Krystian Nowakowski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Krystian Nowakowski has a total of 69 co-authors. Here are the top co-authors by number of shared publications:
- Frank H. L. Koppens
ICFO - Institut de Ciències Fotòniques, The Barcelona Institute of Science and Technology, Castelldefels (Barcelona), Spain
4 shared publications - Hitesh Agarwal
ICFO—Institut de Ciències Fotòniques, The Barcelona Institute of Science and Technology, Castelldefels (Barcelona), Spain
4 shared publications - Kenji Watanabe
National Institute for Materials Science
4 shared publications - Riccardo Bertini
ICFO—Institut de Ciències Fotòniques, The Barcelona Institute of Science and Technology, Castelldefels (Barcelona), Spain
4 shared publications - Roshan Krishna Kumar
ICFO - Institut de Ciències Fotòniques, The Barcelona Institute of Science and Technology, Castelldefels (Barcelona), Spain
4 shared publications - Takashi Taniguchi
National Institute for Materials Science
4 shared publications
Latest Publications
- 7 August 2025
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 389 (6760) , 644-649
Single-photon detection enabled by negative differential conductivity in moiré superlattices
Detecting individual light quanta is essential for quantum information, space exploration, advanced machine vision, and fundamental science. In this work, we introduce a single-photon detection mechanism using highly photosensitive nonequilibrium electron phases in moiré materials. Using tunable bands in bilayer graphene/hexagonal boron nitride superlattices, we engineer negative differential conductance and a sensitive bistable state capable of detecting single photons. Operating in this regime, we demonstrate single-photon counting at mid-infrared (11.3 micrometers) and visible wavelengths (675 nanometers) and temperatures up to 25 kelvin. This detector offers prospects for broadband, high-temperature quantum technologies with complementary metal-oxide semiconductor compatibility and seamless integration into photonic-integrated circuits. Our analysis suggests that the underlying mechanism originates from superlattice-induced negative differential velocity.
- 7 August 2025
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 389 (6760) , 644-649
Single-photon detection enabled by negative differential conductivity in moiré superlattices
Detecting individual light quanta is essential for quantum information, space exploration, advanced machine vision, and fundamental science. In this work, we introduce a single-photon detection mechanism using highly photosensitive nonequilibrium electron phases in moiré materials. Using tunable bands in bilayer graphene/hexagonal boron nitride superlattices, we engineer negative differential conductance and a sensitive bistable state capable of detecting single photons. Operating in this regime, we demonstrate single-photon counting at mid-infrared (11.3 micrometers) and visible wavelengths (675 nanometers) and temperatures up to 25 kelvin. This detector offers prospects for broadband, high-temperature quantum technologies with complementary metal-oxide semiconductor compatibility and seamless integration into photonic-integrated circuits. Our analysis suggests that the underlying mechanism originates from superlattice-induced negative differential velocity.
- Open Access
- 1 April 2025
- Published by Springer Nature in Nature Materials
- Vol. 24 (6) , 978
Author Correction: Terahertz photocurrent probe of quantum geometry and interactions in magic-angle twisted bilayer graphene
- 1 April 2025
- Published by Springer Nature in Nature Materials
- Vol. 24 (6) , 978
Open AccessAuthor Correction: Terahertz photocurrent probe of quantum geometry and interactions in magic-angle twisted bilayer graphene
- 24 March 2025
- Published by Springer Nature in Nature Materials
- Vol. 24 (7) , 1034-1041
Terahertz photocurrent probe of quantum geometry and interactions in magic-angle twisted bilayer graphene
Moiré materials represent strongly interacting electron systems bridging topological and correlated physics. Despite notable advances, decoding wavefunction properties underlying the quantum geometry remains challenging. Here we utilize polarization-resolved photocurrent measurements to probe magic-angle twisted bilayer graphene, leveraging its sensitivity to the Berry connection that encompasses quantum ‘textures’ of electron wavefunctions. Using terahertz light resonant with optical transitions of its flat bands, we observe bulk photocurrents driven by broken symmetries and reveal the interplay between electron interactions and quantum geometry. We observe inversion-breaking gapped states undetectable through quantum transport, sharp changes in the polarization axes caused by interaction-induced band renormalization and recurring photocurrent patterns at integer filling factors of the moiré unit cell that track the evolution of quantum geometry through the cascade of phase transitions. The large and tunable terahertz response intrinsic to flat-band systems offers direct insights into the quantum geometry of interacting electrons and paves the way for innovative terahertz quantum technologies.
