Yingying Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yingying Wang has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Arjuna Madanayake
Florida International University, Miami, USA
4 shared publications - Soumyajit Mandal
Brookhaven National Laboratory
4 shared publications - Jifu Liang
Department of Electrical Engineering and Computer Science, Case Western Reserve University, Cleveland, OH 44106 USA
2 shared publications - Leonid Belostotski
University of Calgary
2 shared publications Ge Wu
Department of Electrical and Computer Engineering, University of Calgary, Calgary, AB, Canada
1 shared publication- Gihan Janith Mendis
Department of Computer and Information Technology, Purdue University, West Lafayette, IN, USA
1 shared publication
Latest Publications
- 6 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 67 (9) , 2934-2947
A 1.0-8.3 GHz Cochlea-Based Real-Time Spectrum Analyzer With Δ-Σ-Modulated Digital Outputs
The biological inner ear, or cochlea, is a sophisticated signal processing system that performs spectrum analysis over an ultra-broadband frequency range of ~20 Hz to 20 kHz with exquisite sensitivity and high energy efficiency. Electronic cochlear models, which mimic the exponentially-tapered structure of the biological inner ear using bidirectional transmission lines or filter cascades, act as fast and hardware-efficient spectrum analyzers at both audio and radio frequencies. This paper describes a cochlea-based digitally-programmable single-chip radio frequency (RF) spectrum analyzer in 65 nm CMOS. This “RF cochlea” chip includes a transmission-line active cochlear model with 50 parallel exponentially-spaced stages that analyzes the radio spectrum from 1.0-8.3 GHz. The outputs of all stages are encoded in parallel as delta-sigma (Δ-Σ) modulated digital signals for real-time demodulation and analysis by a digital back-end processor. The chip consumes 418 mW and typically generates ~1 GS/s of total data at an ENOB of 5-6 bits. An artificial intelligence (AI)-driven single-channel cognitive radio (CR) receiver based on the RF cochlea has also been implemented and tested.
- 6 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 67 (9) , 2934-2947
A 1.0-8.3 GHz Cochlea-Based Real-Time Spectrum Analyzer With Δ-Σ-Modulated Digital Outputs
The biological inner ear, or cochlea, is a sophisticated signal processing system that performs spectrum analysis over an ultra-broadband frequency range of ~20 Hz to 20 kHz with exquisite sensitivity and high energy efficiency. Electronic cochlear models, which mimic the exponentially-tapered structure of the biological inner ear using bidirectional transmission lines or filter cascades, act as fast and hardware-efficient spectrum analyzers at both audio and radio frequencies. This paper describes a cochlea-based digitally-programmable single-chip radio frequency (RF) spectrum analyzer in 65 nm CMOS. This “RF cochlea” chip includes a transmission-line active cochlear model with 50 parallel exponentially-spaced stages that analyzes the radio spectrum from 1.0-8.3 GHz. The outputs of all stages are encoded in parallel as delta-sigma (Δ-Σ) modulated digital signals for real-time demodulation and analysis by a digital back-end processor. The chip consumes 418 mW and typically generates ~1 GS/s of total data at an ENOB of 5-6 bits. An artificial intelligence (AI)-driven single-channel cognitive radio (CR) receiver based on the RF cochlea has also been implemented and tested.
- 19 October 2018
- Published by Springer Nature in Multidimensional Systems and Signal Processing
- Vol. 30 (3) , 1609-1631
$\varvec{\varDelta }$–$\varvec{\varSigma }$ noise-shaping in 3-D space–time for 2-D wideband antenna array receivers- 19 October 2018
- Published by Springer Nature in Multidimensional Systems and Signal Processing
- Vol. 30 (3) , 1609-1631
$\varvec{\varDelta }$–$\varvec{\varSigma }$ noise-shaping in 3-D space–time for 2-D wideband antenna array receivers- 24 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 66 (2) , 569-582
$\Delta-\Sigma$ Noise-Shaping in 2-D Space-Time for Wideband Antenna Array ReceiversThis paper proposes multi-dimensional signal processing methods to extend Δ-Σ modulation into the two-dimensional (2-D) space, time case. The proposed 2-D noise-shaping methods employ lossless discrete integrators (LDIs) to reduce the spectral overlap of the regions of support (ROSs) of array signals with that of both thermal and quantization noise in microwave and mm-wave array processing systems. Spatio-temporal low-pass filtering can then be used to improve the overall noise figure, linearity, and resolution of the resulting N-port receiver. A proof-of-concept 65-port receiver that uses first-order Δ-Σ within both the low-noise amplifier and analog-to-digital converter (ADC) has been designed in the UMC 65-nm CMOS process. Detailed circuit simulations with wideband RF inputs at a center frequency of 4 GHz confirm that the proposed 2-D noise-shaping approach provides significant improvements in noise, linearity, and resolution. Specifically, noise figure (NF) improves by 1.5 dB, IIP3 improves by 15 dB, and the effective number of bits (ENOB) improves by 3.1 bits. Experimental results from a low-frequency board-level implementation of a 64-port ADC with first-order noise shaping are also presented.
