Georgios Doundoulakis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Interests
Georgios Doundoulakis has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
A. Adikimenakis
2 shared publicationsA. Georgakilas
2 shared publicationsDimitris Pavlidis
College of Engineering and Computing, Florida International University, Miami, FL, USA
2 shared publicationsK. Tsagaraki
2 shared publicationsM. Androulidaki
2 shared publicationsA. Kostopoulos
Institute of Electronic Structure & Laser (IESL)
1 shared publication
Latest Publications
- 17 January 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 53 (6) , 2773-2780
Field Emission Properties of Top–Down GaN Nanowires Characterized in Vacuum by a Nanometer-Resolution Piezoelectric Probing System
- 17 January 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 53 (6) , 2773-2780
Field Emission Properties of Top–Down GaN Nanowires Characterized in Vacuum by a Nanometer-Resolution Piezoelectric Probing System
- 20 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 68 (9) , 4806
Corrections to “Electrical Characteristics of Vertical GaN Nanowire Vacuum Field Emitter Devices” [Jun 21 3034-3039]
In the above article [1] , the units of the y-axis in Fig. 4(a) should be kA/cm 2 instead of A/cm 2 . The figure with the correct units is presented here.
- 20 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 68 (9) , 4806
Corrections to “Electrical Characteristics of Vertical GaN Nanowire Vacuum Field Emitter Devices” [Jun 21 3034-3039]
In the above article [1] , the units of the y-axis in Fig. 4(a) should be kA/cm 2 instead of A/cm 2 . The figure with the correct units is presented here.
- 12 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 68 (6) , 3034-3039
Electrical Characteristics of Vertical GaN Nanowire Vacuum Field Emitter Devices
The electrical characteristics of simulated vertical gallium nitride (GaN) nanowire (NW) vacuum field emission diodes (VFEDs) and GaN NW vacuum field emission transistors (VFETs) with flat- and sharp-tip GaN NW field emitters (FEs) are presented by investigating their dependence on geometry and material parameters. For a flat-tip GaN NW VFED, the turn-on voltage (V TO ) was decreased by decreasing the GaN NW diameter ( D), the anode to emitter distance (d), the work function of the anode metal (φ M ), or by increasing the GaN NW height ( h). Variations in doping concentration (N D ) of the GaN NW do not impact V TO . The sharp-tip GaN NW VFEDs exhibited decreased V TO as the degree of sharpness ( d sh ) was increased from 0 to 0.5 μm. The saturation emitter current density (J sat ) was only affected by variations in N D , and was increased for increased N D . The transfer (I DS - V GS ) characteristics of sharp-tip VFETs exhibited reduced threshold voltage (V TH ), increased transconductance (G tm, max ), and ON-/ OFF-current ratio, compared with the flat-tip ones. The output (J DS - V DS ) characteristics of both types of devices showed nonlinear behavior at the low V DS regime.
- 12 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 68 (6) , 3034-3039
Electrical Characteristics of Vertical GaN Nanowire Vacuum Field Emitter Devices
The electrical characteristics of simulated vertical gallium nitride (GaN) nanowire (NW) vacuum field emission diodes (VFEDs) and GaN NW vacuum field emission transistors (VFETs) with flat- and sharp-tip GaN NW field emitters (FEs) are presented by investigating their dependence on geometry and material parameters. For a flat-tip GaN NW VFED, the turn-on voltage (V TO ) was decreased by decreasing the GaN NW diameter ( D), the anode to emitter distance (d), the work function of the anode metal (φ M ), or by increasing the GaN NW height ( h). Variations in doping concentration (N D ) of the GaN NW do not impact V TO . The sharp-tip GaN NW VFEDs exhibited decreased V TO as the degree of sharpness ( d sh ) was increased from 0 to 0.5 μm. The saturation emitter current density (J sat ) was only affected by variations in N D , and was increased for increased N D . The transfer (I DS - V GS ) characteristics of sharp-tip VFETs exhibited reduced threshold voltage (V TH ), increased transconductance (G tm, max ), and ON-/ OFF-current ratio, compared with the flat-tip ones. The output (J DS - V DS ) characteristics of both types of devices showed nonlinear behavior at the low V DS regime.
