SMShigehito Miki

Shigehito Miki

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shigehito Miki has a total of 148 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Evaluating the resolution-efficiency trade-off of optical Kerr gating via biphoton temporal correlation measurements

    by Takahisa Kuwana, Masahiro Yabuno, Hirotaka Terai, Shigehito Miki, Peter J. Mosley, Rui-Bo Jin, Ryosuke Shimizu

    Fiber-based optical Kerr gating is a promising technique for ultrafast single-photon detection. While a fundamental trade-off between temporal resolution and detection efficiency has been anticipated, its experimental verification has remained elusive due to the lack of a suitable platform. In this study, we demonstrate the unexplored trade-off relationship using a highly efficient optical Kerr-gating system based on a photonic crystal fiber. Our results elucidate the inherent constraints governing the trade-off, providing a critical foundation for the future design and optimization of ultrafast single-photon detection.

  • Evaluation of NbTiN Superconducting Strip Photon Detectors With 0.1–30 µm Strip Widths

    by Tomohiro Haneishi, Masahiro Yabuno, Hiroki Kutsuma, Shigehito Miki, Taro Yamashita

    We report the niobium titanium nitride (NbTiN) superconducting strip photon detectors (SSPDs) with strip widths ranging from 0.1 to 30 µm. The bias current dependences of the detection efficiencies at the 1550 nm wavelength and the dark count rates were systematically evaluated in the wide range of the strip widths. Single-photon detection was confirmed and a saturation trend in the bias current dependence of detection efficiency was also observed for all strip width SSPDs. In addition, we measured the physical properties of the NbTiN films and found the switching current of SSPDs gradually deviated lower from the estimated depairing current with increasing the strip width. Furthermore, the dark counts occurred at the lower bias current relative to the depairing current as the strip width increased. These results suggest that the bias current is unevenly distributed as the strip width increases and the concentrated bias current may induce the dark counts. Our results would provide valuable insights into a better understanding of SSPDs with a wide range of strip widths, the origin of dark counts, and the mechanism of photon detection in superconducting strip.


  • 超伝導ストリップ光子検出技術の新展開

    by Shigehito Miki

    Photon absorption in a superconducting strip with a thickness of only a few nanometers produces excited quasiparticles eventually produce a localized resistive region. A Superconducting Strip Photon Detector (SSPD) based on this phenomenon was proposed in 2001, and today, the detection efficiency is approaching 100 %, the dark count rate and timing jitter is overwhelmingly low as compared to other single photon detectors. SSPD has already positioned as an indispensable technology in various advanced technological fields such as quantum technology, live cell observation, LIDAR, and deep space optical communication technology. Recently, there have been several reports that break down stereotypes about what an SSPD should be. In this article, I focus on intriguing topics concerning the latest research and development trends in SSPD.


  • Open Access

    Single-flux-quantum signal processors monolithically integrated with a superconducting nanostrip single-photon detector array

    by Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki, Shuichi Nagasawa, Mutsuo Hidaka, Hirotaka Terai

    We developed a monolithic integration process for a superconducting nanostrip single-photon detector (SNSPD) and a cryogenic signal processor based on a single-flux-quantum (SFQ) circuit. Sixteen-pixel SNSPDs consisting of a 10-nm-thick and 100-nm-wide NbTiN nanowire were fabricated on a 3-in. Si wafer with an SFQ merger fabricated by the National Institute of Advanced Industrial Science and Technology Nb 2.5 kA/cm2 standard process 2. Subsequently, we illuminated the photons on the 16-pixel SNSPD array through an optical fiber and obtained a similar bias-current dependence of the detection efficiency with a single-pixel SNSPD without the SFQ merger. This indicates that the SFQ merger works correctly, and that the power dissipation of the SFQ circuit, which is estimated to be 200 μW, does not deteriorate the photon detection of SNSPD fabricated on the same chip with a size of 5 × 5 mm2. Furthermore, we measured timing jitter using a pulsed laser as the photon source. Owing to the careful tuning of the wiring length between each pixel of the 16-pixel SNSPD and each input port of the SFQ merger, the obtained timing jitter was 41.4 ps, which is approximately equal to or less than that of the single-pixel SNSPD.


  • Large-Area Niobium Titanium Nitride Superconducting Microstrip Single-Photon Detector Fabricated Using a Photolithography Process

    by Masahiro Yabuno, Fumihiro China, Shigehito Miki, Hirotaka Terai

    In this paper, we present a large-area niobium titanium nitride (NbTiN) superconducting microstrip single-photon detector (SMSPD) fabricated using a photolithography process. We fabricated a 1-μm-wide NbTiN-SMSPD covering 420 × 420 μm 2 active area with a filling factor of 20% using an i-line stepper. The detector is cooled down to approximately 2.2 K, and its performance is evaluated at the wavelengths from visible to near-infrared. The detector operates stably without a shunt resistor and shows single-photon sensitivity for photons with a wavelength of 1550 nm. The bias current dependence of the detection count rate is measured at the wavelengths from 406 to 1550 nm. The saturation of the detection count rate with increasing the bias current was successfully observed at wavelengths below 850 nm, suggesting an internal detection efficiency approaching 100%. Furthermore, we evaluated the timing jitter performance using the femtosecond pulse laser with a wavelength of 1550 nm. Consequently, we achieved a system timing jitter of 85 ps for a light spot diameter of 100 μm.


