Min Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Min Liu has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Changguang Deng
National Engineering Laboratory for Modern Materials Surface Engineering Technology & The Key Lab of Guangdong for Modern Surface Engineering Technology, Guangdong Institute of New Materials, Guangdong Academy of Sciences, Guangzhou, China
1 shared publication- Changguang Deng
Guangdong Acad Sci, Inst New Mat, Natl Engn Lab Modern Mat Surface Engn Technol, Guangzhou 510651, Peoples R China
1 shared publication Chunming Deng
National Engineering Laboratory for Modern Materials Surface Engineering Technology & The Key Lab of Guangdong for Modern Surface Engineering Technology, Guangdong Institute of New Materials, Guangdong Academy of Sciences, Guangzhou, China
1 shared publication- Chunming Deng
Institute of New Materials, Guangdong Academy of Sciences, National Engineering Laboratory for Modern Materials Surface Engineering Technology, the Key Lab of Guangdong for Modern Surface Engineering Technology, Guangzhou 510651, China
1 shared publication Deng Chun-Min
1 shared publicationJianlei Cui
State Key Laboratory for Manufacturing Systems Engineering, Xi’an Jiaotong University, Xi’an, China
1 shared publication
Latest Publications
- Open Access
- 10 November 2022
- Published by Springer Nature in npj Materials Degradation
- Vol. 6 (1) , 1-7
Al2O3-modified 7YSZ thermal barrier coatings for protection against volcanic ash corrosion
To prevent volcanic ash corrosion using thermal barrier coatings (TBCs), a novel method using Al2O3-modification was proposed to reduce molten CMAS wettability on TBCs surface through a lotus effect. Plasma spray-physical vapor deposition (PS-PVD), a third-generation method for TBCs fabrication, was adopted to deposit 7YSZ TBCs with a feather-like microstructure. Then, Al2O3 modification was introduced to fabricate a dense Al2O3 overlay with nano/micro-sized grains on the TBCs surface. The wetting ability of CMAS on APS/EB-PVD/PS-PVD 7YSZ TBCs was comparatively in situ observed at 1250 °C for 3600 s. The results indicated that the dense Al2O3 overlay inhibited penetration of molten CMAS. Additionally, the micro/nano dual-sized structure, which is similar to the papillary structure of a lotus leaf, reduced molten CMAS wettability on the TBCs surface. The results demonstrated that the Al2O3-modified TBCs had better CMAS corrosion resistance than the as-deposited APS/EB-PVD/PS-PVD TBCs.
- 10 November 2022
- Published by Springer Nature in npj Materials Degradation
- Vol. 6 (1) , 1-7
Open AccessAl2O3-modified 7YSZ thermal barrier coatings for protection against volcanic ash corrosion
To prevent volcanic ash corrosion using thermal barrier coatings (TBCs), a novel method using Al2O3-modification was proposed to reduce molten CMAS wettability on TBCs surface through a lotus effect. Plasma spray-physical vapor deposition (PS-PVD), a third-generation method for TBCs fabrication, was adopted to deposit 7YSZ TBCs with a feather-like microstructure. Then, Al2O3 modification was introduced to fabricate a dense Al2O3 overlay with nano/micro-sized grains on the TBCs surface. The wetting ability of CMAS on APS/EB-PVD/PS-PVD 7YSZ TBCs was comparatively in situ observed at 1250 °C for 3600 s. The results indicated that the dense Al2O3 overlay inhibited penetration of molten CMAS. Additionally, the micro/nano dual-sized structure, which is similar to the papillary structure of a lotus leaf, reduced molten CMAS wettability on the TBCs surface. The results demonstrated that the Al2O3-modified TBCs had better CMAS corrosion resistance than the as-deposited APS/EB-PVD/PS-PVD TBCs.
- Open Access
Electrochemical Corrosive Behaviors of Fe-Based Amorphous/Nanocrystalline Coating on Stainless Steel Prepared by HVOF-Sprayed
In this study, FeCrMnWMoSi amorphous/nanocrystalline coating was prepared on stainless steel by high-velocity oxygen fuel (HVOF) spraying. In order to thoroughly evaluate this novel material, the corrosion behaviors and corrosive film characteristics of the amorphous/nanocrystalline coating in NaCl corrosive media were studied using electrochemical measurement technologies such as potentiodynamic polarization curves and electrochemical impedance spectroscopy (EIS). It was found that the corrosion resistance of Fe-based amorphous/nanocrystalline coating could be attributed to the passive film formed, which consisted of Fe, Cr, Mo, and W oxides. pH has an important influence on the corrosion resistance of amorphous/nanocrystalline coating by changing the pitting corrosion mechanism. Under neutral and acidic conditions, the corrosion mechanism of Fe-based amorphous/nanocrystalline coating was mainly local pitting corrosion. However, under strong alkaline conditions, the amorphous/nanocrystalline coating not only had pitting corrosion, but also had the active dissolution of the passive film. Therefore, the anti-corrosion performance of Fe-based amorphous/nanocrystalline coating under alkaline conditions was not as good as neutral and acidic corrosive medium.