- 1 August 2019
- Published by Elsevier in Solid-State Electronics
- Vol. 158, 1-10
Experimental and modeling insight for fin-shaped transistors based on AlN/GaN/AlN double barrier heterostructure
- 1 August 2019
- Published by Elsevier in Solid-State Electronics
- Vol. 158, 1-10
Experimental and modeling insight for fin-shaped transistors based on AlN/GaN/AlN double barrier heterostructure
- 25 April 2019
- Published by IOP Publishing in Nanotechnology
- Vol. 30 (28) , 285304
Nanofabrication of normally-off GaN vertical nanowire MESFETs
Gallium nitride (GaN) all-around (wrap) gate vertical nanowire (V-NW) field-effect transistors (FETs) are favorable for enhanced electrostatic control of the gate and selectivity for normally on/off operation. In this work, GaN V-NW FETs with a Schottky barrier gate (V-NW MESFETs), were fabricated for the first time. A nanofabrication process with comprehensive description of all processing steps is reported. It was validated with the demonstration of GaN V-NW MESFETs consisting of an array of 900 (30 × 30) GaN NWs with the narrowest until now reported diameter of 100 nm and all-around gate length of 250 nm. The GaN NWs were formed by a top-down approach, which combines conventional nanopatterning techniques and anisotropic wet etching of an initial GaN epilayer, grown by plasma assisted molecular beam epitaxy on a sapphire (0001) substrate. DC I – V characteristics exhibited normally-off operation and threshold voltage of +0.4 V, due to electron depletion region from the all-around Schottky barrier. A maximum drain-source current density ( J ds ) of 330 A cm −2 and maximum transconductance ( g m ) of 285 S cm −2 were obtained from I – V measurements. The results and directions for further optimization were discussed.
- 25 April 2019
- Published by IOP Publishing in Nanotechnology
- Vol. 30 (28) , 285304
Nanofabrication of normally-off GaN vertical nanowire MESFETs
Gallium nitride (GaN) all-around (wrap) gate vertical nanowire (V-NW) field-effect transistors (FETs) are favorable for enhanced electrostatic control of the gate and selectivity for normally on/off operation. In this work, GaN V-NW FETs with a Schottky barrier gate (V-NW MESFETs), were fabricated for the first time. A nanofabrication process with comprehensive description of all processing steps is reported. It was validated with the demonstration of GaN V-NW MESFETs consisting of an array of 900 (30 × 30) GaN NWs with the narrowest until now reported diameter of 100 nm and all-around gate length of 250 nm. The GaN NWs were formed by a top-down approach, which combines conventional nanopatterning techniques and anisotropic wet etching of an initial GaN epilayer, grown by plasma assisted molecular beam epitaxy on a sapphire (0001) substrate. DC I – V characteristics exhibited normally-off operation and threshold voltage of +0.4 V, due to electron depletion region from the all-around Schottky barrier. A maximum drain-source current density ( J ds ) of 330 A cm −2 and maximum transconductance ( g m ) of 285 S cm −2 were obtained from I – V measurements. The results and directions for further optimization were discussed.
- 20 June 2018
- Published by Springer Nature in Journal of Micro and Bio Robotics
- Vol. 14 (3-4) , 51-57
Multimodal microscopy test standard for scanning microwave, electron, force and optical microscopy
- 20 June 2018
- Published by Springer Nature in Journal of Micro and Bio Robotics
- Vol. 14 (3-4) , 51-57
Multimodal microscopy test standard for scanning microwave, electron, force and optical microscopy
- 14 June 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 119 (22) , 224305
Selective-area growth of GaN nanowires on SiO2-masked Si (111) substrates by molecular beam epitaxy
We analyze a method to selectively grow straight, vertical gallium nitride nanowires by plasma-assisted molecular beam epitaxy (MBE) at sites specified by a silicon oxide mask, which is thermally grown on silicon (111) substrates and patterned by electron-beam lithography and reactive-ion etching. The investigated method requires only one single molecular beam epitaxy MBE growth process, i.e., the SiO2 mask is formed on silicon instead of on a previously grown GaN or AlN buffer layer. We present a systematic and analytical study involving various mask patterns, characterization by scanning electron microscopy, transmission electron microscopy, and photoluminescence spectroscopy, as well as numerical simulations, to evaluate how the dimensions (window diameter and spacing) of the mask affect the distribution of the nanowires, their morphology, and alignment, as well as their photonic properties. Capabilities and limitations for this method of selective-area growth of nanowires have been identified. A window diameter less than 50 nm and a window spacing larger than 500 nm can provide single nanowire nucleation in nearly all mask windows. The results are consistent with a Ga diffusion length on the silicon dioxide surface in the order of approximately 1 μm.
- 14 June 2016
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 119 (22) , 224305
Selective-area growth of GaN nanowires on SiO2-masked Si (111) substrates by molecular beam epitaxy
We analyze a method to selectively grow straight, vertical gallium nitride nanowires by plasma-assisted molecular beam epitaxy (MBE) at sites specified by a silicon oxide mask, which is thermally grown on silicon (111) substrates and patterned by electron-beam lithography and reactive-ion etching. The investigated method requires only one single molecular beam epitaxy MBE growth process, i.e., the SiO2 mask is formed on silicon instead of on a previously grown GaN or AlN buffer layer. We present a systematic and analytical study involving various mask patterns, characterization by scanning electron microscopy, transmission electron microscopy, and photoluminescence spectroscopy, as well as numerical simulations, to evaluate how the dimensions (window diameter and spacing) of the mask affect the distribution of the nanowires, their morphology, and alignment, as well as their photonic properties. Capabilities and limitations for this method of selective-area growth of nanowires have been identified. A window diameter less than 50 nm and a window spacing larger than 500 nm can provide single nanowire nucleation in nearly all mask windows. The results are consistent with a Ga diffusion length on the silicon dioxide surface in the order of approximately 1 μm.