Victoria B. Bekezhanova
Research Subjects
Victoria B. Bekezhanova has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Olga N. Goncharova
Altai State University, Barnaul, Russia
16 shared publications O. N. Goncharova
Altai State University, Institute of Mathematics and Information Technologies, Barnaul, 656049, Russia
5 shared publications- Илья Александрович Шефер
Siberian Fed Univ, Inst Math & Comp Sci, Svobodny 79, Krasnoyarsk 660041, Russia
5 shared publications O.N. Goncharova
4 shared publicationsI. A. Shefer
Siberian Federal University
2 shared publicationsInstitute of Computational Modeling of SB RAS
2 shared publications
Latest Publications
- 1 September 2026
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 271
Convection in a double-layered system of liquids with close densities
- 1 September 2026
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 271
Convection in a double-layered system of liquids with close densities
- 1 October 2024
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 65 (5) , 829-843
INFLUENCE OF THE BOUNDARY THERMAL REGIME ON CHARACTERISTICS OF BILAYER FLOWS UNDER DIFFUSIVE EVAPORATION
The characteristics of joint flows of evaporating liquid and a laminar gas stream in a plane horizontal channel are studied based on an exact partially invariant solution of thermosolutal convection equations. The influence of the liquid layer thickness and the conditions for the temperature function on the upper wall of the channel on the rate of evaporation caused by gas pumping is investigated. The exact solution is verified by comparison with experimental data. The linear stability of the exact solutions is studied. It is established that regardless of the type of boundary thermal regime, oscillatory instability in the form of cellular convection always appears in the system. Thermal insulation of the upper wall does not lead to a change in the structure of the most dangerous perturbations, slightly destabilizes the flow in the case of long-wave perturbations, and has a stabilizing effect in the case of short-wave perturbations.
- 1 October 2024
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 65 (5) , 829-843
INFLUENCE OF THE BOUNDARY THERMAL REGIME ON CHARACTERISTICS OF BILAYER FLOWS UNDER DIFFUSIVE EVAPORATION
The characteristics of joint flows of evaporating liquid and a laminar gas stream in a plane horizontal channel are studied based on an exact partially invariant solution of thermosolutal convection equations. The influence of the liquid layer thickness and the conditions for the temperature function on the upper wall of the channel on the rate of evaporation caused by gas pumping is investigated. The exact solution is verified by comparison with experimental data. The linear stability of the exact solutions is studied. It is established that regardless of the type of boundary thermal regime, oscillatory instability in the form of cellular convection always appears in the system. Thermal insulation of the upper wall does not lead to a change in the structure of the most dangerous perturbations, slightly destabilizes the flow in the case of long-wave perturbations, and has a stabilizing effect in the case of short-wave perturbations.
- Open Access
- 1 January 2024
- Published by Tech Science Press in Fluid Dynamics & Materials Processing
- Vol. 20 (7) , 1667-1686
Numerical Simulation of Thermocapillary Convection with Evaporation Induced by Boundary Heating
The dynamics of a bilayer system filling a rectangular cuvette subjected to external heating is studied. The influence of two types of thermal exposure on the flow pattern and on the dynamic contact angle is analyzed. In particular, the cases of local heating from below and distributed thermal load from the lateral walls are considered. The simulation is carried out within the frame of a two-sided evaporative convection model based on the Boussinesq approximation. A benzine–air system is considered as reference system. The variation in time of the contact angle is described for both heating modes. Under lateral heating, near-wall boundary layers emerge together with strong convection, whereas the local thermal load from the lower wall results in the formation of multicellular motion in the entire volume of the fluids and the appearance of transition regimes followed by a steady-state mode. The results of the present study can aid the design of equipment for thermal coating or drying and the development of methods for the formation of patterns with required structure and morphology.
- 1 January 2024
- Published by Tech Science Press in Fluid Dynamics & Materials Processing
- Vol. 20 (7) , 1667-1686
Open AccessNumerical Simulation of Thermocapillary Convection with Evaporation Induced by Boundary Heating
The dynamics of a bilayer system filling a rectangular cuvette subjected to external heating is studied. The influence of two types of thermal exposure on the flow pattern and on the dynamic contact angle is analyzed. In particular, the cases of local heating from below and distributed thermal load from the lateral walls are considered. The simulation is carried out within the frame of a two-sided evaporative convection model based on the Boussinesq approximation. A benzine–air system is considered as reference system. The variation in time of the contact angle is described for both heating modes. Under lateral heating, near-wall boundary layers emerge together with strong convection, whereas the local thermal load from the lower wall results in the formation of multicellular motion in the entire volume of the fluids and the appearance of transition regimes followed by a steady-state mode. The results of the present study can aid the design of equipment for thermal coating or drying and the development of methods for the formation of patterns with required structure and morphology.
