Hossain Ghahraloud
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hossain Ghahraloud has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Farsi
Department of Chemical Engineering, School of Chemical and Petroleum Engineering, Shiraz University, Shiraz, Iran
5 shared publications - Zohreh Vafapour
Department of Electrical and Computer Engineering, Johns Hopkins University, Baltimore, Maryland 21218, USA
3 shared publications - Mohammad Reza Rahimpour
Department of Chemical Engineering, Shiraz University, Shiraz, Iran
2 shared publications Afsaneh Keshavarz
Department of Physics, College of Science, Shiraz University, Shiraz, 71946, Fars, Iran
1 shared publicationM. Farsi
1 shared publicationM.R. Rahimpour
Department of Chemical Engineering, School of Chemical and Petroleum Engineering , Shiraz University , Shiraz , Iran
1 shared publication
Latest Publications
- 17 September 2022
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (16) , 6244-6252
Process modeling and optimization of an eco-friendly process for acid gas conversion to hydrogen
- 17 September 2022
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 48 (16) , 6244-6252
Process modeling and optimization of an eco-friendly process for acid gas conversion to hydrogen
- 18 February 2019
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 37 (9) , 997-1007
Modeling, operability analysis and optimization of isooctane production over solid catalyst
The main object of this study is modeling and simulation of isooctane production through isobutane alkylation in a multi stage fixed bed reactor at steady state condition. A heterogeneous one-dimensional model is developed based on the mass and energy conservation laws to calculate optimal operating condition of the reactors based on a multi objective optimization model. The simulation results show that there is an optimum value for olefin concentration in the feed stream to maximize process selectivity and isooctane production capacity. Then, the optimum butene concentration is calculated by TOPSIS decision-making method based on developed Pareto front. In addition, the performance of alkylation process to produce isooctane is analyzed, and the predicted component molar flow rate, conversion, temperature, and selectivity are presented.
- 18 February 2019
- Published by Taylor & Francis in Petroleum Science and Technology
- Vol. 37 (9) , 997-1007
Modeling, operability analysis and optimization of isooctane production over solid catalyst
The main object of this study is modeling and simulation of isooctane production through isobutane alkylation in a multi stage fixed bed reactor at steady state condition. A heterogeneous one-dimensional model is developed based on the mass and energy conservation laws to calculate optimal operating condition of the reactors based on a multi objective optimization model. The simulation results show that there is an optimum value for olefin concentration in the feed stream to maximize process selectivity and isooctane production capacity. Then, the optimum butene concentration is calculated by TOPSIS decision-making method based on developed Pareto front. In addition, the performance of alkylation process to produce isooctane is analyzed, and the predicted component molar flow rate, conversion, temperature, and selectivity are presented.
- 6 November 2018
- Published by Walter de Gruyter GmbH in Chemical Product and Process Modeling
- Vol. 14 (2)
Modification of Claus Sulfur Recovery Unit by Isothermal Reactors to Decrease Sulfur Contaminant Emission: Process Modeling and Optimization
Due to environmental limitations and issues, the main goal of this research is modification of conventional Claus sulfur recovery process to decreases sulfur contaminant emission. In this regard, two environmentally friendly alternatives are proposed based on the isothermal concept in reactors. Since Claus reaction is exothermic and reversible, the adiabatic fixed bed reactors in the catalytic section of Claus process are substituted by the isothermal reactors. The furnace and catalytic reactors are modeled based on the mass and energy conservation laws at steady state condition. To prove accuracy of the developed model, the simulation results of conventional process are compared with the available plant data. Then, the optimal condition of modified processes are calculated considering sulfur recovery as the objective function using the Genetic algorithm as a useful method in global optimization. The attainable decision variables are inlet temperature of furnace and reactors, coolant temperature, feed split fraction and air flow rate in the furnace. The simulation results show that H2S conversion in the proposed cases increases about 1.87 % and 1.78 % compared to the conventional process. Generally, the main advantages of proposed structures are higher sulfur recovery and lower sulfur contaminant emission such as COS and CS2 emission.
- 6 November 2018
- Published by Walter de Gruyter GmbH in Chemical Product and Process Modeling
- Vol. 14 (2)
Modification of Claus Sulfur Recovery Unit by Isothermal Reactors to Decrease Sulfur Contaminant Emission: Process Modeling and Optimization
Due to environmental limitations and issues, the main goal of this research is modification of conventional Claus sulfur recovery process to decreases sulfur contaminant emission. In this regard, two environmentally friendly alternatives are proposed based on the isothermal concept in reactors. Since Claus reaction is exothermic and reversible, the adiabatic fixed bed reactors in the catalytic section of Claus process are substituted by the isothermal reactors. The furnace and catalytic reactors are modeled based on the mass and energy conservation laws at steady state condition. To prove accuracy of the developed model, the simulation results of conventional process are compared with the available plant data. Then, the optimal condition of modified processes are calculated considering sulfur recovery as the objective function using the Genetic algorithm as a useful method in global optimization. The attainable decision variables are inlet temperature of furnace and reactors, coolant temperature, feed split fraction and air flow rate in the furnace. The simulation results show that H2S conversion in the proposed cases increases about 1.87 % and 1.78 % compared to the conventional process. Generally, the main advantages of proposed structures are higher sulfur recovery and lower sulfur contaminant emission such as COS and CS2 emission.
