ALAi-Jun Li

Ai-Jun Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ai-Jun Li has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A homotopy boundary element method model based on modified potential flow with nonlinear dissipative conditions

    by Xiao-Lei Sun, Yong Liu, Ai-Jun Li, Hua-Jun Li

    This study develops a general three-dimensional homotopy boundary element method (HBEM) model for analyzing wave-induced hydrodynamic problems of marine structures. Artificial dissipative surfaces are introduced into fluid domains where wave energy dissipation is non-negligible. The mass flux across these surfaces remains continuous, while local head loss is assumed to occur on both sides of these surfaces. Quadratic (nonlinear) pressure loss conditions are imposed on these dissipative surfaces to equivalently represent the viscous dissipation effect. In solving the boundary value problem, the conventional boundary integral equation derived from the second Green's theorem is applied to the structure surfaces, whereas a hypersingular boundary integral equation is deduced for the dissipative surfaces. After discretizing all boundaries into a series of constant panels, an algebraic system is obtained from the two types of boundary integral equations. The application of quadratic pressure loss conditions renders this system nonlinear, which is solved using the homotopy analysis method. The proposed HBEM model is validated by considering the problems of fluid resonance in narrow gaps and wave resonance in moonpools. The calculated results are in excellent agreement with both analytical results in the literature and numerical results based on a direct iteration method. Moreover, with an appropriately calibrated dissipation coefficient, the calculated results of the free surface amplitude inside narrow gaps and moonpools agree well with published experimental measurements. The present HBEM model can offer a reliable and efficient computational tool for the hydrodynamic analysis of wave–structure interaction.


  • Water wave diffraction and radiation by a vertical truncated cylinder in front of a partially reflective vertical wall

    by Xiao-Lei Sun, Ai-Jun Li, Yong Liu, Hua-Jun Li

    This paper studies water wave interaction with a vertical truncated cylinder in front of a partially reflective vertical wall. An analytical solution for the hydrodynamic problem is developed using the mirror image method and eigenfunction expansion method. In the outer fluid region, reduced diffracted/radiated waves induced by the mirror image of the truncated cylinder are introduced to satisfy the partially reflective condition on the vertical wall. The velocity potential of the fluid motion is expressed in the form of Bessel–Fourier series in local cylindrical coordinate systems. The expansion coefficients in the velocity potential are determined by the conditions on the cylinder surface and the boundary between adjacent regions. The wave excitation forces, added mass, and radiation damping are calculated through the velocity potential. Typical cases are presented to clarify the effect of key parameters on the hydrodynamic quantities. The results indicate that the wave excitation forces oscillate with the frequency owing to the vertical wall. The magnitude of the wall reflection coefficient mainly affects the peaks of excitation forces, whereas the phase of the reflection coefficient imposes obvious effects on the frequencies of peaks and troughs. Moreover, the added mass and radiation damping in the surge and pitch directions are more sensitive to the wall reflection coefficient (including magnitude and phase) than those in the sway and roll directions. Increasing the cylinder-wall spacing leads to more frequent oscillations of the hydrodynamic quantities, and the added mass and radiation damping in the surge and pitch directions is more susceptible to the spacing effect. Subsequently, the energy capture performance of a heave cylindrical wave energy absorber is studied based on the analytical solution. When the absorber undergoes resonance motion with water waves, its energy capture performance is significantly improved. The absorber performance at the resonant frequency increases in a nearly linear relationship with the magnitude of the reflection coefficient (with the same phase).

  • Analytical study of water wave interaction with a vertical cylinder surrounded by a non-concentric cylindrical perforated wall

    by Ai-Jun Li, Yong Liu, Xin-Yu Wang

    The wave interaction between water waves and concentric cylindrical structures received extensive attention, but analytical investigations on the hydrodynamic problems of non-concentric structures were rarely reported. In this study, a vertical cylinder surrounded by a non-concentric cylindrical perforated wall is taken as an example, where the vertical cylinder can be regarded as a platform and the perforated wall can serve as a protective facility. An analytical method for the hydrodynamic problems of non-concentric cylindrical structures is developed in the context of the potential flow theory. In the analytical process, the entire fluid domain is divided into two regions, and the velocity potentials of the fluid motion are expressed by the Bessel–Fourier series. Graft's addition theorem is used to address the problem caused by hybrid coordinate systems, and the expansion coefficients in the velocity potentials are determined through the boundary condition on the perforated wall. The linear wave forces and mean drift forces on the cylinder and the perforated wall are obtained, and the calculation expression of the dissipated wave power of the perforated wall is given. The analytical solution converges rapidly, and the calculated results are consistent with the numerical results of the boundary element method. Typical examples are presented to examine the effects of the wave frequency, the cylinder position, and the porous effect parameter on the hydrodynamic quantities. The results show that the wave forces on the inner cylinder and the perforated wall are sensitive to the cylinder position, and there exists an optimal geometric porosity to maximize the energy-dissipating performance of the perforated wall. The present analytical scheme can provide a basic reference for wave-induced hydrodynamic problems of other complicated non-concentric structures.


