Jianjin Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jianjin Yang has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
Shengyang Zhu
9 shared publicationsWanming Zhai
8 shared publications- Wanming Zhai
Southwest Jiaotong University
5 shared publications Xiaoan Zhang
School of Mechanical Engineering, Lanzhou Jiaotong University, Lanzhou, China
4 shared publications- Shengyang Zhu
Southwest Jiaotong University
3 shared publications - Georges Kouroussis
Université de Mons
2 shared publications
Latest Publications
- 27 August 2026
- Published by Taylor & Francis in International Journal of Rail Transportation
- p. 1-41
The nonlinear dynamic behaviours and modelling of polymer elements in railway tracks: a state-of-the-art review
1. As an efficient, reliable, and high-capacity mode of transportation, railway systems are undergoing continuous development towards higher speeds and heavier loads. However, the increases in trai...
- 27 August 2026
- Published by Taylor & Francis in International Journal of Rail Transportation
- p. 1-41
The nonlinear dynamic behaviours and modelling of polymer elements in railway tracks: a state-of-the-art review
1. As an efficient, reliable, and high-capacity mode of transportation, railway systems are undergoing continuous development towards higher speeds and heavier loads. However, the increases in trai...
- 20 May 2026
- Published by World Scientific Pub Co Pte Ltd in International Journal of Structural Stability and Dynamics
Design and Experiment of a Railway Noise Barrier Based on the Phononic Crystals
The increasing operating speeds and service frequencies of rail transit systems have posed unprecedented challenges to the acoustic environmental quality adjacent to railway alignments. Noise barriers, as the most effective solution for mitigating rail transit noise, currently represent the predominant noise reduction measure in this field. However, the continuous enhancement of noise control requirements along railways has revealed the inherent limitations of traditional noise barriers, which exhibit diminishing potential for further acoustic performance improvements. Phononic crystals exhibit distinctive band gap properties that enable superior suppression of acoustic waves within their forbidden bands. The application of these materials in rail transit noise control could solve the existing noise mitigation challenges. Moreover, rail transit systems impose stringent installation requirements for ancillary equipment. Consequently, this study develops a novel phononic crystal noise barrier design featuring bi-periodic cross-shaped unit cells, while incorporating the shape characteristics of traditional noise barriers. The effectiveness and applicability of the proposed design have been verified through theoretical and experimental studies.
- 20 May 2026
- Published by World Scientific Pub Co Pte Ltd in International Journal of Structural Stability and Dynamics
Design and Experiment of a Railway Noise Barrier Based on the Phononic Crystals
The increasing operating speeds and service frequencies of rail transit systems have posed unprecedented challenges to the acoustic environmental quality adjacent to railway alignments. Noise barriers, as the most effective solution for mitigating rail transit noise, currently represent the predominant noise reduction measure in this field. However, the continuous enhancement of noise control requirements along railways has revealed the inherent limitations of traditional noise barriers, which exhibit diminishing potential for further acoustic performance improvements. Phononic crystals exhibit distinctive band gap properties that enable superior suppression of acoustic waves within their forbidden bands. The application of these materials in rail transit noise control could solve the existing noise mitigation challenges. Moreover, rail transit systems impose stringent installation requirements for ancillary equipment. Consequently, this study develops a novel phononic crystal noise barrier design featuring bi-periodic cross-shaped unit cells, while incorporating the shape characteristics of traditional noise barriers. The effectiveness and applicability of the proposed design have been verified through theoretical and experimental studies.
- 26 December 2024
- Published by Elsevier in Computers and Geotechnics
- Vol. 179
A 3D train-track-tunnel-soil coupled dynamics model based on semi-analytical cylindrical layer element
- 26 December 2024
- Published by Elsevier in Computers and Geotechnics
- Vol. 179
A 3D train-track-tunnel-soil coupled dynamics model based on semi-analytical cylindrical layer element
- 13 December 2024
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 140
A spatial train-track-tunnel coupled dynamics model for assessing influences of curved railway line on circular tunnel vibrations
- 13 December 2024
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 140
A spatial train-track-tunnel coupled dynamics model for assessing influences of curved railway line on circular tunnel vibrations
- Open Access
- 13 July 2024
- Published by Springer Nature in Railway Engineering Science
- Vol. 32 (4) , 518-532
Noise reduction mechanism of high-speed railway box-girder bridges installed with MTMDs on top plate
The issue of low-frequency structural noise radiated from high-speed railway (HSR) box-girder bridges (BGBs) is a significant challenge worldwide. Although it is known that vibrations in BGBs caused by moving trains can be reduced by installing multiple tuned mass dampers (MTMDs) on the top plate, there is limited research on the noise reduction achieved by this method. This study aims to investigate the noise reduction mechanism of BGBs installed with MTMDs on the top plate. A sound radiation prediction model for the BGB installed with MTMDs is developed, based on the vehicle–track–bridge coupled dynamics and acoustics boundary element method. After being verified by field tested results, the prediction model is employed to study the reduction of vibration and noise of BGBs caused by the MTMDs. It is found that installing MTMDs on top plate can significantly affect the vibration distribution and sound radiation law of BGBs. However, its impact on the sound radiation caused by vibrations dominated by the global modes of BGBs is minimal. The noise reduction achieved by MTMDs is mainly through changing the acoustic radiation contributions of each plate of the bridge. In the lower frequency range, the noise reduction of BGB caused by MTMDs can be more effective if the installation of MTMDs can modify the vibration frequency and distribution of the BGB to avoid the influence of small vibrations and disperse the sound radiation from each plate.
