Yiyuan Zhong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yiyuan Zhong has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Jingtian Tang
Central South University
5 shared publications - Zhengyong Ren
School of Geosciences and Info-Physics Central South University 410083 Changsha China
5 shared publications - Chaojian Chen
School of Geosciences and Info-Physics, Central South University, Changsha, China
4 shared publications - Huang Chen
School of Resources and Safety Engineering and the State Key Laboratory of Coal Mine Disaster Dynamics and Control, Chongqing University, Chongqing, China
2 shared publications - Kejia Pan
School of Mathematics and Statistics, HNP-LAMA, Central South University, Changsha, China
2 shared publications - Yen Joe Tan
Department of Earth and Environmental Sciences, The Chinese University of Hong Kong, Hong Kong SAR, China
2 shared publications
Latest Publications
- Open Access
- 14 June 2024
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 51 (12)
Deep‐Learning‐Based Phase Picking for Volcano‐Tectonic and Long‐Period Earthquakes
The application of deep‐learning‐based seismic phase pickers has surged in recent years. However, the efficacy of these models when applied to monitoring volcano seismicity has yet to be fully evaluated. Here, we first compile a data set of seismic waveforms from various volcanoes globally. We then show that the performances of two widely used deep‐learning pickers deteriorate systematically as the earthquakes' frequency content decreases. Therefore, the performances are especially poor for long‐period earthquakes often associated with fluid/magma movement. Subsequently, we train new models which perform significantly better, including when tested on two data sets where no training data were used: volcanic earthquakes along the Cascadia subduction zone and tectonic low‐frequency earthquakes along the Nankai Trough. Our model/workflow can be applied to improve monitoring of volcano seismicity globally while our compiled data set can be used to benchmark future methods for characterizing volcano seismicity, especially long‐period earthquakes which are difficult to monitor.
- 14 June 2024
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 51 (12)
Open AccessDeep‐Learning‐Based Phase Picking for Volcano‐Tectonic and Long‐Period Earthquakes
The application of deep‐learning‐based seismic phase pickers has surged in recent years. However, the efficacy of these models when applied to monitoring volcano seismicity has yet to be fully evaluated. Here, we first compile a data set of seismic waveforms from various volcanoes globally. We then show that the performances of two widely used deep‐learning pickers deteriorate systematically as the earthquakes' frequency content decreases. Therefore, the performances are especially poor for long‐period earthquakes often associated with fluid/magma movement. Subsequently, we train new models which perform significantly better, including when tested on two data sets where no training data were used: volcanic earthquakes along the Cascadia subduction zone and tectonic low‐frequency earthquakes along the Nankai Trough. Our model/workflow can be applied to improve monitoring of volcano seismicity globally while our compiled data set can be used to benchmark future methods for characterizing volcano seismicity, especially long‐period earthquakes which are difficult to monitor.
- Open Access
- 12 June 2024
- Published by Wiley
Deep‐Learning‐Based Phase Picking for Volcano‐Tectonic and Long‐Period Earthquakes
A document by Yiyuan Zhong. Click on the document to view its contents.
- 12 June 2024
- Published by Wiley
Open AccessDeep‐Learning‐Based Phase Picking for Volcano‐Tectonic and Long‐Period Earthquakes
A document by Yiyuan Zhong. Click on the document to view its contents.
- 21 September 2022
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 49 (18)
Magnetic Anomalies Caused by 3D Polyhedral Structures With Arbitrary Polynomial Magnetization
Magnetization is a natural property of magnetic materials which is widely used to analyze paramagnetic data, locate unexploded ordnance, explore mineral deposits and gas resources, and image anomalous magnetic structures in the Earth's crust. An essential and challenging task is to compute accurate magnetic anomalies caused by realistic magnetic 3D structures. In this study, for the first time, we derive the analytical expressions of magnetic potential, magnetic field and magnetic gradient tensor for magnetic materials with 3D polyhedral shapes and magnetization vectors that may vary in the space following polynomial trends. The order of polynomials can vary from one to high positive integers in both horizontal and vertical directions. Synthetic and realistic deposit models are used to validate our analytical solutions. We release the open‐source code in C++.
