Vinícius Rückert Roso
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Vinícius Rückert Roso has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Carlos Eduardo Castilla Alvarez
Department of Mechanical Engineering, Post-Graduate Program in Environmental Engineering, Federal University of Lavras (Universidade Federal de Lavras/UFLA), Lavras, Brazil
10 shared publications Ramon Molina Valle
Universidade Federal de Minas Gerais
9 shared publicationsNathália Duarte Souza Alvarenga Santos
Universidade Federal de Minas Gerais
7 shared publications- Mario Eduardo Santos Martins
Federal University of Santa Maria, Santa Maria, Brazil
4 shared publications - Antonio García
Universitat Politècnica de València
3 shared publications - Javier Monsalve-Serrano
Universitat Politècnica de València
3 shared publications
Latest Publications
- 21 June 2022
- Published by Elsevier in Expert Systems with Applications
- Vol. 207
Optimum fuzzy logic controller applied to a hybrid hydraulic vehicle to minimize fuel consumption and emissions
- 21 June 2022
- Published by Elsevier in Expert Systems with Applications
- Vol. 207
Optimum fuzzy logic controller applied to a hybrid hydraulic vehicle to minimize fuel consumption and emissions
- 1 January 2021
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 135
Effects of gasoline composition on engine performance, exhaust gases and operational costs
- 1 January 2021
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 135
Effects of gasoline composition on engine performance, exhaust gases and operational costs
- 1 May 2020
- Published by Elsevier in Renewable Energy
- Vol. 150, 58-77
Potential of bio-ethanol in different advanced combustion modes for hybrid passenger vehicles
- 1 May 2020
- Published by Elsevier in Renewable Energy
- Vol. 150, 58-77
Potential of bio-ethanol in different advanced combustion modes for hybrid passenger vehicles
- 13 January 2020
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Exhaust Emission Analysis of a Spark Ignition Engine Operating with Hydrogen Injection in a Pre-Combustion Chamber
Due to the large negative impact of combustion gas emissions on air quality and the more stringent environmental legislation, research on internal combustion engines (ICE) are being developed to reduce emissions of pollutant gases to the atmosphere. One of the research fronts is the use of lean mixtures with the pre-chamber ignition system (PCIS). This system consists of a pre-chamber (PC) connected to the main chamber by one or more interconnecting holes. A spark plug initiates combustion of the mixture present in the pre-chamber, which is propagated as gas jet into the main chamber, igniting the lean mixture present therein. The gas jets have high thermal and kinetic energy, which promote faster combustion duration, making the system less prone to knock and with lower cyclic variability of the IMEP, enabling the lean limit extension. The pre-chamber system can be assisted with a supplementary liquid or gaseous fuel injection, enabling the charge stratification. In this context, this paper aims to evaluate the reduction in exhaust emissions from an ICE adapted with a stratified PCIS operating with lean mixture (ethanol-air) in the main chamber and hydrogen injected directly into the pre-chamber. The tests were carried out on a Ford Sigma 1.6L engine operating at 2250 rpm and under an indicated effective mean pressure of 5bar. It was possible to identify that with the use of the pre-chamber ignition system, the lean limit of the mixture was extended to lambda 1.7 with low cyclic variability of the IMEP. If compared to the baseline engine, the PCIS prototype operating with lambda 1.7 showed reduction in volumetric exhaust emissions of 98.4% for NOx, 35.3% for HC, 69.9% for CO and 46.2% for CO2. These results allow to conclude that the use of PCIS to burn lean mixtures can promote significant reductions in exhaust gases emissions to the atmosphere.
- 13 January 2020
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Exhaust Emission Analysis of a Spark Ignition Engine Operating with Hydrogen Injection in a Pre-Combustion Chamber
Due to the large negative impact of combustion gas emissions on air quality and the more stringent environmental legislation, research on internal combustion engines (ICE) are being developed to reduce emissions of pollutant gases to the atmosphere. One of the research fronts is the use of lean mixtures with the pre-chamber ignition system (PCIS). This system consists of a pre-chamber (PC) connected to the main chamber by one or more interconnecting holes. A spark plug initiates combustion of the mixture present in the pre-chamber, which is propagated as gas jet into the main chamber, igniting the lean mixture present therein. The gas jets have high thermal and kinetic energy, which promote faster combustion duration, making the system less prone to knock and with lower cyclic variability of the IMEP, enabling the lean limit extension. The pre-chamber system can be assisted with a supplementary liquid or gaseous fuel injection, enabling the charge stratification. In this context, this paper aims to evaluate the reduction in exhaust emissions from an ICE adapted with a stratified PCIS operating with lean mixture (ethanol-air) in the main chamber and hydrogen injected directly into the pre-chamber. The tests were carried out on a Ford Sigma 1.6L engine operating at 2250 rpm and under an indicated effective mean pressure of 5bar. It was possible to identify that with the use of the pre-chamber ignition system, the lean limit of the mixture was extended to lambda 1.7 with low cyclic variability of the IMEP. If compared to the baseline engine, the PCIS prototype operating with lambda 1.7 showed reduction in volumetric exhaust emissions of 98.4% for NOx, 35.3% for HC, 69.9% for CO and 46.2% for CO2. These results allow to conclude that the use of PCIS to burn lean mixtures can promote significant reductions in exhaust gases emissions to the atmosphere.
