OBOlha Bohomaz

Olha Bohomaz

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Olha Bohomaz has a total of 35 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Method of rational use of excess thermal energy of mining cogeneration power plants

    by Viktor Kostenko, Olha Bohomaz, Oleksii Kutniashenko, Stanislav Sidnei, Tetiana Kostenko, Svitlana Fedchenko, Eduard Drahonenko

    The object of research is the heat flows of hot gases and liquids generated during the operation of the energy source of a mine-based cogeneration power plant (CPP). The subject of research is the methods and means of utilizing the CPP's thermal energy for the demineralization of mine wastewater. The research addresses the problem of inefficient thermal energy utilization during the operation of mine-based cogeneration power plants during periods of minimal thermal load. It was established that, during the warm season, a significant portion of the generated thermal energy finds no useful application and is lost. This results in a drop in the CPP's overall efficiency from 90% to less than 55%. Such data indicate the inefficient use of significant energy potential that could otherwise be harnessed for other technological processes. An improvement to the plant's design is proposed by incorporating a subsystem for the evaporation and condensation of mine wastewater; this allows for the efficient use of thermal energy from exhaust gases and turbocharger gases of diesel engines during the warm season. Implementing the proposed solution enables the conversion of otherwise wasted thermal energy into additional useful products: demineralized water, steam condensation heat, and concentrated salt residues. Calculations determined that the thermal power of the exhaust gases from a single JMS-620 diesel engine is sufficient to drive the water evaporation process across a total surface area of approximately 40 m2 and yield at least 28.8 m3 of demineralized water per day. The use of seasonal surplus thermal energy to produce demineralized water from wastewater can be implemented not only at mine-based CPPs but also at cogeneration facilities in other sector, such as biogas and metallurgical plant, and within district heating systems.

  • Increasing the ecological efficiency of water desalination by solar installations

    by Viktor Kostenko, Olha Bohomaz, Tetiana Kostenko, Stanislav Sidnei, Maryna Tavrel, Kateryna Shevchyk

    This article presents a theoretical justification of the design parameters of a solar desalination plant intended for the extraction of fresh water from brine. A series of conducted investigations revealed the mechanisms of solar energy distribution and the principal heat losses within the components of the solar desalination plant. This made it possible to theoretically determine the interaction between key natural and anthropogenic factors influencing the increase in the environmental efficiency of the water desalination process. A universal structural scheme for a solar desalination plant is proposed, comprising a thermally insulated casing with inlet and outlet pipes for brine supply and vapour extraction, respectively, and a transparent cover beneath which a basin containing the initial brine is located, with an adsorber positioned on its surface. A novel design of a hermetically sealed, hemispherical heating chamber is introduced, which enables a reduction in the brine boiling point and a considerable increase in the intensity of vapour generation. The derived theoretical dependence of the mass condensation rate of fresh water on the technical parameters of the desalination plant may serve as a foundation for the development of a virtual model, facilitating further optimisation of the plant’s design parameters in order to increase the energy efficiency of the desalination process and minimize the negative impact on the environment.

  • TECHNOLOGY FOR RECYCLING CONSTRUCTION MATERIALS DURING THE DISMANTLING OF DESTROYED STRUCTURES

    by Viktor Kostenko, Maryna Tavrel, Olga Bohomaz, Oleksii Kutniashenko, Tetiana Kostenko

    As a result of the full-scale invasion, significant areas of Ukrainian settlements have been destroyed, creating an urgent need for effective and cost-efficient solutions for rubble removal and infrastructure restoration. Large volumes of construction waste pose an environmental problem but also represent a potential source of secondary raw materials for construction. In this context, the use of mobile mechanized complexes for collecting, crushing, and sorting debris is of particular importance. The research methodology includes analysis of international experience, development of a technological scheme for mobile intensive dismantling, and coordination of production process parameters to ensure high productivity and environmental safety. The aim of the work is to justify a technology for mobile dismantling with subsequent recycling of construction waste for use in road, concrete, and foundation works in the post-war period. The results demonstrate that the proposed technology allows efficient sorting and crushing of materials, reduces logistics costs, enables reuse of up to 50 % of natural gravel and sand, and minimizes negative environmental impact. Limitations are associated with varying machine productivity, waste composition, and the need for preliminary stockpiling of material. The practical value lies in reducing construction costs and accelerating the restoration of destroyed settlements. The scientific novelty is determined by the harmonization of technological processes and integration of mobile intensive dismantling methods, providing both economic and environmental benefits. The proposed technology combines circular economy principles with the real needs of post-war construction.

