Pretom Saha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Pretom Saha has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Toufiq Reza
Department of Chemistry and Chemical Engineering, Florida Institute of Technology, Melbourne, USA
7 shared publications Akbar Saba
Department of Mechanical Engineering, 1 Ohio University, Athens, USA
2 shared publicationsKyle McGaughy
Department of Biomedical and Chemical Engineering and Sciences, Florida Institute of Technology, Melbourne, USA
2 shared publicationsShanta Mazumder
Department of Mechanical Engineering, 1 Ohio University, Athens, USA
2 shared publications- Akbar Saba
Institute for Sustainable Energy and the Environment, Ohio University, Athens, OH 45701, USA
1 shared publication - Diana Franqui-Villanueva
USDA-PWA, ARS, WRRC, BCE, 800 Buchanan Street, Albany, CA 94710, USA
1 shared publication
Latest Publications
- Open Access
Transformation of Sulfur during Co-Hydrothermal Carbonization of Coal Waste and Food Waste
Co-hydrothermal carbonization (Co-HTC) is an emerging technology for processing multiple waste streams together to improve their fuel properties in the solid product, known as hydrochar, compared to the hydrothermal carbonization (HTC) of those individual streams. Sulfur is considered one of the most toxic contaminants in solid fuel and the combustion of this sulfur results in the emission of SOx. It was reported in the literature that, besides the fuel properties, Co-HTC reduced the total sulfur content in the hydrochar phase significantly. However, the transformation of different forms of sulfur has not yet been studied. Therefore, this study investigated the transformation of different forms of sulfur under the Co-HTC treatment. In the study, the Co-HTC of food waste (FW) and two types of coal wastes (middle bottom (CW1) and 4 top (CW2)) were conducted at 180 °C, 230 °C and 280 °C for 30 min. Different forms of sulfur were measured by using elemental analysis (total sulfur), and a wet chemical method (sulfate sulfur and pyritic sulfur). The organic sulfur was measured by the difference method. The results showed that a maximum of 49% and 65% decrease in total sulfur was achieved for CW1FW and CW2FW, respectively, at 230 °C. Similar to the total sulfur, the organic sulfur was also decreased about 85% and 75% for CW1FW and CW2FW, respectively. Based on these results, a sulfur transformation mechanism under Co-HTC treatment was proposed.
Open AccessTransformation of Sulfur during Co-Hydrothermal Carbonization of Coal Waste and Food Waste
Co-hydrothermal carbonization (Co-HTC) is an emerging technology for processing multiple waste streams together to improve their fuel properties in the solid product, known as hydrochar, compared to the hydrothermal carbonization (HTC) of those individual streams. Sulfur is considered one of the most toxic contaminants in solid fuel and the combustion of this sulfur results in the emission of SOx. It was reported in the literature that, besides the fuel properties, Co-HTC reduced the total sulfur content in the hydrochar phase significantly. However, the transformation of different forms of sulfur has not yet been studied. Therefore, this study investigated the transformation of different forms of sulfur under the Co-HTC treatment. In the study, the Co-HTC of food waste (FW) and two types of coal wastes (middle bottom (CW1) and 4 top (CW2)) were conducted at 180 °C, 230 °C and 280 °C for 30 min. Different forms of sulfur were measured by using elemental analysis (total sulfur), and a wet chemical method (sulfate sulfur and pyritic sulfur). The organic sulfur was measured by the difference method. The results showed that a maximum of 49% and 65% decrease in total sulfur was achieved for CW1FW and CW2FW, respectively, at 230 °C. Similar to the total sulfur, the organic sulfur was also decreased about 85% and 75% for CW1FW and CW2FW, respectively. Based on these results, a sulfur transformation mechanism under Co-HTC treatment was proposed.
- 24 June 2020
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 12 (1) , 39-49
Technoeconomic analysis of co-hydrothermal carbonization of coal waste and food waste
- 24 June 2020
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 12 (1) , 39-49
Technoeconomic analysis of co-hydrothermal carbonization of coal waste and food waste
- 2 June 2020
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 12 (1) , 3-13
Co-hydrothermal carbonization of coal waste and food waste: fuel characteristics
- 2 June 2020
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 12 (1) , 3-13
Co-hydrothermal carbonization of coal waste and food waste: fuel characteristics
- 1 July 2019
- Published by Elsevier in Energy Conversion and Management
- Vol. 191, 12-22
A steady-state equilibrium-based carbon dioxide gasification simulation model for hydrothermally carbonized cow manure
- 1 July 2019
- Published by Elsevier in Energy Conversion and Management
- Vol. 191, 12-22
A steady-state equilibrium-based carbon dioxide gasification simulation model for hydrothermally carbonized cow manure
- Open Access
Hydrothermal Carbonization of Various Paper Mill Sludges: An Observation of Solid Fuel Properties
Each year the pulp and paper industries generate enormous amounts of effluent treatment sludge. The sludge is made up of various fractions including primary, secondary, deinked, fiber rejects sludge, etc. The goal of this study was to evaluate the fuel properties of the hydrochars produced from various types of paper mill sludges (PMS) at 180 °C, 220 °C, and 260 °C. The hydrochars, as well as the raw feedstocks, were characterized by means of ultimate analysis, proximate analysis, moisture, ash, lignin, sugar, and higher heating value (HHVdaf) measurements. Finally, combustion indices of selected hydrochars were evaluated and compared with bituminous coal. The results showed that HHVdaf of hydrochar produced at 260 °C varied between 11.4 MJ/kg and 31.5 MJ/kg depending on the feedstock. This implies that the fuel application of hydrochar produced from PMS depends on the quality of feedstocks rather than the hydrothermal carbonization (HTC) temperature. The combustion indices also showed that when hydrochars are co-combusted with coal, they have similar combustion indices to that of coal alone. However, based on the energy and ash contents in the produced hydrochars, Primary and Secondary Sludge (PPS2) could be a viable option for co-combustion with coal in an existing coal-fired power plant.