- 26 September 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (42) , 14114-14123
Hydrogen Production through Thermal Decomposition of Hydrogen Sulfide: Modification of the Sulfur Recovery Unit To Produce Ultrapure Hydrogen
- 26 September 2018
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 57 (42) , 14114-14123
Hydrogen Production through Thermal Decomposition of Hydrogen Sulfide: Modification of the Sulfur Recovery Unit To Produce Ultrapure Hydrogen
- 24 April 2018
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 35 (5) , 1192-1199
Semiconductor-based far-infrared biosensor by optical control of light propagation using THz metamaterial
By incorporating a dielectric material into a semiconductor thin film, we have demonstrated an optically reconfigurable classical electromagnetically induced reflectance (Cl-EIR) effect in planar metamaterials (MMs) functioning at the far-infrared (far-IR) frequency regime. The proposed far-IR sensor is a microstructure composed of a semiconductor thin film and three dielectric antennas. Numerical analyses based on the far- and near-field interaction are investigated in detail. The coupling between the subradiant and supperradiant modes verify the existence of the Cl-EIR effect. The Cl-EIR frequency could be tuned by changing the surrounding medium, the temperature of the semiconductor layer, the semiconductor material, and the substrate material. Therefore, the proposed complementary MM microstructure, based on a semiconductor featuring tunable reflectance windows, may open up new avenues for designing tunable temperature sensors, optical and biomedical sensors, switches, and slow light devices.
- 24 April 2018
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 35 (5) , 1192-1199
Semiconductor-based far-infrared biosensor by optical control of light propagation using THz metamaterial
By incorporating a dielectric material into a semiconductor thin film, we have demonstrated an optically reconfigurable classical electromagnetically induced reflectance (Cl-EIR) effect in planar metamaterials (MMs) functioning at the far-infrared (far-IR) frequency regime. The proposed far-IR sensor is a microstructure composed of a semiconductor thin film and three dielectric antennas. Numerical analyses based on the far- and near-field interaction are investigated in detail. The coupling between the subradiant and supperradiant modes verify the existence of the Cl-EIR effect. The Cl-EIR frequency could be tuned by changing the surrounding medium, the temperature of the semiconductor layer, the semiconductor material, and the substrate material. Therefore, the proposed complementary MM microstructure, based on a semiconductor featuring tunable reflectance windows, may open up new avenues for designing tunable temperature sensors, optical and biomedical sensors, switches, and slow light devices.
- 1 December 2017
- Published by Elsevier in Journal of the Taiwan Institute of Chemical Engineers
- Vol. 81, 95-103
Modeling and optimization of methanol oxidation over metal oxide catalyst in an industrial fixed bed reactor
- 1 December 2017
- Published by Elsevier in Journal of the Taiwan Institute of Chemical Engineers
- Vol. 81, 95-103
Modeling and optimization of methanol oxidation over metal oxide catalyst in an industrial fixed bed reactor
- 21 November 2017
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 34 (12) , 2586-2592
Graphene-based mid-infrared biosensor
We propose a new graphene-based metamaterial biosensor to achieve tunable plasmon-induced transparency in the mid-infrared (mid-IR) regime. The structure consists of a graphene sheet with three cut-out strips that has been located on a substrate. It is shown that the plasmonically induced transparency (PIT) can be realized by breaking the symmetry of the structure in the normal incidence and also changing the polarization of the incident light in the symmetric case. By optimizing the physical parameters of the antennas, an extremely strong optical sensing coefficient (about 99%) is observed in the mid-IR frequency range based on the PIT effect, which is much larger than that of related previous studies. More importantly, we observed a blueshift in the transparency window through the increase of the gate voltage of the graphene’s chemical potential. The transparency window strongly depends on the physical parameters of the substrate and filling material. Furthermore, it is found that the biosensing application of the proposed structure is highly dependent on inserting an ultra-thin buffer layer between the graphene and substrate layer, leading to a tunable PIT in the mid-IR regime.
- 21 November 2017
- Published by Optica Publishing Group in Journal of the Optical Society of America B
- Vol. 34 (12) , 2586-2592
Graphene-based mid-infrared biosensor
We propose a new graphene-based metamaterial biosensor to achieve tunable plasmon-induced transparency in the mid-infrared (mid-IR) regime. The structure consists of a graphene sheet with three cut-out strips that has been located on a substrate. It is shown that the plasmonically induced transparency (PIT) can be realized by breaking the symmetry of the structure in the normal incidence and also changing the polarization of the incident light in the symmetric case. By optimizing the physical parameters of the antennas, an extremely strong optical sensing coefficient (about 99%) is observed in the mid-IR frequency range based on the PIT effect, which is much larger than that of related previous studies. More importantly, we observed a blueshift in the transparency window through the increase of the gate voltage of the graphene’s chemical potential. The transparency window strongly depends on the physical parameters of the substrate and filling material. Furthermore, it is found that the biosensing application of the proposed structure is highly dependent on inserting an ultra-thin buffer layer between the graphene and substrate layer, leading to a tunable PIT in the mid-IR regime.
- 1 July 2017
- Published by Elsevier in Journal of the Taiwan Institute of Chemical Engineers
- Vol. 76, 1-9
Modeling and optimization of an industrial Claus process: Thermal and catalytic section
- 1 July 2017
- Published by Elsevier in Journal of the Taiwan Institute of Chemical Engineers
- Vol. 76, 1-9
Modeling and optimization of an industrial Claus process: Thermal and catalytic section