Makhach N. Magomedov
Research Subjects
Makhach N. Magomedov has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Hong-Wu Song
Chief Researcher Institute for Geothermal Problems of Dagestan Scientific Center of Russian Academy of Sciences Makhachkala Russia
1 shared publicationInstitute for Geothermal Research of the Dagestan Scientific Center of RAS
1 shared publicationShi-Hong Zhang
Chief Researcher Institute for Geothermal Problems of Dagestan Scientific Center of Russian Academy of Sciences Makhachkala Russia
1 shared publicationShuai-Feng Chen
Chief Researcher Institute for Geothermal Problems of Dagestan Scientific Center of Russian Academy of Sciences Makhachkala Russia
1 shared publicationXiang-Cheng Zhang
Chief Researcher Institute for Geothermal Problems of Dagestan Scientific Center of Russian Academy of Sciences Makhachkala Russia
1 shared publicationXu Zhang
Chief Researcher Institute for Geothermal Problems of Dagestan Scientific Center of Russian Academy of Sciences Makhachkala Russia
1 shared publication
Latest Publications
- 25 October 2026
- Published by Elsevier in Surface Science
Study of the tungsten surface properties at various temperatures and pressures
- 25 October 2026
- Published by Elsevier in Surface Science
Study of the tungsten surface properties at various temperatures and pressures
- Open Access
- 25 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (20)
Study of thermoelastic and surface properties of tantalum at various temperatures and pressures
An analytical method (i.e., no computer simulation) has been developed to calculate the thermoelastic and surface properties of tantalum (Ta) at any (corresponding to the solid phase) temperature T and pressure P. This method takes into account the contribution of both lattice and electronic metal subsystems. This method calculated the equation of state of Ta, as well as the baric and temperature dependence for the Debye temperature, Grüneisen parameter, isothermal elastic modulus, thermal expansion coefficient, and isobaric heat capacity. It was shown that the calculated dependences are in good agreement with the data obtained both experimentally and using computer simulation. For the first time, the surface properties of Ta were calculated: the specific surface energy, as well as its derivatives in temperature and pressure. Both the baric dependences of these functions along isotherms 300 and 3000 K and the temperature dependences along isobars 0 and 100 GPa were obtained. This made it possible both to study the properties of Ta under P–T conditions that were difficult to access experimentally and to find out in which area of the P–T arguments the electronic contribution to these properties is noticeable, and in which area its influence on the properties of Ta can be neglected.
- 25 November 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (20)
Open AccessStudy of thermoelastic and surface properties of tantalum at various temperatures and pressures
An analytical method (i.e., no computer simulation) has been developed to calculate the thermoelastic and surface properties of tantalum (Ta) at any (corresponding to the solid phase) temperature T and pressure P. This method takes into account the contribution of both lattice and electronic metal subsystems. This method calculated the equation of state of Ta, as well as the baric and temperature dependence for the Debye temperature, Grüneisen parameter, isothermal elastic modulus, thermal expansion coefficient, and isobaric heat capacity. It was shown that the calculated dependences are in good agreement with the data obtained both experimentally and using computer simulation. For the first time, the surface properties of Ta were calculated: the specific surface energy, as well as its derivatives in temperature and pressure. Both the baric dependences of these functions along isotherms 300 and 3000 K and the temperature dependences along isobars 0 and 100 GPa were obtained. This made it possible both to study the properties of Ta under P–T conditions that were difficult to access experimentally and to find out in which area of the P–T arguments the electronic contribution to these properties is noticeable, and in which area its influence on the properties of Ta can be neglected.
- 28 May 2025
- Published by Elsevier in Solid State Communications
- Vol. 403
Baric dependence of the rhodium melting point in the macro- and nanocrystal state
- 28 May 2025
- Published by Elsevier in Solid State Communications
- Vol. 403
Baric dependence of the rhodium melting point in the macro- and nanocrystal state
- 9 January 2025
- Published by Elsevier in Solid State Communications
- Vol. 397
Calculation of Debye temperature and Grüneisen parameter at low temperatures
- 9 January 2025
- Published by Elsevier in Solid State Communications
- Vol. 397
Calculation of Debye temperature and Grüneisen parameter at low temperatures
- 30 July 2024
- Published by Elsevier in Solid State Communications
- Vol. 391
Lindemann ratio for classical and quantum crystals
- 30 July 2024
- Published by Elsevier in Solid State Communications
- Vol. 391
Lindemann ratio for classical and quantum crystals
- 1 July 2024
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 69 (7) , 2024-2032
Changing the Parameters of Vacancy Formation and Self-Diffusion in Various Polymorphic Modifications of Iron
The activation parameters for various iron structures were calculated by the analytical method based on the paired four-parameter Mie–Lennard-Jones interatomic interaction potential. Within the framework of a single method, all the activation processes parameters were calculated: Gibbs energy, enthalpy, entropy and volume for both the process of electroneutral vacancy formation and for the process of atom self-diffusion. The isobaric temperature dependences of the indicated activation parameters for BCC and FCC iron structures from T = 10 to 1810 K along two isobars: P = 0 and 10 GPa were calculated. It is shown that at the α–γ transition temperature (1184 K), the activation parameters decrease during the isobaric transition from the BCC to the FCC structure. At the γ–δ transition temperature (1667 K), the activation parameters increase during the transition from the FCC to the BCC structure. With increasing pressure, the jumps magnitude for the Gibbs energy and the enthalpy of the activation process increases, and for the entropy and volume of the activation process decreases. It is shown that, at low temperatures, due to quantum regularities, activation parameters strongly depend on temperature, and the entropy of activation processes in this region is negative. In the high temperature region, a good agreement has been obtained with the experimental estimates of activation parameters for different iron structures known from the literature.
