Satu Ojala
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Satu Ojala has a total of 176 co-authors. Here are the top co-authors by number of shared publications:
- Riitta Liisa Keiski
Environmental and Chemical Engineering, Faculty of Technology, University of Oulu, P.O. Box 4300, FI-90014 Oulu, Finland
12 shared publications - Rachid Brahmi
Laboratory of Coordination and Analytical Chemistry, Faculty of Sciences, Chouaib Doukkali University, El Jadida, Morocco
7 shared publications - Tiina Laitinen
Environmental and Chemical Engineering, Faculty of Technology, University of Oulu, 90570 Oulu, Finland
7 shared publications Riitta L. Keiski
6 shared publications- Sérgio Botelho de Oliveira
Chemistry Department, Federal Institute of Goiás, Goiânia 75132-903, Brazil
6 shared publications - Tiina Laitinen
Environmental and Chemical Engineering (ECE), Faculty of Technology, University of Oulu, Oulu, Finland
6 shared publications
Latest Publications
- 13 November 2026
- Published by Wiley in Chemphyschem
- Vol. 27 (22)
Geopolymers as Hydrogen Storage Media
Materials‐based hydrogen storage has gained attention due to the limitations of storing hydrogen as a gas or liquid. In this study, geopolymers were explored as a hydrogen storage medium for the first time by systematically varying their Si:Al:Na/K ratios and gradually introducing Ca. The hydrogen adsorption performance was evaluated at −20, +25, or +40 °C and hydrogen pressures up to 100 bar. The Ca‐free compositions exhibited better performance in comparison to the Ca‐containing ones. Furthermore, the Na‐based geopolymers could adsorb more hydrogen than the K‐based geopolymers. For the Ca‐free geopolymers, hydrogen adsorption increased with increasing Si/Al ratio and was positively correlated with specific surface area and pore volume, but negatively correlated with average pore size. The best performance was achieved with the composition Si 20 Al 1 Na 1 which had the gravimetric hydrogen adsorption capacity of 0.64 wt.% at −20 °C and 100 bar. Even though the result is below the practical target value of 6.5 wt.% as defined by the U.S. Department of Energy, geopolymers outperformed similar zeolites when comparing to the earlier literature. Additionally, the Si 20 Al 1 Na 1 composition demonstrated excellent stability over multiple adsorption/desorption cycles. The results of this study can be used to further develop geopolymers as hydrogen storage media via chemical modifications or hybrid systems.
- 13 November 2026
- Published by Wiley in Chemphyschem
- Vol. 27 (22)
Geopolymers as Hydrogen Storage Media
Materials‐based hydrogen storage has gained attention due to the limitations of storing hydrogen as a gas or liquid. In this study, geopolymers were explored as a hydrogen storage medium for the first time by systematically varying their Si:Al:Na/K ratios and gradually introducing Ca. The hydrogen adsorption performance was evaluated at −20, +25, or +40 °C and hydrogen pressures up to 100 bar. The Ca‐free compositions exhibited better performance in comparison to the Ca‐containing ones. Furthermore, the Na‐based geopolymers could adsorb more hydrogen than the K‐based geopolymers. For the Ca‐free geopolymers, hydrogen adsorption increased with increasing Si/Al ratio and was positively correlated with specific surface area and pore volume, but negatively correlated with average pore size. The best performance was achieved with the composition Si 20 Al 1 Na 1 which had the gravimetric hydrogen adsorption capacity of 0.64 wt.% at −20 °C and 100 bar. Even though the result is below the practical target value of 6.5 wt.% as defined by the U.S. Department of Energy, geopolymers outperformed similar zeolites when comparing to the earlier literature. Additionally, the Si 20 Al 1 Na 1 composition demonstrated excellent stability over multiple adsorption/desorption cycles. The results of this study can be used to further develop geopolymers as hydrogen storage media via chemical modifications or hybrid systems.