  • Open Access

    Two-photon spectral modulation via temporal manipulation: Quantum optical synthesis of spectral modes from temporal square waves

    by Rui-Bo Jin, Hiroki Oshima, Takumi Yagisawa, Masahiro Yabuno, Shigehito Miki, Fumihiro China, Hirotaka Terai, Ryosuke Shimizu

    Precise manipulation of the time–frequency modes of entangled photons is crucial for future quantum science and technologies. Recently, the frequency-domain-quantum-optical-synthesis (FD-QOS) method was demonstrated by creating a superposition of different joint temporal amplitudes: those temporal distributions can be controlled by manipulating the joint spectral amplitude in 2D frequency space via a Fourier optical relation. This FD-QOS method provides an efficient, flexible, and easy-to-control way to precisely modulate the temporal distributions of the entangled photon in an ultrafast region. However, manipulation of only the temporal modes is not sufficient for various applications in quantum information, since spectral modulations are also needed on many occasions. Here, we present a proof-of-concept experiment of two-photon spectral modulation via temporal manipulation of a biphoton wave packet. This protocol, called time-domain-quantum-optical-synthesis (TD-QOS), is achieved by adjusting the relative phases between two joint temporal distributions. In addition, the two-photon joint spectral distributions are characterized by measuring the joint spectral intensities and Hong–Ou–Mandel interferences. The combination of FD-QOS and TD-QOS enables complete control over the biphoton states. Our work would further develop quantum technologies that rely on the time–frequency modes of entangled photons.


  • Development of next generation superconducting nanostrip single photon detection technology

    by Shigehito Miki, Masahiro Yabuno, Shigeyuki Miyajima, Fumihiro China, Hirotaka Terai

    Superconducting nanostrip single photon detectors (SNSPDs) have already utilized as promising single photon detectors in variety of applications. At the same time, great efforts have been paid for realizing next generation SNSPD technologies, enabling higher performance and higher functionalities. In the presentation, we will introduce the diverse research on next generation SNSPD technology, including superconducting digital readout circuit.

  • Mid-infrared photon counting with superconducting nanowires

    by Dmitry V. Morozov, Gregor G. Taylor, Kleanthis Erotokritou, Shigehito Miki, Hirotaka Terai, Robert H. Hadfield

    Superconducting Nanowire Single photon Detectors (SNSPDs) offer unparalleled performance for IR photon counting, combining close to unity quantum efficiency, low intrinsic noise and ultrafast timing jitter. The ability of SNSPDs to count photons in mid-IR band up to 7 um wavelength opens up new possibilities in quantum optics, laser ranging, free space Quantum Key Distribution (QKD) and astronomy. Here we report on development of mid-IR SNSPDs including device design, fabrication, optimisation of superconducting materials and characterisation. We present a characterisation setup covering 1.5 - 4.2 um spectral region based on tuneable optical parametric oscillator with picosecond long pulses. We then demonstrate the viability of mid infrared SNSPDs for a variety of applications and report the results from single photon light detection and ranging (LIDAR) experiment with 2.3 um photons. This work paves the way for future app in free space QKD, deep space communication and astronomy.


  • Timing Jitter Characterization of the SFQ Coincidence Circuit by Optically Time-Controlled Signals From SSPDs

    by Shigehito Miki, Shigeyuki Miyajima, Masahiro Yabuno, Taro Yamashita, Takashi Yamamoto, Nobuyuki Imoto, Rikizo Ikuta, Robert A. Kirkwood, Robert H. Hadfield, Hirotaka Terai

    We report on the timing jitter characterization of the superconducting single flux quantum (SFQ) coincidence circuit, which is an essential component of the superconducting coincidence photon counter. Two superconducting nanowire single photon detectors (SSPDs), each of which is irradiated with optically time-controlled photons, are connected to the SFQ coincidence circuit, and the timing jitter of the SFQ circuit is evaluated by changing the relative time delay between two input ports for the SFQ comparator unit. We successfully observe the transition curve of the probability of obtaining the signal from the SFQ coincidence circuit by sweeping photon arrival time to each SSPD and confirm that this curve shifts temporally upon changing the bias current to the Josephson transmission line (JTL) in the SFQ circuit. A systematic investigation reveals that the relation between time delay and the bias current to JTL can be estimated. The full width half maximum timing jitter of the SFQ circuit is 1.1 ps, which is sufficiently low so that it does not influence the entire timing jitter of the coincidence photon counter.


  • Demonstration of a Superconducting Nanowire Single-Photon Detector using Adiabatic Quantum-Flux-Parametron Logic in a 0.1-W Gifford-McMahon Cryocooler

    by Naoki Takeuchi, Taro Yamashita, Shigeyuki Miyajima, Shigehito Miki, Nobuyuki Yoshikawa, Hirotaka Terai

    Superconducting nanowire single-photon detectors (SSPDs or SNSPDs) have superior performance and are thus used for many applications, such as quantum information and laser communications. Lately, much effort has been spent on the development of multi-pixel SSPD arrays to achieve single-photon-level imaging. SSPD arrays require efficient readout schemes that reduce the number of coaxial cables for reading out the SSPD pixels. In a previous study, we proposed a readout interface using adiabatic quantum-flux (AQFP) logic, which digitizes the information of an SSPD at cryogenic temperature. In this study, we show the first demonstration of an SSPD that is read out by the AQFP readout interface placed in the same 0.1-W Gifford-McMahon (GM) cryocooler. The measurement results showed that the AQFP readout interface reads out the SSPD with low error rates. Also, it was found that the temperature of the sample stage did not change even after the AQFP readout interface was turned on, which indicates that the power and current required for the AQFP readout interface are sufficiently low for implementations using a compact cryocooler.