- 1 July 2024
- Published by Pleiades Publishing Ltd in Technical Physics
- Vol. 69 (7) , 2024-2032
Changing the Parameters of Vacancy Formation and Self-Diffusion in Various Polymorphic Modifications of Iron
The activation parameters for various iron structures were calculated by the analytical method based on the paired four-parameter Mie–Lennard-Jones interatomic interaction potential. Within the framework of a single method, all the activation processes parameters were calculated: Gibbs energy, enthalpy, entropy and volume for both the process of electroneutral vacancy formation and for the process of atom self-diffusion. The isobaric temperature dependences of the indicated activation parameters for BCC and FCC iron structures from T = 10 to 1810 K along two isobars: P = 0 and 10 GPa were calculated. It is shown that at the α–γ transition temperature (1184 K), the activation parameters decrease during the isobaric transition from the BCC to the FCC structure. At the γ–δ transition temperature (1667 K), the activation parameters increase during the transition from the FCC to the BCC structure. With increasing pressure, the jumps magnitude for the Gibbs energy and the enthalpy of the activation process increases, and for the entropy and volume of the activation process decreases. It is shown that, at low temperatures, due to quantum regularities, activation parameters strongly depend on temperature, and the entropy of activation processes in this region is negative. In the high temperature region, a good agreement has been obtained with the experimental estimates of activation parameters for different iron structures known from the literature.
- 5 January 2024
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (3) , 035405
Nanocrystalline surface energy studied within the Gibbs thermodynamic framework
In the equilibrium thermodynamics framework, expressions were obtained that determine the dependences of the specific surface energy and surface pressure on the size () and shape of a freestanding nanocrystal at different pressure and temperature . Based on these expressions, the behavior of the and functions for fcc Au have been studied. The calculations performed for the macrocrystal showed good agreement with the experimental data. Calculations for a nanocrystal have shown that at , the function lies in the negative region, i.e., the nanocrystal is stretched by surface pressure the more the higher of temperature, or the more the nanocrystal shape is deviated from an energy-optimal shape. With a decrease in at , the function decreases more noticeably the higher of temperature, or the more the nanocrystal shape deviates from an energy-optimal shape. Based on these results, it was shown that the increase in the function obtained in some articles with an isomorphic-isothermal decrease in does not correspond to the physical properties of nanoparticles. In these articles, the nanoparticle was compressed by surface pressure, which increased with an isomorphic-isothermal decrease of the value. This compression led to the corresponding growth of the function both with an isomorphic-isothermal decrease in size and with an isomeric (i.e., at ) increase in the nanoparticle temperature.- 5 January 2024
- Published by American Physical Society (APS) in Physical Review B
- Vol. 109 (3) , 035405
Nanocrystalline surface energy studied within the Gibbs thermodynamic framework
In the equilibrium thermodynamics framework, expressions were obtained that determine the dependences of the specific surface energy and surface pressure on the size () and shape of a freestanding nanocrystal at different pressure and temperature . Based on these expressions, the behavior of the and functions for fcc Au have been studied. The calculations performed for the macrocrystal showed good agreement with the experimental data. Calculations for a nanocrystal have shown that at , the function lies in the negative region, i.e., the nanocrystal is stretched by surface pressure the more the higher of temperature, or the more the nanocrystal shape is deviated from an energy-optimal shape. With a decrease in at , the function decreases more noticeably the higher of temperature, or the more the nanocrystal shape deviates from an energy-optimal shape. Based on these results, it was shown that the increase in the function obtained in some articles with an isomorphic-isothermal decrease in does not correspond to the physical properties of nanoparticles. In these articles, the nanoparticle was compressed by surface pressure, which increased with an isomorphic-isothermal decrease of the value. This compression led to the corresponding growth of the function both with an isomorphic-isothermal decrease in size and with an isomeric (i.e., at ) increase in the nanoparticle temperature.