Omar Mohamed Omar Ibrahim
Research Subjects
Omar Mohamed Omar Ibrahim has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Nour Bassim Frahat
Department of Civil and Architectural Constructions, Faculty of Technology and Education, Suez University, Suez, Egypt
3 shared publications - Ibrahim Saad Agwa
Department of Civil and Architectural Constructions, Faculty of Technology and Education, Suez University, Suez, Egypt
2 shared publications A.S. Awed
1 shared publication- Ahmed T. Baraghith
Structural Engineering Department, Faculty of Engineering, Tanta University
1 shared publication Ashraf M. Heniegal
1 shared publicationAshraf Mohamed Heniegal
1 shared publication
Latest Publications
- 25 May 2026
- Published by Elsevier in Journal of Building Engineering
- Vol. 127
Structure performance of concrete with hybrid rubber and basalt aggregates under static and impact loads
- 25 May 2026
- Published by Elsevier in Journal of Building Engineering
- Vol. 127
Structure performance of concrete with hybrid rubber and basalt aggregates under static and impact loads
- Open Access
- 1 September 2024
- Published by Jan Evangelista Purkyne University in Usti nad Labem in Manufacturing Technology
- Vol. 24 (4) , 567-577
Ultimate Response of Strengthened RC Beams in the Flexural Using Plain Cementitious Composites Layer
This paper aims to study the efficiency of using prefabricated layers made from plain cementitious composite materials for enhancing the flexural behavior of reinforced concrete (RC) continuous beams. The strengthening system was applied at 20...
- 1 September 2024
- Published by Jan Evangelista Purkyne University in Usti nad Labem in Manufacturing Technology
- Vol. 24 (4) , 567-577
Open AccessUltimate Response of Strengthened RC Beams in the Flexural Using Plain Cementitious Composites Layer
This paper aims to study the efficiency of using prefabricated layers made from plain cementitious composite materials for enhancing the flexural behavior of reinforced concrete (RC) continuous beams. The strengthening system was applied at 20...
- 1 September 2021
- Published by Elsevier in Journal of Building Engineering
- Vol. 41
New techniques for the energy saving of sustainable buildings by using phase change materials
- 1 September 2021
- Published by Elsevier in Journal of Building Engineering
- Vol. 41
New techniques for the energy saving of sustainable buildings by using phase change materials
- 10 March 2019
- Published by Tulpar Academic Publishing in Challenge Journal of Concrete Research Letters
- Vol. 10 (1) , 13
Fresh and hardened properties of self-compacting concrete containing of cement kiln dust
There are many wastes form the cement industry among them cement kiln dust (CKD). This residue is obtained after the process of burning the raw materials of cement in the rotary kiln where it is suctioned by fans during the clinker exit of the rotary kiln. Cement dust is a major environmental and economic problem in terms of high quality air pollution ranging from (20-100) microns and the proportions of chlorides, sulphates, alkali and lime living in a way that threatens the general health of human, as well as water pollution if the waste is discharged by rivers and waterways. This investigation’s main objective is to present the potential of using CKD as a cement replacement in self-compacting concrete (SCC). Eight mixes incorporating CKD with partial cement replacement of 0%, 5%, 10%, 20%, 30%, 40%, 50% and 75% in addition to control mix were investigated. The properties of all mixture were determined. Based on the experimental program results, it was found that SCC mixture incorporating 5% to 10% of CKD was almost similar to that of control mixture. The workability of SCC concrete decreased as CKD replacement increased. This established benefits of substituting cement by CKD to make SCC.
- 10 March 2019
- Published by Tulpar Academic Publishing in Challenge Journal of Concrete Research Letters
- Vol. 10 (1) , 13
Fresh and hardened properties of self-compacting concrete containing of cement kiln dust
There are many wastes form the cement industry among them cement kiln dust (CKD). This residue is obtained after the process of burning the raw materials of cement in the rotary kiln where it is suctioned by fans during the clinker exit of the rotary kiln. Cement dust is a major environmental and economic problem in terms of high quality air pollution ranging from (20-100) microns and the proportions of chlorides, sulphates, alkali and lime living in a way that threatens the general health of human, as well as water pollution if the waste is discharged by rivers and waterways. This investigation’s main objective is to present the potential of using CKD as a cement replacement in self-compacting concrete (SCC). Eight mixes incorporating CKD with partial cement replacement of 0%, 5%, 10%, 20%, 30%, 40%, 50% and 75% in addition to control mix were investigated. The properties of all mixture were determined. Based on the experimental program results, it was found that SCC mixture incorporating 5% to 10% of CKD was almost similar to that of control mixture. The workability of SCC concrete decreased as CKD replacement increased. This established benefits of substituting cement by CKD to make SCC.