Einat Strumza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Einat Strumza has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Shmuel Hayun
Department of Materials Engineering, Ben-Gurion University of the Negev, Beer-Sheva, Israel
3 shared publications - Alexandra Navrotsky
Arizona State University
2 shared publications - Kristina Lilova
Peter A. Rock Thermochemistry Laboratory and NEAT ORU, University of California Davis, Davis, USA
2 shared publications - Tamilarasan Subramani
School of Molecular Sciences and Center for Materials of the Universe, Arizona State University, Tempe, Arizona 85287, United States
2 shared publications - Ori Yeheskel
Materials Consultant, P.O. Box 7010, Shoham 6081668, Israel
1 shared publication - Roey Ben David
Department of Chemical and Biological Physics, Weizmann Institute of Science, 234 Herzl Street, Rehovot 76100, Israel
1 shared publication
Latest Publications
- 23 July 2026
- Published by Elsevier in Acta Materialia
- Vol. 317
From heat capacity to Gibbs energy: An experimental thermodynamic route for single-phase high-entropy alloys
- 23 July 2026
- Published by Elsevier in Acta Materialia
- Vol. 317
From heat capacity to Gibbs energy: An experimental thermodynamic route for single-phase high-entropy alloys
- Open Access
- 24 February 2026
- Published by Elsevier in SSRN Electronic Journal
From Heat Capacity to Gibbs Free Energy: An Experimental Thermodynamic Route for Single-Phase High-Entropy Alloys
A comprehensive experimental methodology is developed to determine thermodynamic functions of single-phase AlₓCoCrFeNi high-entropy alloys (HEAs). The approach integrates calorimetry, thermophysical measurements, and physically based entropy models. Low-temperature heat capacity, Cp(T), was measured from 4 to 473 K, while high-temperature Cp(T) was obtained near the solidus. Controlled interpolation enables construction of metastable Cp(T) curves across decomposition regions. The enthalpy of formation at 298 K was determined using high-temperature oxide melt solution calorimetry and combined with Cp(T) to derive temperature-dependent enthalpies, H(T). Configurational entropy for the FCC phase was calculated using ideal-solution theory, whereas B2 phases entropies were estimated from sublattice occupancies predicted by CALPHAD (TCHEA4 database), due to the lack of experimental techniques for site-specific composition measurements. Thermal entropy was obtained by integrating Cp(T)/T. These components were combined to generate Gibbs free energy functions, G(T), for each alloy. For B2 alloys, experimentally derived G(T) curves agree well with TCHEA4 predictions over a broad temperature range. In contrast, the FCC alloy exhibits notable discrepancies, reflecting anomalies in Cp(T) and uncertainties in entropy contributions. This work establishes an experimentally grounded framework for constructing G(T) functions in complex alloys, providing critical benchmarks for CALPHAD database development and validation.
- 24 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessFrom Heat Capacity to Gibbs Free Energy: An Experimental Thermodynamic Route for Single-Phase High-Entropy Alloys
A comprehensive experimental methodology is developed to determine thermodynamic functions of single-phase AlₓCoCrFeNi high-entropy alloys (HEAs). The approach integrates calorimetry, thermophysical measurements, and physically based entropy models. Low-temperature heat capacity, Cp(T), was measured from 4 to 473 K, while high-temperature Cp(T) was obtained near the solidus. Controlled interpolation enables construction of metastable Cp(T) curves across decomposition regions. The enthalpy of formation at 298 K was determined using high-temperature oxide melt solution calorimetry and combined with Cp(T) to derive temperature-dependent enthalpies, H(T). Configurational entropy for the FCC phase was calculated using ideal-solution theory, whereas B2 phases entropies were estimated from sublattice occupancies predicted by CALPHAD (TCHEA4 database), due to the lack of experimental techniques for site-specific composition measurements. Thermal entropy was obtained by integrating Cp(T)/T. These components were combined to generate Gibbs free energy functions, G(T), for each alloy. For B2 alloys, experimentally derived G(T) curves agree well with TCHEA4 predictions over a broad temperature range. In contrast, the FCC alloy exhibits notable discrepancies, reflecting anomalies in Cp(T) and uncertainties in entropy contributions. This work establishes an experimentally grounded framework for constructing G(T) functions in complex alloys, providing critical benchmarks for CALPHAD database development and validation.
- 1 March 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 856
Comprehensive study of phase transitions in equiatomic AlCoCrFeNi high-entropy alloy
- 1 March 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 856
Comprehensive study of phase transitions in equiatomic AlCoCrFeNi high-entropy alloy
- 26 February 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (11) , 8665-8674
In situ detection of thermally induced porosity in additively manufactured and sintered objects
- 26 February 2019
- Published by Springer Nature in Journal of Materials Science
- Vol. 54 (11) , 8665-8674
In situ detection of thermally induced porosity in additively manufactured and sintered objects