Layachi Khamliche
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Layachi Khamliche has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Nadia Ouasfi
Laboratory of Organic Chemistry, Bioorganic and Environment, Faculty of Sciences, University of Chouaïb Doukkali, El Jadida, Morocco
4 shared publicationsAnas Salhi
Chemistry Department, Faculty of Science, Laboratory of Organic Chemistry, Bioorganic and Environment, University Chouaïb Doukkali, El Jadida, Morocco
2 shared publications- Mohamed Zbair
Université de Haute-Alsace, CNRS, IS2M UMR 7361, F-68100 Mulhouse, France; Université de Haute Alsace (UHA), 68093 Mulhouse, France
2 shared publications - Said Bouzikri
Laboratory of Organic Chemistry, Bioorganic and Environment, Chemistry Department, Faculty of Sciences, University Chouaïb Doukkali, 24000 El Jadida, Morocco
2 shared publications Salem Bakkas
Chemistry Department, Faculty of Science, Laboratory of Organic Chemistry, Bioorganic and Environment, University Chouaïb Doukkali, El Jadida, Morocco
2 shared publications- Charafeddine Jama
Materials and Transformations Unit, University of Lille, CNRS, INRAE, Centrale Lille, UMR 8207-UMET, F-59000 Lille, France
1 shared publication
Latest Publications
- 3 January 2023
- Published by Springer Nature in Nanotechnology for Environmental Engineering
- Vol. 8 (1) , 317-332
The brown marine algae “Laminaria digitata” for the outstanding biosorption of methylene blue and reactive blue 19 dyes: kinetics, equilibrium, thermodynamics, regeneration, and mechanism studies
- 3 January 2023
- Published by Springer Nature in Nanotechnology for Environmental Engineering
- Vol. 8 (1) , 317-332
The brown marine algae “Laminaria digitata” for the outstanding biosorption of methylene blue and reactive blue 19 dyes: kinetics, equilibrium, thermodynamics, regeneration, and mechanism studies
- 1 February 2022
- Published by Springer Nature in Nanotechnology for Environmental Engineering
- Vol. 7 (3) , 647-660
Intercalated double layer hydroxide with sodium lauryl sulfate for cationic dye adsorption from aqueous solution
- 1 February 2022
- Published by Springer Nature in Nanotechnology for Environmental Engineering
- Vol. 7 (3) , 647-660
Intercalated double layer hydroxide with sodium lauryl sulfate for cationic dye adsorption from aqueous solution
- 6 February 2020
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (27) , 33636-33648
Marine alga “Bifurcaria bifurcata”: biosorption of Reactive Blue 19 and methylene blue from aqueous solutions
In this study, we have investigated the removal efficiency of two organic pollutants: methylene blue (MB) and Reactive Blue 19 (RB19) dyes by using a brown marine alga abundantly available on the Moroccan coastlines called Bifurcaria bifurcata (Bif-Bcata). During the experiments that were conducted in batch mode, we have studied the effect of some parameters such as pH, Bif-Bcata mass, contact time, and initial dye concentration in order to optimize the most suitable biosorption conditions. The biosorption tests on Bif-Bcata showed that the equilibrium is reached after 15 min for both dyes MB and RB19. The optimal pH values are 5.6 and 1.0 for MB and RB19, respectively. Kinetic studies revealed that the biosorption of both dyes follows the pseudo-second-order model. The biosorption isotherms demonstrated that the Langmuir model is the most appropriate to describe the biosorption equilibrium for both dyes MB and RB19 with maximum biosorption capacities reaching 2744.5 mg/g for MB and 88.7 mg/g for RB19. According to these results, it is clear that Bif-Bcata can be considered a promising biomaterial to be used as an effective biosorbent for the elimination of cationic and anionic dyes from textile effluents.
- 6 February 2020
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (27) , 33636-33648
Marine alga “Bifurcaria bifurcata”: biosorption of Reactive Blue 19 and methylene blue from aqueous solutions
In this study, we have investigated the removal efficiency of two organic pollutants: methylene blue (MB) and Reactive Blue 19 (RB19) dyes by using a brown marine alga abundantly available on the Moroccan coastlines called Bifurcaria bifurcata (Bif-Bcata). During the experiments that were conducted in batch mode, we have studied the effect of some parameters such as pH, Bif-Bcata mass, contact time, and initial dye concentration in order to optimize the most suitable biosorption conditions. The biosorption tests on Bif-Bcata showed that the equilibrium is reached after 15 min for both dyes MB and RB19. The optimal pH values are 5.6 and 1.0 for MB and RB19, respectively. Kinetic studies revealed that the biosorption of both dyes follows the pseudo-second-order model. The biosorption isotherms demonstrated that the Langmuir model is the most appropriate to describe the biosorption equilibrium for both dyes MB and RB19 with maximum biosorption capacities reaching 2744.5 mg/g for MB and 88.7 mg/g for RB19. According to these results, it is clear that Bif-Bcata can be considered a promising biomaterial to be used as an effective biosorbent for the elimination of cationic and anionic dyes from textile effluents.
