Hongying Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hongying Wang has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Robert Bogdan Staszewski
University College Dublin
6 shared publications Ali Esmailiyan
Equal1 Labs Ltd., Dublin, Ireland
3 shared publications- Dirk Leipold
Equal1 Labs Inc., Fremont, CA, USA
3 shared publications - Elena Blokhina
Equal1 Labs
3 shared publications - Filippo Schembari
School of Electrical and Electronic Engineering, University College Dublin, Dublin 4, Ireland
3 shared publications - Imran Bashir
Equal1 Labs Inc., Fremont, CA, USA
3 shared publications
Latest Publications
- Open Access
- 26 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (6) , 1861-1865
An On-Chip Picoampere-Level Leakage Current Sensor for Quantum Processors in 22-nm FD-SOI CMOS
In this article, we present an embedded picoampere-level leakage current sensor of low hardware complexity for quantum computing applications. It senses a leakage current on capacitors comprising a capacitive DAC (CDAC) intended for the control of energy confinement levels and quantum states of a nearby quantum dot structure integrated on the same die. As the quantum states exhibit an exponential sensitivity to the control voltages, any changes in the output voltage of the CDAC due to noise, ripples, or leakage current should be monitored and characterized accurately. For this purpose, we exploit a 1-bit continuous-time comparator to digitize the slope of the CDAC output voltage due to the leakage current. The proposed system occupies 0.013 mm and measures the leakage current over varied temperature from 3.8 K to 270 K. The average leakage current of the CDAC at 3.8 K was measured at 3.57 pA.
- 26 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 70 (6) , 1861-1865
Open AccessAn On-Chip Picoampere-Level Leakage Current Sensor for Quantum Processors in 22-nm FD-SOI CMOS
In this article, we present an embedded picoampere-level leakage current sensor of low hardware complexity for quantum computing applications. It senses a leakage current on capacitors comprising a capacitive DAC (CDAC) intended for the control of energy confinement levels and quantum states of a nearby quantum dot structure integrated on the same die. As the quantum states exhibit an exponential sensitivity to the control voltages, any changes in the output voltage of the CDAC due to noise, ripples, or leakage current should be monitored and characterized accurately. For this purpose, we exploit a 1-bit continuous-time comparator to digitize the slope of the CDAC output voltage due to the leakage current. The proposed system occupies 0.013 mm and measures the leakage current over varied temperature from 3.8 K to 270 K. The average leakage current of the CDAC at 3.8 K was measured at 3.57 pA.
- Open Access
- 24 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 3, 354-357
A Fully Integrated DAC for CMOS Position-Based Charge Qubits with Single-Electron Detector Loopback Testing
This letter presents a fully integrated interface circuitry with a position-based charge qubit structure implemented in 22-nm FDSOI CMOS. The quantum structure is controlled by a tiny capacitive DAC (CDAC) that occupies 3.5×45 μm and consumes 0.27 mW running at a 2 GHz system clock. The state of the quantum structure is measured by a single-electron detector that consumes 1 mW (including its output driver) with an area of 40×25 μm. The low power and miniaturized layout of these circuits pave the way for integration in a large quantum core with thousands of qubits, which is a necessity for practical quantum computers. The CDAC output noise of 12 μV-rms is estimated through mathematical analysis while the ≤ 0.225 mV-rms input referred noise of the detector is verified by measurements at 3.4 K. The functionality of the system and performance of the CDAC are verified in a loop-back mode with the detector sensing the CDAC-induced electron tunneling from the floating diffusion node into the quantum structure.
- 24 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 3, 354-357
Open AccessA Fully Integrated DAC for CMOS Position-Based Charge Qubits with Single-Electron Detector Loopback Testing
This letter presents a fully integrated interface circuitry with a position-based charge qubit structure implemented in 22-nm FDSOI CMOS. The quantum structure is controlled by a tiny capacitive DAC (CDAC) that occupies 3.5×45 μm and consumes 0.27 mW running at a 2 GHz system clock. The state of the quantum structure is measured by a single-electron detector that consumes 1 mW (including its output driver) with an area of 40×25 μm. The low power and miniaturized layout of these circuits pave the way for integration in a large quantum core with thousands of qubits, which is a necessity for practical quantum computers. The CDAC output noise of 12 μV-rms is estimated through mathematical analysis while the ≤ 0.225 mV-rms input referred noise of the detector is verified by measurements at 3.4 K. The functionality of the system and performance of the CDAC are verified in a loop-back mode with the detector sensing the CDAC-induced electron tunneling from the floating diffusion node into the quantum structure.