- 24 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 66 (2) , 569-582
$\Delta-\Sigma$ Noise-Shaping in 2-D Space-Time for Wideband Antenna Array ReceiversThis paper proposes multi-dimensional signal processing methods to extend Δ-Σ modulation into the two-dimensional (2-D) space, time case. The proposed 2-D noise-shaping methods employ lossless discrete integrators (LDIs) to reduce the spectral overlap of the regions of support (ROSs) of array signals with that of both thermal and quantization noise in microwave and mm-wave array processing systems. Spatio-temporal low-pass filtering can then be used to improve the overall noise figure, linearity, and resolution of the resulting N-port receiver. A proof-of-concept 65-port receiver that uses first-order Δ-Σ within both the low-noise amplifier and analog-to-digital converter (ADC) has been designed in the UMC 65-nm CMOS process. Detailed circuit simulations with wideband RF inputs at a center frequency of 4 GHz confirm that the proposed 2-D noise-shaping approach provides significant improvements in noise, linearity, and resolution. Specifically, noise figure (NF) improves by 1.5 dB, IIP3 improves by 15 dB, and the effective number of bits (ENOB) improves by 3.1 bits. Experimental results from a low-frequency board-level implementation of a 64-port ADC with first-order noise shaping are also presented.
- Open Access
- 9 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Signal Processing
- Vol. 12 (2) , 368-382
Wideband $N$ -Beam Arrays Using Low-Complexity Algorithms and Mixed-Signal Integrated CircuitsThis paper proposes a low-complexity wideband beamforming subarray for millimeter wave (mmW) 5G wireless communications. The multibeam subarray is based on using a novel delay Vandermonde matrix (DVM) algorithm to efficiently generate analog true-time-delay beams that have no beam squint. A factorization for the DVM leading to low-complexity analog realizations is provided and complexity analysis for real and complex inputs is derived. The DVM is a special case of a Vandermonde matrix but with complex nodes that lack any special properties (unlike the discrete Fourier transform matrix). Error bounds for the DVM are established and then analyzed for numerical stability. Mixed-signal CMOS integrated circuits designs are proposed for the implementation of DVM multibeam algorithms along with low-complexity digital realizations to achieve hybrid beamforming for mmW applications. Analog-digital hybrid mmW multibeam beamforming circuits and systems are designed, for example, with eight beams at 28 GHz and simulated in cadence for functional verification.
- 9 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Signal Processing
- Vol. 12 (2) , 368-382
Open AccessWideband $N$ -Beam Arrays Using Low-Complexity Algorithms and Mixed-Signal Integrated CircuitsThis paper proposes a low-complexity wideband beamforming subarray for millimeter wave (mmW) 5G wireless communications. The multibeam subarray is based on using a novel delay Vandermonde matrix (DVM) algorithm to efficiently generate analog true-time-delay beams that have no beam squint. A factorization for the DVM leading to low-complexity analog realizations is provided and complexity analysis for real and complex inputs is derived. The DVM is a special case of a Vandermonde matrix but with complex nodes that lack any special properties (unlike the discrete Fourier transform matrix). Error bounds for the DVM are established and then analyzed for numerical stability. Mixed-signal CMOS integrated circuits designs are proposed for the implementation of DVM multibeam algorithms along with low-complexity digital realizations to achieve hybrid beamforming for mmW applications. Analog-digital hybrid mmW multibeam beamforming circuits and systems are designed, for example, with eight beams at 28 GHz and simulated in cadence for functional verification.