- 13 January 2020
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Effects of operation temperature on exhaust emissions in a spark ignition system using pre-chamber stratified system
Atmospheric pollution is the major public health issue in many cities around the world. Internal combustion engines (ICE) and industries are common sources of pollutants that aggravate this situation. Aiming to overcome this problem, increasingly restrictive legislation on combustion pollutant emissions has been formulated and new technologies are being developed to ensure compliance with such restrictions. In this scenario, the lean mixtures appear as a possible alternative, but also bring some inconveniences such as combustion instabilities. Pre-chamber ignition systems (PCIS) enable a more stable combustion process due to high kinetic, thermal and chemical energy of the gases from the pre-chamber (PC), which pass through nozzles and begin the combustion process of the air-fuel mixture contained in the main combustion chamber (MC). However, some challenges still have to be overcome in the development of these systems, one of the main ones being hydrocarbon (HC) emissions. Therefore, the main goal of this investigation is to evaluate the effect of operating temperature on the pollutants emissions from an ICE with stratified pre-chamber ignition system (SPCIS) and to verify specifically the possibility of HC emissions reduction by raising the operating temperature. So, an ICE equipped with a SPCIS, operating with indirect injection of ethanol in the MC and direct injection of hydrogen in the PC, was tested under lean conditions of λ = 1.4, at 2250 rpm and indicated mean effective pressure of 5 bar. With the increase in the operating temperature of the ICE from 70 °C to 100 °C, were observed emission reductions in percentage volume of 42.4% for HC and 20.4% for CO, while NOx emissions increased in 33.7%. These results allow to conclude that the increase in operating temperature is a viable alternative to achieve lower HC emission with PCIS.
- 13 January 2020
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Effects of operation temperature on exhaust emissions in a spark ignition system using pre-chamber stratified system
Atmospheric pollution is the major public health issue in many cities around the world. Internal combustion engines (ICE) and industries are common sources of pollutants that aggravate this situation. Aiming to overcome this problem, increasingly restrictive legislation on combustion pollutant emissions has been formulated and new technologies are being developed to ensure compliance with such restrictions. In this scenario, the lean mixtures appear as a possible alternative, but also bring some inconveniences such as combustion instabilities. Pre-chamber ignition systems (PCIS) enable a more stable combustion process due to high kinetic, thermal and chemical energy of the gases from the pre-chamber (PC), which pass through nozzles and begin the combustion process of the air-fuel mixture contained in the main combustion chamber (MC). However, some challenges still have to be overcome in the development of these systems, one of the main ones being hydrocarbon (HC) emissions. Therefore, the main goal of this investigation is to evaluate the effect of operating temperature on the pollutants emissions from an ICE with stratified pre-chamber ignition system (SPCIS) and to verify specifically the possibility of HC emissions reduction by raising the operating temperature. So, an ICE equipped with a SPCIS, operating with indirect injection of ethanol in the MC and direct injection of hydrogen in the PC, was tested under lean conditions of λ = 1.4, at 2250 rpm and indicated mean effective pressure of 5 bar. With the increase in the operating temperature of the ICE from 70 °C to 100 °C, were observed emission reductions in percentage volume of 42.4% for HC and 20.4% for CO, while NOx emissions increased in 33.7%. These results allow to conclude that the increase in operating temperature is a viable alternative to achieve lower HC emission with PCIS.
- 1 January 2020
- Published by Elsevier in Engineering Failure Analysis
- Vol. 108
Review of engine journal bearing tribology in start-stop applications
- 1 January 2020
- Published by Elsevier in Engineering Failure Analysis
- Vol. 108
Review of engine journal bearing tribology in start-stop applications
- 1 November 2019
- Published by Elsevier in Applied Energy
- Vol. 254
Evaluation of a stratified prechamber ignition concept for vehicular applications in real world and standardized driving cycles
- 1 November 2019
- Published by Elsevier in Applied Energy
- Vol. 254
Evaluation of a stratified prechamber ignition concept for vehicular applications in real world and standardized driving cycles
- 1 September 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 160
Combustion analysis of a SI engine with stratified and homogeneous pre-chamber ignition system using ethanol and hydrogen
- 1 September 2019
- Published by Elsevier in Applied Thermal Engineering
- Vol. 160
Combustion analysis of a SI engine with stratified and homogeneous pre-chamber ignition system using ethanol and hydrogen