ZBZiqiang Bi

Ziqiang Bi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ziqiang Bi has a total of 53 co-authors. Here are the top co-authors by number of shared publications:

  • Ka Lok Man

    Department of Computer Science and Software Engineering, Xi’an Jiaotong-Liverpool University, Suzhou, 215123, China and Imec-DistriNet, KU Leuven, Leuven, B-3001, Belgium and Faculty of Engineering, Computing and Science, Swinburne University of Technology Sarawak Campus, Kuching 93350, Malaysia

    10 shared publications
  • Jieming Ma

    Xi’an Jiaotong-Liverpool University, Suzhou, China

    9 shared publications
  • Jieming Ma

    Xi’ an Jiaotong-Liverpool University,Department of Computer Science and Software Engineering,Suzhou,China

    8 shared publications
  • Jeremy S. Smith

    Department of Electrical Engineering and Electronics, University of Liverpool, Liverpool, U.K.

    6 shared publications
  • Yong Yue

    Department of Computer Science and Software Engineering, Xi’an Jiaotong-Liverpool University, Suzhou, 215123, China

    4 shared publications
  • Xinyu Pan

    School of Electronic and Information Engineering, Suzhou University of Science and Technology, Suzhou, China

    3 shared publications

Latest Publications

  • Open Access

    A Comparative Study on the Degradation Behaviors of Ferroelectric Gate GaN HEMT with PZT and PZT/Al2O3 Gate Stacks

    by Lixiang Chen, Zhiqi Lu, Chaowei Fu, Ziqiang Bi, Miaoling Que, Jiawei Sun, Yunfei Sun

    In this paper, the degradation behaviors of the ferroelectric gate Gallium nitride (GaN) high electron mobility transistor (HEMT) under positive gate bias stress are discussed. Devices with a gate dielectric that consists of pure Pb(Zr,Ti)O3 (PZT) and a composite PZT/Al2O3 bilayer are studied. Two different mechanisms, charge trapping and generation of traps, both contribute to the degradation. We have observed positive threshold voltage shift in both kinds of devices under positive gate bias stress. In the devices with a PZT gate oxide, we have found the degradation is owing to electron trapping in pre-existing oxide traps. However, the degradation is caused by electron trapping in pre-existing oxide traps and the generation of traps for the devices with a composite PZT/Al2O3 gate oxide. Owing to the large difference in dielectric constants between PZT and Al2O3, the strong electric field in the Al2O3 interlayer makes PZT/Al2O3 GaN HEMT easier to degrade. In addition, the ferroelectricity in PZT enhances the electric field in Al2O3 interlayer and leads to more severe degradation. According to this study, it is worth noting that the reliability problem of the ferroelectric gate GaN HEMT may be more severe than the conventional metal–insulator–semiconductor HEMT (MIS-HEMT).


  • Open Access

    A solar irradiance estimation technique via curve fitting based on dual-mode Jaya optimization

    by Ziqiang Bi, Guanying Chu, Xinyu Pan, Jichong Guo, Minming Gu, Jianmin Ban

    Solar irradiance is a crucial environmental parameter for optimal control of photovoltaic (PV) systems. However, precise measurements of the solar irradiance are difficult since the irradiation sensors (i.e., pyranometer or pyrheliometer) are expensive and hard to calibrate. This paper proposes a cost-effective and accurate method for estimating the solar irradiance with a PV module via curve fitting. A dual-mode Jaya (DM-Jaya) optimization algorithm is introduced to extract the real-time value of solar irradiance from the measured PV characteristics data by using two search strategies. The step sizes of a random walk are taken from even and Lévy distribution distributions in different searching phases. Compared with the traditional irradiance sensors, the proposed estimator does not require additional circuit and obtains relatively lower error rates. A comparative study of seven population-based optimization algorithms for the optimal design of the estimator is presented. These algorithms include particle swarm optimization (PSO), cuckoo search (CS), Jaya, simulated annealing (SA), genetic algorithm (GA), supply-demand-based optimization (SDO), and the proposed DM-Jaya algorithm. Simulations and experimental results reveal that DM-Jaya outperforms the other optimization algorithms in terms of the estimation speed and accuracy.


  • Real-Time Maximum Power Point Estimation of Photovoltaic Systems Using Shading Information

    by Jieming Ma, Ziqiang Bi, Kangshi Wang, Hai-Ning Liang, Ka Lok Man, Jeremy S. Smith

    Under partial shading conditions, a series-connected photovoltaic (PV) string often shows multipeak power–voltage ( $P$ – $V$ ) characteristics, which indicate a multimodal distribution of maximum power points (MPPs). The phenomenon brings challenges to the MPP estimation since a single model usually cannot perform well in different modes. To address this problem, a real-time shading identification process is proposed to identify the shading information of the applied PV string. The measured data are divided into several fields according to the obtained number of peaks in the $P$ – $V$ curve. Multiple Gaussian process regression (M-GPR) models are then proposed to predict the MPP locus in a specific data field. Experiments are conducted to evaluate the accuracy of the proposed method. Simulation and experimental results show that the shading information enables the proposed M-GPR to obtain more accurate estimation performance compared to its single-model counterparts.