Open AccessElectrochemical Corrosive Behaviors of Fe-Based Amorphous/Nanocrystalline Coating on Stainless Steel Prepared by HVOF-Sprayed
In this study, FeCrMnWMoSi amorphous/nanocrystalline coating was prepared on stainless steel by high-velocity oxygen fuel (HVOF) spraying. In order to thoroughly evaluate this novel material, the corrosion behaviors and corrosive film characteristics of the amorphous/nanocrystalline coating in NaCl corrosive media were studied using electrochemical measurement technologies such as potentiodynamic polarization curves and electrochemical impedance spectroscopy (EIS). It was found that the corrosion resistance of Fe-based amorphous/nanocrystalline coating could be attributed to the passive film formed, which consisted of Fe, Cr, Mo, and W oxides. pH has an important influence on the corrosion resistance of amorphous/nanocrystalline coating by changing the pitting corrosion mechanism. Under neutral and acidic conditions, the corrosion mechanism of Fe-based amorphous/nanocrystalline coating was mainly local pitting corrosion. However, under strong alkaline conditions, the amorphous/nanocrystalline coating not only had pitting corrosion, but also had the active dissolution of the passive film. Therefore, the anti-corrosion performance of Fe-based amorphous/nanocrystalline coating under alkaline conditions was not as good as neutral and acidic corrosive medium.
- Open Access
- 1 January 2015
- Published by Shanghai Institute of Ceramics in Journal of Inorganic Materials
- Vol. 30 (3) , 282-286
Oxidation-resistance of ZrB$lt;inf$gt;2$lt;/inf$gt;-MoSi$lt;inf$gt;2$lt;/inf$gt; Composite Coatings Prepared by Atmospheric Plasma Spraying
MoSi 2 复合涂层及其抗氧化性能 毛金元 1, 2 , 刘 敏 2 , 毛 杰 2 , 邓春明 2 , 曾德长 1 , 徐 林 3 (1. 华南理工大学 材料科学与工程学院, 广州 510640; 2. 广州有色金属研究院 新材料研究所, 广州 510650; 3. 航天材料及工艺研究所, 北京 100076) 摘 要: 采用喷雾干燥与真空烧结技术制备出不同 MoSi 2 含量的 ZrB 2-MoSi 2 球形团聚粉末, 并以平均粒径为 30 m 的 ZrB 2-MoSi 2 团聚粉末为原料, 利用大气等离子喷涂法在 C/C 复合材料表面制备包覆完整的 ZrB 2-MoSi 2 复合涂层, 借助 XRD、SEM 等对涂层的组织结构以及涂层的抗氧化性能进行了研究。结果表明: ZrB 2-MoSi 2 涂层结构均匀致 密, 结合强度达到 7.2 MPa。适当含量的 MoSi 2 , 可以提高涂层的抗高温氧化性能; ZrB
- 1 January 2015
- Published by Shanghai Institute of Ceramics in Journal of Inorganic Materials
- Vol. 30 (3) , 282-286
Open AccessOxidation-resistance of ZrB$lt;inf$gt;2$lt;/inf$gt;-MoSi$lt;inf$gt;2$lt;/inf$gt; Composite Coatings Prepared by Atmospheric Plasma Spraying
MoSi 2 复合涂层及其抗氧化性能 毛金元 1, 2 , 刘 敏 2 , 毛 杰 2 , 邓春明 2 , 曾德长 1 , 徐 林 3 (1. 华南理工大学 材料科学与工程学院, 广州 510640; 2. 广州有色金属研究院 新材料研究所, 广州 510650; 3. 航天材料及工艺研究所, 北京 100076) 摘 要: 采用喷雾干燥与真空烧结技术制备出不同 MoSi 2 含量的 ZrB 2-MoSi 2 球形团聚粉末, 并以平均粒径为 30 m 的 ZrB 2-MoSi 2 团聚粉末为原料, 利用大气等离子喷涂法在 C/C 复合材料表面制备包覆完整的 ZrB 2-MoSi 2 复合涂层, 借助 XRD、SEM 等对涂层的组织结构以及涂层的抗氧化性能进行了研究。结果表明: ZrB 2-MoSi 2 涂层结构均匀致 密, 结合强度达到 7.2 MPa。适当含量的 MoSi 2 , 可以提高涂层的抗高温氧化性能; ZrB