Dong-Gil Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dong-Gil Yu has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Taehyoung Lee
Department of Environmental Science, Hankuk University of Foreign Studies, Yongin, Republic of Korea
3 shared publications - Taehyun Park
Department of Environmental Science, Hankuk University of Foreign Studies, Yongin, Republic of Korea
3 shared publications - Gyutae Park
Department of Environmental Science, Hankuk University of Foreign Studies, 81, Oedae-ro, Mohyun-eup, Yongin 17035, Korea
2 shared publications - Jongtae Lee
Transportation Pollution Research Center, National Institute of Environmental Research, Incheon 22689, Republic of Korea
2 shared publications - Jung-Hun Woo
Seoul National University, Republic of Korea
2 shared publications - Kyunghoon Kim
Department of Environmental Science, Hankuk University of Foreign Studies, Yongin 17035, Korea
2 shared publications
Latest Publications
- Open Access
- 2 December 2021
- Published by MDPI AG in Atmosphere
- Vol. 12 (12) , 1607
Seasonal and Spatial Variations of Atmospheric Ammonia in the Urban and Suburban Environments of Seoul, Korea
Atmospheric ammonia is a significant pollutant throughout the year, necessitating standardized measurement and identification of emission factors. We performed a quantized evaluation of ammonia concentrations at various locations in and around Seoul, South Korea. The established testing methods of the Radiello Passive Sampler were used for ammonia sampling, and the method was validated using annular denuder sampling. Urban and suburban areas were studied to gain a deeper understanding of the factors responsible for ammonia pollution. This study aimed to establish the fluctuations in concentration over one year, by analyzing the seasonal and regional variation in ammonia concentration. Livestock and agricultural areas recorded the highest concentration of ammonia among all sites, with the highest concentration recorded in autumn. However, at most of the other studied sites, the highest and lowest ammonia concentrations were recorded during summer and winter, respectively. This study attempted to establish a correlation between ammonia concentration and temperature, as well as ammonia concentration and altitude.
- 2 December 2021
- Published by MDPI AG in Atmosphere
- Vol. 12 (12) , 1607
Open AccessSeasonal and Spatial Variations of Atmospheric Ammonia in the Urban and Suburban Environments of Seoul, Korea
Atmospheric ammonia is a significant pollutant throughout the year, necessitating standardized measurement and identification of emission factors. We performed a quantized evaluation of ammonia concentrations at various locations in and around Seoul, South Korea. The established testing methods of the Radiello Passive Sampler were used for ammonia sampling, and the method was validated using annular denuder sampling. Urban and suburban areas were studied to gain a deeper understanding of the factors responsible for ammonia pollution. This study aimed to establish the fluctuations in concentration over one year, by analyzing the seasonal and regional variation in ammonia concentration. Livestock and agricultural areas recorded the highest concentration of ammonia among all sites, with the highest concentration recorded in autumn. However, at most of the other studied sites, the highest and lowest ammonia concentrations were recorded during summer and winter, respectively. This study attempted to establish a correlation between ammonia concentration and temperature, as well as ammonia concentration and altitude.
- Open Access
- 24 August 2020
- Published by MDPI AG in Applied Sciences
- Vol. 10 (17) , 5856
Characterizing Black Carbon Emissions from Gasoline, LPG, and Diesel Vehicles via Transient Chassis-Dynamometer Tests
With global anthropogenic black carbon (BC) emissions increasing, automobiles are significantly contributing as the major source of emissions. However, the appropriate regulations of BC emissions from vehicles are not in place. This study examined BC emissions following fuel types (gasoline, liquefied petroleum gas (LPG), and diesel) and engine combustion (gasoline direct injection (GDI) and multi-port injection (MPI) for gasoline vehicles) with emission regulations. To this end, chassis dynamometer and aethalometer (AE33) were used. Driving modes created by the National Institute of Environmental Research (NIER) and emission certification modes (CVS-75 and NEDC) for vehicles in Korea were used to determine BC emissions for various vehicle speeds. In addition, the contributions of biomass and coal combustion to the data of AE33 were analyzed to determine the possibility of tracking the BC sources. MPI, LPG, and EURO 6 with diesel particulate filter (DPF) vehicles emitted the lowest BC emissions in NIER modes. Among gasoline vehicles, MPI vehicles showed the lower BC content in PM emissions. Also, older vehicles in MPI vehicles emitted the high PM and BC emissions. The BC emissions of EURO 3 vehicles without DPF were the highest as the results of previous studies, and it was found that as emissions regulations were tightened, the level of BC results of diesel vehicles became similar with MPI vehicles. The average absorption Ångström exponent (AAE) from difference emissions sources were biomass combustion (oak wood) > coal combustion (the power plant stack) > automobile emissions (gasoline, LPG, diesel).
