JYJing Yuan

Jing Yuan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jing Yuan has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • New Discontinuous Space Vector Modulation Strategies for Impedance-Source Inverter With Superior Thermal and Harmonic Performance

    by Ping Liu, Jie Xu, Meidi Sun, Jing Yuan, Frede Blaabjerg

    Impedance-source inverters provide a promising single-stage power conversion with boost-buck capabilities and inverter legs short-circuit immunity. To achieve superior thermal and output harmonic performance, two novel discontinuous modulation strategies for the three-phase quasi-Z source inverter, called the maximum-boost discontinuous space vector modulation (SVM) and the simple-boost discontinuous SVM respectively, are proposed in this article. By properly arranging the shoot-through states and clamping a certain switch to the positive or negative dc-link rail during one-third of the fundamental period, reduced thermal stresses and superior total harmonic distortion performance can be achieved. The proposed modulation strategies are analyzed and compared to the conventional ones in terms of current stresses, power losses, thermal stresses, and output harmonics. Finally, simulations and experimental tests are carried out to validate the performance of the proposed modulation strategies and verify the presented analysis.


  • Differential Power Processing for Ultra-Efficient Data Storage

    by Ping Wang, Yenan Chen, Jing Yuan, Robert C. N. Pilawa-Podgurski, Minjie Chen

    This article presents the hardware, software, and power codesign of an ultra-efficient data storage server with differential power processing (DPP). DPP can reduce the power conversion stress, improve the efficiency, and enhance the functionality of modular power electronics systems. The power inputs of a large number of hard disk drives (HDDs) were connected in series and supported by a multiport ac-coupled differential power processing (MAC-DPP) converter through a multiwinding transformer. Methods for controlling the multi-input multi-output power flow in the multiwinding transformer while avoiding core saturation were investigated. A ten-port MAC-DPP prototype with 700-W/in $^3$ power density was built to support a 450-W HDD storage system with ten series-stacked voltage domains. The prototype was tested on a 50-HDD server testbench, and the overall system loss is below 1 W (99.77% system efficiency). The server was able to maintain high-speed reading and writing operation of all 50 HDDs against the worst hot-swapping scenarios. A variety of hardware/software configurations and many cloud storage techniques were tested on the fully functioning server. Experimental results show that the energy efficiency of large-scale information systems (CPU/GPU clusters, memory banks, HDD arrays, etc.) can be greatly improved by software, hardware, and power codesign.


  • Multi-channel Speech Enhancement with Multiple-target GANs

    by Jing Yuan, Changchun Bao

    In noisy scenes, speech enhancement is an important technology to improve the speech quality. In this paper, a multi-channel speech enhancement algorithm with multiple-target Generative Adversarial Networks (GANs) is proposed. Firstly, using the spatial characteristics of microphone array, the mask of target speech signal is generated by the multiple-target GAN (MT-GAN). Secondly, the mask is estimated based on complex Gaussian mixture model (CGMM), which is combined with the mask predicted by network in an iterative way to obtain a more robust speech enhancement system. Finally, the estimated mask is used to construct beamformer. Thus, the noisy speech is enhanced by the constructed beamformer. The experimental results show that compared with the reference methods, the speech quality and intelligibility of the proposed method are improved effectively.

  • Open Access

    Modified Impedance-Source Inverter with Continuous Input Currents and Fault-Tolerant Operations

    by Jing Yuan, Yongheng Yang, Ping Liu, Yanfeng Shen, Frede Blaabjerg

    Impedance-source (Z-source) inverters are increasingly adopted in practice, where a high voltage gain is required. However, issues like drawing a non-continuous current from the DC source and ceasing the energy supply under DC source faults are also observed. In this paper, an embedded enhanced-boost Z-source inverter (EEB-ZSI) is thus proposed to tackle the issues. The proposed EEB-ZSI employs two DC sources, which enable the continuous input current and fault-tolerant operations (e.g., open-circuit and short-circuit faults in the DC sources). The operational principles are presented in detail with an in-depth circuit analysis. Moreover, the proposed EEB-ZSI is benchmarked with prior-art Z-source inverters. Experimental tests further demonstrate the effectiveness of EEB-ZSI regarding the continuous input current and flexible fault tolerance.


