Alexander Eliyas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alexander Eliyas has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
S. Rakovsky
Bulgarian Academy of Sciences
2 shared publications- Anna Zorkovská
Institute of Geotechnics, Slovak Academy of Sciences, 040 01 Košice, Slovakia
1 shared publication - Daniela Stoyanova
Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, “Acad. G. Bonchev” St., Bl. 11, 1113 Sofia, Bulgaria
1 shared publication - Erika Dutková
Institute of Geotechnics, Slovak Academy of Sciences, Kosice, Slovakia
1 shared publication - Irina Stambolova
Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, “Acad. G. Bonchev” St., Bl. 11, 1113 Sofia, Bulgaria
1 shared publication - Ivan Ivanov
Bulgarian Academy of Sciences
1 shared publication
Latest Publications
- Open Access
Surface Morphological and Chemical Features of Anticorrosion ZrO2–TiO2 Coatings: Impact of Zirconium Precursor
Dense, highly textured, hydrophobic ZrO2-TiO2 (1:1) coatings with amorphous structure were prepared using the sol-gel method. Both organic and inorganic zirconium precursor salts were used. The present study dealt with the investigation of their protective ability in a selected model corrosive medium with chloride ions as corrosion activators. The coatings showed good anticorrosion performance during the test, which was demonstrated both by the weight loss method and potentiodynamic polarization curves. The samples were characterized by means of X-ray diffraction (XRD), Atomic Force Microscopy (AFM), contact angle measurements, Infrared spectroscopy (IRS), Scanning Electron Microscopy (SEM), Differential Thermal analysis (DTA-TG) and X-ray photoelectron spectroscopy (XPS). It was established that the extent of influence of some factors, like treatment temperature (Ttr) and type of zirconium precursor, was different. The PD curves of samples treated at 400 °C (A4 and B4, respectively) demonstrated an increased effect of the precursor in comparison to Ttr, since the application of organic Zr salt led to deterioration of the anodic passivation zones. Contrary to this, the coatings obtained from both the organic and inorganic Zr precursor salts with Ttr = 500 °C had similar corrosion efficiency, i.e., the influence of the precursor was minimized. All investigated coatings had no visible corrosion damage. It seems that some complex structural and surface parameters, such as amorphous dense structure, surface smoothness, hydrophobicity and the surface chemical composition (low hydroxyl groups content), were responsible for the increased anticorrosion properties of the composite films.
Open AccessSurface Morphological and Chemical Features of Anticorrosion ZrO2–TiO2 Coatings: Impact of Zirconium Precursor
Dense, highly textured, hydrophobic ZrO2-TiO2 (1:1) coatings with amorphous structure were prepared using the sol-gel method. Both organic and inorganic zirconium precursor salts were used. The present study dealt with the investigation of their protective ability in a selected model corrosive medium with chloride ions as corrosion activators. The coatings showed good anticorrosion performance during the test, which was demonstrated both by the weight loss method and potentiodynamic polarization curves. The samples were characterized by means of X-ray diffraction (XRD), Atomic Force Microscopy (AFM), contact angle measurements, Infrared spectroscopy (IRS), Scanning Electron Microscopy (SEM), Differential Thermal analysis (DTA-TG) and X-ray photoelectron spectroscopy (XPS). It was established that the extent of influence of some factors, like treatment temperature (Ttr) and type of zirconium precursor, was different. The PD curves of samples treated at 400 °C (A4 and B4, respectively) demonstrated an increased effect of the precursor in comparison to Ttr, since the application of organic Zr salt led to deterioration of the anodic passivation zones. Contrary to this, the coatings obtained from both the organic and inorganic Zr precursor salts with Ttr = 500 °C had similar corrosion efficiency, i.e., the influence of the precursor was minimized. All investigated coatings had no visible corrosion damage. It seems that some complex structural and surface parameters, such as amorphous dense structure, surface smoothness, hydrophobicity and the surface chemical composition (low hydroxyl groups content), were responsible for the increased anticorrosion properties of the composite films.
