Alexander Pogromsky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexander Pogromsky has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
- Henk Nijmeijer
Eindhoven University of Technology
19 shared publications - Alexey S. Matveev
Sirius University
8 shared publications - Jacobus E. Rooda
Department of Mechanical Engineering, Eindhoven University of Technology, Eindhoven, The Netherlands
8 shared publications - Brandon Caasenbrood
Eindhoven University of Technology
7 shared publications - Roel van Den Berg
Department of Mechanical Engineering Eindhoven University of Technology P.O. Box 513, 5600 MB Eindhoven, The Netherlands
5 shared publications - Kirill Rogov
Department of Mechanical Engineering, Eindhoven University of Technology 1 , Eindhoven 5612 AZ, The Netherlands
3 shared publications
Latest Publications
- 2 September 2026
- Published by Springer Nature
- p. 221-228
Conclusions and Recommendations
- 2 September 2026
- Published by Springer Nature
- p. 27-47
A Brief Historical Overview on the Progress of Soft Robotics
- 2 September 2026
- Published by Springer Nature
- p. 27-47
A Brief Historical Overview on the Progress of Soft Robotics
- 2 September 2026
- Published by Springer Nature
- p. 159-219
Sorotoki—A General MATLAB Package for the Design, Modeling and Control of Soft Robots
- 2 September 2026
- Published by Springer Nature
- p. 159-219
Sorotoki—A General MATLAB Package for the Design, Modeling and Control of Soft Robots
- 2 September 2026
- Published by Springer Nature
- p. 75-122
Dynamic Modeling of Soft Robots—The Constant Strain Approach
- 2 September 2026
- Published by Springer Nature
- p. 75-122
Dynamic Modeling of Soft Robots—The Constant Strain Approach
- 2 September 2026
- Published by Springer Nature
- p. 1-25
Introduction
- 2 September 2026
- Published by Springer Nature
- p. 123-158
Port-Hamiltonian Cosserat Models for Soft Robots—Beyond the Constant Strain Approach
- 2 September 2026
- Published by Springer Nature
- p. 123-158
Port-Hamiltonian Cosserat Models for Soft Robots—Beyond the Constant Strain Approach
- 2 September 2026
- Published by Springer Nature
- p. 49-73
Gradient-Based Optimization for Soft Robots
- Open Access
- 1 September 2026
- Published by AIP Publishing in Chaos: An Interdisciplinary Journal of Nonlinear Science
- Vol. 36 (9)
Huygens’ synchrony: Emergent modes of planar symmetrically coupled pendula
We study the collective dynamics of metronomes coupled through a common platform that is free to move in two spatial dimensions, extending Huygens’ classical experiment on synchronizing pendulum clocks. Allowing planar motion of the coupling medium gives rise to emerging robust synchronization patterns. Experiments reveal a geometry-induced transition between two qualitatively distinct collective states: a translational mode, in which the metronomes synchronize with shifted phases and drive planar translation of the platform, and a rotational mode, characterized by in-phase synchronization and oscillatory rotation about the platform’s center of mass. The transition between these modes is controlled by the spatial arrangement of the oscillators and is naturally interpreted as a symmetry-related bifurcation. First-principles multibody simulations reproduce the observed behaviors, while application of the Harmonic Balance method enables analytical continuation and characterization of both stable and unstable synchronized solutions. These results highlight how multidimensional dynamical coupling and symmetry alone can organize collective motion, providing a minimal mechanical setting for studying emergent synchronization phenomena in nonlinear oscillator networks.
- 1 September 2026
- Published by AIP Publishing in Chaos: An Interdisciplinary Journal of Nonlinear Science
- Vol. 36 (9)
Open AccessHuygens’ synchrony: Emergent modes of planar symmetrically coupled pendula
We study the collective dynamics of metronomes coupled through a common platform that is free to move in two spatial dimensions, extending Huygens’ classical experiment on synchronizing pendulum clocks. Allowing planar motion of the coupling medium gives rise to emerging robust synchronization patterns. Experiments reveal a geometry-induced transition between two qualitatively distinct collective states: a translational mode, in which the metronomes synchronize with shifted phases and drive planar translation of the platform, and a rotational mode, characterized by in-phase synchronization and oscillatory rotation about the platform’s center of mass. The transition between these modes is controlled by the spatial arrangement of the oscillators and is naturally interpreted as a symmetry-related bifurcation. First-principles multibody simulations reproduce the observed behaviors, while application of the Harmonic Balance method enables analytical continuation and characterization of both stable and unstable synchronized solutions. These results highlight how multidimensional dynamical coupling and symmetry alone can organize collective motion, providing a minimal mechanical setting for studying emergent synchronization phenomena in nonlinear oscillator networks.