- 24 March 2025
- Published by Springer Nature in Nature Materials
- Vol. 24 (7) , 1034-1041
Terahertz photocurrent probe of quantum geometry and interactions in magic-angle twisted bilayer graphene
Moiré materials represent strongly interacting electron systems bridging topological and correlated physics. Despite notable advances, decoding wavefunction properties underlying the quantum geometry remains challenging. Here we utilize polarization-resolved photocurrent measurements to probe magic-angle twisted bilayer graphene, leveraging its sensitivity to the Berry connection that encompasses quantum ‘textures’ of electron wavefunctions. Using terahertz light resonant with optical transitions of its flat bands, we observe bulk photocurrents driven by broken symmetries and reveal the interplay between electron interactions and quantum geometry. We observe inversion-breaking gapped states undetectable through quantum transport, sharp changes in the polarization axes caused by interaction-induced band renormalization and recurring photocurrent patterns at integer filling factors of the moiré unit cell that track the evolution of quantum geometry through the cascade of phase transitions. The large and tunable terahertz response intrinsic to flat-band systems offers direct insights into the quantum geometry of interacting electrons and paves the way for innovative terahertz quantum technologies.
- 21 September 2023
- Published by Springer Nature in Nature Photonics
- Vol. 17 (12) , 1047-1053
Ultra-broadband photoconductivity in twisted graphene heterostructures with large responsivity
- 21 September 2023
- Published by Springer Nature in Nature Photonics
- Vol. 17 (12) , 1047-1053
Ultra-broadband photoconductivity in twisted graphene heterostructures with large responsivity
- Open Access
- 6 April 2020
- Published by American Physical Society (APS) in Physical Review B
- Vol. 101 (16) , 165103
Spin splitting and strain in epitaxial monolayer on grapheneWe present the electronic and structural properties of monolayer grown by pulsed-laser deposition on monolayer graphene (MLG) on SiC. The spin splitting in the valence band at was eV, as determined by angle-resolved photoemission spectroscopy. Synchrotron-based grazing-incidence in-plane x-ray diffraction (XRD) revealed the in-plane lattice constant of monolayer to be Å. This indicates a lattice compression of % relative to bulk . By using the experimentally determined graphene lattice constant ( Å), we found that a unit cell of the slightly compressed is perfectly commensurate with a graphene lattice with a mismatch below 0.03%, which could explain why the monolayer is compressed on MLG. From XRD and first-principles calculations, we conclude that the observed size of strain will affect only on the order of a few meV. In addition, angle-resolved, ultraviolet, and x-ray photoelectron spectroscopies shed light on the band alignment between and MLG/SiC and indicate electron transfer from graphene to the monolayer. As further revealed by atomic force microscopy, the island size depends on the number of carbon layers on top of the SiC substrate. This suggests that the epitaxy of favors the weak van der Waals interactions with graphene, while it is perturbed by the influence of the SiC substrate and its carbon buffer layer.- 6 April 2020
- Published by American Physical Society (APS) in Physical Review B
- Vol. 101 (16) , 165103
Open AccessSpin splitting and strain in epitaxial monolayer on grapheneWe present the electronic and structural properties of monolayer grown by pulsed-laser deposition on monolayer graphene (MLG) on SiC. The spin splitting in the valence band at was eV, as determined by angle-resolved photoemission spectroscopy. Synchrotron-based grazing-incidence in-plane x-ray diffraction (XRD) revealed the in-plane lattice constant of monolayer to be Å. This indicates a lattice compression of % relative to bulk . By using the experimentally determined graphene lattice constant ( Å), we found that a unit cell of the slightly compressed is perfectly commensurate with a graphene lattice with a mismatch below 0.03%, which could explain why the monolayer is compressed on MLG. From XRD and first-principles calculations, we conclude that the observed size of strain will affect only on the order of a few meV. In addition, angle-resolved, ultraviolet, and x-ray photoelectron spectroscopies shed light on the band alignment between and MLG/SiC and indicate electron transfer from graphene to the monolayer. As further revealed by atomic force microscopy, the island size depends on the number of carbon layers on top of the SiC substrate. This suggests that the epitaxy of favors the weak van der Waals interactions with graphene, while it is perturbed by the influence of the SiC substrate and its carbon buffer layer. - 27 February 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (12) , 5548-5556
Control of the metal/WS2 contact properties using 2-dimensional buffer layers
In order to precisely control current flow through electrical contacts to WS2, MoSe2 and graphene were used as thin interfacial buffer layers. As shown by spatially-resolved conductive-AFM data, the barrier heights are tunable with MoSe2 buffer layer thickness, while graphene enhances transport by depinning the Fermi level.