  • Constrained-damping and multi-segments effects on the hydrodynamic response of floating structures under wave action

    by Guoheng Xing, Hui Fang, Aijun Li

    Effects of constrained damping and multi-segments on the hydrodynamic response of floating structures under wave action are clarified by an improved viscoelasticity-hydrodynamic coupled model, in which shear deformation of viscoelastic core constrained by surfaces bending in the floating sandwich multi-segments is modeled and coupled of the material viscoelasticity, structural dynamic, and potential flow theory. Then, higher-order hysteresis-hydrodynamic equations with articulated-separated continuity conditions, as well as velocity potential functions for plate-covered and free-water areas, are calculated using the perturbation and partition matching methods. As an illustration, a floating multi-segments structure, consisting of high-stiffness elastic-surface layers and a low-stiffness viscoelastic-core layer, is analyzed. The analytical functions of deflection, bending moment, and shear force, incorporating fluid-structure-component-material parameters, have been formulated, thereby enabling a direct assessment of the effects of constrained-damping and multi-segment configurations on hydrodynamic response to wave action, which are expected to provide new ideas for novel marine structures.


  • Water wave interaction with a bottom-standing surface-piercing porous compound coaxial cylinder

    by Jiaxiu Cao, Aijun Li, Chenxu Gu, Chao Wang

    The concept of the integration of offshore wind power and ocean ranch represents a development trend of intensive use of the sea. With the rise of this concept, this paper proposes a new type of porous marine structure. Based on the assumptions of the linearized theory of water waves, the wave diffraction and radiation problems of the bottom-standing surface-piercing porous compound coaxial cylinder are studied in this paper. Two seabed conditions are considered: (a) the ideal state, where the seabed is impermeable, and (b) the actual state, where the seabed is porous. The analytical models for the hydrodynamic problems of the porous cylinder placed on the impermeable and porous seabed are established. The wave diffraction and radiation problems are solved by using the eigenfunction expansion method and the velocity potentials of the fluid motion are derived. To verify the correctness of the program, the present model is reduced and compared with existing models. After completing the verification, the effects of the porous seabed and structural parameters on the hydrodynamic characteristics of the porous cylinder are studied. The results indicate that the porous seabed has effects on the wave run-up on the porous cylinder, and the higher the seabed porous effect parameter, the smaller the wave run-up on the porous cylindrical surface of the outer cylinder and the impermeable cylindrical surface of the inner cylinder. Enlarging the porous effect parameter and the radius ratio of the compound cylinder leads to decreases in the wave force, moment, added mass, and radiation damping. By changing the parameters of the porous cylinder, the hydrodynamic characteristics of the porous cylinder can be greatly reduced. This study is expected to provide support for engineering design of relevant marine structures.


  • Open Access

    Hydrodynamic performance of vertical cylindrical wave energy absorbers in front of a vertical wall

    by Ai-Jun Li, Yong Liu, Xin-Yu Wang

    This paper studies the hydrodynamic performance of vertical cylindrical absorbers in front of a vertical wall. All the absorbers are independent of each other and restricted to only the heave motion. Based on a linear potential flow theory, an analytical solution is developed for the problems of wave diffraction and radiation by absorbers. In the solving procedure, the hydrodynamic problem is first transformed into an equivalent problem in an open water domain using the image principle. The number of absorbers in the equivalent problem is twice that in the real problem, and the plane layout is symmetric about the original vertical wall. The velocity potential of the fluid domain is obtained using the method of variable separation, and the unknown expansion coefficients in the velocity potential are determined by the matched boundary conditions. The heave excitation force, added mass, radiation damping, motion response, and energy capture width of the absorbers are calculated. Case studies are presented to show the effects of the wall reflection and hydrodynamic interaction on the energy extraction performance of the wave energy converter (WEC) system. Subsequently, the WEC performance under the action of irregular waves is analyzed by considering an incident wave spectrum, and the mean annual absorbed power of the device is estimated by considering the wave data statistics at the actual sites. The results indicate that when the wave motion resonates with the absorber motion, the energy extraction performance of the absorbers is significantly improved. The performance of the absorbers can be effectively improved when the structures are close to the antinodes of a standing wave field. By designing a reasonable plane layout, the hydrodynamic interaction can play a constructive role in the performance of the WEC system.


