Anne Chantal Gouget-Laemmel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Anne Chantal Gouget-Laemmel has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Aloysius Siriwardena
Laboratoire de Glycochimie des Antimicrobiens et des Agroressources (LG2A), (FRE 3517-CNRS), Université de Picardie Jules Verne, 33 Rue St Leu, 80039 Amiens, France
2 shared publicationsFrançois Ozanam
Physique de la Matière Condensée, Ecole Polytechnique-CNRS, France
2 shared publications- François Ozanam
Physique de la Matière Condensée, École Polytechnique, CNRS, 91128 Palaiseau, France
2 shared publications Jean-Noël Chazalviel
Physique de la Matière Condensée, Ecole Polytechnique-CNRS, 91128 Palaiseau, France
2 shared publications- Jie Yang
Physique de la Matière Condensée, Ecole Polytechnique-CNRS, France
2 shared publications - Rabah Boukherroub
Univ. Lille, CNRS, Univ. Polytechnique Hauts-de-France, UMR 8520, IEMN, Lille F-59000, France
2 shared publications
Latest Publications
- 1 February 2016
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 464, 198-205
A quantitative method to discriminate between non-specific and specific lectin–glycan interactions on silicon-modified surfaces
- 1 February 2016
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 464, 198-205
A quantitative method to discriminate between non-specific and specific lectin–glycan interactions on silicon-modified surfaces
- 12 September 2014
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 86 (20) , 10340-10349
Quantitative Assessment of the Multivalent Protein–Carbohydrate Interactions on Silicon
A key challenge in the development of glycan arrays is that the sensing interface be fabricated reliably so as to ensure the sensitive and accurate analysis of the protein–carbohydrate interaction of interest, reproducibly. These goals are complicated in the case of glycan arrays as surface sugar density can influence dramatically the strength and mode of interaction of the sugar ligand at any interface with lectin partners. In this Article, we describe the preparation of carboxydecyl-terminated crystalline silicon (111) surfaces onto which are grafted either mannosyl moieties or a mixture of mannose and spacer alcohol molecules to provide “diluted” surfaces. The fabrication of the silicon surfaces was achieved efficiently through a strategy implicating a “click” coupling step. The interactions of these newly fabricated glycan interfaces with the lectin, Lens culinaris, have been characterized using quantitative infrared (IR) spectroscopy in the attenuated total geometry (ATR). The density of mannose probes and lectin targets was precisely determined for the first time by the aid of special IR calibration experiments, thus allowing for the interpretation of the distribution of mannose and its multivalent binding with lectins. These experimental findings were accounted for by numerical simulations of lectin adsorption.
- 12 September 2014
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 86 (20) , 10340-10349
Quantitative Assessment of the Multivalent Protein–Carbohydrate Interactions on Silicon
A key challenge in the development of glycan arrays is that the sensing interface be fabricated reliably so as to ensure the sensitive and accurate analysis of the protein–carbohydrate interaction of interest, reproducibly. These goals are complicated in the case of glycan arrays as surface sugar density can influence dramatically the strength and mode of interaction of the sugar ligand at any interface with lectin partners. In this Article, we describe the preparation of carboxydecyl-terminated crystalline silicon (111) surfaces onto which are grafted either mannosyl moieties or a mixture of mannose and spacer alcohol molecules to provide “diluted” surfaces. The fabrication of the silicon surfaces was achieved efficiently through a strategy implicating a “click” coupling step. The interactions of these newly fabricated glycan interfaces with the lectin, Lens culinaris, have been characterized using quantitative infrared (IR) spectroscopy in the attenuated total geometry (ATR). The density of mannose probes and lectin targets was precisely determined for the first time by the aid of special IR calibration experiments, thus allowing for the interpretation of the distribution of mannose and its multivalent binding with lectins. These experimental findings were accounted for by numerical simulations of lectin adsorption.
