Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Lei Zhao has a total of 36 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Load transfer mechanisms in support ropes of flexible rockfall barriers: Geometrical relationships and transmission attenuation

    by Lei Zhao, Ding-Fu Zou, Xin Qi, Ping-Chuan Ma

    Support ropes of flexible barriers perform dual roles of establishing primary load-transfer pathways and providing attachment points for energy-dissipating devices. Due to the limitations of current measurement methodologies, rope force sensors are usually installed in rope ends, at where energy dissipating devices are also attached, to avoid movement interference with net or post end during large sliding process. The measured force value actually reflects the working force of the attached energy-dissipating device rather than the maximum internal force of the whole rope. To investigate the correlation between the measured force and the maximum internal force, a validated numerical model was employed to investigate the spatial distribution characteristics of internal force along support rope firstly. Second, the relationships between the internal force of upper and lower support ropes at both sides of the middle and border post ends were built based on geometrical relationships and equilibrium conditions, respectively. Subsequently, parametric simulations were carried out to study the effect of transmission attenuation, including the friction coefficient between support rope and post end, as well as transmission length represented by span number of flexible barriers. Finally, a variable named cable force ratio was defined and an applicable calculation formula was built comprehensively considering geometrical relationship and transmission attenuation. The results provides a basis for the optimum design of support ropes of flexible rockfall barriers.


  • Open Access

    Prediction method for the tension force of support ropes in flexible rockfall barriers based on full-scale experiments and numerical analysis

    by Xin Qi, Lei Zhao, Qing-Cheng Meng

    This paper proposes a prediction method for the tension force of support ropes in flexible rockfall barriers. The method is based on two full-scale model tests with an impact energy of 3000 kJ, as well as 36 set numerical models featuring varying lengths and impact energies. From the results of full scale tests and numerical models, it is inferred that the tension force at the end of the support rope is significantly less than that at the point of impact, exhibiting an approximate Gaussian attenuation distribution with propagation distance. To account for the attenuation of tensile forces in support ropes, a tensile attenuation coefficient is defined. Through comparative analysis of data obtained from 36 models with varying impact energies and propagation distances, the average attenuation coefficient for the upper support rope is determined to be approximately 0.7, while the average coefficient for the lower support rope is around 0.8. Utilizing the least squares method, a prediction method for the tension force of support ropes in flexible rockfall barriers is established. This method takes into account both the propagation distance and impact energy, enabling accurate predictions of the tensile behavior of the ropes under different conditions. This prediction model provides valuable insights for engineers in the design and optimization of these flexible barriers for rockfall mitigation.


  • Open Access

    Equivalent Relationship of the Mechanical Behavior of Ring Nets under Static Punching and Dynamic Impact Conditions

    by Xin Qi, Qianqian Deng, Lei Zhao, Song Yuan, Zhenliang Li, Xibao Wang, Zhixiang Yu

    To build the equivalent relationship of the mechanical behavior of ring nets under static punching and dynamic impact conditions, a series of tests with different parameters were conducted. The equivalent coefficients of breaking force, breaking displacement, and net energy dissipation were defined to describe the potential relationship. Besides, sensitivity analyses were made. The results showed that, with the increase of impact velocity, the equivalent coefficients of breaking force decreased as a power function, and the equivalent coefficients of breaking displacement and net energy dissipation both decreased linearly. As the ring diameter increased, the equivalent coefficients of breaking force increased linearly, but the equivalent coefficients of breaking displacement and net energy dissipation both decreased linearly. With the increase of the aspect ratio of ring net, the equivalent coefficients of breaking force and breaking displacement decreased linearly and exponentially, respectively, and the equivalent coefficients of net energy dissipation decreased as a power function. With the increase of the ratio of loading head area to ring net area, the equivalent coefficients of breaking force increased as a power function, and the equivalent coefficients of breaking displacement and net energy dissipation decreased and increased linearly, respectively. The influence degrees of these parameters are as follows: impact velocity > ring diameter > aspect ratio of ring net > ratio of loading area to ring net area. Based on these four parameters, the equivalent coefficient formulas of static punching and dynamic impact were established.


  • Open Access

    A Case Study on the Energy Capacity of a Flexible Rockfall Barrier in Resisting Landslide Debris

    by Lei Zhao, Lijun Zhang, Zhixiang Yu, Xin Qi, Hu Xu, Yifan Zhang

    Landslides frequently occur in forest areas with a steep hillside, especially when severely disturbed by human activities. After sustained heavy rainfall, a landslide occurred near the Tianwan tunnel entrance of the Chongqing-Huaihua railway in China. Fortunately, the landslide debris was successfully intercepted by a flexible barrier originally installed to stop rockfalls, which is, to date, the first publicly reported case of landslide debris having been successfully intercepted by a flexible barrier without any damage, in mainland of China. A field investigation was first conducted, and then a back analysis of the landslide mobility and the interaction between the landslide and the flexible barrier was carried out. The back analysis showed that the impact energy was three-times larger than the rated energy capacity of the flexible barrier. It also showed that the elongation of the brake rings and the deflection of the flexible barrier from the numerical simulation was comparable to that from the field measurements. The fact that these brake rings were not elongated to their limit indicated that the capacity of the flexible barrier still had a surplus. Finally, to investigate the maximum energy capacity of a flexible rockfall barrier in resisting landslide debris, parametric analyses of a flexible barrier impacted by landslide debris with different impact energies and velocities were carried out using a coupled ALE-FEM modeling technique. The results showed that the flexible barrier dissipated less than 40% of the total energy of the landslide debris. With an increase of impact energy, the energy dissipation ratio of the flexible barrier decreased linearly. The maximum energy capacity of a flexible rockfall barrier in resisting landslide debris is four-times that of resisting a rockfall.


  • Open Access

    Wind Tunnel Test of Wind Load on a Typical Cross Line High-Speed Railway Station

    by Lei Zhao, Zhixiang Yu, Xin Qi, Hu Xu

  • Dynamic response of flexible rockfall barriers with different block shapes

    by Zhixiang Yu, Liru Luo, Chun Liu, Liping Guo, Xin Qi, Lei Zhao


  • Coupled numerical simulation of a flexible barrier impacted by debris flow with boulders in front

    by L. Zhao, J. W. He, Z. X. Yu, Y. P. Liu, Z. H. Zhou, S. L. Chan


  • Open Access

    Nonlinear Numerical Modeling of the Wire‐Ring Net for Flexible Barriers

    by Zhixiang Yu, Chun Liu, Liping Guo, Lei Zhao, Shichun Zhao

    To investigate the nonlinear mechanical behavior of the wire‐ring net, this paper presents a new numerical model that can collectively consider equivalence between numerical and actual wire rings. Quasi‐static tests, including tensile tests on steel wires and one‐ring specimens, and puncturing tests on net specimens were conducted. Based on the test results, the axial constitutive curves of steel wires were obtained. The linear correlation equations for the breaking loads of the one‐ring specimens and the puncturing strength of wire‐ring nets were established, both of which were related to the number of windings. The wire rings were modeled via an equivalent structure with a single winding and a circular cross section. Equivalence between the numerical and actual wire rings in terms of bending and tensile strength, total mass, contact with sliding friction, and rupture behavior were also derived and presented. In particular, the emphasis was on simulating the flattening effect, a phenomenon rarely accounted for in conventional numerical models. All dominant factors were reflected in a model with the material law by the input of material parameters. The proposed mechanical model was calibrated and verified by the data from the tests of the wire‐ring net. The calibrated mechanical model is also shown to successfully simulate a full‐scale test of a flexible rockfall protection barrier according to the ETAG027 standard.