AGAdane K. Geremew

Adane K. Geremew

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Adane K. Geremew has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High-frequency current oscillations in charge-density-wave 1T-TaS2 devices: Revisiting the “narrow band noise” concept

    by Adane K. Geremew, Sergey Rumyantsev, Bishwajit Debnath, Roger K. Lake, Alexander A. Balandin

    We report on the current oscillations in quasi-2D 1T-TaS2 charge-density-wave two-dimensional devices. The MHz-frequency range of the oscillations and the linear dependence of the frequency of the oscillations on the current closely resemble the narrow band noise, which was often observed in the classical bulk quasi-1D trichalcogenide charge-density-wave materials. In bulk quasi-1D materials, the narrow band noise was interpreted as direct evidence of charge-density-wave sliding. Despite the similarities, we argue that the nature of the MHz oscillations in 1T-TaS2 is different from the narrow band noise. Analysis of the biasing conditions and current indicates that the observed oscillations are related to the current instabilities due to the voltage-induced transition from the nearly commensurate to incommensurate charge-density-wave phase.


  • Low-frequency electronic noise in superlattice and random-packed thin films of colloidal quantum dots

    by Adane Geremew, Caroline Qian, Alex Abelson, Sergey Rumyantsev, Fariborz Kargar, Matt Law, Alexander A. Balandin

    We report measurements of low-frequency electronic noise in ordered superlattice, weakly-ordered and random-packed thin films of 6.5 nm PbSe quantum dots prepared using several different ligand chemistries. For all samples, the normalized noise spectral density of the dark current revealed a Lorentzian component, reminiscent of the generation–recombination noise, superimposed on the 1/f background (f is the frequency). An activation energy of ∼0.3 eV was extracted from the temperature dependence of the noise spectra in the ordered and random quantum dot films. The noise level in the ordered films was lower than that in the weakly-ordered and random-packed films. A large variation in the magnitude of the noise spectral density was also observed in samples with different ligand treatments. The obtained results are important for application of colloidal quantum dot films in photodetectors.


  • Low Resistivity and High Breakdown Current Density of 10 nm Diameter van der Waals TaSe3 Nanowires by Chemical Vapor Deposition

    by Thomas Anthony Empante, Aimee Martinez, Michelle Wurch, Yanbing Zhu, Adane K. Geremew, Koichi Yamaguchi, Miguel Isarraraz, Sergey Rumyantsev, Evan J. Reed, Alexander A. Balandin, et al.

    Micron-scale single-crystal nanowires of metallic TaSe3, a material that forms -Ta-Se3-Ta-Se3- stacks separated from one another by a tubular van der Waals (vdW) gap, have been synthesized using chemical vapor deposition (CVD) on a SiO2/Si substrate, in a process compatible with semiconductor industry requirements. Their electrical resistivity was found unaffected by downscaling from the bulk to as little as 7 nm in width and height, in striking contrast to the resistivity of copper for the same dimensions. While the bulk resistivity of TaSe3 is substantially higher than that of bulk copper, at the nanometer scale the TaSe3 wires become competitive to similar-sized copper ones. Moreover, we find that the vdW TaSe3 nanowires sustain current densities in excess of 10^8 A/cm2 and feature an electromigration energy barrier twice that of copper. The results highlight the promise of quasi-one-dimensional transition metal trichalcogenides for electronic interconnect applications and the potential of van der Waals materials for downscaled electronics.


