Hsin-Chiao Daniel Ou-Yang

In this chapter, we review the applications of optical coherence tomography (OCT) on the nondestructive characterization of the drying processes of colloidal droplets and latex coatings. Employing time-lapse, high-speed imaging, OCT can be used to monitor the dynamic process of drying colloidal droplets. With the aid of high-scattering, micron-sized tracer particles, fluid flows have been captured; phase boundaries are also visible in liquid crystal droplets; and the speckle contrast analysis differentiates the dynamics of particles, showing the packing process and the coffee ring phenomenon. In a waterborne latex coat, time-lapse OCT imaging reveals spatial changes of microstructures, i.e., detachment of latex, cracks, and shear bands; with speckle contrast analysis, 1D and 2D particles’ packing process that is initiated from latex/air interface can also be monitored over time. OCT can serve as an experimental platform for fundamental studies of drying colloidal systems. In the future, OCT can also be employed as an in-line quality control tool of polymer coatings and paints for industrial applications.

Living cells are known to be in thermodynamically nonequilibrium, which is largely brought about by intracellular molecular motors. The motors consume chemical energies to generate stresses and reorganize the cytoskeleton for the cell to move and divide. However, since there has been a lack of direct measurements characterizing intracellular stresses, questions remained unanswered on the intricacies of how cells use such stresses to regulate their internal mechanical integrity in different microenvironments. This report describes a new experimental approach by which we reveal an environmental rigidity-dependent intracellular stiffness that increases with intracellular stress - a revelation obtained, surprisingly, from a correlation between the fluctuations in cellular stiffness and that of intracellular stresses. More surprisingly, by varying two distinct parameters, environmental rigidity and motor protein activities, we observe that the stiffness-stress relationship follows the same curve. This finding provides some insight into the intricacies by suggesting that cells can regulate their responses to their mechanical microenvironment by adjusting their intracellular stress.

The ability to manipulate and control active microparticles is essential for designing microrobots for applications. This paper describes the use of electric and magnetic fields to control the direction and speed of induced-charge electrophoresis (ICEP) driven metallic Janus microrobots. A direct current (DC) magnetic field applied in the direction perpendicular to the electric field maintains the linear movement of particles in a 2D plane. Phoretic force spectroscopy (PFS), a phase-sensitive detection method to detect the motions of phoretic particles, is used to characterize the frequency-dependent phoretic mobility and drag coefficient of the phoretic force. When the electric field is scanned over a frequency range of 1 kHz–1 MHz, the Janus particles exhibit an ICEP direction reversal at a crossover frequency at ~30 kH., Below this crossover frequency, the particle moves in a direction towards the dielectric side of the particle, and above this frequency, the particle moves towards the metallic side. The ICEP phoretic drag coefficient measured by PFS is found to be similar to that of the Stokes drag. Further investigation is required to study microscopic interpretations of the frequency at which ICEP mobility switched signs and the reason why the magnitudes of the forward and reversed modes of ICEP are so different.

We measured the intrinsic electrophoretic drag coefficient of a single charged particle by optically trapping the particle and applying an AC electric field, and found it to be markedly different from that of the Stokes drag. The drag coefficient, along with the measured electrical force, yield a mobility-zeta potential relation that agrees with the literature. By using the measured mobility as input, numerical calculations based on the Poisson–Nernst–Planck equations, coupled to the Navier–Stokes equation, reveal an intriguing microscopic electroosmotic flow near the particle surface, with a well-defined transition between an inner flow field and an outer flow field in the vicinity of electric double layer’s outer boundary. This distinctive interface delineates the surface that gives the correct drag coefficient and the effective electric charge. The consistency between experiments and theoretical predictions provides new insights into the classic electrophoresis problem, and can shed light on new applications of electrophoresis to investigate biological nanoparticles.

We demonstrate wavelength-independent optical limiting based on colloidal phase transitions induced by the dielectrophoretic force from focused electromagnetic radiation. The focused radiation acts as an optical trap that increases the particle density. The increased density then leads to a colloidal gas-solid phase transition and an aggregate that effectively blocks the incoming radiation when it passes a threshold power. The process is reversible, with the colloidal particles returning to a homogenous distribution after the incoming radiation is removed. We demonstrate the effect using polystyrene nanoparticles mixed with pluronics and polyethylene glycol polymers in low-concentration KCl salt solutions. We observe the light-induced phase separation under confocal fluorescent microscope, and we provide a proof-of-principle demonstration of optical limiting using a 100 μm thick colloid cell.

Latex, an aqueous dispersion of sub-micron polymer particles, is widely used as polymer binder in waterborne coatings and adhesives. Drying of a latex is inhomogeneous, during which the spatial distribution of particles is non-uniform and changes with time, usually resulting in a compromise of the integrity of a dried film. To study drying inhomogeneity of latex, we developed a system integrating optical coherence tomography (OCT) with gravimetric and video analysis (OCT-Gravimetry-Video method) to non-destructively monitor the drying process of non-film-forming latexes consisting of hard polystyrene spheres over time. OCT structural and speckle images of the latex’s internal structure show the packing process of particles, the detachment of latex and the formation of apparent shear bands in cross-sectional views. Video recordings show the formation of cracks and the propagation of the drying boundary in the horizontal direction. The drying curve, measured by gravimetry, shows the drying rate and the water content of the latex at each drying stage. Furthermore, we find that the particle size affects packing and cracking phenomena remarkably. The OCT-Gravimetry-Video method serves as a general and robust approach to investigate the drying process of waterborne latex system. This method can be employed for fundamental studies of colloids and for evaluations of industrial latex products.

An optical binding force between two nearby colloidal particles trapped by two coherent laser beams is measured by phase-sensitive detection. The binding force is long-range and spatially oscillatory. For identical linearly-polarized incident beams, the oscillation period is equal to the optical wavelength. For mutually perpendicular polarizations, a new force appears with half-wavelength periodicity, caused by double inter-particle scattering. This force is observable only with cross-polarized incident beams, for which the stronger single-scattering forces are forbidden by parity.