- Open Access
Chalcogenide Quaternary Cu2FeSnS4 Nanocrystals for Solar Cells: Explosive Character of Mechanochemical Synthesis and Environmental Challenge
In this study we demonstrate the synthesis of quaternary semiconductor nanocrystals of stannite Cu2FeSnS4/rhodostannite Cu2FeSn3S8 (CFTS) via mechanochemical route using Cu, Fe, Sn and S elements as precursors in one-pot experiments. Methods of X-ray diffraction (XRD), nitrogen adsorption, high-resolution transmission electron microscopy (HRTEM), scanning transmission electron microscopy (STEM), energy-dispersive X-ray spectroscopy (EDX) and X-ray photoelectron spectroscopy (XPS) were applied to characterize properties of the unique nanostructures. Mechanochemical route of synthesis induced new phenomena like explosive character of reaction, where three stages could be identified and the formation of nanostructures 5–10 nm in size. By using XPS method, Cu(I), Fe(II), Sn(IV) and S(-II) species were identified on the surface of CFTS. The value of optical band gap 1.27 eV is optimal for semiconductors applicable as absorbers in solar cells. The significant photocatalytic activity of the CFTS nanocrystals was also evidenced. The obtained results confirm the excellent properties of the quaternary semiconductor nanocrystals synthesized from earth-abundant elements.
Open AccessChalcogenide Quaternary Cu2FeSnS4 Nanocrystals for Solar Cells: Explosive Character of Mechanochemical Synthesis and Environmental Challenge
In this study we demonstrate the synthesis of quaternary semiconductor nanocrystals of stannite Cu2FeSnS4/rhodostannite Cu2FeSn3S8 (CFTS) via mechanochemical route using Cu, Fe, Sn and S elements as precursors in one-pot experiments. Methods of X-ray diffraction (XRD), nitrogen adsorption, high-resolution transmission electron microscopy (HRTEM), scanning transmission electron microscopy (STEM), energy-dispersive X-ray spectroscopy (EDX) and X-ray photoelectron spectroscopy (XPS) were applied to characterize properties of the unique nanostructures. Mechanochemical route of synthesis induced new phenomena like explosive character of reaction, where three stages could be identified and the formation of nanostructures 5–10 nm in size. By using XPS method, Cu(I), Fe(II), Sn(IV) and S(-II) species were identified on the surface of CFTS. The value of optical band gap 1.27 eV is optimal for semiconductors applicable as absorbers in solar cells. The significant photocatalytic activity of the CFTS nanocrystals was also evidenced. The obtained results confirm the excellent properties of the quaternary semiconductor nanocrystals synthesized from earth-abundant elements.
- 7 August 2013
- Published by Springer Nature in Catalysis Letters
- Vol. 143 (9) , 942-949
Comparative Study of Ceria Supported Nano-sized Platinum Catalysts Synthesized by Extractive-Pyrolytic Method for Low-Temperature WGS Reaction
- 7 August 2013
- Published by Springer Nature in Catalysis Letters
- Vol. 143 (9) , 942-949
Comparative Study of Ceria Supported Nano-sized Platinum Catalysts Synthesized by Extractive-Pyrolytic Method for Low-Temperature WGS Reaction
- 1 January 2013
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 16 (1) , 31-51
Ozone Degradation of Alcohols, Ketones, Ethers and Hydroxybenzenes: Determination of Pathways and Kinetic Parameters
- 1 January 2013
- Published by Sycamore Global Publications in Journal of Advanced Oxidation Technologies
- Vol. 16 (1) , 31-51
Ozone Degradation of Alcohols, Ketones, Ethers and Hydroxybenzenes: Determination of Pathways and Kinetic Parameters
- 29 January 2011
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 102 (2) , 251-261
Transferring concepts from classical catalysis to the new field of photocatalysis
- 29 January 2011
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 102 (2) , 251-261
Transferring concepts from classical catalysis to the new field of photocatalysis