Yinnan Bai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yinnan Bai has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Xiaofeng Zhao
School of Electronic Engineering, Heilongjiang University, Harbin, China
3 shared publications - Dianzhong Wen
The Key Laboratory of Electronics Engineering, College of Heilongjiang Province, Heilongjiang University, Harbin 150080, China
2 shared publications - Sen Li
Key Laboratory of Electronics Engineering College of Heilongjiang Province, Heilongjiang University, Harbin 150006, Heilongjiang Province, China
2 shared publications - Yi Li
Key Laboratory of Electronics Engineering, College of Heilongjiang Province, Heilongjiang University, Harbin 150080, China
2 shared publications - Chunpeng Ai
Key Laboratory of Electronics Engineering, College of Heilongjiang Province, Heilongjiang University, Harbin 150080, China
1 shared publication - Chunpeng Ai
College of Electronic Engineering, Heilongjiang University, Harbin 150001, China
1 shared publication
Latest Publications
- Open Access
- 17 May 2019
- Published by MDPI AG in Micromachines
- Vol. 10 (5) , 331
Fabrication and Characteristic of a Double Piezoelectric Layer Acceleration Sensor Based on Li-Doped ZnO Thin Film
In this paper, a double piezoelectric layer acceleration sensor based on Li-doped ZnO (LZO) thin film is presented. It is constituted by Pt/LZO/Pt/LZO/Pt/Ti functional layers and a Si cantilever beam with a proof mass. The LZO thin films were prepared by radio frequency (RF) magnetron sputtering. The composition, chemical structure, surface morphology, and thickness of the LZO thin film were analyzed. In order to study the effect of double piezoelectric layers on the sensitivity of the acceleration sensor, we designed two structural models (single and double piezoelectric layers) and fabricated them by using micro-electro-mechanical system (MEMS) technology. The test results show that the resonance frequency of the acceleration sensor was 1363 Hz. The sensitivity of the double piezoelectric layer was 33.1 mV/g, which is higher than the 26.1 mV/g of single piezoelectric layer sensitivity, both at a resonance frequency of 1363 Hz.
- 17 May 2019
- Published by MDPI AG in Micromachines
- Vol. 10 (5) , 331
Open AccessFabrication and Characteristic of a Double Piezoelectric Layer Acceleration Sensor Based on Li-Doped ZnO Thin Film
In this paper, a double piezoelectric layer acceleration sensor based on Li-doped ZnO (LZO) thin film is presented. It is constituted by Pt/LZO/Pt/LZO/Pt/Ti functional layers and a Si cantilever beam with a proof mass. The LZO thin films were prepared by radio frequency (RF) magnetron sputtering. The composition, chemical structure, surface morphology, and thickness of the LZO thin film were analyzed. In order to study the effect of double piezoelectric layers on the sensitivity of the acceleration sensor, we designed two structural models (single and double piezoelectric layers) and fabricated them by using micro-electro-mechanical system (MEMS) technology. The test results show that the resonance frequency of the acceleration sensor was 1363 Hz. The sensitivity of the double piezoelectric layer was 33.1 mV/g, which is higher than the 26.1 mV/g of single piezoelectric layer sensitivity, both at a resonance frequency of 1363 Hz.
- Open Access
- 12 April 2018
- Published by MDPI AG in Micromachines
- Vol. 9 (4) , 178
Fabrication Technology and Characteristics Research of the Acceleration Sensor Based on Li-Doped ZnO Piezoelectric Thin Films
An acceleration sensor based on piezoelectric thin films is proposed in this paper, which comprises the elastic element of a silicon cantilever beam and a piezoelectric structure with Li-doped ZnO piezoelectric thin films. The Li-doped ZnO piezoelectric thin films were prepared on SiO2/Si by radio frequency (RF) magnetron sputtering method. The microstructure and micrograph of ZnO piezoelectric thin films is analysed by a X-ray diffractometer (XRD), scanning electron microscope (SEM), X-ray photoelectron spectroscopy (XPS), and piezoresponse force microscopy (PFM), respectively. When the sputtering power of 220 W and Li-doped concentration of 5%, ZnO piezoelectric thin films have a preferred (002) orientation. The chips of the sensor were fabricated on the silicon substrate by micro-electromechanical systems (MEMS) technology, meanwhile, the proposed sensor was packaged on the printed circuit board (PCB). The experimental results show the sensitivity of the proposed sensor is 29.48 mV/g at resonant frequency (1479.8 Hz).
