Yalin Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yalin Wang has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Diwen Ying
School of Environmental Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
2 shared publications - Jinping Jia
School of Environmental Science and Engineering, Shanghai Jiao Tong University, 800 Dong Chuan Road, Shanghai 200240, P. R. China
2 shared publications - Chen Yang
School of Environmental Science and Engineering, Shanghai Jiao Tong University, No. 800 Dong Chuan Rd., Shanghai 200240, China
1 shared publication - Hongbo Zhang
School of Chemical and Environmental Engineering, Shanghai Institute of Technology, Shanghai 201418, P. R. China
1 shared publication - Juexiu Li
School of Smart Energy and Environment, Zhongyuan University of Technology, Zhengzhou 450007, China
1 shared publication - Kan Li
State Key Laboratory of Green Papermaking and Resource Recycling, Shanghai Engineering Research Center of Solid Waste Treatment and Resource Recovery, School of Environmental Science and Engineering Shanghai Jiao Tong University Shanghai P. R. China
1 shared publication
Latest Publications
- Open Access
- 27 February 2019
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 16 (5) , 711
In Plasma Catalytic Oxidation of Toluene Using Monolith CuO Foam as a Catalyst in a Wedged High Voltage Electrode Dielectric Barrier Discharge Reactor: Influence of Reaction Parameters and Byproduct Control
Volatile organic compounds (VOCs) emission from anthropogenic sources has becoming increasingly serious in recent decades owing to the substantial contribution to haze formation and adverse health impact. To tackle this issue, various physical and chemical techniques are applied to eliminate VOC emissions so as to reduce atmospheric pollution. Among these methods, non-thermal plasma (NTP) is receiving increasing attention for the higher removal efficiency, non-selectivity, and moderate operation, whereas the unwanted producing of NO2 and O3 remains important drawback. In this study, a dielectric barrier discharge (DBD) reactor with wedged high voltage electrode coupled CuO foam in an in plasma catalytic (IPC) system was developed to remove toluene as the target VOC. The monolith CuO foam exhibits advantages of easy installation and controllable of IPC length. The influencing factors of IPC reaction were studied. Results showed stronger and more stable plasma discharge in the presence of CuO foam in DBD reactor. Enhanced performance was observed in IPC reaction for both of toluene conversion rate and CO2 selectivity compared to the sole NTP process at the same input energy. The longer the contributed IPC length, the higher the toluene removal efficiency. The toluene degradation mechanism under IPC condition was speculated. The producing of NO2 and O3 under IPC process were effectively removed using Na2SO3 bubble absorption.
- 27 February 2019
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 16 (5) , 711
Open AccessIn Plasma Catalytic Oxidation of Toluene Using Monolith CuO Foam as a Catalyst in a Wedged High Voltage Electrode Dielectric Barrier Discharge Reactor: Influence of Reaction Parameters and Byproduct Control
Volatile organic compounds (VOCs) emission from anthropogenic sources has becoming increasingly serious in recent decades owing to the substantial contribution to haze formation and adverse health impact. To tackle this issue, various physical and chemical techniques are applied to eliminate VOC emissions so as to reduce atmospheric pollution. Among these methods, non-thermal plasma (NTP) is receiving increasing attention for the higher removal efficiency, non-selectivity, and moderate operation, whereas the unwanted producing of NO2 and O3 remains important drawback. In this study, a dielectric barrier discharge (DBD) reactor with wedged high voltage electrode coupled CuO foam in an in plasma catalytic (IPC) system was developed to remove toluene as the target VOC. The monolith CuO foam exhibits advantages of easy installation and controllable of IPC length. The influencing factors of IPC reaction were studied. Results showed stronger and more stable plasma discharge in the presence of CuO foam in DBD reactor. Enhanced performance was observed in IPC reaction for both of toluene conversion rate and CO2 selectivity compared to the sole NTP process at the same input energy. The longer the contributed IPC length, the higher the toluene removal efficiency. The toluene degradation mechanism under IPC condition was speculated. The producing of NO2 and O3 under IPC process were effectively removed using Na2SO3 bubble absorption.
- Open Access
A Highly Efficient Dual Rotating Disks Photocatalytic Fuel Cell with Wedged Surface TiO2 Nanopore Anode and Hemoglobin Film Cathode
In this study, a dual rotating-disk photocatalytic fuel cell using TiO2 on Ti plate with a wedged surface as the anode and hemoglobin (Hb) on graphite as the cathode was investigated and found to show excellent performance of simultaneous organic pollutant degradation and electricity generation. This study is based on a well-developed photocatalytic fuel cell equipped with dual rotating disks for wastewater treatment that we developed previously, and the innovation of this new device is using a hemoglobin on graphite cathode for in situ hydrogen peroxide (H2O2) generation. The result proved with confidence that H2O2 was generated in situ on a cathode surface with the exited electron transferred from organic oxidation in a photoanodic half cell, and the organic pollutants were removed by the reaction with H2O2 and ·OH in a cathodic half cell. This design uses the invalid excited electron from the photoanode and enhances the overall performance of Rhodamine B degradation compared with the cells using the cathode without Hb. Compared with traditional photocatalytic reactors, the photocatalytic fuel cell developed above shows much better utilization efficiency of incident light and a higher degradation performance of organic pollutants and a larger photocurrent.
Open AccessA Highly Efficient Dual Rotating Disks Photocatalytic Fuel Cell with Wedged Surface TiO2 Nanopore Anode and Hemoglobin Film Cathode
In this study, a dual rotating-disk photocatalytic fuel cell using TiO2 on Ti plate with a wedged surface as the anode and hemoglobin (Hb) on graphite as the cathode was investigated and found to show excellent performance of simultaneous organic pollutant degradation and electricity generation. This study is based on a well-developed photocatalytic fuel cell equipped with dual rotating disks for wastewater treatment that we developed previously, and the innovation of this new device is using a hemoglobin on graphite cathode for in situ hydrogen peroxide (H2O2) generation. The result proved with confidence that H2O2 was generated in situ on a cathode surface with the exited electron transferred from organic oxidation in a photoanodic half cell, and the organic pollutants were removed by the reaction with H2O2 and ·OH in a cathodic half cell. This design uses the invalid excited electron from the photoanode and enhances the overall performance of Rhodamine B degradation compared with the cells using the cathode without Hb. Compared with traditional photocatalytic reactors, the photocatalytic fuel cell developed above shows much better utilization efficiency of incident light and a higher degradation performance of organic pollutants and a larger photocurrent.