- 21 September 2022
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 49 (18)
Magnetic Anomalies Caused by 3D Polyhedral Structures With Arbitrary Polynomial Magnetization
Magnetization is a natural property of magnetic materials which is widely used to analyze paramagnetic data, locate unexploded ordnance, explore mineral deposits and gas resources, and image anomalous magnetic structures in the Earth's crust. An essential and challenging task is to compute accurate magnetic anomalies caused by realistic magnetic 3D structures. In this study, for the first time, we derive the analytical expressions of magnetic potential, magnetic field and magnetic gradient tensor for magnetic materials with 3D polyhedral shapes and magnetization vectors that may vary in the space following polynomial trends. The order of polynomials can vary from one to high positive integers in both horizontal and vertical directions. Synthetic and realistic deposit models are used to validate our analytical solutions. We release the open‐source code in C++.
- 19 May 2022
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 127 (5)
Constrained Gravity Inversion With Adaptive Inversion Grid Refinement in Spherical Coordinates and Its Application to Mantle Structure Beneath Tibetan Plateau
We develop a novel gravity inversion algorithm in spherical coordinates based on adaptive inversion mesh refinement and multiphysical parameter constraints. The inversion mesh is discretized into tesseroids (spherical prisms) to take the curvature of the Earth into account. To reduce the number of unknowns and computational cost, the inversion mesh is adaptively refined according to the spatial variation of parameters at each iteration. Wavelet compression is used to further reduce the computational requirement. Besides, to alleviate the nonuniqueness of inversion, the algorithm is capable of incorporating a priori models from other geophysical methods via cross‐gradient coupling and/or direct parameter coupling. For cross‐gradient coupling, the vector product of spatial gradients of two model parameters is included in the objective function. For direct parameter coupling, an a priori model is converted to a density model using the relation between two physical properties, which is then used as the initial and reference model in the inversion. A synthetic example is presented to demonstrate the effectiveness of our inversion method. Finally, we invert the gravity data over the Tibetan Plateau to obtain the density variations in the upper mantle, with a global S wave tomographic model used as a constraint. The inversion model shows that the mantle lithosphere beneath the Himalayan collision zone varies from west to east. Low‐density anomalies are observed beneath the southern and the northern Tibetan Plateau, which are consistent with published low‐velocity anomalies and magmatism distributions, possibly indicating two asthenospheric upwellings.
- 19 May 2022
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 127 (5)
Constrained Gravity Inversion With Adaptive Inversion Grid Refinement in Spherical Coordinates and Its Application to Mantle Structure Beneath Tibetan Plateau
We develop a novel gravity inversion algorithm in spherical coordinates based on adaptive inversion mesh refinement and multiphysical parameter constraints. The inversion mesh is discretized into tesseroids (spherical prisms) to take the curvature of the Earth into account. To reduce the number of unknowns and computational cost, the inversion mesh is adaptively refined according to the spatial variation of parameters at each iteration. Wavelet compression is used to further reduce the computational requirement. Besides, to alleviate the nonuniqueness of inversion, the algorithm is capable of incorporating a priori models from other geophysical methods via cross‐gradient coupling and/or direct parameter coupling. For cross‐gradient coupling, the vector product of spatial gradients of two model parameters is included in the objective function. For direct parameter coupling, an a priori model is converted to a density model using the relation between two physical properties, which is then used as the initial and reference model in the inversion. A synthetic example is presented to demonstrate the effectiveness of our inversion method. Finally, we invert the gravity data over the Tibetan Plateau to obtain the density variations in the upper mantle, with a global S wave tomographic model used as a constraint. The inversion model shows that the mantle lithosphere beneath the Himalayan collision zone varies from west to east. Low‐density anomalies are observed beneath the southern and the northern Tibetan Plateau, which are consistent with published low‐velocity anomalies and magmatism distributions, possibly indicating two asthenospheric upwellings.
- 1 May 2019
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 164, 53-64
A new method for gravity modeling using tesseroids and 2D Gauss-Legendre quadrature rule
- 1 May 2019
- Published by Elsevier in Journal of Applied Geophysics
- Vol. 164, 53-64
A new method for gravity modeling using tesseroids and 2D Gauss-Legendre quadrature rule
- 1 May 2019
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 84 (3) , A31-A35
New analytical expression of the magnetic gradient tensor for homogeneous polyhedrons
We have developed a new analytical expression for the magnetic-gradient tensor for polyhedrons with homogeneous magnetization vectors. Instead of performing the direct derivative on the closed-form solutions of the magnetic field, it is obtained by first transforming the volume integrals of the magnetic-field tensor into surface integrals over polyhedral facets, in terms of the gradient theorem. Second, the surface divergence theorem transforms the surface integrals over polyhedral facets into edge integrals and structure-simplified surface integrals. Third, we develop analytical expressions for these edge integrals and simplified surface integrals. We use a synthetic prismatic target to verify the accuracies of the new analytical expression. Excellent agreements are obtained between our results and those calculated by other published formulas. The new analytical expression of the magnetic-gradient tensor can play a fundamental role in advancing magnetic mineral explorations, environmental surveys, unexploded ordnance and submarine detection, aeromagnetic and marine magnetic surveys because more and more magnetic tensor data have been collected by magnetic-tensor gradiometry instruments.