  • Open Access

    A material–structure-wave integrated hydro-viscoelastic model for floating composite structure with generalized boundary

    by Muying Zhu, Hui Fang, Aijun Li, Yong Liu

    A floating viscoelastic composite structure with generalized elastic constraints, in which the material–structure-wave interaction induces energy dissipation, is analyzed with a novel cross-scale integrated hydro-viscoelastic model. A double-level three-dimensional (3D) representative volume element model coupling mesoscale reinforced particles to a macroscale composite structure is established to obtain the structure's viscoelastic dynamic equation. Therefore, a hydro-viscoelasticity analytical model for floating composite structures with arbitrary elastic constraints under wave action is developed in the context of potential flow theory. In the process of solving the velocity potential, the dispersion equation of the water covered by the composite structure is derived. The hydrodynamic and mechanical behaviors of the floating composite structure, including the reflection coefficient, transmission coefficient, dissipation coefficient, deflection, shear force, and bending moment, are comprehensively calculated, which depend on the cross-scale integrated effects of wave action, structural features, material characteristics, and constraint combinations. This material–structure-wave integrated model would be useful to elucidate the hydro-viscoelastic dissipation mechanism of marine structures.


  • Initial Approach Segment Control for Out-of-Plane Capture Based on a Space Tether System

    by Liu Xiaoxiao, Li Aijun, Wang Changqing, Lu Hongshi

    Study of the release of a tether from a base station spacecraft to a given rendezvous maneuver feasibility point for the out-of-plane capture of space debris by a space tether system. Considering the out-of-plane angle of the system, the pseudospectral method is used to plan the optimal trajectory of the initial approach section, and the effect of the initial state error on the initial approach segment trajectory is analyzed. In turn, the system model is controlled by segmental feedback using sliding mode control based on an adaptive convergence law to overcome the initial state error. The results show that initial approach section control can be achieved by adjusting the tether tension and the out-of-plane thrust on the capture mechanism, provided that the relevant constraints are met.

  • Open Access

    Wave scattering by porous cylinders with inner columns near a vertical wall

    by Ai-Jun Li, Yong Liu, Hui Fang

    This paper studies wave scattering by multiple dual porous circular cylinders in front of a vertical wall. Each cylinder is composed of an outer partially perforated cylindrical shell and an inner impermeable column, and a circular wave-absorbing chamber is formed by the shell and column. An analytical solution to the hydrodynamic problem is developed in the context of potential flow theory. In the solving procedure, the hydrodynamic problem is transformed into an equivalent problem in an open water domain by using the image principle. The whole fluid domain in the equivalent problem is divided into multiple regions, and the velocity potential of the fluid motion in each region is expressed as the Fourier–Bessel series. The effect of the perforated shell on wave motion is considered through a pressure loss condition. The unknown coefficients in the velocity potential are determined by the transmission conditions on the boundaries between adjacent regions. The wave force, wave run-up on the porous cylinders, and the surface elevation near the cylinders are calculated. The analytical results are consistent with published results in several limiting cases. Typical cases are presented to clarify the characteristics of the wave force and wave run-up on the cylinders and discuss the effects of the wall and hydrodynamic interference on the hydrodynamic quantities. Moreover, several feasible applications of dual porous cylinders are discussed by visualizing the distribution of wave amplitude near the structures, and some valuable results are given.


  • Hydrodynamic performance and energy absorption of multiple spherical absorbers along a straight coast

    by Ai-Jun Li, Yong Liu

    The development and utilization of wave energy have great potentiality to alleviate the urgent problem of global energy shortage. Spherical bodies can be used as point absorbers to extract wave energy, and much attention has been paid to the performance of spherical absorbers in an open water domain. This study focuses on the hydrodynamic performance and energy absorption of multiple spherical absorbers in front of a straight coast. The coast is assumed to be a fully reflecting vertical wall, and all the absorbers are restricted to only heave motion. An analytical solution based on linear potential flow theory is developed for the problem of wave diffraction and radiation by multiple absorbers. In the solution procedure, the hydrodynamic problem is transformed into an equivalent problem in an open water domain by applying the image principle. The velocity potential of the fluid motion is solved using the method of multipole expansions combined with the shift of local spherical coordinate systems. Then, the wave excitation force, added mass coefficient, radiation damping coefficient, and energy extraction performance of the absorbers are calculated. Case studies are presented to analyze the effects of the coastal reflection and hydrodynamic interaction among absorbers on the energy extraction performance of the wave energy converter (WEC) system. The effects of wave frequency, incident angle, spacing between the absorber and coast, submergence depth, absorber number, and plane layout are also clarified. The results suggest that the energy extraction performance of an isolated absorber is significantly improved when the motions of the waves and absorber are in resonance, and the coastal reflection can enhance the overall energy extraction performance for a WEC system with multiple absorbers. In addition, when the number of absorbers increases, the effects of the coastal reflection and hydrodynamic interaction become more complicated.