- 28 October 2026
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 33 (39) , 17884-17899
Nickel-modified cobalt phosphate: physicochemical properties and catalytic performance in the total oxidation of ethanol
- 28 October 2026
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 33 (39) , 17884-17899
Nickel-modified cobalt phosphate: physicochemical properties and catalytic performance in the total oxidation of ethanol
- Open Access
- 30 May 2026
- Published by Elsevier in Journal of Environmental Management
- Vol. 410, 130074
Engineering Bi3O4Br/TiO2 nanobelt/glucose hydrochar heterostructures for enhanced visible-light degradation of pharmaceutical pollutants
- 30 May 2026
- Published by Elsevier in Journal of Environmental Management
- Vol. 410, 130074
Open AccessEngineering Bi3O4Br/TiO2 nanobelt/glucose hydrochar heterostructures for enhanced visible-light degradation of pharmaceutical pollutants
- Open Access
- 4 March 2026
- Published by Elsevier in SSRN Electronic Journal
Sustainable CuO-impregnated NaX zeolite derived from natural bentonite clay for enhanced Catalytic Wet Peroxide Oxidation of Rhodamine B dye
The effective treatment of dye-contaminated industrial wastewater remains a critical environmental challenge due to the high chemical stability and poor biodegradability of synthetic dyes. In this study, a CuO-loaded NaX zeolite (CuO/NaX) catalyst was synthesized and evaluated for the catalytic wet peroxide oxidation (CWPO) of Rhodamine B (RhB) as a model organic pollutant. NaX zeolite was prepared via hydrothermal conversion of natural bentonite, an abundant and low-cost aluminosilicate resource, while copper oxide was introduced by wet impregnation followed by calcination to enhance catalytic activity. The physicochemical properties of the raw bentonite, synthesized NaX zeolite, and CuO/NaX catalyst were comprehensively characterized using X-Ray Diffraction (XRD), Fourier-Transform Infrared Spectroscopy (FTIR), Field-Emission Scanning Electron Microscopy coupled with Energy-Dispersive X-ray Spectroscopy (FESEM–EDS), Brunauer–Emmett–Teller (BET) surface area analysis, Transmission Electron Microscopy (TEM), and X-ray Photoelectron Spectroscopy (XPS). The catalytic performance of the CuO/NaX system was systematically investigated under different operating conditions, including copper loading, solution’s pH, reaction temperature, hydrogen peroxide concentration, and catalyst dosage. Key performance metrics such as RhB degradation efficiency, reaction kinetics, catalyst reusability, and copper leaching were evaluated. The results demonstrate that the 10%CuO/NaX catalyst exhibits high catalytic activity, achieving 98% RhB removal within 150 min at pH 5.68, good structural stability, low copper leaching, and excellent reusability over five cycles. These findings highlight the potential of bentonite-derived CuO/NaX catalysts as cost-effective and sustainable materials for CWPO-based treatment of dye-containing industrial wastewater, contributing to the development of robust catalytic systems for advanced wastewater remediation.
- 4 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSustainable CuO-impregnated NaX zeolite derived from natural bentonite clay for enhanced Catalytic Wet Peroxide Oxidation of Rhodamine B dye
The effective treatment of dye-contaminated industrial wastewater remains a critical environmental challenge due to the high chemical stability and poor biodegradability of synthetic dyes. In this study, a CuO-loaded NaX zeolite (CuO/NaX) catalyst was synthesized and evaluated for the catalytic wet peroxide oxidation (CWPO) of Rhodamine B (RhB) as a model organic pollutant. NaX zeolite was prepared via hydrothermal conversion of natural bentonite, an abundant and low-cost aluminosilicate resource, while copper oxide was introduced by wet impregnation followed by calcination to enhance catalytic activity. The physicochemical properties of the raw bentonite, synthesized NaX zeolite, and CuO/NaX catalyst were comprehensively characterized using X-Ray Diffraction (XRD), Fourier-Transform Infrared Spectroscopy (FTIR), Field-Emission Scanning Electron Microscopy coupled with Energy-Dispersive X-ray Spectroscopy (FESEM–EDS), Brunauer–Emmett–Teller (BET) surface area analysis, Transmission Electron Microscopy (TEM), and X-ray Photoelectron Spectroscopy (XPS). The catalytic performance of the CuO/NaX system was systematically investigated under different operating conditions, including copper loading, solution’s pH, reaction temperature, hydrogen peroxide concentration, and catalyst dosage. Key performance metrics such as RhB degradation efficiency, reaction kinetics, catalyst reusability, and copper leaching were evaluated. The results demonstrate that the 10%CuO/NaX catalyst exhibits high catalytic activity, achieving 98% RhB removal within 150 min at pH 5.68, good structural stability, low copper leaching, and excellent reusability over five cycles. These findings highlight the potential of bentonite-derived CuO/NaX catalysts as cost-effective and sustainable materials for CWPO-based treatment of dye-containing industrial wastewater, contributing to the development of robust catalytic systems for advanced wastewater remediation.
