Siti Aishah Mohamad Badaruddin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Siti Aishah Mohamad Badaruddin has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Chia Sheng Bien
MIMOS BERHAD
2 shared publications - Hing Wah Lee
Nanoelectronics Lab, MIMOS Berhad, Technology Park Malaysia, Kuala Lumpur 57000, Malaysia
2 shared publications - Abdul Manaf Hashim
Malaysia-Japan International Institute of Technology (MJIIT), Universiti Teknologi Malaysia (UTM), Kuala Lumpur, Malaysia
1 shared publication - Mohd Faizol Abdullah
MIMOS Semiconductor (M) Sdn Bhd, Technology Park Malaysia, 57000 Kuala Lumpur, Malaysia
1 shared publication - Mohd Rofei Mat Hussin
MIMOS Berhad, Technology Park Malaysia, Kuala Lumpur 57000, Malaysia
1 shared publication - Norazreen Abd Aziz
Department of Electrical, Electronic and Systems Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia, Bangi, Malaysia
1 shared publication
Latest Publications
- Open Access
Highly Sensitive Sub-ppm CH3COOH Detection by Improved Assembly of Sn3O4-RGO Nanocomposite
Detection of sub-ppm acetic acid (CH3COOH) is in demand for environmental gas monitoring. In this article, we propose a CH3COOH gas sensor based on Sn3O4 and reduced graphene oxide (RGO), where the assembly of Sn3O4-RGO nanocomposites is dependent on the synthesis method. Three nanocomposites prepared by three different synthesis methods are investigated. The optimum assembly is by hydrothermal reactions of Sn4+ salts and pre-reduced RGO (designated as RS nanocomposite). Raman spectra verified the fingerprint of RGO in the synthesized RS nanocomposite. The Sn3O4 planes of (111), (210), (130), () are observed from the X-ray diffractogram, and its average crystallite size is 3.94 nm. X-ray photoelectron spectroscopy on Sn3d and O1s spectra confirm the stoichiometry of Sn3O4 with Sn:O ratio = 0.76. Sn3O4-RGO-RS exhibits the highest response of 74% and 4% at 2 and 0.3 ppm, respectively. The sensitivity within sub-ppm CH3COOH is 64%/ppm. Its superior sensing performance is owing to the embedded and uniformly wrapped Sn3O4 nanoparticles on RGO sheets. This allows a massive relative change in electron concentration at the Sn3O4-RGO heterojunction during the on/off exposure of CH3COOH. Additionally, the operation is performed at room temperature, possesses good repeatability, and consumes only ~4 µW, and is a step closer to the development of a commercial CH3COOH sensor.Open AccessHighly Sensitive Sub-ppm CH3COOH Detection by Improved Assembly of Sn3O4-RGO Nanocomposite
Detection of sub-ppm acetic acid (CH3COOH) is in demand for environmental gas monitoring. In this article, we propose a CH3COOH gas sensor based on Sn3O4 and reduced graphene oxide (RGO), where the assembly of Sn3O4-RGO nanocomposites is dependent on the synthesis method. Three nanocomposites prepared by three different synthesis methods are investigated. The optimum assembly is by hydrothermal reactions of Sn4+ salts and pre-reduced RGO (designated as RS nanocomposite). Raman spectra verified the fingerprint of RGO in the synthesized RS nanocomposite. The Sn3O4 planes of (111), (210), (130), () are observed from the X-ray diffractogram, and its average crystallite size is 3.94 nm. X-ray photoelectron spectroscopy on Sn3d and O1s spectra confirm the stoichiometry of Sn3O4 with Sn:O ratio = 0.76. Sn3O4-RGO-RS exhibits the highest response of 74% and 4% at 2 and 0.3 ppm, respectively. The sensitivity within sub-ppm CH3COOH is 64%/ppm. Its superior sensing performance is owing to the embedded and uniformly wrapped Sn3O4 nanoparticles on RGO sheets. This allows a massive relative change in electron concentration at the Sn3O4-RGO heterojunction during the on/off exposure of CH3COOH. Additionally, the operation is performed at room temperature, possesses good repeatability, and consumes only ~4 µW, and is a step closer to the development of a commercial CH3COOH sensor. - Open Access
- 6 June 2012
- Published by Springer Nature in Discover Nano
- Vol. 7 (1) , 288
Formation of silicon nanostructures with a combination of spacer technology and deep reactive ion etching
