Jean-Daniel Deschênes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jean-Daniel Deschênes has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Hugo Bergeron
National Institute of Standards and Technology, 325 Broadway, Boulder, CO, 80305, USA
5 shared publications- Nathan R. Newbury
National Institute of Standards and Technology, Boulder, USA
5 shared publications William C. Swann
National Institute of Standards and Technology, Boulder, Colorado 80305, USA
5 shared publications- Laura C. Sinclair
National Institute of Standards and Technology 1 , 325 Broadway, Boulder, Colorado 80305, USA
4 shared publications Isaac Khader
National Institute of Standards and Technology, 325 Broadway, Boulder, CO, 80305, USA
3 shared publicationsKevin C. Cossel
National Institute of Standards and Technology, 325 Broadway, Boulder, CO, 80305, USA
3 shared publications
Latest Publications
- 1 March 2021
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 15 (3) , 034002
Scaling up Frequency-Comb-Based Optical Time Transfer to Long Terrestrial Distances
Frequency-comb-based optical two-way time and frequency transfer (O-TWTFT) can support future ultra-precise clock networks over free-space links. However, demonstrations have thus far only operated at one corner of a complex parameter space, which balances received optical power, timing performance, and update rate. Here, we analyze the performance of O-TWTFT across this parameter space, with a specific focus on extending the link distance at constant launch power and telescope aperture. We perform experiments across a three-node network spanning 28 km of turbulent air, and successfully demonstrate a more than 2000× reduction in the required received optical power corresponding to a potential 45× increase in distance. This distance increase does come with an associated reduction in timing precision, with the uncertainty increasing from 60 as to 20 fs at 10 s averaging times. However, this level of precision is still more than adequate for most applications. In addition, it comes with a reduction in sampling rate, which potentially limits this approach to static links. Interestingly, because this system optimization does not require any hardware modifications, O-TWTFT links could be dynamically tuned to support future long-distance optical clock networks over a range of conditions and applications.
- 1 March 2021
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 15 (3) , 034002
Scaling up Frequency-Comb-Based Optical Time Transfer to Long Terrestrial Distances
Frequency-comb-based optical two-way time and frequency transfer (O-TWTFT) can support future ultra-precise clock networks over free-space links. However, demonstrations have thus far only operated at one corner of a complex parameter space, which balances received optical power, timing performance, and update rate. Here, we analyze the performance of O-TWTFT across this parameter space, with a specific focus on extending the link distance at constant launch power and telescope aperture. We perform experiments across a three-node network spanning 28 km of turbulent air, and successfully demonstrate a more than 2000× reduction in the required received optical power corresponding to a potential 45× increase in distance. This distance increase does come with an associated reduction in timing precision, with the uncertainty increasing from 60 as to 20 fs at 10 s averaging times. However, this level of precision is still more than adequate for most applications. In addition, it comes with a reduction in sampling rate, which potentially limits this approach to static links. Interestingly, because this system optimization does not require any hardware modifications, O-TWTFT links could be dynamically tuned to support future long-distance optical clock networks over a range of conditions and applications.
- Open Access
- 18 April 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-7
Femtosecond time synchronization of optical clocks off of a flying quadcopter
Future optical clock networks will require free-space optical time-frequency transfer between flying clocks. However, simple one-way or standard two-way time transfer between flying clocks will completely break down because of the time-of-flight variations and Doppler shifts associated with the strongly time-varying link distances. Here, we demonstrate an advanced, frequency comb-based optical two-way time-frequency transfer (O-TWTFT) that can successfully synchronize the optical timescales at two sites connected via a time-varying turbulent air path. The link between the two sites is established using either a quadcopter-mounted retroreflector or a swept delay line at speeds up to 24 ms−1. Despite 50-ps breakdown in time-of-flight reciprocity, the sites’ timescales are synchronized to < 1 fs in time deviation. The corresponding sites’ frequencies agree to ~ 10−18 despite 10−7 Doppler shifts. This work demonstrates comb-based O-TWTFT can enable free-space optical networks between airborne or satellite-borne optical clocks for precision navigation, timing and probes of fundamental science.