- 1 May 2019
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 84 (3) , A31-A35
New analytical expression of the magnetic gradient tensor for homogeneous polyhedrons
We have developed a new analytical expression for the magnetic-gradient tensor for polyhedrons with homogeneous magnetization vectors. Instead of performing the direct derivative on the closed-form solutions of the magnetic field, it is obtained by first transforming the volume integrals of the magnetic-field tensor into surface integrals over polyhedral facets, in terms of the gradient theorem. Second, the surface divergence theorem transforms the surface integrals over polyhedral facets into edge integrals and structure-simplified surface integrals. Third, we develop analytical expressions for these edge integrals and simplified surface integrals. We use a synthetic prismatic target to verify the accuracies of the new analytical expression. Excellent agreements are obtained between our results and those calculated by other published formulas. The new analytical expression of the magnetic-gradient tensor can play a fundamental role in advancing magnetic mineral explorations, environmental surveys, unexploded ordnance and submarine detection, aeromagnetic and marine magnetic surveys because more and more magnetic tensor data have been collected by magnetic-tensor gradiometry instruments.
- Open Access
- 22 March 2018
- Published by Springer Nature in Surveys in Geophysics
- Vol. 39 (5) , 901-935
Gravity Gradient Tensor of Arbitrary 3D Polyhedral Bodies with up to Third-Order Polynomial Horizontal and Vertical Mass Contrasts
- 22 March 2018
- Published by Springer Nature in Surveys in Geophysics
- Vol. 39 (5) , 901-935
Open AccessGravity Gradient Tensor of Arbitrary 3D Polyhedral Bodies with up to Third-Order Polynomial Horizontal and Vertical Mass Contrasts
- 1 January 2018
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 83 (1) , G1-G13
Gravity anomalies of arbitrary 3D polyhedral bodies with horizontal and vertical mass contrasts up to cubic order
A new singularity-free analytical formula has been developed for the gravity field of arbitrary 3D polyhedral mass bodies with horizontally and vertically varying density contrast using third-order polynomial functions. First, the observation sites are moved to the origin of the coordinate system. Then, the volume and surface integral theorems are invoked successively to transform the volume integrals into surface integrals over polygonal faces and into line integrals over the edges of the polyhedral mass bodies. Furthermore, singularity-free closed-form solutions are derived for these line integrals over the edges. Thus, the observation sites can be located inside, on, or outside the 3D distributions. A synthetic prismatic mass body is adopted to verify the accuracy and singularity-free property of our newly developed analytical expressions. Excellent agreements are obtained between our solutions and other published closed-form solutions with relative errors in the order of to . In addition, an octahedral model and a near-Earth asteroid model are used to verify the accuracy of the presented method for complicated target structures by comparing the results with those from a high-order Gaussian quadrature approach.- 1 January 2018
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 83 (1) , G1-G13
Gravity anomalies of arbitrary 3D polyhedral bodies with horizontal and vertical mass contrasts up to cubic order
A new singularity-free analytical formula has been developed for the gravity field of arbitrary 3D polyhedral mass bodies with horizontally and vertically varying density contrast using third-order polynomial functions. First, the observation sites are moved to the origin of the coordinate system. Then, the volume and surface integral theorems are invoked successively to transform the volume integrals into surface integrals over polygonal faces and into line integrals over the edges of the polyhedral mass bodies. Furthermore, singularity-free closed-form solutions are derived for these line integrals over the edges. Thus, the observation sites can be located inside, on, or outside the 3D distributions. A synthetic prismatic mass body is adopted to verify the accuracy and singularity-free property of our newly developed analytical expressions. Excellent agreements are obtained between our solutions and other published closed-form solutions with relative errors in the order of to . In addition, an octahedral model and a near-Earth asteroid model are used to verify the accuracy of the presented method for complicated target structures by comparing the results with those from a high-order Gaussian quadrature approach.