Dariusz Przybylski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dariusz Przybylski has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Andrzej Stafiniak
Faculty of Microsystem Electronics and Photonics, Wroclaw University of Technology, Janiszewskiego 11/17, 50-372 Wroclaw, Poland
1 shared publication - Joanna Prazmowska
Wroclaw Univ Sci & Technol, Dept Microelect & Nanotechnol, Fac Microsyst Elect & Photon, Janiszewskiego 11-17, PL-50372 Wroclaw, Poland
1 shared publication - Mateusz Wośko
Faculty of Electronics, Photonics and Microsystems, Wrocław University of Science and Technology, Wybrzeże Wyspiańskiego 27, 50-370 Wrocław, Poland
1 shared publication - Michał StęPniak
Wroclaw Univ Sci & Technol, Fac Elect Photon & Microsyst, Wybrzezdote Wyspianskiego 27, PL-50370 Wroclaw, Poland
1 shared publication - Regina Paszkiewicz
Faculty of Electronics, Photonics and Microsystems, Wrocław University of Science and Technology, Wybrzeże Wyspiańskiego 27, 50-370 Wrocław, Poland
1 shared publication - Sergiusz Patela
Wroclaw Univ. of Technology (Poland)
1 shared publication
Latest Publications
- Open Access
- 12 December 2020
- Published by MDPI AG in Electronics
- Vol. 9 (12) , 2129
Growth Uniformity in Selective Area Epitaxy of AlGaN/GaN Heterostructures for the Application in Semiconductor Devices
The design of modern semiconductor devices often requires the fabrication of three-dimensional (3D) structures to integrate microelectronic components with photonic, micromechanical, or sensor systems within one semiconductor substrate. It is a technologically challenging task, as a strictly defined profile of the device structure is obligatory. This can be achieved either by chemical etching or selective deposition on a masked substrate. In this paper, the growth uniformity of AlGaN/GaN heterostructures during selective-area metalorganic vapour-phase epitaxy (SA-MOVPE) was studied. Such structures are typically used in order to fabricate high-electron-mobility transistors (HEMT). The semiconductor material was deposited through 200 μm long stripe-shaped open windows in a SiO2 mask on GaN/sapphire templates. The window width was varied from 5 μm to 160 μm, whereas mask width separating particular windows varied from 5 μm to 40 μm. The experiment was repeated for three samples differing in GaN layer thickness: 150 nm, 250 nm, and 500 nm. Based on theoretical models of the selective growth, a sufficiently uniform thickness of epitaxially grown AlGaN/GaN heterostructure has been achieved by selecting the window half-width that is smaller than the diffusion length of the precursor molecules. A Ga diffusion length of 15 μm was experimentally extracted by measuring the epitaxial material agglomeration in windows in the dielectric mask. Measurements were conducted while using optical profilometry.
- 12 December 2020
- Published by MDPI AG in Electronics
- Vol. 9 (12) , 2129
Open AccessGrowth Uniformity in Selective Area Epitaxy of AlGaN/GaN Heterostructures for the Application in Semiconductor Devices
The design of modern semiconductor devices often requires the fabrication of three-dimensional (3D) structures to integrate microelectronic components with photonic, micromechanical, or sensor systems within one semiconductor substrate. It is a technologically challenging task, as a strictly defined profile of the device structure is obligatory. This can be achieved either by chemical etching or selective deposition on a masked substrate. In this paper, the growth uniformity of AlGaN/GaN heterostructures during selective-area metalorganic vapour-phase epitaxy (SA-MOVPE) was studied. Such structures are typically used in order to fabricate high-electron-mobility transistors (HEMT). The semiconductor material was deposited through 200 μm long stripe-shaped open windows in a SiO2 mask on GaN/sapphire templates. The window width was varied from 5 μm to 160 μm, whereas mask width separating particular windows varied from 5 μm to 40 μm. The experiment was repeated for three samples differing in GaN layer thickness: 150 nm, 250 nm, and 500 nm. Based on theoretical models of the selective growth, a sufficiently uniform thickness of epitaxially grown AlGaN/GaN heterostructure has been achieved by selecting the window half-width that is smaller than the diffusion length of the precursor molecules. A Ga diffusion length of 15 μm was experimentally extracted by measuring the epitaxial material agglomeration in windows in the dielectric mask. Measurements were conducted while using optical profilometry.
- 1 March 2019
- Published by Polish Academy of Sciences Chancellery in Opto-Electronics Review
- Vol. 27 (1) , 79-89
Modelling of a two-dimensional photonic crystal as an antireflection coating for optoelectronic applications
- 1 March 2019
- Published by Polish Academy of Sciences Chancellery in Opto-Electronics Review
- Vol. 27 (1) , 79-89
Modelling of a two-dimensional photonic crystal as an antireflection coating for optoelectronic applications