- 18 April 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-7
Open AccessFemtosecond time synchronization of optical clocks off of a flying quadcopter
Future optical clock networks will require free-space optical time-frequency transfer between flying clocks. However, simple one-way or standard two-way time transfer between flying clocks will completely break down because of the time-of-flight variations and Doppler shifts associated with the strongly time-varying link distances. Here, we demonstrate an advanced, frequency comb-based optical two-way time-frequency transfer (O-TWTFT) that can successfully synchronize the optical timescales at two sites connected via a time-varying turbulent air path. The link between the two sites is established using either a quadcopter-mounted retroreflector or a swept delay line at speeds up to 24 ms−1. Despite 50-ps breakdown in time-of-flight reciprocity, the sites’ timescales are synchronized to < 1 fs in time deviation. The corresponding sites’ frequencies agree to ~ 10−18 despite 10−7 Doppler shifts. This work demonstrates comb-based O-TWTFT can enable free-space optical networks between airborne or satellite-borne optical clocks for precision navigation, timing and probes of fundamental science.
- Open Access
- 22 February 2019
- Published by American Physical Society (APS) in Physical Review A
- Vol. 99 (2) , 023844
Femtosecond optical two-way time-frequency transfer in the presence of motion
Platform motion poses significant challenges to high-precision optical time and frequency transfer. We give a detailed description of these challenges and their solutions in comb-based optical two-way time and frequency transfer (O-TWTFT). Specifically, we discuss the breakdown in reciprocity due to relativity and due to asynchronous sampling, the impact of optical and electrical dispersion, and velocity-dependent transceiver calibration. We present a detailed derivation of the equations governing comb-based O-TWTFT in the presence of motion. We describe the implementation of real-time signal processing algorithms based on these equations and demonstrate active synchronization of two sites over turbulent air paths to below-1-fs time deviation despite effective velocities of , which is the maximum achievable with our physical setup. With the implementation of the time transfer equation derived here, we find no velocity-dependent bias between the synchronized clocks to within a two-sigma statistical uncertainty of 330 as.- 22 February 2019
- Published by American Physical Society (APS) in Physical Review A
- Vol. 99 (2) , 023844
Open AccessFemtosecond optical two-way time-frequency transfer in the presence of motion
Platform motion poses significant challenges to high-precision optical time and frequency transfer. We give a detailed description of these challenges and their solutions in comb-based optical two-way time and frequency transfer (O-TWTFT). Specifically, we discuss the breakdown in reciprocity due to relativity and due to asynchronous sampling, the impact of optical and electrical dispersion, and velocity-dependent transceiver calibration. We present a detailed derivation of the equations governing comb-based O-TWTFT in the presence of motion. We describe the implementation of real-time signal processing algorithms based on these equations and demonstrate active synchronization of two sites over turbulent air paths to below-1-fs time deviation despite effective velocities of , which is the maximum achievable with our physical setup. With the implementation of the time transfer equation derived here, we find no velocity-dependent bias between the synchronized clocks to within a two-sigma statistical uncertainty of 330 as. - Open Access
Femtosecond Synchronization of Optical Clocks Off of a Flying Quadcopter
Future optical clock networks will require free-space optical time-frequency transfer between flying clocks. However, simple one-way or standard two-way time transfer between flying clocks will completely break down because of the time-of-flight variations and Doppler shifts associated with the strongly time-varying optical link distances. Here, we demonstrate an advanced, comb-based optical two-way time-frequency transfer that can successfully synchronize the optical timescales at two sites connected via a time-varying turbulent air path. The link between the two sites is established using either a quadcopter-mounted retroreflector or a swept delay line at speeds up to 24 m/s. Despite 50-ps breakdown in time-of-flight reciprocity, the sites' timescales are synchronized to < 1 fs in time deviation. The corresponding sites' frequencies agree to $\sim$ $10^{-18}$ despite $10^{-7}$ Doppler shifts. This work demonstrates comb-based O-TWTFT can enable free-space optical networks between airborne or satellite-borne optical clocks for precision navigation, timing and probes of fundamental science.Open AccessFemtosecond Synchronization of Optical Clocks Off of a Flying Quadcopter
