Prince Bahoumina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Prince Bahoumina has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Aymen Abdelghani
Unrversity of Limoges, CNRS, XLIM UMR 7252, Limoges, France
2 shared publications- Corinne Dejous
Univ. Bordeaux, Bordeaux INP, CNRS, IMS, UMR 5218, 351 Cours de la Liberation, Talence, 33400, France
2 shared publications - Dominique Baillargeat
University of Limoges, CNRS, XLIM UMR 7252, F-87060 Limoges, France
2 shared publications - Hamida Hallil
Univ. Bordeaux, Bordeaux INP, CNRS, IMS UMR 5218, F-33405 Talence, France
2 shared publications Kamel Frigui
Unrversity of Limoges, CNRS, XLIM UMR 7252, Limoges, France
2 shared publications- Stephane Bila
University of Limoges, CNRS, XLIM UMR 7252, Limoges, France
2 shared publications
Latest Publications
- 7 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 93-96
Inkjet-Printed RF Gas Sensors based on conductive nanomaterials for VOCs monitoring
This paper proposes an innovative differential sensor based on planar microwave transducers printed on flexible substrate by low-cost printing technologies and operating at ambient temperature. The gas detection is obtained from a differential approach between a reference channel and gas sensitive one based on PEDOT: PSS-MWCNT. A preliminary sensor is fabricated and tested around 3.6 GHz. The experimental behavior in the presence of ethanol vapor is encouraging and validates the proof-of-concept.
- 7 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 93-96
Inkjet-Printed RF Gas Sensors based on conductive nanomaterials for VOCs monitoring
This paper proposes an innovative differential sensor based on planar microwave transducers printed on flexible substrate by low-cost printing technologies and operating at ambient temperature. The gas detection is obtained from a differential approach between a reference channel and gas sensitive one based on PEDOT: PSS-MWCNT. A preliminary sensor is fabricated and tested around 3.6 GHz. The experimental behavior in the presence of ethanol vapor is encouraging and validates the proof-of-concept.
- 15 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 19 (4) , 1346-1353
Differential Passive Microwave Planar Resonator- Based Sensor for Chemical Particle Detection in Polluted Environments
This paper presents an inkjet-printed differential passive microwave planar resonator-based sensor for toxic vapor detection at room temperature. Two devices are presented, with 5 (D1) and 50 (D2) layers of composite sensitive film (PEDOT:PSS-MWCNTs). Each one consists of two band-pass resonators with the fundamental modes around 2.5 and 2.7 GHz. Theoretical and experimental results are presented, both devices show sensitivity to ethanol vapor ranging from 500 to 1300 ppm according to the magnitude and resonant frequency shifts of their scattering parameters (S-parameters). Limitations due to a continuous drift on both the reference and the sensitive channels are discussed. Though further improvements are needed, such sensor is a good candidate for integration into real-time multi-sensing platforms adaptable for the Internet of Things.
- 15 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 19 (4) , 1346-1353
Differential Passive Microwave Planar Resonator- Based Sensor for Chemical Particle Detection in Polluted Environments
This paper presents an inkjet-printed differential passive microwave planar resonator-based sensor for toxic vapor detection at room temperature. Two devices are presented, with 5 (D1) and 50 (D2) layers of composite sensitive film (PEDOT:PSS-MWCNTs). Each one consists of two band-pass resonators with the fundamental modes around 2.5 and 2.7 GHz. Theoretical and experimental results are presented, both devices show sensitivity to ethanol vapor ranging from 500 to 1300 ppm according to the magnitude and resonant frequency shifts of their scattering parameters (S-parameters). Limitations due to a continuous drift on both the reference and the sensitive channels are discussed. Though further improvements are needed, such sensor is a good candidate for integration into real-time multi-sensing platforms adaptable for the Internet of Things.