Changle Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Changle Wang has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
- Kaiming Zhou
Aston Institute of Photonic Technologies, Aston University, Birmingham, U.K.
3 shared publications - Lin Zhang
Aston Institute of Photonic Technologies (AIPT), Aston University, Birmingham B4 7ET, UK
3 shared publications David J. Webb
Aston Institute of Photonic Technologies, Aston University, Aston Triangle, Birmingham B47ET, UK
2 shared publicationsRonald Neal
Dept of Maths and Computing, Faculty of Science and Technology, University of Plymouth, Plymouth PL4 8AA, UK
2 shared publications- Yunhe Zhao
Institute of Logistics Science and Engineering, Shanghai Maritime University, Shanghai 201306, China
2 shared publications Anna V. Hine
School of Life and Health Sciences, Aston University, Aston Triangle, Birmingham B47ET, UK
1 shared publication
Latest Publications
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (16) , 25763-25768
Fiber Specklegram Sensor Based on Reflective Mode Rotation in Few-Mode Fiber
In this paper, a fiber specklegram sensor is formed from reflective mode rotation in few-mode fiber (FMF) with tilted fiber Bragg gratings (TFBG). The FMF-TFBG with different tilt angles have been fabricated, and could realize the high-efficient reflective mode conversion from fundamental mode to high-order core modes (LP 11 , LP 21 , LP 02 , LP 31 , and LP 12 modes) simultaneously when the tilt angle is 1.6°. With the twist induced in FMF-TFBG, the recorded LP 11 , LP 21 and LP 31 mode specklegram rotated with fiber twisting. The specklegrams rotation angle are detected using speeded-up robust feature algorithm combined with Canny edge detection algorithm to improve the accuracy. When fiber twist angle changes from −300° to 300°, the specklegram rotation angle of LP 11 , LP 21 and LP 31 mode is linearly related to fiber twist angle, with linearity of 0.515, 0.544 and 0.528, respectively. Therefore, the proposed mode rotation from FMF-TFBG with advantages of low cost, high accuracy and excellent performances, could give rise a new generation of fiber specklegram sensor.
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 24 (16) , 25763-25768
Fiber Specklegram Sensor Based on Reflective Mode Rotation in Few-Mode Fiber
In this paper, a fiber specklegram sensor is formed from reflective mode rotation in few-mode fiber (FMF) with tilted fiber Bragg gratings (TFBG). The FMF-TFBG with different tilt angles have been fabricated, and could realize the high-efficient reflective mode conversion from fundamental mode to high-order core modes (LP 11 , LP 21 , LP 02 , LP 31 , and LP 12 modes) simultaneously when the tilt angle is 1.6°. With the twist induced in FMF-TFBG, the recorded LP 11 , LP 21 and LP 31 mode specklegram rotated with fiber twisting. The specklegrams rotation angle are detected using speeded-up robust feature algorithm combined with Canny edge detection algorithm to improve the accuracy. When fiber twist angle changes from −300° to 300°, the specklegram rotation angle of LP 11 , LP 21 and LP 31 mode is linearly related to fiber twist angle, with linearity of 0.515, 0.544 and 0.528, respectively. Therefore, the proposed mode rotation from FMF-TFBG with advantages of low cost, high accuracy and excellent performances, could give rise a new generation of fiber specklegram sensor.
- Open Access
- 1 June 2019
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 135, 102-110
An ultra-sensitive aptasensor on optical fibre for the direct detection of bisphenol A
- 1 June 2019
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 135, 102-110
Open AccessAn ultra-sensitive aptasensor on optical fibre for the direct detection of bisphenol A
- Open Access
- 20 April 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (4) , 643
Carbon Nanotube Mode-Locked Fiber Laser Generating Cylindrical Vector Beams with a Two-Mode Fiber Bragg Grating
We propose and demonstrate a compact all-fiber laser generating cylindrical vector beam (CVB) using carbon nanotubes as the saturable absorber for mode-locking and a two-mode fiber Bragg grating (TM-FBG) as the mode discriminator. Both radially and azimuthally polarized beams with a polarization purity of 90% were obtained by simply adjusting the polarization controllers. The CVB mode-locked fiber laser operates at 1552.9 nm with a 3-dB line width of less than 0.02 nm, generating ns CVB pulses. The all-fiber CVB laser may have potential applications from fundamental research to practical applications, such as particle capture, high-resolution measurement and material processing.
- 20 April 2018
- Published by MDPI AG in Applied Sciences
- Vol. 8 (4) , 643
Open AccessCarbon Nanotube Mode-Locked Fiber Laser Generating Cylindrical Vector Beams with a Two-Mode Fiber Bragg Grating
We propose and demonstrate a compact all-fiber laser generating cylindrical vector beam (CVB) using carbon nanotubes as the saturable absorber for mode-locking and a two-mode fiber Bragg grating (TM-FBG) as the mode discriminator. Both radially and azimuthally polarized beams with a polarization purity of 90% were obtained by simply adjusting the polarization controllers. The CVB mode-locked fiber laser operates at 1552.9 nm with a 3-dB line width of less than 0.02 nm, generating ns CVB pulses. The all-fiber CVB laser may have potential applications from fundamental research to practical applications, such as particle capture, high-resolution measurement and material processing.