- 5 October 2023
- Published by Wiley in Mathematical Methods in the Applied Sciences
- Vol. 47 (2) , 847-872
Modeling of stratified two‐phase flows with non‐uniform evaporation based on the exact solution of convection equations
Within the framework of the Oberbeck–Boussinesq approximation, the exact solution of equations of thermoconcentration convection is studied, which has the group origin. The issue of applicability of the exact solution for describing steady‐state convective flows of a liquid and a co‐current gas flux under the conditions of inhomogeneous evaporation of the diffusive type in a flat horizontal channel is discussed. Algorithms for obtaining analytical representations of the required functions for various types of the boundary conditions for the temperature function on the outer channel wall are proposed. The influence of the external thermal load and boundary thermal conditions on the structure of the velocity and temperature fields, evaporation mass flow rate, and vapor content in the gas layer is investigated at an example of the HFE‐7100–nitrogen system. The solution correctly predicts hydrodynamical, temperature, and concentration parameters of convective regimes appearing in the two‐phase system. The main characteristics are compared with the characteristics of the system in the case of uniform evaporation with a constant intensity.
- 5 October 2023
- Published by Wiley in Mathematical Methods in the Applied Sciences
- Vol. 47 (2) , 847-872
Modeling of stratified two‐phase flows with non‐uniform evaporation based on the exact solution of convection equations
Within the framework of the Oberbeck–Boussinesq approximation, the exact solution of equations of thermoconcentration convection is studied, which has the group origin. The issue of applicability of the exact solution for describing steady‐state convective flows of a liquid and a co‐current gas flux under the conditions of inhomogeneous evaporation of the diffusive type in a flat horizontal channel is discussed. Algorithms for obtaining analytical representations of the required functions for various types of the boundary conditions for the temperature function on the outer channel wall are proposed. The influence of the external thermal load and boundary thermal conditions on the structure of the velocity and temperature fields, evaporation mass flow rate, and vapor content in the gas layer is investigated at an example of the HFE‐7100–nitrogen system. The solution correctly predicts hydrodynamical, temperature, and concentration parameters of convective regimes appearing in the two‐phase system. The main characteristics are compared with the characteristics of the system in the case of uniform evaporation with a constant intensity.
- 1 August 2023
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 64 (4) , 564-574
SIMULATION OF CONVECTION IN A TWO-PHASE SYSTEM UNDER CONDITIONS OF DIFFUSIVE EVAPORATION IN A CLOSED REGION
This paper describes the study of a problem of thermocapillary convection in a flat bounded region filled with liquid and gas in contact along the interfacial interface under weak evaporation. It is proposed to investigate the heat and mass transfer processes and the parameters of phase transitions during local heating using a two-sided mathematical model based on the Oberbeck–Boussinesq equations. The characteristics of mass transfer through a thermocapillary interface due to evaporation and vapor content in the gas layer are analyzed with account for the influence of the Soret and Dufour effects. The results of a numerical study of the evolution of the interface and unsteady flows in a cell are presented. The calculation of the main characteristics of the liquid — gas system and the position of the interface at each time is carried out using a specially developed numerical algorithm. The model presented in this study makes it possible to describe the formation of characteristic thermal and concentration structures and the transition modes of cellular convection with a complex configuration of flows in layers.
- 1 August 2023
- Published by Pleiades Publishing Ltd in Journal of Applied Mechanics and Technical Physics
- Vol. 64 (4) , 564-574
SIMULATION OF CONVECTION IN A TWO-PHASE SYSTEM UNDER CONDITIONS OF DIFFUSIVE EVAPORATION IN A CLOSED REGION
This paper describes the study of a problem of thermocapillary convection in a flat bounded region filled with liquid and gas in contact along the interfacial interface under weak evaporation. It is proposed to investigate the heat and mass transfer processes and the parameters of phase transitions during local heating using a two-sided mathematical model based on the Oberbeck–Boussinesq equations. The characteristics of mass transfer through a thermocapillary interface due to evaporation and vapor content in the gas layer are analyzed with account for the influence of the Soret and Dufour effects. The results of a numerical study of the evolution of the interface and unsteady flows in a cell are presented. The calculation of the main characteristics of the liquid — gas system and the position of the interface at each time is carried out using a specially developed numerical algorithm. The model presented in this study makes it possible to describe the formation of characteristic thermal and concentration structures and the transition modes of cellular convection with a complex configuration of flows in layers.