- 24 August 2020
- Published by MDPI AG in Applied Sciences
- Vol. 10 (17) , 5856
Open AccessCharacterizing Black Carbon Emissions from Gasoline, LPG, and Diesel Vehicles via Transient Chassis-Dynamometer Tests
With global anthropogenic black carbon (BC) emissions increasing, automobiles are significantly contributing as the major source of emissions. However, the appropriate regulations of BC emissions from vehicles are not in place. This study examined BC emissions following fuel types (gasoline, liquefied petroleum gas (LPG), and diesel) and engine combustion (gasoline direct injection (GDI) and multi-port injection (MPI) for gasoline vehicles) with emission regulations. To this end, chassis dynamometer and aethalometer (AE33) were used. Driving modes created by the National Institute of Environmental Research (NIER) and emission certification modes (CVS-75 and NEDC) for vehicles in Korea were used to determine BC emissions for various vehicle speeds. In addition, the contributions of biomass and coal combustion to the data of AE33 were analyzed to determine the possibility of tracking the BC sources. MPI, LPG, and EURO 6 with diesel particulate filter (DPF) vehicles emitted the lowest BC emissions in NIER modes. Among gasoline vehicles, MPI vehicles showed the lower BC content in PM emissions. Also, older vehicles in MPI vehicles emitted the high PM and BC emissions. The BC emissions of EURO 3 vehicles without DPF were the highest as the results of previous studies, and it was found that as emissions regulations were tightened, the level of BC results of diesel vehicles became similar with MPI vehicles. The average absorption Ångström exponent (AAE) from difference emissions sources were biomass combustion (oak wood) > coal combustion (the power plant stack) > automobile emissions (gasoline, LPG, diesel).
- Open Access
- 16 April 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (8) , 1573
Characterization of Emission Factors Concerning Gasoline, LPG, and Diesel Vehicles via Transient Chassis-Dynamometer Tests
Gaseous emissions from vehicles contribute substantially to air pollution and climate change. Vehicular emissions also contain secondary pollutants produced via chemical reactions that occur between the emitted gases and atmospheric air. This study aims at understanding patterns concerning emission of regulated, greenhouse, and precursor gases, which demonstrate potential for secondary aerosol (SA) formation, from vehicles incorporating different engine technologies—multi-point injection (MPI) and gasoline direct injection (GDI)—and using different fuels—gasoline, liquefied petroleum gas (LPG), and diesel. Drive cycles from the National Institute of Environmental Research (NIER) were used in this study. Results obtained from drive cycle tests demonstrate a decline in aggregate gas emissions corresponding to an increase in average vehicle speed. CO2 accounts for more than 99% of aggregate gaseous emissions. In terms of concentration, CO and NH3 form predominantly non-CO2 emissions from gasoline and LPG vehicles, whereas nitrogen oxides (NOx) and non-methane hydrocarbons (NMHC) dominate diesel-vehicle emissions. A higher percentage of SO2 is emitted from diesel vehicles compared to their gasoline- and LPG-powered counterparts. EURO-5- and EURO-6-compliant vehicles equipped with diesel particulate filters (DPFs) tend to emit higher amounts of NO2 compared to EURO-3-compliant vehicles, which are not equipped with DPFs. Vehicles incorporating GDI tend to emit less CO2 compared to those incorporating MPI, albeit at the expense of increased CO emissions. The authors believe that results reported in this paper concerning regulated and unregulated pollutant-emission monitoring can contribute towards an accurate evaluation of both primary and secondary air-pollution scenarios in Korea.
- 16 April 2019
- Published by MDPI AG in Applied Sciences
- Vol. 9 (8) , 1573
Open AccessCharacterization of Emission Factors Concerning Gasoline, LPG, and Diesel Vehicles via Transient Chassis-Dynamometer Tests
Gaseous emissions from vehicles contribute substantially to air pollution and climate change. Vehicular emissions also contain secondary pollutants produced via chemical reactions that occur between the emitted gases and atmospheric air. This study aims at understanding patterns concerning emission of regulated, greenhouse, and precursor gases, which demonstrate potential for secondary aerosol (SA) formation, from vehicles incorporating different engine technologies—multi-point injection (MPI) and gasoline direct injection (GDI)—and using different fuels—gasoline, liquefied petroleum gas (LPG), and diesel. Drive cycles from the National Institute of Environmental Research (NIER) were used in this study. Results obtained from drive cycle tests demonstrate a decline in aggregate gas emissions corresponding to an increase in average vehicle speed. CO2 accounts for more than 99% of aggregate gaseous emissions. In terms of concentration, CO and NH3 form predominantly non-CO2 emissions from gasoline and LPG vehicles, whereas nitrogen oxides (NOx) and non-methane hydrocarbons (NMHC) dominate diesel-vehicle emissions. A higher percentage of SO2 is emitted from diesel vehicles compared to their gasoline- and LPG-powered counterparts. EURO-5- and EURO-6-compliant vehicles equipped with diesel particulate filters (DPFs) tend to emit higher amounts of NO2 compared to EURO-3-compliant vehicles, which are not equipped with DPFs. Vehicles incorporating GDI tend to emit less CO2 compared to those incorporating MPI, albeit at the expense of increased CO emissions. The authors believe that results reported in this paper concerning regulated and unregulated pollutant-emission monitoring can contribute towards an accurate evaluation of both primary and secondary air-pollution scenarios in Korea.