- 1 October 2012
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 28 (41) , 14654-14664
Influence of the Molecular Design on the Antifouling Performance of Poly(ethylene glycol) Monolayers Grafted on (111) Si
Various poly(ethylene glycol) monomethyl ether moieties were grafted onto hydrogenated silicon surfaces in order to investigate the influence of the molecular design on the antifouling performance of such coatings. The grafted chains were either oligo(ethylene oxide) chains (EG)nOMe bound to silicon via Si–O–C covalent bonds, or hybrid alkyl/oligo(ethylene oxide) chains Cp(EG)nOMe bound via Si–C covalent bonds (from home-synthesized precursors). Quantitative IR spectroscopy gave the molecular coverage of the grafted layers, and AFM imaging demonstrated that a proper surfactinated rinse yields Cp(EG)nOMe layers free of unwanted residues. The protein-repellent character of these grafted layers (here, toward BSA) was studied by IR and AFM imaging. Cp(EG)nOMe layers exhibit a lower surface concentration than (EG)nOMe layers, because of the presence of a solvent in the grafting solution; they however demonstrate high resistance against BSA adsorption for high values of the n/p ratio and a higher stability than (EG)nOMe. This behavior is consistently explained by the poor ordering capability of the alkyl part of the layer, contrary to what is observed for similar layers on Au, and the key role of an entangled arrangement of the ethylene oxide chains which forms when these chains are long enough.
- 1 October 2012
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 28 (41) , 14654-14664
Influence of the Molecular Design on the Antifouling Performance of Poly(ethylene glycol) Monolayers Grafted on (111) Si
Various poly(ethylene glycol) monomethyl ether moieties were grafted onto hydrogenated silicon surfaces in order to investigate the influence of the molecular design on the antifouling performance of such coatings. The grafted chains were either oligo(ethylene oxide) chains (EG)nOMe bound to silicon via Si–O–C covalent bonds, or hybrid alkyl/oligo(ethylene oxide) chains Cp(EG)nOMe bound via Si–C covalent bonds (from home-synthesized precursors). Quantitative IR spectroscopy gave the molecular coverage of the grafted layers, and AFM imaging demonstrated that a proper surfactinated rinse yields Cp(EG)nOMe layers free of unwanted residues. The protein-repellent character of these grafted layers (here, toward BSA) was studied by IR and AFM imaging. Cp(EG)nOMe layers exhibit a lower surface concentration than (EG)nOMe layers, because of the presence of a solvent in the grafting solution; they however demonstrate high resistance against BSA adsorption for high values of the n/p ratio and a higher stability than (EG)nOMe. This behavior is consistently explained by the poor ordering capability of the alkyl part of the layer, contrary to what is observed for similar layers on Au, and the key role of an entangled arrangement of the ethylene oxide chains which forms when these chains are long enough.
- Open Access
- 6 June 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 412
Peptide immobilisation on porous silicon surface for metal ions detection
In this work, a Glycyl-Histidyl-Glycyl-Histidine (GlyHisGlyHis) peptide is covalently anchored to the porous silicon PSi surface using a multi-step reaction scheme compatible with the mild conditions required for preserving the probe activity. In a first step, alkene precursors are grafted onto the hydrogenated PSi surface using the hydrosilylation route, allowing for the formation of a carboxyl-terminated monolayer which is activated by reaction with N-hydroxysuccinimide in the presence of a peptide-coupling carbodiimide N-ethyl-N'-(3-dimethylaminopropyl)-carbodiimide and subsequently reacted with the amino linker of the peptide to form a covalent amide bond. Infrared spectroscopy (FT-IR) and X-ray photoelectron spectroscopy are used to investigate the different steps of functionalization.
- 6 June 2011
- Published by Springer Nature in Discover Nano
- Vol. 6 (1) , 412
Open AccessPeptide immobilisation on porous silicon surface for metal ions detection
In this work, a Glycyl-Histidyl-Glycyl-Histidine (GlyHisGlyHis) peptide is covalently anchored to the porous silicon PSi surface using a multi-step reaction scheme compatible with the mild conditions required for preserving the probe activity. In a first step, alkene precursors are grafted onto the hydrogenated PSi surface using the hydrosilylation route, allowing for the formation of a carboxyl-terminated monolayer which is activated by reaction with N-hydroxysuccinimide in the presence of a peptide-coupling carbodiimide N-ethyl-N'-(3-dimethylaminopropyl)-carbodiimide and subsequently reacted with the amino linker of the peptide to form a covalent amide bond. Infrared spectroscopy (FT-IR) and X-ray photoelectron spectroscopy are used to investigate the different steps of functionalization.