- Open Access
Application of a Partially Invariant Exact Solution of the Thermosolutal Convection Equations for Studying the Instability of an Evaporative Flow in a Channel Heated from Above
The characteristics of a stationary flow of a volatile liquid driven by a co-current gas flux in a flat horizontal mini-channel upon the non-zero transverse temperature drop are studied. We use an exact solution of the thermosolutal convection equations for describing the heat and mass transfer caused by the combined action of gas pumping, buoyancy, thermocapillarity and linear heating of the channel walls in a two-layer system. The influence of heating from above on the parameters of the ground state and the stability characteristics of the basic flow is explored using an example of the ethanol–air system. We evaluate the thresholds of the linear stability and select the most dangerous modes. Heating from above results in flow stabilization. Instability appears in the form of oscillatory cellular convective patterns.
Open AccessApplication of a Partially Invariant Exact Solution of the Thermosolutal Convection Equations for Studying the Instability of an Evaporative Flow in a Channel Heated from Above
The characteristics of a stationary flow of a volatile liquid driven by a co-current gas flux in a flat horizontal mini-channel upon the non-zero transverse temperature drop are studied. We use an exact solution of the thermosolutal convection equations for describing the heat and mass transfer caused by the combined action of gas pumping, buoyancy, thermocapillarity and linear heating of the channel walls in a two-layer system. The influence of heating from above on the parameters of the ground state and the stability characteristics of the basic flow is explored using an example of the ethanol–air system. We evaluate the thresholds of the linear stability and select the most dangerous modes. Heating from above results in flow stabilization. Instability appears in the form of oscillatory cellular convective patterns.
- 27 February 2023
- Published by The Royal Society in Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 381 (2245) , 20220078
Comparative study of convection characteristics for a system with deformable interface based on the Navier–Stokes and Oberbeck–Boussinesq equations
The right choice of the appropriate mathematical model is crucial for evaluating the physical plausibility of modelling results. The issue of the correct application of the classical Boussinesq approximation for studying the heat and mass transfer in fluidic systems with a deformable boundary is a subject of scientific discussions despite the good agreement of numerous theoretical and numerical results obtained within the convection models based on the Oberbeck–Boussinesq equations with the data of physical experiments and observations. A comparative analysis of the results of numerical simulations in the framework of two-sided models based on the Navier–Stokes equations, and their Boussinesq approximation, is performed in the context of a convection problem in a locally heated two-phase system with a deformable interface. It is demonstrated that the application of the standard Boussinesq approximation allows one to give a consistent description of the effect of interface deformations on combined buoyant–thermocapillary driven fluid motions. This article is part of the theme issue ‘New trends in pattern formation and nonlinear dynamics of extended systems’.
- 27 February 2023
- Published by The Royal Society in Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 381 (2245) , 20220078
Comparative study of convection characteristics for a system with deformable interface based on the Navier–Stokes and Oberbeck–Boussinesq equations
The right choice of the appropriate mathematical model is crucial for evaluating the physical plausibility of modelling results. The issue of the correct application of the classical Boussinesq approximation for studying the heat and mass transfer in fluidic systems with a deformable boundary is a subject of scientific discussions despite the good agreement of numerous theoretical and numerical results obtained within the convection models based on the Oberbeck–Boussinesq equations with the data of physical experiments and observations. A comparative analysis of the results of numerical simulations in the framework of two-sided models based on the Navier–Stokes equations, and their Boussinesq approximation, is performed in the context of a convection problem in a locally heated two-phase system with a deformable interface. It is demonstrated that the application of the standard Boussinesq approximation allows one to give a consistent description of the effect of interface deformations on combined buoyant–thermocapillary driven fluid motions. This article is part of the theme issue ‘New trends in pattern formation and nonlinear dynamics of extended systems’.