Leila Kasaei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Leila Kasaei has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Emily G. Sukenik
Energy Storage Research Group, Department of Material Science and Engineering, Rutgers University, North Brunswick, USA
2 shared publications - Glenn G. Amatucci
Rutgers University, Department of Materials Science and Engineering; Energy Storage Research Group (ESRG), United States of America
2 shared publications Hussein Hijazi
Department of Physics & Astronomy, Rutgers, The State University of New Jersey, Piscataway, New Jersey 08854, United States of America
2 shared publications- Ke Chen
Department of Physics, Temple University, Philadelphia, PA, USA
2 shared publications - Mengjun Li
Rutgers, The State Univ. of New Jersey (United States)
2 shared publications Torgny Gustafsson
Physics and Astronomy, Rutgers University New Brunswick, New Brunswick, New Jersey, UNITED STATES
2 shared publications
Latest Publications
- 13 June 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 579
Impact of gradient porosity in ultrathick electrodes for lithium batteries
- 13 June 2023
- Published by Elsevier in Journal of Power Sources
- Vol. 579
Impact of gradient porosity in ultrathick electrodes for lithium batteries
- 21 November 2022
- Published by Springer Nature in Ionics
- Vol. 29 (1) , 233-257
Engineering high transport plastic separators for next-generation Li-ion batteries
- 21 November 2022
- Published by Springer Nature in Ionics
- Vol. 29 (1) , 233-257
Engineering high transport plastic separators for next-generation Li-ion batteries
- 1 September 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (9) , 092518
Magnetic Characterization of Electrodeposited Pt1−xNix Alloy Films: Influence of Deposition Potential and the Presence of Boric Acid
Pt1-xNix (x = 0.25 to 0.92) thin films were examined for possible application as magnetic thermometers. The alloys were prepared by potentiostatic electrodeposition from aqueous chloride-based solutions in the presence and absence of 0.5 mol dm−3 B(OH)3. Alloy composition was controlled by the deposition potential with the Ni concentration increasing towards more reducing potentials. Films with x > 0.45 were ferromagnetic with the magnetization at 300 K increasing with nickel content. Magnetization vs temperature (M vs T) at 8 kA m−1 (100 Oe) showed an increase in the Curie temperature from less than 200 K to above 400 K for the alloys investigated. For films deposited at potentials >−0.6 V vs the saturated calomel electrode (SCE), boric acid had negligible effect on the magnetization at the maximum applied field in M vs H measurements. In contrast, for depositions at more reducing potentials <−0.6 V vs SCE the presence of boric acid resulted in diminished magnetization. This effect was attributed to elevated incorporation of oxygen (up to ∼4 atomic %), along with boron incorporation of about 400 μmol mol−1.
- 1 September 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (9) , 092518
Magnetic Characterization of Electrodeposited Pt1−xNix Alloy Films: Influence of Deposition Potential and the Presence of Boric Acid
Pt1-xNix (x = 0.25 to 0.92) thin films were examined for possible application as magnetic thermometers. The alloys were prepared by potentiostatic electrodeposition from aqueous chloride-based solutions in the presence and absence of 0.5 mol dm−3 B(OH)3. Alloy composition was controlled by the deposition potential with the Ni concentration increasing towards more reducing potentials. Films with x > 0.45 were ferromagnetic with the magnetization at 300 K increasing with nickel content. Magnetization vs temperature (M vs T) at 8 kA m−1 (100 Oe) showed an increase in the Curie temperature from less than 200 K to above 400 K for the alloys investigated. For films deposited at potentials >−0.6 V vs the saturated calomel electrode (SCE), boric acid had negligible effect on the magnetization at the maximum applied field in M vs H measurements. In contrast, for depositions at more reducing potentials <−0.6 V vs SCE the presence of boric acid resulted in diminished magnetization. This effect was attributed to elevated incorporation of oxygen (up to ∼4 atomic %), along with boron incorporation of about 400 μmol mol−1.
- 1 August 2019
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 32 (9) , 095009
Normal-state and superconducting properties of Co-doped BaFe 2 As 2 and MgB 2 thin films after focused helium ion beam irradiation
We have investigated the normal-state and superconducting properties of Co-doped BaFe 2 As 2 (Ba122) and MgB 2 thin films irradiated at room temperature using a 30 keV focused He + ion beam with doses between 10 12 and 10 17 cm 2 . We show that superconductivity is suppressed and the normal-state resistivity is increased upon irradiation. The critical dose for the complete suppression of superconductivity is ∼5 × 10 14 cm −2 for Ba122 and ∼8 × 10 15 cm −2 for MgB 2 . The dependence of the normal-state and superconducting properties on irradiation dose is discussed, taking into account the spatial distribution of ion-induced damage. Hillock formation due to the substrate swelling, arising from the He + ions stopped in the substrate, is also observed. The findings provide guidelines for exploiting focused He + ion beam irradiation in fabricating iron pnictide and MgB 2 planar Josephson junctions.
- 1 August 2019
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 32 (9) , 095009
Normal-state and superconducting properties of Co-doped BaFe 2 As 2 and MgB 2 thin films after focused helium ion beam irradiation
We have investigated the normal-state and superconducting properties of Co-doped BaFe 2 As 2 (Ba122) and MgB 2 thin films irradiated at room temperature using a 30 keV focused He + ion beam with doses between 10 12 and 10 17 cm 2 . We show that superconductivity is suppressed and the normal-state resistivity is increased upon irradiation. The critical dose for the complete suppression of superconductivity is ∼5 × 10 14 cm −2 for Ba122 and ∼8 × 10 15 cm −2 for MgB 2 . The dependence of the normal-state and superconducting properties on irradiation dose is discussed, taking into account the spatial distribution of ion-induced damage. Hillock formation due to the substrate swelling, arising from the He + ions stopped in the substrate, is also observed. The findings provide guidelines for exploiting focused He + ion beam irradiation in fabricating iron pnictide and MgB 2 planar Josephson junctions.