- 12 April 2018
- Published by MDPI AG in Micromachines
- Vol. 9 (4) , 178
Open AccessFabrication Technology and Characteristics Research of the Acceleration Sensor Based on Li-Doped ZnO Piezoelectric Thin Films
An acceleration sensor based on piezoelectric thin films is proposed in this paper, which comprises the elastic element of a silicon cantilever beam and a piezoelectric structure with Li-doped ZnO piezoelectric thin films. The Li-doped ZnO piezoelectric thin films were prepared on SiO2/Si by radio frequency (RF) magnetron sputtering method. The microstructure and micrograph of ZnO piezoelectric thin films is analysed by a X-ray diffractometer (XRD), scanning electron microscope (SEM), X-ray photoelectron spectroscopy (XPS), and piezoresponse force microscopy (PFM), respectively. When the sputtering power of 220 W and Li-doped concentration of 5%, ZnO piezoelectric thin films have a preferred (002) orientation. The chips of the sensor were fabricated on the silicon substrate by micro-electromechanical systems (MEMS) technology, meanwhile, the proposed sensor was packaged on the printed circuit board (PCB). The experimental results show the sensitivity of the proposed sensor is 29.48 mV/g at resonant frequency (1479.8 Hz).
- Open Access
- 23 March 2017
- Published by MDPI AG in Micromachines
- Vol. 8 (4) , 95
Two-Dimensional Magnetic Field Sensor Based on Silicon Magnetic Sensitive Transistors with Differential Structure
A two-dimensional (2D) magnetic field sensor consisting of four silicon magnetic sensitive transistors (SMSTs) with similar characteristics is presented in this paper. By use of micro-electromechanical systems (MEMS) and integrated packaging technology, this sensor fabricated by using the silicon wafer with a orientation and high resistivity, was packaged on printed circuit boards (PCBs). In order to detect the magnetic fields in the x and y axes directions, two of the four SMSTs with opposite magnetic sensitive directions were located along the x and −x axes directions, symmetrically, and the others were located along the y and −y axes directions. The experimental results show that when the VCE = 10.0 V and IB = 6.0 mA, the magnetic sensitivities of the sensor in the x and y axes directions are 366.0 mV/T and 365.0 mV/T, respectively. It is possible to measure the 2D magnetic field and improve the magnetic sensitivity, significantly.
- 23 March 2017
- Published by MDPI AG in Micromachines
- Vol. 8 (4) , 95
Open AccessTwo-Dimensional Magnetic Field Sensor Based on Silicon Magnetic Sensitive Transistors with Differential Structure
A two-dimensional (2D) magnetic field sensor consisting of four silicon magnetic sensitive transistors (SMSTs) with similar characteristics is presented in this paper. By use of micro-electromechanical systems (MEMS) and integrated packaging technology, this sensor fabricated by using the silicon wafer with a orientation and high resistivity, was packaged on printed circuit boards (PCBs). In order to detect the magnetic fields in the x and y axes directions, two of the four SMSTs with opposite magnetic sensitive directions were located along the x and −x axes directions, symmetrically, and the others were located along the y and −y axes directions. The experimental results show that when the VCE = 10.0 V and IB = 6.0 mA, the magnetic sensitivities of the sensor in the x and y axes directions are 366.0 mV/T and 365.0 mV/T, respectively. It is possible to measure the 2D magnetic field and improve the magnetic sensitivity, significantly.