- Open Access
- 1 January 2018
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 269, 545-555
Laser-sculpted hybrid photonic magnetometer with nanoscale magnetostrictive interaction
- 1 January 2018
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 269, 545-555
Open AccessLaser-sculpted hybrid photonic magnetometer with nanoscale magnetostrictive interaction
- 24 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (3) , 742-747
In-Line Mach-Zehnder Interferometer With D-Shaped Fiber Grating for Temperature-Discriminated Directional Curvature Measurement
A high-sensitivity curvature sensing configuration is implemented by using a fiber Mach-Zehnder interferometer (MZI) with D-shaped fiber Bragg grating (FBG). A segment of D-shaped fiber is fusion spliced into a single mode fiber at both sides, and then a short FBG is inscribed in the D-shaped fiber. The fiber device yields a significant spectrum sensitivity as high as 87.7 nm/m$^-1$ to the ultra-low curvature range from 0 to 0.3 m$^-1$, and can distinguish the orientation of curvature experienced by the fiber as the attenuation dip producing either a blue or red wavelength shift, by virtue of the asymmetry of D-shaped fiber cladding. In addition, by tracking both resonant wavelengths of the MZI and embedded FBG, the temperature and curvature can be measured simultaneously.
- 24 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (3) , 742-747
In-Line Mach-Zehnder Interferometer With D-Shaped Fiber Grating for Temperature-Discriminated Directional Curvature Measurement
A high-sensitivity curvature sensing configuration is implemented by using a fiber Mach-Zehnder interferometer (MZI) with D-shaped fiber Bragg grating (FBG). A segment of D-shaped fiber is fusion spliced into a single mode fiber at both sides, and then a short FBG is inscribed in the D-shaped fiber. The fiber device yields a significant spectrum sensitivity as high as 87.7 nm/m$^-1$ to the ultra-low curvature range from 0 to 0.3 m$^-1$, and can distinguish the orientation of curvature experienced by the fiber as the attenuation dip producing either a blue or red wavelength shift, by virtue of the asymmetry of D-shaped fiber cladding. In addition, by tracking both resonant wavelengths of the MZI and embedded FBG, the temperature and curvature can be measured simultaneously.
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
A dual-parameter active fibre sensor based on modal interference in few-mode fibres
We propose a dual-parameter active fibre sensor based on a fibre ring laser using a single-mode-two-mode-single-mode (STS) fibre interferemeter and a four-mode FBG as the intracavity dual-parameter sensing element. The interferometric spectra of the STS are investigated with different core-offset parameters and few-mode fibre length. The highest LP11 mode excitation ratio is achieved with a 6μm core-offset distance in the STS which achieves best sensing ability. High precision dual-parameter sensing of pressure and tension are achieved experimentally by measurements of fibre laser output wavelength and intensity.
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
A dual-parameter active fibre sensor based on modal interference in few-mode fibres
We propose a dual-parameter active fibre sensor based on a fibre ring laser using a single-mode-two-mode-single-mode (STS) fibre interferemeter and a four-mode FBG as the intracavity dual-parameter sensing element. The interferometric spectra of the STS are investigated with different core-offset parameters and few-mode fibre length. The highest LP11 mode excitation ratio is achieved with a 6μm core-offset distance in the STS which achieves best sensing ability. High precision dual-parameter sensing of pressure and tension are achieved experimentally by measurements of fibre laser output wavelength and intensity.
- Open Access
- 25 May 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (11) , 12107-12115
Theoretical and experimental analysis of excessively tilted fiber gratings
We have theoretically and experimentally investigated the dual-peak feature of tilted fiber gratings with excessively tilted structure (named as Ex-TFGs). We have explained the dual-peak feature by solving eigenvalue equations for TM0m and TE0m of a circular waveguide, in which the TE (transverse electric) and TM (transverse magnetic) core modes are coupled into TE and TM cladding modes, respectively. Meanwhile, in the experiment, we have verified that one of the dual peaks at the shorter wavelength is due to the TM mode coupling whereas the other one at the longer wavelength arises from TE mode coupling when a linearly polarized light launched into the Ex-TFG. We have also investigated the peak separation of TE and TM cladding mode for different surrounding medium refractive indexes (SRI), revealed that the dual peaks separation is decreasing as increasing of SRI, which agrees very well with the theoretical analysis results.
- 25 May 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (11) , 12107-12115
Open AccessTheoretical and experimental analysis of excessively tilted fiber gratings
We have theoretically and experimentally investigated the dual-peak feature of tilted fiber gratings with excessively tilted structure (named as Ex-TFGs). We have explained the dual-peak feature by solving eigenvalue equations for TM0m and TE0m of a circular waveguide, in which the TE (transverse electric) and TM (transverse magnetic) core modes are coupled into TE and TM cladding modes, respectively. Meanwhile, in the experiment, we have verified that one of the dual peaks at the shorter wavelength is due to the TM mode coupling whereas the other one at the longer wavelength arises from TE mode coupling when a linearly polarized light launched into the Ex-TFG. We have also investigated the peak separation of TE and TM cladding mode for different surrounding medium refractive indexes (SRI), revealed that the dual peaks separation is decreasing as increasing of SRI, which agrees very well with the theoretical analysis results.