ambedkar National Institute of Technology Jalandhar, GT Road by pass, Jalandhar, Punjab-144008, India

    2 shared publications
  • Parag P. Chavan

    Department of Chemistry, Dr Babasaheb Ambedkar Marathwada University, Aurangabad 431004, MS, India

    2 shared publications
  • Pratiksha D. Tanwade

    Department of Chemistry, Dr Babasaheb Ambedkar Marathwada University, Aurangabad 431004, Maharashtra, India

    2 shared publications
  • Sadhika Khullar

    Department of Chemistry, Dr B.R. Ambedkar National Institute of Technology Jalandhar, GT Road by pass, Jalandhar, Punjab-144008, India

    2 shared publications

Latest Publications

  • Ni/NiO@rGO nanocomposite catalyzed green and efficient synthesis of 4,4-(arylmethylene)bis(3-methyl-1 H -pyrazol-5-ol) derivatives via tandem Knoevenagel–Michael reaction

    by Vishal S. Waghchaure, Mahesh N. Waman, Ashishkumar P. Katariya, Omprakash B. Pawar, Vijay S. Sapner, Shankar S. Narwade, Satish U. Deshmukh, Bhaskar R. Sathe

    The present work describes catalytic activity of a Ni/NiO@rGO nanocomposite for the synthesis of bis(pyrazolyl) methane derivatives in ethanol solvent using a tandem Knoevenagel Michael reaction of 3-methyl-1-phenyl-5-pyrazolone with aryl aldehydes.

  • Open Access

    Correction: Construction of efficient Pb( ii ) carboxylate catalysts for the oxygen and hydrogen evolution reactions

    by Janak, Vijay S. Sapner, Bhaskar R. Sathe, Sadhika Khullar

    Correction for ‘Construction of efficient Pb( ii ) carboxylate catalysts for the oxygen and hydrogen evolution reactions’ by Janak et al. , Dalton Trans. , 2024, https://doi.org/10.1039/d4dt02958e.

  • Construction of efficient Pb( ii ) carboxylate catalysts for the oxygen and hydrogen evolution reactions

    by Janak, Vijay S. Sapner, Bhaskar R. Sathe, Sadhika Khullar

    The development of cost-effective and efficient electrocatalysts can solve the problems associated with the production of energy via water-splitting reactions. In this work, we have focused on two lead-based coordination polymers (CPs), namely, {[Pb2(TPBN)(HBTC)2]2·2.5H2O}n (CP1) and {[Pb2(TPBN)(NDC)2]·H2O}n (CP2), that were synthesized by self-assembly method at room temperature in good yields. The two-dimensional structures of CP1 and CP2 were determined by single-crystal X-ray diffraction studies. Their phase purity and thermal stability were confirmed by powder X-ray diffraction and TGA analysis, respectively. In addition to this, Hirshfeld surface analysis of CP1 and CP2 revealed the key differences in their intermolecular interactions. Both CP1 and CP2 were employed for HER and OER. It has been found that the change in the carboxylate from BTC to NDC resulted in better electrocatalytic activity towards water-splitting reactions. This may be attributed to the presence of more π character in NDC compared to BTC, which makes the electron flow much easier for HER process. CP1 and CP2 showed overpotential values of −0.58 V and −0.55 V, respectively, in 1 M H2SO4 to reach a 10 mA cm−2 current density with Tafel slopes of 31 mV dec−1 and 25 mV dec−1, respectively. For the OER process, CP1 and CP2 exhibited overpotentials of 590 mV and 470 mV, respectively, in 1 M KOH at a current density of 50 mA cm−2 with Tafel slope values of 81 mV dec−1 and 56 mV dec−1, respectively. Turnover frequency (TOF) values of CP1 and CP2 were 1.05 s−1 and 3.21 s−1 for OER and 1.97 s−1 and 9.65 s−1 for HER, respectively. These results indicate that both CPs can act as highly efficient electrocatalysts for clean energy production.


  • Open Access

    Spherical Ni/NiO nanoparticles decorated on nanoporous carbon (NNC) as an active electrode material for urea and water oxidation reactions

    by Parag P. Chavan, Pratiksha D. Tanwade, Vijay S. Sapner, Bhaskar R. Sathe

    Herein, we report a chemical method for scalable synthesis of spherical Ni/NiO nanoparticle-decorated nanoporous carbon (NNC) based electrocatalytic system using a simple and easy chemical method with ultra-high activity towards urea electrooxidation. Morphological analysis by scanning electron microscopy (SEM) and high-resolution transmission electron microscopy (HR-TEM) confirms the formation of Ni/NiO NPs on highly nanoporous carbon with an average size of ∼50 nm. X-ray diffraction (XRD) confirms NNC with a face-centred cubic (FCC) crystal structure. Ni/NiO NPs intercalated with nanoporous carbon exhibited the best electrocatalytic performance towards urea oxidation with an ultra-low onset potential of ∼0.33 V vs. SCE, and faster electrokinetic mechanism confirmed from Tafel slope (∼45 mV dec−1), EIS Rct (∼6.98 Ω), and long term durability for 7 h at 10 mA cm−2 with high CO poisoning tolerance. This work affords noble metal-free electrocatalysts for novel appliances and remarkable potential for urea determination, hydrogen generation, real-time water remediation, and energy conversion.