- Open Access
- 21 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 3, 206-209
A Single-Electron Injection Device for CMOS Charge Qubits Implemented in 22-nm FD-SOI
This brief presents a single-electron injection device for position-based charge qubit structures implemented in 22 nm FD-SOI CMOS. Quantum dots are implemented in local well areas separated by tunnel barriers controlled by gate terminals overlapping with a thin 5 nm undoped silicon film. Interface of the quantum structure with classical electronic circuitry is provided with single-electron transistors that feature doped wells on the classic side. A small 0.7×0.4 μm elementary quantum core is co-located with control circuitry inside the quantum operation cell which is operating at 3.5 K and a 2 GHz clock frequency. With this apparatus, we demonstrate a single electron injection into a quantum dot.
- 21 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 3, 206-209
Open AccessA Single-Electron Injection Device for CMOS Charge Qubits Implemented in 22-nm FD-SOI
This brief presents a single-electron injection device for position-based charge qubit structures implemented in 22 nm FD-SOI CMOS. Quantum dots are implemented in local well areas separated by tunnel barriers controlled by gate terminals overlapping with a thin 5 nm undoped silicon film. Interface of the quantum structure with classical electronic circuitry is provided with single-electron transistors that feature doped wells on the classic side. A small 0.7×0.4 μm elementary quantum core is co-located with control circuitry inside the quantum operation cell which is operating at 3.5 K and a 2 GHz clock frequency. With this apparatus, we demonstrate a single electron injection into a quantum dot.
- Open Access
- 6 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (12) , 2828-2832
An Adaptive-Resolution Quasi-Level-Crossing Delta Modulator With VCO-Based Residue Quantizer
This brief introduces an adaptive-resolution (AR) quasi-level-crossing delta modulator ADC with a voltage-controlled oscillator (VCO)-based residue quantizer for Internet-of-Things (IoT) wireless sensor nodes. The residue voltage signal is digitized by a VCO-based residue quantizer, thus leading to a straightforward implementation of level-crossing (LC) and AR algorithms in digital domain. The inherent and mismatch-induced dithering provided by the VCO-based residue quantizer increases the proposed modulator’s dynamic range and average sampling rate for slowly-varying input signals, enabling accurate sampling and conversion. For fast-varying signals, the AR algorithm is adopted to reduce the average sampling rate by a factor of three compared to the straightforward LC algorithm at the edge of the modulator’s signal bandwidth. Fabricated in 28-nm CMOS, the proposed modulator achieves a peak SNDR of 53 dB over a signal bandwidth of 1.78 MHz.
- 6 March 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (12) , 2828-2832
Open AccessAn Adaptive-Resolution Quasi-Level-Crossing Delta Modulator With VCO-Based Residue Quantizer
This brief introduces an adaptive-resolution (AR) quasi-level-crossing delta modulator ADC with a voltage-controlled oscillator (VCO)-based residue quantizer for Internet-of-Things (IoT) wireless sensor nodes. The residue voltage signal is digitized by a VCO-based residue quantizer, thus leading to a straightforward implementation of level-crossing (LC) and AR algorithms in digital domain. The inherent and mismatch-induced dithering provided by the VCO-based residue quantizer increases the proposed modulator’s dynamic range and average sampling rate for slowly-varying input signals, enabling accurate sampling and conversion. For fast-varying signals, the AR algorithm is adopted to reduce the average sampling rate by a factor of three compared to the straightforward LC algorithm at the edge of the modulator’s signal bandwidth. Fabricated in 28-nm CMOS, the proposed modulator achieves a peak SNDR of 53 dB over a signal bandwidth of 1.78 MHz.
- Open Access
- 8 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (2) , 298-311
An Event-Driven Quasi-Level-Crossing Delta Modulator Based on Residue Quantization
- 8 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (2) , 298-311
Open AccessAn Event-Driven Quasi-Level-Crossing Delta Modulator Based on Residue Quantization
- Open Access
- 16 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 67 (2) , 578-589
Passive SC $\Delta\Sigma$ Modulator Based on Pipelined Charge-Sharing Rotation in 28-nm CMOS- 16 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 67 (2) , 578-589
Open AccessPassive SC $\Delta\Sigma$ Modulator Based on Pipelined Charge-Sharing Rotation in 28-nm CMOS