Ju Liu

The Guidelines for Sustainable Aquaculture (GSAs) emphasize that formulating proper regional development plans is essential for achieving sustainable growth in aquaculture. Conventional research has limitations in allocating resources from a regional scale, subject to various constraints relating to the social, economic, environmental, and other domains. To fill this research gap, this study proposes an inexact regional aquaculture system planning model (IRAM) to optimally allocate resources including energy, water, area, media, and labor among various aquaculture species across multiple aquafarms under uncertainty. The model is applied to Fujian Province, China, over a 15-year planning horizon (2026–2040, three 5-year periods). As model-based scenario insights derived under specific assumptions, the main findings are as follows: (i) the system cost would increase by [18.75, 20.00]%, while the product output would greatly rise by [41.57, 47.54]% from period 1 to period 3; (ii) renewable energy (wind and solar) would supply [60.32, 81.05]% of the total electricity by period 3; (iii) shallow-sea culture ([48.6, 50.2]%) and pond culture ([17.6, 18.8]%) would receive the highest media allocation via internet platforms, supporting community communication; and (iv) pollutant and carbon emissions would decline due to the adoption of low-carbon feed and renewable energy penetration. The findings are scenario-dependent, and their practical applicability relies on the sensitivity analysis and model code/data availability discussed in the main text. One limitation lies in its inadequate ability to handle stochastic and fuzzy information commonly encountered in real-world planning problems.

The high-temperature friction behavior of 17-4PH stainless steel (17-4PH SS) subjected to laser shock peening (LSP) was investigated through high-temperature friction tests and microstructural characterization. The residual stress distribution induced by LSP was determined by numerical simulation and subsequently validated by experimental measurements. The results indicate that LSP generated a gradient nanostructure and gradient residual compressive stress field near the specimen surface, which together constituted a gradient structural layer (GSL). During high-temperature friction process, the existence of GSL altered the microstructural evolution and stress state of the worn surface, resulting in a transition of the dominant wear mechanism from adhesive wear to abrasive wear, which contributed to the significantly improved wear resistance of 17-4PH SS.

The system analysis method is suitable for detecting the optimal pathways for regional sustainable (e.g., green, low carbon) socioeconomic development. This study develops an inexact fractional energy–output–water–carbon nexus system planning model to minimize total carbon emission intensity (CEI, total carbon emissions/total economic output) under a set of nexus constraints. Superior to related research, the model (i) proposes a CEI considering both sectoral intermediate use (indirect) and final use (direct); (ii) quantifies the dependencies among energy, output, water, and carbon; (iii) restricts water utilization for carbon emission mitigation; (iv) adopts diverse mitigation measures to achieve carbon neutrality; (v) handles correlative chance-constraints and crisp credibility-constraints. A case in Fujian province (in China) is conducted to verify its feasibility. Results disclose that the total CEI would fluctuate between 45.05 g/CNY and 47.67 g/CNY under uncertainties. The annual total energy and total output would, on average, increase by 0.58% and 2.82%, respectively. Eight mitigation measures would be adopted to reduce the final carbon emission into the air to 0 by 2060. Compared with 2025, using water for carbon emission mitigation would increase 17-fold by 2060. For inland regions, authorities should incorporate other unconventional water sources. In addition, the coefficients of embodied energy consumption and water utilization are the most critical parameters.