  • Enhanced Electrochemical NO 2 − Oxidation Reactions on Biomolecule Functionalised Graphene Oxide

    by Parag P. Chavan, Vijay S. Sapner, Bhaskar R. Sathe

    Herein, electrochemical oxidation of nitrite (NO 2 − ) is demonstrated using metal‐free, electrochemically highly stable, and selective biomolecule i. e. tyramine functionalized graphene oxide (GT) electrocatalyst for nitrite oxidation in phosphate buffer at pH‐7. The successful functionalization of a biomolecule on graphene is carried out by a simple chemical method. The surface features of biomolecule functionalized graphene oxide were studied by using both spectroscopic and microscopic techniques including scanning electron microscope (SEM) which shows wrinkled and folded structures having a thickness of ∼20 nm corresponding to a few layer of graphene. Moreover, their structural analysis was carried out using X‐ray photoelectron spectroscopy nitrogen band at peak position of ∼400 eV reveals biomolecule functionalization, Fourier‐transform infrared spectroscopy (FTIR) reveals significant peak at 1580 cm −1 corresponding to amine functionalization, Raman Spectroscopy reveals enhanced I D /I G ratio as compared to GO. The electrochemical surface area (ECSA) found tobe 3.60 cm 2 . The as‐synthesized electrocatalyst is found to be more active towards electro‐oxidation of nitrite (NO 2 − ) at a low onset potential of 0.6 V vs saturated calomel electrode (SCE) from linear sweep voltammetry (LSV), cyclic voltammetry (CV), and electrochemical impedance spectroscopy (EIS) measurements. Moreover, its current stability at a given potential is also tested by chronoamperometric (i‐t) measurements within a concentration range of 0 μM to 7 μM and is having long term good electrochemical stability at an onset potential of 0.6 V vs SCE. The onset potential of GT was 0.6 V vs SCE, the limit of detection (LOD) 0.933 μM and high current density 21 mA cm −2 as compared to GO 8.7 mA cm −2 . Considering above perspectives, our findings emphasizes the importance of biomolecule functionalised GO is the best electrocatalyst for electro‐oxidation of nitrites, which is one of the important species for environmental remediation.


  • Metal-free graphene-based nanoelectrodes for the electrochemical determination of ascorbic acid (AA) and p -nitrophenol ( p -NP): implication towards biosensing and environmental monitoring

    by Vijay S. Sapner, Bhaskar R. Sathe

    Herein, a metal-free tyramine-functionalized graphene oxide (T-GO) electrocatalyst was used for the electrochemical determination of ascorbic acid (AA) and an organic pollutant specially substituted by a phenolic compound, i.e., p-nitrophenol (p-NP), in 1 M phosphate buffer solution at pH 7 as a model species. The cyclic voltammetry investigation of AA and p-NP has a significant role in biosensing and the management of industrial waste. Thus, the electrochemical detection of AA and p-NP was successfully achieved using the T-GO-modified GC electrode for the oxidation of AA at an onset potential of −0.03 V vs. SCE. A redox reaction occurred for the detection of p-NP at an onset potential oxidation peak (O1) of 0.047 V vs. SCE and reduction peaks (R1 and R2) at −0.62 V vs. SCE and 0.147 V vs. SCE, respectively. The stability and reproducibility of the T-GO-based electrocatalyst were outstanding for the detection of both AA and p-NP, which can be attributed to its improved active surface area after the functionalization of GO with tyramine.


  • Open Access

    Graphene oxide-based electrochemical activation of ethionamide towards enhanced biological activity

    by Balaji B. Mulik, Sambhaji T. Dhumal, Vijay S. Sapner, Naziya N. M. A. Rehman, Prashant P. Dixit, Bhaskar R. Sathe

    The electrochemical behavior of ethionamide (ETO) was investigated on GO (∼500 nm) using the linear sweep voltammetric (LSV) technique at the sweep rate of 10 mV s−1 in 1 M PBS buffer solution, and the characteristic anodic signal was examined at 0.240 V over the potential range of −0.4 to 1 V vs. SCE. However, linearity was observed with the increase in scan rate (2–300 mV s−1) and concentration of ETO (1 μM to 100 mM), suggesting that the process involved diffusion-controlled electron transfer. The results also exhibited excellent current and potential stability, limit of detection (LOD 1.33) and limit of quantification (LOQ 4.4) at optimized experimental conditions. This electrochemical oxidation method was successfully applied in the complete oxidation of ETO to its oxidized form, which was further confirmed by high resolution mass spectroscopy (HRMS) and Fourier transform infrared (FTIR) spectroscopic measurements. Interestingly, the comparative biological evaluation of ETO and ETO-O (oxidised form) showed good enhancement in the activity of oxidised ETO against some Gram-negative pathogens, such as E. aerogenes, S. abony, S. boydii, and E. coli.


  • Open Access

    Enhanced oxygen evolution reaction on amine functionalized graphene oxide in alkaline medium

    by Vijay S. Sapner, Balaji B. Mulik, Renuka V. Digraskar, Shankar S. Narwade, Bhaskar R. Sathe

    Development of highly efficient oxygen evolution reaction (OER) electrocatalysts is a critical challenge in the cost-effective generation of clean fuels. Here, a metal-free tyramine functionalized graphene oxide (T-GO) electrocatalyst is proposed to use in alkaline electrolytes for enhanced OER. Moreover, the T-GO and GO nanomaterials are well characterized by SEM, XRD, FTIR, XPS and Raman spectroscopy. T-GO exhibits an electrocatalytic OER with a current density of 2 mA cm−2 at a low onset potential of ∼1.39 V and a small Tafel slope of about 69 mV dec−1 and GO exhibits an onset potential of 1.51 V and Tafel slope of about 92 mV dec−1. Additionally, the current stability and RRDE based diffusion controlled response of the T-GO electrocatalyst are outstanding compared to GO. This study establishes metal free T-GO as an efficient electrocatalyst for the OER and used for cathodic production of hydrogen as a counter reaction in the field of water splitting.