- 27 February 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (12) , 5548-5556
Control of the metal/WS2 contact properties using 2-dimensional buffer layers
In order to precisely control current flow through electrical contacts to WS2, MoSe2 and graphene were used as thin interfacial buffer layers. As shown by spatially-resolved conductive-AFM data, the barrier heights are tunable with MoSe2 buffer layer thickness, while graphene enhances transport by depinning the Fermi level.
- Open Access
- 14 February 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (9) , 5411-5420
Universal Fermi-Level Pinning in Transition-Metal Dichalcogenides
Understanding the electron transport through transition metal dichalcogenides (TMDCs) based semiconductor/metal junctions is vital for the realization of future TMDC based (opto-)electronic devices. Despite the bonding in TMDCs being largely constrained within the layers, strong Fermi level pinning was observed in TMDC based devices, reducing the tunability of the Schottky barrier height. We present evidence that metal induced gap states (MIGS) are the origin for the large Fermi level pinning similar to conventional semiconductors. A variety of TMDCs (MoSe2, WSe2, WS2 and MoTe2) were investigated using high-spatial resolution surface characterization techniques, permitting us to distinguish between defected and pristine regions. The Schottky barrier heights on the pristine regions can be explained by MIGS, inducing partial Fermi level pinning. The Fermi level pinning strength is further enhanced by disorder induced gap states (DIGS) induced by transition metal vacancies or substitutionals at the defected regions. Our findings emphasize the importance of defects on the electron transport properties in TMDC based devices and confirm the origin of Fermi level pinning in TMDC based metal/semiconductor junctions.
- 14 February 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (9) , 5411-5420
Open AccessUniversal Fermi-Level Pinning in Transition-Metal Dichalcogenides
Understanding the electron transport through transition metal dichalcogenides (TMDCs) based semiconductor/metal junctions is vital for the realization of future TMDC based (opto-)electronic devices. Despite the bonding in TMDCs being largely constrained within the layers, strong Fermi level pinning was observed in TMDC based devices, reducing the tunability of the Schottky barrier height. We present evidence that metal induced gap states (MIGS) are the origin for the large Fermi level pinning similar to conventional semiconductors. A variety of TMDCs (MoSe2, WSe2, WS2 and MoTe2) were investigated using high-spatial resolution surface characterization techniques, permitting us to distinguish between defected and pristine regions. The Schottky barrier heights on the pristine regions can be explained by MIGS, inducing partial Fermi level pinning. The Fermi level pinning strength is further enhanced by disorder induced gap states (DIGS) induced by transition metal vacancies or substitutionals at the defected regions. Our findings emphasize the importance of defects on the electron transport properties in TMDC based devices and confirm the origin of Fermi level pinning in TMDC based metal/semiconductor junctions.
- 24 December 2018
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 19 (2) , 1190-1196
Barrier Inhomogeneities in Atomic Contacts on WS2
The downscaling of electrical components requires a proper understanding of the physical mechanisms governing charge transport. Here, we have investigated atomic-scale contacts and their transport characteristics on WS2 using conductive atomic force microscopy (c-AFM). We demonstrate that c-AFM can provide true atomic resolution, revealing atom vacancies, ad-atoms and periodic modulations arising from electronic effects. Moreover, we find a lateral variation of the surface conductivity that arises from the lattice periodicity of WS2. Three distinct sites are identified, i.e., atop, bridge and hollow. The current transport across these atomic metal-semiconductor interfaces is understood by considering thermionic emission and Fowler-Nordheim tunnelling. Current modulations arising from point defects and the contact geometry promise a novel route for the direct control of atomic point contacts in diodes and devices.
- 24 December 2018
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 19 (2) , 1190-1196
Barrier Inhomogeneities in Atomic Contacts on WS2
The downscaling of electrical components requires a proper understanding of the physical mechanisms governing charge transport. Here, we have investigated atomic-scale contacts and their transport characteristics on WS2 using conductive atomic force microscopy (c-AFM). We demonstrate that c-AFM can provide true atomic resolution, revealing atom vacancies, ad-atoms and periodic modulations arising from electronic effects. Moreover, we find a lateral variation of the surface conductivity that arises from the lattice periodicity of WS2. Three distinct sites are identified, i.e., atop, bridge and hollow. The current transport across these atomic metal-semiconductor interfaces is understood by considering thermionic emission and Fowler-Nordheim tunnelling. Current modulations arising from point defects and the contact geometry promise a novel route for the direct control of atomic point contacts in diodes and devices.