  • Bias-Voltage Driven Switching of the Charge-Density-Wave and Normal Metallic Phases in 1T-TaS2 Thin-Film Devices

    by Adane K. Geremew, Sergey Rumyantsev, Fariborz Kargar, Bishwajit Debnath, Adrian Nosek, Matthew A. Bloodgood, Marc Bockrath, Tina T. Salguero, Roger K. Lake, Alexander A. Balandin

    We report on switching among three charge-density-wave phases – commensurate, nearly commensurate, incommensurate – and the high-temperature normal metallic phase in thin-film 1T-TaS2 devices induced by application of an in-plane bias voltage. The switching among all phases has been achieved over a wide temperature range, from 77 K to 400 K. The low-frequency electronic noise spectroscopy has been used as an effective tool for monitoring the transitions, particularly the switching from the incommensurate charge-density-wave phase to the normal metal phase. The noise spectral density exhibits sharp increases at the phase transition points, which correspond to the step-like changes in resistivity. Assignment of the phases is consistent with low-field resistivity measurements over the temperature range from 77 K to 600 K. Analysis of the experimental data and calculations of heat dissipation indicate that Joule heating plays a dominant role in the voltage induced transitions in the 1T-TaS2 devices on Si/SiO2 substrates, contrary to some recent claims. The possibility of the bias-voltage switching among four different phases of 1T-TaS2 is a promising step toward nanoscale device applications. The results also demonstrate the potential of noise spectroscopy for investigating and identifying phase transitions in the materials.


  • Proton-irradiation-immune electronics implemented with two-dimensional charge-density-wave devices

    by A. K. Geremew, F. Kargar, E. X. Zhang, S. E. Zhao, E. Aytan, M. A. Bloodgood, T. T. Salguero, S. Rumyantsev, A. Fedoseyev, D. M. Fleetwood, et al.

    We demonstrate that the charge-density-wave devices with quasi-two-dimensional 1T-TaS 2 channels show remarkable immunity to bombardment with 1.8 MeV protons to a fluence of at least 10 14 H + cm −2 .


  • Unique features of the generation–recombination noise in quasi-one-dimensional van der Waals nanoribbons

    by Adane K. Geremew, Sergey Rumyantsev, Matthew A. Bloodgood, Tina T. Salguero, Alexander A. Balandin

    We describe the low-frequency current fluctuations, i.e. electronic noise, in quasi-one-dimensional ZrTe 3 van der Waals nanoribbons, which have recently attracted attention owing to their extraordinary high current carrying capacity.


  • Transistor-Less Logic Circuits Implemented With 2-D Charge Density Wave Devices

    by Alexander G. Khitun, Adane K. Geremew, Alexander A. Balandin

    We propose logic gates and circuits implemented with 2-D charge density wave (CDW) devices, which operate at room temperature. The 1T-TaS 2 charge density wave devices exhibit a voltage triggered phase transition between the nearly commensurate and incommensurate CDW states, which is accompanied by an abrupt change of the resistance and hysteresis. The unique output characteristics of such devices allow for building logic gates and circuits without any transistors. Using the experimentally measured current–voltage characteristics, we model and numerically simulate the performance of the inverter and the OR logic gates consisting of CDW devices and regular resistors. Owing to the radiation-hard nature of the CDW devices and absence of transistors, the proposed circuits can be utilized in various harsh environments on earth or outer space.


  • Current Carrying Capacity of Quasi-1D ZrTe3Van Der Waals Nanoribbons

    by A. Geremew, M. A. Bloodgood, E. Aytan, B. W. K. Woo, S. R. Corber, G. Liu, K. Bozhilov, T. T. Salguero, S. Rumyantsev, M. P. Rao, et al.

    Quasi-1D van der Waals materials, such as transition metal trichalcogenides, have strong covalent bonds in one direction and weaker bonds in crossplane directions. They can be prepared as crystalline nanowires or nanoribbons consisting of 1D atomic threads, i.e., chains. We have examined the current carrying capacity of ZrTe 3 nanoribbons using a set of structures fabricated by the shadow mask method. The bulk crystals were synthesized by the chemical vapor transport method and exfoliated onto Si/SiO 2 substrates. It was found that ZrTe 3 nanoribbons reveal an exceptionally high current density, on the order of ~100 MA/cm 2 , at the peak of the stressing DC current. The low-frequency noise was of 1/f type near room temperature (f is the frequency). The noise amplitude scaled with the resistance, following the trend established for other low-dimensionalmaterials. The high current density in ZrTe 3 can be attributed to the single-crystalnature of quasi-1D van der Waals materials.