  • An Enhanced 0.8$\text{V}_\text{OC}$-Model-Based Global Maximum Power Point Tracking Method for Photovoltaic Systems

    by Ziqiang Bi, Jieming Ma, Ka Lok Man, Jeremy S. Smith, Yong Yue, Huiqing Wen

    Under partial shading conditions (PSC), the power-voltage (P-V) characteristic curve of a photovoltaic (PV) string exhibits multiple peaks, posing a big challenge to the problem of global maximum power point tracking (GMPPT). The traditional 0.8Voc-model-based GMPPT method locates the global maximum power point (GMPP) locus by comparing the power at each local power peaks. However, a considerable amount of time is required for iteratively scanning each 0.8Voc vicinity. To address this problem, an improved 0.8Voc-model-based GMPPT method is proposed in this paper. A shading vector is firstly used to characterize the PSC. The proposed GMPPT method estimates the 0.8Voc region with the GMPP directly from the measured shading vector by the k-Nearest Neighbors (k-NN) approach and saves the time consumed in the comparison process involved in the conventional method. The simulation and experimental experiments demonstrate that the proposed method is capable of tracking the GMPP efficiently and accurately under various shading patterns. By comparing with the original 0.8Voc-model-based method, the proposed method reduces the tracking step by 75% while maintaining good prediction accuracy.


  • Open Access

    Identification of Partial Shading Conditions for Photovoltaic Strings

    by Ziqiang Bi, Jieming Ma, Kangshi Wang, Ka Lok Man, Jeremy S. Smith, Yong Yue

    Under partial shading conditions (PSC), the power-voltage (P-V) characteristic curve of photovoltaic (PV) strings exhibits multiple peaks. Such mismatching phenomenon brings challenges in controlling the output power. To analyze the electrical characteristics of PV strings in complex environments, a quantitative analysis method is required to characterize the PSC. This paper introduces the shading matrix to describe the shading rate and shading strength information. The proposed shading matrix would provide maximum power point tracking (MPPT) controllers with the essential environmental information to improve the global maximum power point (GMPP) tracking performance. A modified Tabu search (MTS) based identification method is proposed to estimate the shading matrix. The proposed modified method involves a preselection process of updating the Tabu list to optimize the searching efficiency. The accuracy and efficiency of the proposed analytical estimation expression are validated through simulations and experiments. By comparing with binary search (BS), golden-section search (GS) and Tabu search (TS) algorithms, the proposed MTS algorithm is demonstrated to perceive the shading information at least 18.75% faster.


  • A Novel Global Maximum Power Point Tracking Method based on Shading Detection

    by Ziqiang Bi, Jieming Ma, Ka Lok Man, Yong Yue, Jeremy S. Smith

    Partial shading conditions (PSC) caused by the nearby trees and dust are inevitable in photovoltaic (PV) generation systems. Traditional maximum power point tracking (MPPT) methods may fail in tracking the global maximum power point (GMPP) under PSC. This paper proposes a novel global maximum power point tracking (GMPPT) method whose tracking speed is faster than the previously published GMPPT methods since it directly estimates the locus of GMPP based on the shading information. The advanced performance of the proposed method has been validated through the simulation using Simulink. Two popular MPPT methods including perturb and observe (P&O) and particle swarm optimization (PSO) were also implemented, along with the proposed method under different shading scenarios, for the comparative validation.


  • Predicting the Global Maximum Power Point Locus using Shading Information

    by Jieming Ma, Ziqiang Bi, Ka Lok Man, Hai-Ning Liang, Jeremy S. Smith

    The power-voltage characteristic curves of a series-connected photovoltaic (PV) system exhibit multiple peaks in partial shading scenario (PSS). However, there lacks a feasible model that obtains the capability of predicting the global maximum power point (GMPP) locus. This paper analyzes the GMPP characterization and demonstrates that the voltage at the GMPP is located over a large range in various PSS. With the aim of improving the prediction performance, multiple Gaussian process regression (MGPR) models are proposed to predict the GMPP locus by using shading information, such as the shading rate and shading strength. The performance of the method is evaluated using a dataset obtained in a variety of environmental conditions. The results show that it outperforms the existing prediction models in terms of accuracy. With its high prediction capability, the proposed method can be used to increase the maximum power point tracking performance in PV systems.


  • Global MPPT Method for Photovoltaic Systems Operating under Partial Shading Conditions using the 0.8VOC Model

    by Ziqiang Bi, Jieming Ma, Ka Lok Man, Jeremy S. Smith, Yong Yue, Huiqing Wen

    The power-voltage (P-V) characteristics of a photovoltaic (PV) array exhibit multiple peaks under partial shading conditions (PSC). The classical 0.8V OC -model-based maximum power point tracking (MPPT) method assumes that the peaks are located at multiples of the 0.8V OC (open-circuit voltage). The global maximum power point (GMPP) is obtained after comparing the power of these voltage regions. In this paper, the proposed method reduces the comparison process and the voltage region can be determined based on the shading information. The improved performance of the proposed method has been verified using Simulink. The simulation results demonstrate that the proposed technique is feasible and efficient in comparison with the classical 0.8V OC -model-based method.


  • Maximum Power Point Estimation for Photovoltaic Strings Subjected to Partial Shading Scenarios

    by Jieming Ma, Haochuan Jiang, Ziqiang Bi, Kaizhu Huang, Xingshuo Li, Huiqing Wen

    Partial shading is an unavoidable complication in the field of photovoltaic (PV) generation. Bypass diodes have become a standard feature of solar cell arrays to improve array performance under partial shading scenarios (PSS). However, the current-voltage and power-voltage characteristic data vary with different shading patterns. In this paper, a shading pattern detection algorithm is first proposed to estimate the number of shaded modules in a PV string. The result is then fed to a field-support vector regression (F-SVR) model, in which the measured features are transfered into a style-free high-dimension space prior to data training. The process of style-normalized transformation enables the features to be independent and identically distributed. Both simulations and experiments are conducted to evaluate the F-SVR model's ability to estimate the voltage at maximum power points. The results show that the proposed maximum power point estimation method can evidently reduce prediction errors.