- Open Access
- 30 May 2026
- Published by Elsevier in SSRN Electronic Journal
A Soft Ring Robot for Adaptive Locomotion
This paper presents the design and experimental validation of a soft robotic ring that achieves planar locomotion by combining wheel-like efficiency with structural adaptability. In contrast to rigid or hybrid wheel designs that embed soft actuation within a fixed load-bearing frame, the presented system treats the wheel itself as a fully deformable structural element. A pneumatically actuated elastomeric ring is coupled to a rigid internal cart containing most of the system’s mass. Locomotion and large-scale shape reconfiguration are generated through coordinated pressure modulation and controlled redistribution of the center-of-mass, enabling rolling motion, adaptive load transfer, and geometric transformation. Experimental studies demonstrate stable planar locomotion and consistent obstacle traversal under open-loop control, with low trial-to-trial variation in traversal time, indicating repeatable behavior. The robot ascends obstacles up to 69% of its unactuated height and descends obstacles up to 82%, exceeding the geometric limits of rigid wheels of comparable size. The reliability of these behaviors without feedback control highlights that morphological adaptation is achieved through the physical architecture rather than complex control strategies. By relocating compliance to the primary load-bearing structure and coupling it with mass redistribution, the system enables controlled reconfiguration of contact geometry and load paths during environmental interaction. The soft ring robot therefore establishes a morphology-driven locomotion strategy that is compact, energy-efficient, and inherently compliant, making it well suited for operation in unstructured or sensitive environments where fixed-geometry platforms are prone to immobilization or disturbance.
- 30 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessA Soft Ring Robot for Adaptive Locomotion
This paper presents the design and experimental validation of a soft robotic ring that achieves planar locomotion by combining wheel-like efficiency with structural adaptability. In contrast to rigid or hybrid wheel designs that embed soft actuation within a fixed load-bearing frame, the presented system treats the wheel itself as a fully deformable structural element. A pneumatically actuated elastomeric ring is coupled to a rigid internal cart containing most of the system’s mass. Locomotion and large-scale shape reconfiguration are generated through coordinated pressure modulation and controlled redistribution of the center-of-mass, enabling rolling motion, adaptive load transfer, and geometric transformation. Experimental studies demonstrate stable planar locomotion and consistent obstacle traversal under open-loop control, with low trial-to-trial variation in traversal time, indicating repeatable behavior. The robot ascends obstacles up to 69% of its unactuated height and descends obstacles up to 82%, exceeding the geometric limits of rigid wheels of comparable size. The reliability of these behaviors without feedback control highlights that morphological adaptation is achieved through the physical architecture rather than complex control strategies. By relocating compliance to the primary load-bearing structure and coupling it with mass redistribution, the system enables controlled reconfiguration of contact geometry and load paths during environmental interaction. The soft ring robot therefore establishes a morphology-driven locomotion strategy that is compact, energy-efficient, and inherently compliant, making it well suited for operation in unstructured or sensitive environments where fixed-geometry platforms are prone to immobilization or disturbance.
- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 69 (12) , 8820-8827
Optimal Model Reduction by Time-Domain Moment Matching for Lur'e-Type Models
This paper considers the problem of model reduction for Lur'e-type models consisting of a feedback interconnection between linear dynamics and static nonlinearities. We propose an optimal variant of the time-domain moment-matching method in which the $\mathcal {H}_{\infty }$ -norm of the error transfer-function matrix of the linear part of the model is minimised, while the static nonlinearities are inherited from the full-order model. We show that this approach also minimises an error bound on the $\mathcal {L}_{2}$ -norm of the steady-state error between the responses of the full-order nonlinear model and the reduced-order nonlinear model. Furthermore, the proposed approach preserves both the Lur'e-type model structure as well as global stability properties. The problem is cast as an optimisation problem with bilinear matrix inequality constraints. This problem is then solved using a novel algorithm, although global convergence of the algorithm is not guaranteed. The effectiveness of the approach is illustrated in the reduction of a structural dynamics model of a linear beam with nonlinear supports.
- 2 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Automatic Control
- Vol. 69 (12) , 8820-8827
Optimal Model Reduction by Time-Domain Moment Matching for Lur'e-Type Models
This paper considers the problem of model reduction for Lur'e-type models consisting of a feedback interconnection between linear dynamics and static nonlinearities. We propose an optimal variant of the time-domain moment-matching method in which the $\mathcal {H}_{\infty }$ -norm of the error transfer-function matrix of the linear part of the model is minimised, while the static nonlinearities are inherited from the full-order model. We show that this approach also minimises an error bound on the $\mathcal {L}_{2}$ -norm of the steady-state error between the responses of the full-order nonlinear model and the reduced-order nonlinear model. Furthermore, the proposed approach preserves both the Lur'e-type model structure as well as global stability properties. The problem is cast as an optimisation problem with bilinear matrix inequality constraints. This problem is then solved using a novel algorithm, although global convergence of the algorithm is not guaranteed. The effectiveness of the approach is illustrated in the reduction of a structural dynamics model of a linear beam with nonlinear supports.