  • Open Access

    Analysis and design of a high voltage‐gain quasi‐Z‐source DC–DC converter

    by Farhad Abbasi Aghdam Meinagh, Jing Yuan, Yongheng Yang

    In this study, a modified DC–DC converter is proposed, which can achieve a high voltage‐gain exploiting both quasi‐Z‐source and switched‐capacitor networks. In addition to the high voltage‐gain, the proposed converter has low voltage stresses on its elements. The steady‐state analysis in both continuous and discontinuous conduction modes is given in this study. Moreover, the design of the passive elements, the calculation of the non‐ideal voltage gain, and the power loss analysis are done. Then, an extended topology of the proposed converter is presented, which further enhances the voltage gain, while maintaining the voltage stresses of the components. A comprehensive comparison with the prior‐art converters is performed to accentuate the advantages of the proposed converter. Finally, simulations and experimental tests are provided to substantiate the theoretical analysis.


  • Open Access

    A Switched Quasi-Z-Source Inverter with Continuous Input Currents

    by Jing Yuan, Yongheng Yang, Frede Blaabjerg

    Impedance source converters as single-stage power conversion alternatives can boost and regulate the output voltages of renewable energy sources. Nevertheless, they, also known as Z-source inverters (ZSIs), still suffer from limited voltage gains and higher stresses across the components. To tackle such issues, extra diodes, passive components, and active switches can be utilized in the basic ZSIs. In this paper, a modified switched-quasi-Z-source inverter (S-qZSI) is proposed, which features continuous input currents and high boosting capability to boost output voltage by minor modifications of a prior-art topology. Furthermore, the voltage stress of the active switches is reduced, which contributes to a lower cost. The operation principles are discussed comprehensively. The performance of the proposed ZSI in terms of conversion ratio, voltage gain, and stresses on the power switches and capacitors is benchmarked with selected ZSIs. Finally, simulations and experimental tests substantiate the theoretical analysis and superior performance.


  • A Modified Y-Source DC–DC Converter With High Voltage-Gains and Low Switch Stresses

    by Jing Yuan, Ali Mostaan, Yongheng Yang, Yam P. Siwakoti, Frede Blaabjerg

    This letter proposes a modified Y-source dc-dc converter, which features higher voltage-gains but lower voltage stresses on the components. Moreover, the proposed converter draws a continuous current from the dc input with much control flexibility (i.e., a wide range of adjustable duty cycles). Additionally, the coupled inductors have a low turns ratio, and the core saturation issue is avoided due to the dc-current-blocking capacitor. A detailed analysis of the proposed converter is provided, and the performance is benchmarked with selected coupled-inductors-based converters on various aspects. Experimental tests confirm the theoretical analysis.


  • A Trans-Inverse Coupled-Inductor Semi-SEPIC DC/DC Converter With Full Control Range

    by Ali Mostaan, Jing Yuan, Yam P. Siwakoti, Soroush Esmaeili, Frede Blaabjerg

    This letter proposes a single switch magnetically coupled dc/dc converter with high voltage gain. The unique features of the converter are summarized as: 1) voltage gain of the converters is raised by lowering its magnetic turn ratio; 2) wide control range (0 < D < 1); 3) continuous current from the source that makes it a suitable candidate for renewable energy applications; 4) there is no dc current saturation in the core due to the presence of capacitor in the primary winding of the inductor. The feasibility of the proposed converter is studied in details supported by circuit analysis and simulation results. Further, the proposed converter is analyzed and compared with other converters with similar topologies. Finally the superior performance of the circuit is validated experimentally.