- Open Access
- 17 February 2026
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 18 (11) , 5918-5927
Biosynthesized iron oxide nanoparticles using Trichoderma harzianum with applications for phytopathogen control
In the pursuit of a sustainable transition toward green synthesis, the biological production of nanomaterials emerges as an attractive alternative for generating nanomaterials with controlled physicochemical properties. In this work, Fe-based nanostructures were biosynthesized using Trichoderma harzianum with iron precursor concentrations of 5 mM (Fe5) and 10 mM (Fe10), followed by thermal treatment. SEM, AFM, and TEM analyses revealed that precursor concentration governs particle size and aggregation, while annealing drives the phase evolution from Fe3O4 based composition in the as-synthesized nanomaterials to a crystalline α-Fe2O3 phase, as confirmed by XRD and XPS. These techniques further indicate that this transformation is associated with the removal of capping biomolecules and the oxidation of Fe(II) to Fe(III). Biologically, Fe5 and Fe10 acted as potent biostimulants, enhancing T. harzianum growth, sporulation, and pigmentation without inhibition. Dual-culture assays demonstrated that both materials significantly increased the fungus's antagonistic activity against Fusarium oxysporum, Fusarium verticillioides, and Phytophthora infestans. These results highlight the potential of biosynthesized Fe oxide nanoparticles as dual-function platforms that couple nanotechnology and biological control for sustainable crop protection.
- 17 February 2026
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 18 (11) , 5918-5927
Open AccessBiosynthesized iron oxide nanoparticles using Trichoderma harzianum with applications for phytopathogen control
In the pursuit of a sustainable transition toward green synthesis, the biological production of nanomaterials emerges as an attractive alternative for generating nanomaterials with controlled physicochemical properties. In this work, Fe-based nanostructures were biosynthesized using Trichoderma harzianum with iron precursor concentrations of 5 mM (Fe5) and 10 mM (Fe10), followed by thermal treatment. SEM, AFM, and TEM analyses revealed that precursor concentration governs particle size and aggregation, while annealing drives the phase evolution from Fe3O4 based composition in the as-synthesized nanomaterials to a crystalline α-Fe2O3 phase, as confirmed by XRD and XPS. These techniques further indicate that this transformation is associated with the removal of capping biomolecules and the oxidation of Fe(II) to Fe(III). Biologically, Fe5 and Fe10 acted as potent biostimulants, enhancing T. harzianum growth, sporulation, and pigmentation without inhibition. Dual-culture assays demonstrated that both materials significantly increased the fungus's antagonistic activity against Fusarium oxysporum, Fusarium verticillioides, and Phytophthora infestans. These results highlight the potential of biosynthesized Fe oxide nanoparticles as dual-function platforms that couple nanotechnology and biological control for sustainable crop protection.
- Open Access
- 25 December 2025
- Published by Elsevier in Desalination and Water Treatment
- Vol. 325
Coupled sorption and oxidation of amoxicillin over magnetite nanoparticle-coated activated carbon
- 25 December 2025
- Published by Elsevier in Desalination and Water Treatment
- Vol. 325
Open AccessCoupled sorption and oxidation of amoxicillin over magnetite nanoparticle-coated activated carbon
- Open Access
- 13 December 2025
- Published by Elsevier in Journal of Catalysis
- Vol. 454
New bi-functional catalysts for a novel continuous production of propylene oxide with in-situ generated hydrogen peroxide
- 13 December 2025
- Published by Elsevier in Journal of Catalysis
- Vol. 454
Open AccessNew bi-functional catalysts for a novel continuous production of propylene oxide with in-situ generated hydrogen peroxide
- 20 November 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 197
Cu doping induces the generation of Pt4+: enhancing the CO-PROX performance of low Pt loading Pt/CeO2-r catalysts
- 20 November 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 197
Cu doping induces the generation of Pt4+: enhancing the CO-PROX performance of low Pt loading Pt/CeO2-r catalysts
- Open Access
- 29 October 2025
- Published by Elsevier in Applied Surface Science Advances
- Vol. 30
Using TiO2 in photocatalytic reactors: VOCs, NOx, CO2 removal and H2 production
- 29 October 2025
- Published by Elsevier in Applied Surface Science Advances
- Vol. 30
Open AccessUsing TiO2 in photocatalytic reactors: VOCs, NOx, CO2 removal and H2 production