  • Open Access

    Substantiation of parameters of moisture retention in arable land using mining wastes

    by Viktor Kostenko, Olha Bohomaz, Stanislav Sidnei, Maksym Udovenko, Oleksii Kutniashenko, Tetiana Kostenko, Antonina Andrieieva

    The article is devoted to the substantiation of the parameters of the method of accumulation and retention of rain and irrigation water in agricultural fields, reducing its losses due to evaporation and convective removal. To preserve water in arable land, it is proposed to arrange parallel rows...

  • Open Access

    Groundwater quality in coal mines of Ukraine: Possibility of using as drinking water

    by Iryna Shvets, Yevgen Zbykovskyy, Olha Bohomaz

    The article outlines the results of a study of groundwater in the mines of the Donetsk and Lviv-Volyn coal basins of Ukraine. Comparative analysis of groundwater in 9 mines of the Lviv-Volyn coal basin and 7 mines of the Donetsk coal basin confirmed the influence of the depth of mine workings on...


  • USE OF MINING WASTE TO PRESERVE FIELD MOISTURE

    by Viktor Kostenko, Olha Bohomaz, Stanislav Sidnei, Oleksii Кutniashenko, Maryna Tavrel, Svitlana Virych

    Purpose. Justification of the effectiveness of the proposed method of retaining irrigation moisture in arable land due to the formation of filter inclusions. Research methodology. Computer modeling of filtration flows of irrigation water from the surface to the underlying soil layers. Results. In this article, the authors proposed a method to prevent irrigation water loss in agricultural fields by creating grooves on arable land that have a small open surface area. In order to prevent the walls of the groove from collapsing, the possibility of filling their cavity with small solid burnt mining wastes, which have high filtration properties, was considered. At the same time, filling the void of the groove with a mixture made on the basis of burned waste mass with the addition of bottom sediments raised from reservoirs will also act as a means of increasing productivity. The implementation scheme for arranging irrigation ditches filled with burnt rock in the field, as well as the initial and operational conditions , are substantiated. According to the results of computer and mathematical modeling, using the ANSYS WB program, in a non-stationary setting, qualitative indicators of the water distribution mechanism in the experimental soil fragment were obtained. The wave nature of water migration under the influence of gravitational and capillary forces has been established. The studies show that irrigation water is concentrated in the “groove with rock – moistened soil massif” system, which has the shape of an oval with a limited contact plane with the surface. This determines the low intensity of evaporation, and, accordingly, the effectiveness of the proposed method of retaining water in the arable land by adding solid burnt mining waste. Scientific novelty. The use of small solid mining waste to create irrigation ditches on arable land is proposed, and qualitative indicators of the water distribution mechanism in the experimental soil fragment are obtained. Practical significance. The use of small solid mining wastes, which have high filtration properties, to fill the cavity of irrigation ditches on arable land will allow reducing the loss of water to evaporation and improve the physical and mechanical properties of loamy soils. Key words: mining solid waste, irrigation water, ditch, arable land, loamy soil.

  • Open Access

    Increasing the Efficiency of the Solar Plant for Desalination of Water

    by Viktor Kostenko, Olha Bohomaz, Oleksii Kutniashenko, Svitlana Shkrylova, Maryna Tavrel, Tetiana Kostenko, Yuliia Simonova

    The article is devoted to the improvement of the design of a desalination solar plant for more efficient and economical production of desalinated water due to intensive evaporation of the boiling solution, reduction of energy losses to the external environment and the absence of the need for...