Future optical clock networks will require free-space optical time-frequency transfer between flying clocks. However, simple one-way or standard two-way time transfer between flying clocks will completely break down because of the time-of-flight variations and Doppler shifts associated with the strongly time-varying optical link distances. Here, we demonstrate an advanced, comb-based optical two-way time-frequency transfer that can successfully synchronize the optical timescales at two sites connected via a time-varying turbulent air path. The link between the two sites is established using either a quadcopter-mounted retroreflector or a swept delay line at speeds up to 24 m/s. Despite 50-ps breakdown in time-of-flight reciprocity, the sites' timescales are synchronized to < 1 fs in time deviation. The corresponding sites' frequencies agree to $\sim$ $10^{-18}$ despite $10^{-7}$ Doppler shifts. This work demonstrates comb-based O-TWTFT can enable free-space optical networks between airborne or satellite-borne optical clocks for precision navigation, timing and probes of fundamental science. - 4 December 2018
- Published by Optica Publishing Group in Optica
- Vol. 5 (12) , 1542-1548
Time synchronization over a free-space optical communication channel
Future high-precision free-space optical (FSO) clock networks will require laser links to transmit time-frequency between sites and, with this information, to synchronize the times across widely separated clocks. FSO communication networks already use laser links between remote sites to transmit high-speed data. Here we repurpose a FSO digital communication system and use it directly for two-way time-frequency transfer. We demonstrate synchronization of the time between two sites separated by a turbulent air path of 4 km using binary-phase-modulated continuous-wave laser light. Under synchronization, the two sites exhibit a fractional frequency deviation below at 1500 s averaging time and a time deviation below 1 ps at averaging times of seconds to hours. Over an 8 h period, the peak-to-peak wander is 16 ps. This method should be applicable to future ground-to-space and intra-satellite links and could lead to an improved global navigation and satellite system.- 4 December 2018
- Published by Optica Publishing Group in Optica
- Vol. 5 (12) , 1542-1548
Time synchronization over a free-space optical communication channel
Future high-precision free-space optical (FSO) clock networks will require laser links to transmit time-frequency between sites and, with this information, to synchronize the times across widely separated clocks. FSO communication networks already use laser links between remote sites to transmit high-speed data. Here we repurpose a FSO digital communication system and use it directly for two-way time-frequency transfer. We demonstrate synchronization of the time between two sites separated by a turbulent air path of 4 km using binary-phase-modulated continuous-wave laser light. Under synchronization, the two sites exhibit a fractional frequency deviation below at 1500 s averaging time and a time deviation below 1 ps at averaging times of seconds to hours. Over an 8 h period, the peak-to-peak wander is 16 ps. This method should be applicable to future ground-to-space and intra-satellite links and could lead to an improved global navigation and satellite system.- 1 September 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (9) , 093103
An open and flexible digital phase-locked loop for optical metrology
This paper presents an open and flexible digital phase-locked loop optimized for laser stabilization systems. It is implemented on a cheap and easily accessible FPGA-based digital electronics platform (Red Pitaya) running a customizable open-source firmware. A PC-based software interface allows controlling the platform and optimizing the loop parameters remotely. Several tools are included to allow measurement of quantities of interest smoothly and rapidly. To demonstrate the platform’s capabilities, we built a fiber noise canceller over a 400 m fiber link. Noise cancellation was achieved over a 30 kHz bandwidth, a value limited mainly by the delays introduced by the actuator and by the round-trip propagation over the fiber link. We measured a total latency of 565 ns for the platform itself, limiting the theoretically achievable control bandwidth to approximately 225 kHz.
- 1 September 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (9) , 093103
An open and flexible digital phase-locked loop for optical metrology
This paper presents an open and flexible digital phase-locked loop optimized for laser stabilization systems. It is implemented on a cheap and easily accessible FPGA-based digital electronics platform (Red Pitaya) running a customizable open-source firmware. A PC-based software interface allows controlling the platform and optimizing the loop parameters remotely. Several tools are included to allow measurement of quantities of interest smoothly and rapidly. To demonstrate the platform’s capabilities, we built a fiber noise canceller over a 400 m fiber link. Noise cancellation was achieved over a 30 kHz bandwidth, a value limited mainly by the delays introduced by the actuator and by the round-trip propagation over the fiber link. We measured a total latency of 565 ns for the platform itself, limiting the theoretically achievable control bandwidth to approximately 225 kHz.