A new method of fabricating high aspect ratio nanostructures in silicon without the use of sub-micron lithographic technique is reported. The proposed method comprises two important steps including the use of CMOS spacer technique to form silicon nitride nanostructure masking followed by deep reactive ion etching (DRIE) of the silicon substrate to form the final silicon nanostructures. Silicon dioxide is used as the sacrificial layer to form the silicon nitride nanostructures. With DRIE a high etch selectivity of 50:1 between silicon and silicon nitride was achieved. The use of the spacer technique is particularly advantageous where self-aligned nanostructures with potentially unlimited lengths are formed without the need of submicron lithographic tools and resist materials. With this method, uniform arrays of 100 nm silicon nanostructures which are at least 4 μm tall with aspect ratio higher than 40 were successfully fabricated.
- 6 June 2012
- Published by Springer Nature in Discover Nano
- Vol. 7 (1) , 288
Open AccessFormation of silicon nanostructures with a combination of spacer technology and deep reactive ion etching
A new method of fabricating high aspect ratio nanostructures in silicon without the use of sub-micron lithographic technique is reported. The proposed method comprises two important steps including the use of CMOS spacer technique to form silicon nitride nanostructure masking followed by deep reactive ion etching (DRIE) of the silicon substrate to form the final silicon nanostructures. Silicon dioxide is used as the sacrificial layer to form the silicon nitride nanostructures. With DRIE a high etch selectivity of 50:1 between silicon and silicon nitride was achieved. The use of the spacer technique is particularly advantageous where self-aligned nanostructures with potentially unlimited lengths are formed without the need of submicron lithographic tools and resist materials. With this method, uniform arrays of 100 nm silicon nanostructures which are at least 4 μm tall with aspect ratio higher than 40 were successfully fabricated.
- Open Access
- 4 October 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 543
Selective formation of tungsten nanowires
We report on a process for fabricating self-aligned tungsten (W) nanowires with polycrystalline silicon core. Tungsten nanowires as thin as 10 nm were formed by utilizing polysilicon sidewall transfer technology followed by selective deposition of tungsten by chemical vapor deposition (CVD) using WF6 as the precursor. With selective CVD, the process is self-limiting whereby the tungsten formation is confined to the polysilicon regions; hence, the nanowires are formed without the need for lithography or for additional processing. The fabricated tungsten nanowires were observed to be perfectly aligned, showing 100% selectivity to polysilicon and can be made to be electrically isolated from one another. The electrical conductivity of the nanowires was characterized to determine the effect of its physical dimensions. The conductivity for the tungsten nanowires were found to be 40% higher when compared to doped polysilicon nanowires of similar dimensions.
- 4 October 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 543
Open AccessSelective formation of tungsten nanowires
We report on a process for fabricating self-aligned tungsten (W) nanowires with polycrystalline silicon core. Tungsten nanowires as thin as 10 nm were formed by utilizing polysilicon sidewall transfer technology followed by selective deposition of tungsten by chemical vapor deposition (CVD) using WF6 as the precursor. With selective CVD, the process is self-limiting whereby the tungsten formation is confined to the polysilicon regions; hence, the nanowires are formed without the need for lithography or for additional processing. The fabricated tungsten nanowires were observed to be perfectly aligned, showing 100% selectivity to polysilicon and can be made to be electrically isolated from one another. The electrical conductivity of the nanowires was characterized to determine the effect of its physical dimensions. The conductivity for the tungsten nanowires were found to be 40% higher when compared to doped polysilicon nanowires of similar dimensions.