- 6 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-6
Reduced Critical Current Spread in Planar MgB2 Josephson Junction Array Made by Focused Helium Ion Beam
We have fabricated series arrays of closely spaced planar Josephson junctions on MgB2 films using a 30 keV focused helium ion beam. Uniformity of junction parameters within the arrays is sufficient for achieving phase-lock into an applied microwave signal, and flat giant Shapiro steps are observed. The spread in critical current of a 60-Josephson junction array is estimated to be less than 3.5%, significantly better than reported in MgB2 junctions fabricated by other techniques. These results demonstrate the potential of the focused He + ion beam irradiation technique in MgB2 Josephson multi-junction circuit applications such as quantum voltage standards.
- 6 March 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 29 (5) , 1-6
Reduced Critical Current Spread in Planar MgB2 Josephson Junction Array Made by Focused Helium Ion Beam
We have fabricated series arrays of closely spaced planar Josephson junctions on MgB2 films using a 30 keV focused helium ion beam. Uniformity of junction parameters within the arrays is sufficient for achieving phase-lock into an applied microwave signal, and flat giant Shapiro steps are observed. The spread in critical current of a 60-Josephson junction array is estimated to be less than 3.5%, significantly better than reported in MgB2 junctions fabricated by other techniques. These results demonstrate the potential of the focused He + ion beam irradiation technique in MgB2 Josephson multi-junction circuit applications such as quantum voltage standards.
- Open Access
- 1 July 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (7) , 075020
MgB2 Josephson junctions produced by focused helium ion beam irradiation
Planar magnesium diboride Josephson junctions are fabricated using focused helium ion beam irradiation. A single track of ion irradiation with a 30 kV He+ beam with nominal beam diameter < 0.5 nm is used to create a normal-metal barrier on a MgB2 film deposited by hybrid physical-chemical vapor deposition. Josephson coupling is observed below the critical temperature of the electrodes for a He+ doses between 8x1015/cm2 to 4x1016/cm2. Analysis of the temperature dependence of the normal resistance and critical voltage of the junctions shows highly uniform barriers with nearly ideal resistively-shunted junction behavior for higher-dose junctions, while nonequilibrium effects dominate the properties of lower-dose junctions over most of the temperature range. These results demonstrate that focused helium ion beam irradiation can produce high-quality proximity-coupled MgB2 Josephson junctions with tailorable properties, promising for use in superconducting devices and circuits.
- 1 July 2018
- Published by AIP Publishing in AIP Advances
- Vol. 8 (7) , 075020
Open AccessMgB2 Josephson junctions produced by focused helium ion beam irradiation
Planar magnesium diboride Josephson junctions are fabricated using focused helium ion beam irradiation. A single track of ion irradiation with a 30 kV He+ beam with nominal beam diameter < 0.5 nm is used to create a normal-metal barrier on a MgB2 film deposited by hybrid physical-chemical vapor deposition. Josephson coupling is observed below the critical temperature of the electrodes for a He+ doses between 8x1015/cm2 to 4x1016/cm2. Analysis of the temperature dependence of the normal resistance and critical voltage of the junctions shows highly uniform barriers with nearly ideal resistively-shunted junction behavior for higher-dose junctions, while nonequilibrium effects dominate the properties of lower-dose junctions over most of the temperature range. These results demonstrate that focused helium ion beam irradiation can produce high-quality proximity-coupled MgB2 Josephson junctions with tailorable properties, promising for use in superconducting devices and circuits.
- Open Access
- 7 June 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 1-8
Nature of the metal-insulator transition in few-unit-cell-thick LaNiO3 films
The nature of the metal-insulator transition in thin films and superlattices of LaNiO3 only a few unit cells in thickness remains elusive despite tremendous effort. Quantum confinement and epitaxial strain have been evoked as the mechanisms, although other factors such as growth-induced disorder, cation non-stoichiometry, oxygen vacancies, and substrate–film interface quality may also affect the observable properties of ultrathin films. Here we report results obtained for near-ideal LaNiO3 films with different thicknesses and terminations grown by atomic layer-by-layer laser molecular beam epitaxy on LaAlO3 substrates. We find that the room-temperature metallic behavior persists until the film thickness is reduced to an unprecedentedly small 1.5 unit cells (NiO2 termination). Electronic structure measurements using X-ray absorption spectroscopy and first-principles calculation suggest that oxygen vacancies existing in the films also contribute to the metal-insulator transition.
- 7 June 2018
- Published by Springer Nature in Nature Communications
- Vol. 9 (1) , 1-8
Open AccessNature of the metal-insulator transition in few-unit-cell-thick LaNiO3 films
The nature of the metal-insulator transition in thin films and superlattices of LaNiO3 only a few unit cells in thickness remains elusive despite tremendous effort. Quantum confinement and epitaxial strain have been evoked as the mechanisms, although other factors such as growth-induced disorder, cation non-stoichiometry, oxygen vacancies, and substrate–film interface quality may also affect the observable properties of ultrathin films. Here we report results obtained for near-ideal LaNiO3 films with different thicknesses and terminations grown by atomic layer-by-layer laser molecular beam epitaxy on LaAlO3 substrates. We find that the room-temperature metallic behavior persists until the film thickness is reduced to an unprecedentedly small 1.5 unit cells (NiO2 termination). Electronic structure measurements using X-ray absorption spectroscopy and first-principles calculation suggest that oxygen vacancies existing in the films also contribute to the metal-insulator transition.