Anqi Wang

High concentration ozone can damage greatly to the respiratory, cardiovascular systems, and fertility of people, and catalytic decomposition is an important strategy to reduce its harm. However, it remains a challenge to develop efficient ozone decomposition catalysts with high efficiency. In this study, p- and n-type silicon nanowires (Si NWs) are fabricated by wet chemical etching method and are firstly applied to catalytic decompose ozone at room temperature. The p-type Si NWs exhibit 90% ozone (20 ppm O₃/air) decomposition efficiency with great stability, which is much better than that of n-type Si NWs (50%) with same crystal orientation, similar diameter and specific surface area. The catalytic property difference is mainly attributed to the more delocalization holes in the p-type Si NWs, which can accelerate the desorption of ozone decomposition intermediates (i.e., adsorbed oxygen species).

Although significant developments have been made in the low-concentration formaldehyde monitoring in indoor air by using gas sensors, they still suffer from insufficient performance for achieving ppb-level detection. In this work, oriented Si nanowires (SiNWs) with high specific surface area were prepared via metal-assisted chemical etching method (MACE), and then were uniformly coated with graphene oxide (GO) followed by the subsequent reductive process in H2/Ar atmosphere at 800 °C to obtain reduced graphene oxide (RGO). The RGO coating (RGO@n-SiNWs) obviously enhances SiNWs sensitivity to low-concentration formaldehyde, benefiting from the increased specific surface area, the sensitization effect of RGO, and the formation of p-n junction between SiNWs and RGO. Specifically, RGO@n-SiNWs exhibits a high response of 6.4 to 10 ppm formaldehyde at 300 °C, which is about 2.6 times higher than that of pristine SiNWs (~ 2.5). Furthermore, the RGO@n-SiNWs show a high response of 2.4 to 0.1 ppm formaldehyde which is the largest permissive concentration in indoor air, a low detection limit of 35 ppb obtained by non-linear fitting, and fast response/recovery times of 30 and 10 s. In the meanwhile, the sensor also shows high selectivity over other typical interfering gases such as ethanol, acetone, ammonia, methanol, xylene, and toluene, and shows a high stability over a measurement period of 6 days. These results enable the highly sensitive, selective, and stable detection of low-concentration formaldehyde to guarantee safety of indoor environment.