- Open Access
- 28 March 2019
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (17) , 9792-9808
Selected pharmaceuticals removal using algae derived porous carbon: experimental, modeling and DFT theoretical insights
Porous carbon from Laminaria digitata algae activated using NaOH (PCLD@NaOH) was prepared by a chemical activation approach and has been tested for the adsorption of ketoprofen and aspirin molecules. The prepared PCLD@NaOH was characterized using XPS, FTIR, Raman, N2-physisorption, SEM, acidic/basic character (Boehm), and pHPZC. The batch adsorption of ketoprofen and aspirin was investigated under different parameters. The adsorption kinetics on PCLD@NaOH were well described by the Avrami-fractional kinetic model and the equilibrium data by Liu isotherm model. The adsorption capacity of aspirin (970.88 mg g−1 at 25 °C) was higher than ketoprofen (443.45 mg g−1 at 25 °C). The thermodynamic values indicate that the adsorption of ketoprofen and aspirin is exothermic and spontaneous. These results were in good agreement with DFT calculation that shows that the aspirin molecule presents high reactivity, electrophilicity, and softness compared to the ketoprofen molecule. Finally, the response surface methodology was used to optimize the removal efficiency of ketoprofen and aspirin.
- 28 March 2019
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 9 (17) , 9792-9808
Open AccessSelected pharmaceuticals removal using algae derived porous carbon: experimental, modeling and DFT theoretical insights
Porous carbon from Laminaria digitata algae activated using NaOH (PCLD@NaOH) was prepared by a chemical activation approach and has been tested for the adsorption of ketoprofen and aspirin molecules. The prepared PCLD@NaOH was characterized using XPS, FTIR, Raman, N2-physisorption, SEM, acidic/basic character (Boehm), and pHPZC. The batch adsorption of ketoprofen and aspirin was investigated under different parameters. The adsorption kinetics on PCLD@NaOH were well described by the Avrami-fractional kinetic model and the equilibrium data by Liu isotherm model. The adsorption capacity of aspirin (970.88 mg g−1 at 25 °C) was higher than ketoprofen (443.45 mg g−1 at 25 °C). The thermodynamic values indicate that the adsorption of ketoprofen and aspirin is exothermic and spontaneous. These results were in good agreement with DFT calculation that shows that the aspirin molecule presents high reactivity, electrophilicity, and softness compared to the ketoprofen molecule. Finally, the response surface methodology was used to optimize the removal efficiency of ketoprofen and aspirin.
- Open Access
- 31 March 2015
- Published by Mediterranean Journal of Chemistry in Mediterranean Journal of Chemistry
- Vol. 4 (2) , 85-92
Biosorption of Copper (Cu 2+) in aqueous solution by an adsorbent materiel prepared from marine algae (Bifurcaria bifurcata): Equilibrium and kinetic studies
Morocco is a country influenced by the 3500 km of coastline, with the presence of many marine species. Among these species, there is a wide variety of marine algae that have been specifically used in pharmacological studies, but also environmental. Among these seaweed species Bifurcaria bifurcata having a very large biomass was used as a novel adsorbent for the removal of copper in aqueous solution. Adsorption tests showed that the equilibrium is established after 60 minutes. Various experimental parameters were analyzed: pH, adsorbent mass and initial concentration of copper. Experimental results have shown that the adsorption of copper on seaweed pH dependent of the solution and the initial concentration of copper. The adsorption capacity was determined using the Langmuir and Freundlich isotherms. The maximum adsorption capacity is 101.9 mg.g-1. The kinetic study of the adsorption of copper on the algae showed that the adsorption process follows the pseudo-second order kinetic model with high R2 values.
- 31 March 2015
- Published by Mediterranean Journal of Chemistry in Mediterranean Journal of Chemistry
- Vol. 4 (2) , 85-92
Open AccessBiosorption of Copper (Cu 2+) in aqueous solution by an adsorbent materiel prepared from marine algae (Bifurcaria bifurcata): Equilibrium and kinetic studies
Morocco is a country influenced by the 3500 km of coastline, with the presence of many marine species. Among these species, there is a wide variety of marine algae that have been specifically used in pharmacological studies, but also environmental. Among these seaweed species Bifurcaria bifurcata having a very large biomass was used as a novel adsorbent for the removal of copper in aqueous solution. Adsorption tests showed that the equilibrium is established after 60 minutes. Various experimental parameters were analyzed: pH, adsorbent mass and initial concentration of copper. Experimental results have shown that the adsorption of copper on seaweed pH dependent of the solution and the initial concentration of copper. The adsorption capacity was determined using the Langmuir and Freundlich isotherms. The maximum adsorption capacity is 101.9 mg.g-1. The kinetic study of the adsorption of copper on the algae showed that the adsorption process follows the pseudo-second order kinetic model with high R2 values.