- 13 July 2024
- Published by Springer Nature in Railway Engineering Science
- Vol. 32 (4) , 518-532
Open AccessNoise reduction mechanism of high-speed railway box-girder bridges installed with MTMDs on top plate
The issue of low-frequency structural noise radiated from high-speed railway (HSR) box-girder bridges (BGBs) is a significant challenge worldwide. Although it is known that vibrations in BGBs caused by moving trains can be reduced by installing multiple tuned mass dampers (MTMDs) on the top plate, there is limited research on the noise reduction achieved by this method. This study aims to investigate the noise reduction mechanism of BGBs installed with MTMDs on the top plate. A sound radiation prediction model for the BGB installed with MTMDs is developed, based on the vehicle–track–bridge coupled dynamics and acoustics boundary element method. After being verified by field tested results, the prediction model is employed to study the reduction of vibration and noise of BGBs caused by the MTMDs. It is found that installing MTMDs on top plate can significantly affect the vibration distribution and sound radiation law of BGBs. However, its impact on the sound radiation caused by vibrations dominated by the global modes of BGBs is minimal. The noise reduction achieved by MTMDs is mainly through changing the acoustic radiation contributions of each plate of the bridge. In the lower frequency range, the noise reduction of BGB caused by MTMDs can be more effective if the installation of MTMDs can modify the vibration frequency and distribution of the BGB to avoid the influence of small vibrations and disperse the sound radiation from each plate.
- 24 June 2024
- Published by World Scientific Pub Co Pte Ltd in International Journal of Structural Stability and Dynamics
- Vol. 25 (13)
Characteristics and Mechanism of Sound Radiation of Urban Railway Bridge Installed with Sound Barrier
In noise-sensitive areas of urban rail transit (URT), sound barriers are often used to block the propagation of on-track noise such as the wheel–rail noise. However, the vibrations induced by passing trains can also transmit to the sound barriers. Therefore, it is necessary to study the acoustic radiation characteristics of the sound barrier under moving train loads and to evaluate whether installing sound barriers will affect the overall low-frequency noise radiation from the elevated railway. In this paper, the train–track–bridge dynamic interaction theory is adopted to establish a dynamics model for train–track–bridge-sound barrier coupled system, and the acoustic theory is employed to establish acoustic boundary element models for sound barrier, box girder bridge and sound barrier-box girder bridge coupled system, respectively. These models are then used to systematically analyze the characteristics and mechanism of vibrational noise of the sound barrier due to passing trains. The effects of sound barrier on the acoustic environment are also evaluated. Finally, the influencing mechanism of sound barrier on low-frequency acoustic radiation of elevated railway is investigated, and suggestions for future research on low-frequency acoustic radiation of elevated railway are presented. The research results show that the sound barrier can become a significant low-frequency sound source during the trains passing. Installing sound barriers on elevated railway affects the sound environment around the railway mainly through acoustic effects on the noise propagation. The installation of sound barriers has an effect on the vibration characteristics of the box girder bridge. In order to explore the characteristics of low-frequency sound radiation of elevated railways installed with sound barriers, it is necessary to reanalyze the acoustic generation mechanism of the entire structure of the bridge-sound barriers coupled system and combine it with the propagation mechanism of various sound sources.
- 24 June 2024
- Published by World Scientific Pub Co Pte Ltd in International Journal of Structural Stability and Dynamics
- Vol. 25 (13)
Characteristics and Mechanism of Sound Radiation of Urban Railway Bridge Installed with Sound Barrier
In noise-sensitive areas of urban rail transit (URT), sound barriers are often used to block the propagation of on-track noise such as the wheel–rail noise. However, the vibrations induced by passing trains can also transmit to the sound barriers. Therefore, it is necessary to study the acoustic radiation characteristics of the sound barrier under moving train loads and to evaluate whether installing sound barriers will affect the overall low-frequency noise radiation from the elevated railway. In this paper, the train–track–bridge dynamic interaction theory is adopted to establish a dynamics model for train–track–bridge-sound barrier coupled system, and the acoustic theory is employed to establish acoustic boundary element models for sound barrier, box girder bridge and sound barrier-box girder bridge coupled system, respectively. These models are then used to systematically analyze the characteristics and mechanism of vibrational noise of the sound barrier due to passing trains. The effects of sound barrier on the acoustic environment are also evaluated. Finally, the influencing mechanism of sound barrier on low-frequency acoustic radiation of elevated railway is investigated, and suggestions for future research on low-frequency acoustic radiation of elevated railway are presented. The research results show that the sound barrier can become a significant low-frequency sound source during the trains passing. Installing sound barriers on elevated railway affects the sound environment around the railway mainly through acoustic effects on the noise propagation. The installation of sound barriers has an effect on the vibration characteristics of the box girder bridge. In order to explore the characteristics of low-frequency sound radiation of elevated railways installed with sound barriers, it is necessary to reanalyze the acoustic generation mechanism of the entire structure of the bridge-sound barriers coupled system and combine it with the propagation mechanism of various sound sources.
- 8 September 2023
- Published by Elsevier in Structures
- Vol. 57
Mechanism of noise reduction caused by thickening top plate for high-speed railway box-girder bridge
- 8 September 2023
- Published by Elsevier in Structures
- Vol. 57
Mechanism of noise reduction caused by thickening top plate for high-speed railway box-girder bridge
- 8 April 2020
- Published by Springer Nature
- p. 653-666
Analyses of Metro Train-Induced Vibration of Building Above Subway Tunnel
- 8 April 2020
- Published by Springer Nature
- p. 653-666
Analyses of Metro Train-Induced Vibration of Building Above Subway Tunnel