Open AccessHydrothermal Carbonization of Various Paper Mill Sludges: An Observation of Solid Fuel Properties
Each year the pulp and paper industries generate enormous amounts of effluent treatment sludge. The sludge is made up of various fractions including primary, secondary, deinked, fiber rejects sludge, etc. The goal of this study was to evaluate the fuel properties of the hydrochars produced from various types of paper mill sludges (PMS) at 180 °C, 220 °C, and 260 °C. The hydrochars, as well as the raw feedstocks, were characterized by means of ultimate analysis, proximate analysis, moisture, ash, lignin, sugar, and higher heating value (HHVdaf) measurements. Finally, combustion indices of selected hydrochars were evaluated and compared with bituminous coal. The results showed that HHVdaf of hydrochar produced at 260 °C varied between 11.4 MJ/kg and 31.5 MJ/kg depending on the feedstock. This implies that the fuel application of hydrochar produced from PMS depends on the quality of feedstocks rather than the hydrothermal carbonization (HTC) temperature. The combustion indices also showed that when hydrochars are co-combusted with coal, they have similar combustion indices to that of coal alone. However, based on the energy and ash contents in the produced hydrochars, Primary and Secondary Sludge (PPS2) could be a viable option for co-combustion with coal in an existing coal-fired power plant.
- 4 May 2018
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 38 (1) , 154-162
Pyrolysis and carbon dioxide gasification kinetics of hydrochar produced from cow manure
This study focuses on determining the kinetic parameters of pyrolysis and gasification of manure‐derived hydrochar. Hydrochar was first pyrolyzed in Thermogravimetric analyzer at heating rates of 5, 10, and 20°C min−1 with N2 and gasified afterwards with CO2 at 800, 900, and 1000°C for 30, 60, and 90 min. Morphology of the pyrolysis and gasified chars were analyzed with FT‐IR and scanning electron microscope (SEM). Kissinger's method was used to evaluate kinetic parameters for pyrolysis, while Arrhenius method was implemented to evaluate gasification kinetic parameters. Activation energy for pyrolysis and gasification were 211.5 ± 7.7 kJ mol−1 and 270 ± 20 kJ mol−1, respectively. FT‐IR analysis revealed that ‐OH and aliphatic C‐H groups were significantly reduced compare to raw hydrochar during gasification. A decrease of particle size and an increase of amorphous region were observed in SEM analysis, while energy‐dispersive x‐ray spectroscopy analysis revealed an increase in oxygen and carbon contents in gasified char. © 2018 American Institute of Chemical Engineers Environ Prog, 38: 154–162, 2019
- 4 May 2018
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 38 (1) , 154-162
Pyrolysis and carbon dioxide gasification kinetics of hydrochar produced from cow manure
This study focuses on determining the kinetic parameters of pyrolysis and gasification of manure‐derived hydrochar. Hydrochar was first pyrolyzed in Thermogravimetric analyzer at heating rates of 5, 10, and 20°C min−1 with N2 and gasified afterwards with CO2 at 800, 900, and 1000°C for 30, 60, and 90 min. Morphology of the pyrolysis and gasified chars were analyzed with FT‐IR and scanning electron microscope (SEM). Kissinger's method was used to evaluate kinetic parameters for pyrolysis, while Arrhenius method was implemented to evaluate gasification kinetic parameters. Activation energy for pyrolysis and gasification were 211.5 ± 7.7 kJ mol−1 and 270 ± 20 kJ mol−1, respectively. FT‐IR analysis revealed that ‐OH and aliphatic C‐H groups were significantly reduced compare to raw hydrochar during gasification. A decrease of particle size and an increase of amorphous region were observed in SEM analysis, while energy‐dispersive x‐ray spectroscopy analysis revealed an increase in oxygen and carbon contents in gasified char. © 2018 American Institute of Chemical Engineers Environ Prog, 38: 154–162, 2019
- 1 December 2017
- Published by Elsevier in Fuel Processing Technology
- Vol. 167, 711-720
Co-Hydrothermal Carbonization of coal-biomass blend: Influence of temperature on solid fuel properties
- 1 December 2017
- Published by Elsevier in Fuel Processing Technology
- Vol. 167, 711-720
Co-Hydrothermal Carbonization of coal-biomass blend: Influence of temperature on solid fuel properties