  • INCREASING THE EFFICIENCY OF SUPPLYING COMMUNITIES WITH WATER RESOURCES THROUGH THERMOSTABILIZATION OF OPEN WATERS

    by Viktor Kostenko, Maryna Tavrel, Olha Bohomaz

    Purpose. Increasing the efficiency of providing communities with thermostabilised water by using an airlift aerator in open water bodies. Method. Theoretical analysis of the advantages and disadvantages of the currently existing methods and means of water purification, modelling using the demo version of the ANCIS program, using the finite element method, the temperature dynamics of the water column in the hot period of the year and when using a water aeration and thermostabilization installation. Results. In this publication, the authors consider increasing the efficiency of providing communities with water resources of appropriate quality through thermal stabilisation and aeration of water. The paper provides an overview of the main methods of water purification and analyses their purification efficiency. Based on the analysis, the most effective and economical method is water aeration. Aeration makes it possible to mix water layers with a higher temperature with cooler layers, thereby reducing the average temperature of the water. Also, a similar method allows you to additionally saturate the water with oxygen, preventing the excessive formation of cyanobacteria and the death of beneficial hydrobionts of reservoirs. To reflect the effect of turbulent mixing of water masses by an aerator, simulation was carried out using the demo version of the ANCIS program using the finite element method, which consists in finding the solution of integral and differential equations in partial derivatives. The simulation results showed that the thermocline is destroyed during the mixing of water masses and the water temperature cools from 25оC to 22оC. Such a temperature slows down the excessive formation of unwanted hydrobionts and ensures the free dissolution of oxygen in the water. In practical use, in natural surface reservoirs, it is proposed to use several patented airlift-aerator units. This development is effective for low-water reservoirs, mixes water layers with different temperatures, and additionally saturates with oxygen. Scientific novelty. The justification of the feasibility of using thermostabilization installations in surface reservoirs for the possibility of providing urban communities with high-quality water resources was carried out, the process of thermocline destruction by forced mixing of water masses was simulated. Practical significance. On the basis of simulated data, using the demo version of the ANCIS program, it is possible to evaluate the effectiveness of the proposed method of thermostabilization of water for the needs of communities with little water supply. Key words: thermostabilised water, thermocline, water resources, airlift aerator, open reservoirs.


  • ЗАБЕЗПЕЧЕННЯ ВОДОЮ БУДІВЕЛЬНИХ ПІДПРИЄМСТВ НА ВРАЖЕНИХ ВІЙНОЮ ТЕРЕНАХ

    by Viktor Kostenko, Donetsk National Technical University, Maryna Tavrel, Olha Bohomaz

    Purpose. Development of a plant for the preparation of process water of a cement plant, which will allow, at a low cost, to obtain heat-stabilized water of high quality all year round, which would meet the requirements of concrete production. Methodology. A comprehensive research method was used, which includes an analysis of literary sources, an overview of water quality requirements and methods of water preparation at concrete enterprises. Results. Based on the analysis of regulatory documents regarding the quality of water used in concrete production, a water treatment complex has been proposed that solves the problem of water purification to the required quality and thermal stabilization. To prevent the formation of unwanted algae and bacteria, a qualitatively new design of a recirculation aerator capable of saturating water in shallow open water bodies has been offered. By using a geothermal heat exchanger, the water temperature in summer is up to +20°C, and in winter it is not lower than +8°C. In conditions of energy shortage, the installation uses a wind farm, which allows to save money on operation or even make a profit. Scientific novelty. A complex for water preparation for the needs of concrete plants is proposed, which solves the problem of water purification to the required quality and its thermal stabilization. Practical significance. Equipping a plant for the production of a wide range of building materials with a plant for the preparation of process water will make it possible to obtain purified thermally stabilized water from a natural open water body, suitable for sealing the concrete mass and increase the service life of the equipment of the concrete plant. Keywords: aerator, construction enterprise, water treatment, thermal stabilization of water, wind energy.

  • Open Access

    IMPROVEMENT OF MICROCLIMATIC WORKING CONDITIONS FOR MINERS IN DEEP MINES

    by Viktor Kostenko, Olha Bohomaz, Tetiana Kostenko, Oleksii Kutniashenko

    The purpose of the paper is to substantiate possible ways to improve microclimatic conditions at workplaces in deep coal mines by controlling air moisture content. To improve the microclimatic conditions at underground workplaces, the authors propose a unit for dehumidification of air in a blind mine working, which is designed to remove moisture contained in mine air in the form of steam. The results of the calculations showed that by air dehumidification in a blind working, which is supplied by a local ventilation unit at a temperature of 24°C, and then cooled below the dew point and supplied to the face at a temperature of 20°C, the microclimatic index Humidex decreases from a dangerous level of 37.66 to a comfortable level of 12.5. The proposed method of normalising the working conditions of miners in deep mines, with an integrated approach that includes temperature conditioning with simultaneous extraction of high-quality water, as well as facilitating the ventilation regime in mine workings, provides significant benefits in terms of industrial sanitation, technology, and economics.